Carbon cycling in a high-arctic marine ecosystem – Young Sound, NE Greenland

Young Sound is a deep-sill fjord in NE Greenland (74°N). Sea ice usually begins to form in late September and gains a thickness of 1.5 m topped with 0–40 cm of snow before breaking up in mid-July the following year. Primary production starts in spring when sea ice algae begin to flourish at the ice–water interface. Most biomass accumulation occurs in the lower parts of the sea ice, but sea ice algae are observed throughout the sea ice matrix. However, sea ice algal primary production in the fjord is low and often contributes only a few percent of the annual phytoplankton production. Following the break-up of ice, the immediate increase in light penetration to the water column causes a steep increase in pelagic primary production. Usually, the bloom lasts until August–September when nutrients begin to limit production in surface waters and sea ice starts to form. The grazer community, dominated by copepods, soon takes advantage of the increased phytoplankton production, and on an annual basis their carbon demand (7–11 g C m⁻²) is similar to phytoplankton production (6–10 g C m⁻²). Furthermore, the carbon demand of pelagic bacteria amounts to 7–12 g C m⁻² yr⁻¹. Thus, the carbon demand of the heterotrophic plankton is approximately twice the estimated pelagic primary production, illustrating the importance of advected carbon from the Greenland Sea and from land in fuelling the ecosystem.In the shallow parts of the fjord (<40 m) benthic primary producers dominate primary production. As a minimum estimate, a total of 41 g C m⁻² yr⁻¹ is fixed by primary production, of which phytoplankton contributes 15%, sea ice algae <1%, benthic macrophytes 62% and benthic microphytes 22%. A high and diverse benthic infauna dominated by polychaetes and bivalves exists in these shallow-water sediments (<40 m), which are colonized by benthic primary producers and in direct contact with the pelagic phytoplankton bloom. The annual benthic mineralization is 32 g C m⁻² yr⁻¹ of which megafauna accounts for 17%. In deeper waters benthic mineralization is 40% lower than in shallow waters and megafauna, primarily brittle stars, accounts for 27% of the benthic mineralization. The carbon that escapes degradation is permanently accumulated in the sediment, and for the locality investigated a rate of 7 g C m⁻² yr⁻¹ was determined.A group of walruses (up to 50 adult males) feed in the area in shallow waters (<40 m) during the short, productive, ice-free period, and they have been shown to be able to consume <3% of the standing stock of bivalves (Hiatella arctica, Mya truncata and Serripes Groenlandicus), or half of the annual bivalve somatic production. Feeding at greater depths is negligible in comparison with their feeding in the bivalve-rich shallow waters.     

Improving the Coastal Mean Dynamic Topography by Geodetic Combination of Tide Gauge and Satellite Altimetry

Abstract

The ocean mean dynamic topography (MDT) is the surface representation of the ocean circulation. The MDT may be determined by the ocean approach, which involves temporal averaging of numerical ocean circulation model information, or by the geodetic approach, wherein the MDT is derived using the ellipsoidal height of the mean sea surface (MSS), or mean sea level (MSL) minus the geoid as the geoid. The ellipsoidal height of the MSS might be estimated either by satellite or coastal tide gauges by connecting the tide gauge datum to the Earth-centred reference frame. In this article we present a novel approach to improve the coastal MDT, where the solution is based on both satellite altimetry and tide gauge data using new set of 302 tide gauges with ellipsoidal heights through the SONEL network. The approach was evaluated for the Northeast Atlantic coast where a dense network of GNSS-surveyed tide gauges is available. The typical misfit between tide gauge and satellite or oceanographic MDT was found to be around 9?cm. This misfit was found to be mainly due to small scale geoid errors. Similarly, we found, that a single tide gauge places only weak constraints on the coastal dynamic topography.     

Pollen assemblages and their environmental implications in the Qaidam Basin,NW China

The Qaidam Basin is one of the most sensitive areas to climate change in China, owing to its unique geographical position and ecological condition. In this study, 32 surface‐soil pollen samples were collected to reveal the relationship between modern pollen assemblages, vegetation and precipitation in the eastern region of the Qaidam Basin. The results show that Chenopodiaceae (3.8–87%, average 48%), Artemisia (1.7–64.2%, average 17.5%) and Ephedra (0–90%, average 16.3%) are the dominant pollen types in all samples, and that different pollen assemblages correspond to different vegetation types. DCA and CCA of major pollen types demonstrate that precipitation is an important factor in the control of the distribution of vegetation in the study area. The content and concentration of the three major pollen types (Artemisia, Chenopodiaceae and Ephedra) change with the mean annual precipitation, and the optimum mean annual precipitation for Ephedra, Chenopodiaceae and Artemisia is <80, 80–200 and >160 mm, respectively. Correlation analysis between the variation in grain size of the three major pollen types and the main environmental variables shows that the grain size of the three pollen types is positively correlated with precipitation in the Qaidam Basin. The results confirm that precipitation is the most important environmental factor in the Qaidam Basin, and that it has an important effect on pollen grain size in the study area.     

A review of EU bio-economic models for fisheries: The value of a diversity of models

The lessons learned from a review of thirteen existing European bio-economic models used in the evaluation of EU policies are presented. How these models compare and differ in terms of their biological and economic components, the integration between the components, which indicators are selected and how they are used, are described and analysed. The article concludes that the multitude of construction differences reflects the necessity of adapting the modelling approach to answer different questions. Since real life questions in fisheries are so diverse, answering them requires a diversity of models.     

Morphodynamics of a bar-trough surf zone

A field study was made of the distinguishing morphodynamic processes operating in a surf zone which perennially exhibits accentuated bar-trough topography (the “longshore-bar-trough” and “rhytmic-bar-and-beach” states as described by Wright and Short, 1984). Characteristic features of the morphology include a shallow bar with a steep shoreward face, a deep trough, and a steep beach face. This morphology, which is favored by moderate breaker heights and small tidal ranges, strongly controls the coupled suite of hydrodynamic processes. In contrast to fully dissipative surf zones, the bar-trough surf zone is not at all saturated and oscillations at incident wave frequency remain dominant from the break point to the subaerial beach. The degree of incident wave groupiness does not change appreciably across the surf zone. Infragravity standing waves which, in dissipative surf zones, dominate the inshore energy, remain energetically secondary and occur at higher frequencies in the bar trough surf zone. Analyses of the field data combined with numerical simulations of leaky mode and edge wave nodal—antinodal positions over observed surf-zone profiles, indicate that the frequencies which prevail are favored by the resonant condition of antinodes over the bar and nodes in the trough. Standing waves which would have nodes over the bar are suppressed. Sediment resuspension in the surf zone appears to be largely attributable to the incident waves which are the main source of bed shear stress. In addition, the extra near-bottom eddy viscosity provided by the reformed, non-breaking waves traversing the trough significantly affects the vertical velocity profile of the longshore current. Whereas the bar is highly mobile in terms of onshore—offshore migration rates, the beach face and inner regions of the trough are remarkably stable over time.     

Objectives of fisheries management: case studies from the UK, France, Spain and Denmark

The main objectives of fisheries management are generally similar throughout the world. These are often stated in policy documents such as the Common Fisheries Policy and the Magnuson–Stevens Fishery Conservation and Management Act. However, at the local level often the key objectives of management are more detailed, characterised by both the overriding management structure and the status and type of fishery concerned. In this paper, we consider case study fisheries from the UK, France, Spain and Denmark to compare some of the various types of fisheries and fisheries management systems that exist in the European Union. From this, we define the key objectives for each management system.     

FTIR studies of reactions between the nitrate radical and haloethenes

Products and mechanisms for the gas-phase reactions of NO₃ radicals with CH₂=CHCl, CH₂=CCl₂, CHCl=CCl₂,cis-CHCl=CHCl andtrans-CHCl=CHCl in air have been studied. The experiments were carried out at 295±2 K and 740±5 Torr in a 480-L Teflon-coated reaction chamber and at 295±2 K and 760±5 Torr in a 250-L stainless steel reactor. NO₃ was generated by the thermal dissociation of N₂O₅. Experiments with¹⁵NO₃ and CD₂CDCl have also been performed. The initially formed nitrate peroxynitrates decay into carbonyl compounds, nitrates, HCl and ClNO₂. In adidtion, there are indications of nitrooxy acid chlorides being produced. The reactions with CH₂=CCl₂ and CHCl=CCl₂ are more complex due to release of chlorine atoms which eventually lead to formation of chloroacid chlorides.A general reaction mechanism is proposed and the observed concentration-time profiles of reactants and products are simulated for each compound. The rate constants for the initial step of NO₃ addition to the chloroethenes are determined as: (2.6±0.5, 9.4±0.9, 2.0±0.4 and 1.4±0.4) × 10^–16 cm³ molecule^–1 s^–1 for CH₂=CHCl, CH₂=CCl₂, CHCl=CCl₂ andcis-CHCl=CHCl, respectively.     

Intermetallic compounds,copper and palladium alloys in Au–Pd ore of the Skaergaard pluton,Greenland

Copper–palladium intermetallic compounds and alloys (2314 grains) from the Au–Pd ore of the Skaergaard layered gabbroic pluton have been studied. Skaergaardite PdCu, nielsenite PdCu₃, (Cu,Pd)_β, (Cu,Pd)_α, (Pd,Cu,Au,Pt) alloys, and native palladium have been identified as a result of 1680 microprobe analyses. The average compositions and various chemical varieties of these minerals are characterized, as well as vertical and lateral zoning in distribution of noble metals. The primary Pd–Cu alloys were formed within a wide temperature interval broadly synchronously with cooling and crystallization of host gabbro and in close association with separation of Fe–Cu sulfide liquid. In the course of crystallization of residual gabbroic melt enriched in iron, noble and heavy metals and saturated with the supercritical aqueous fluid, PGE and Au are selectively concentrated in the Fe–Cu sulfide phase as Pd–Cu and Cu–Au alloys.     

First results of micropulsation activity observed by sabre

Between September 1981 and March 1982 many Pc5 micropulsation events have been observed by the Wick component of the new SABRE auroral radar. A feature of these observations is that in addition to the characteristic poleward drifting regions of radar backscatter, equatorward moving regions are frequently observed. A consistent diurnal pattern in the direction of drift emerges from a statistical analysis of the data.