Modifications of the porous network of sandstone accompanying the formation of black varnish

Black varnish commonly develops on rain-washed fine-grained monument sandstone. Stone modifications are, to the naked eye, limited to 10-μm thick black film and underlying modified zone about 1-mm thick. Transfer properties (absorption and drying kinetics and permeability) are, however, modified several centimetres under the surface. The present study investigates the modifications of black-varnish covered siliceous sandstones taken from Alsatian monuments (East of France) and of fresh sandstone undergoing wetting–drying cycles in the laboratory. Double-coloured thin-sections revealed gradual changes in the porous network, up to 3 cm under the black varnish. SEM observations showed that the film was mainly composed of iron and phosphorus while the modified zone was rich in calcium and sulphur. Fifty capillary absorption–drying cycles were carried out on fresh sandstone. Absorption kinetics was measured at each cycle. A continuous decrease of sandstone absorption kinetics over the fifty cycles was interpreted as a reorganisation of the porous network, reducing the connectivity of the porous network although total porosity remained unchanged. Wetting–drying cycles carried out under an environmental microscope (ESEM) showed a displacement of the finest particles (clay clusters), filling the macroporosity and decreasing the connectivity.     

Millennium-long recession of limestone facades in London

Historical data on the temperature and precipitation data for London has been combined with output from the Hadley Model to estimate the climate of London for the period 1100–2100 CE. This has been converted to other parameters such as freeze–thaw frequency and snowfall relevant to the weathering of stone facades. The pollutant concentrations have been estimated for the same period, with the historical values taken from single box modelling and future values from changes likely given current policy within the metropolis. These values are used in the Lipfert model to show that the recession from karst weathering dominates across the period, while the contributions of sulphur deposition seem notable only across a shorter period 1700–2000 CE. Observations of the late seventeenth century suggest London architects witnessed a notable increase in the recession rate and attributed “fretting quality” to “smoaks of the sea-coal”. The recession rates measured in the late twentieth century lend some support to the estimates from the Lipfert model. The recession looks to increase only slightly, and frost shattering will decrease while salt weathering is likely to increase.     

High‐pressure metamorphism in Taiwan: from oceanic subduction to arc‐continent collision?

Abstract The Taiwan orogen has been the focus of a number of models of mountain building processes, but little attention has been paid to high‐pressure (HP) metamorphic rocks that are found as exotic blocks intermingled within the deepest units of the mountain belt. In this study, we re‐appraise from updated petrological and thermodynamic databases the physical conditions of HP metamorphism in Taiwan, and we combine our findings with available geochronological data to estimate the thermal history of these rocks. Our results indicate that peak metamorphic conditions of ～550 °C and 10–12 kbar have been followed by a rapid isothermal decompression, with exhumation possibly as rapid as burial. These units have subsequently been stored at a pressure of ～3 kbar for ～4–5 Myr, before their final exhumation, probably facilitated by the accretion of passive margin sequences during the Late Cenozoic collision. Therefore, HP units in Taiwan maintain a record of processes at depth from the early stages of oceanic subduction to the present arc‐continent collision.     

Nonlinear Analysis of Local Site Effects on Seismic Ground Response in the Bam Earthquake

The influence of local geologic and soil conditions on the intensity of ground shaking is addressed in this study. The amplification of the ground motion due to local site effects resulted in severe damage to dwellings in the Bam area during the 2003 Bam Earthquake. A unique set of strong motion acceleration recordings was obtained at the Bam accelerograph station. Although the highest peak ground acceleration recorded was the vertical component (nearly 1 g), the longitudinal component (fault-parallel motion) clearly had the largest maximum velocity as well as maximum ground displacement. Subsurface geotechnical and geophysical (down-hole) data in two different sites have been obtained and used to estimate the local site condition on earthquake ground motion in the area. The ground response analyses have been conducted considering the nonlinear behavior of the soil deposits using both equivalent linear and nonlinear approaches. The fully nonlinear method embodied in FLAC was used to evaluate the nonlinear soil properties on earthquake wave propagation through the soil layer, and compare with the response from the equivalent linear approach. It is shown that thick alluvium deposits amplified the ground motion and resulted in significant damage in residential buildings in the earthquake stricken region. The comparison of results indicated similar response spectra of the motions for both equivalent and nonlinear analyses, showing peaks in the period range of 0.3–1.5 s. However, the amplification levels of nonlinear analysis were less than the equivalent linear method especially in long periods. The observed response spectra are shown to be above the NEHRP building code design requirements, especially at high frequencies.     

Analysis of the 2003 Varunawat Landslide,Uttarkashi, India using Earth Observation data

Mass movements such as landslides in mountainous terrains are natural degradation processes and one of the most important landscape-building factors. Varunawat Parbat overlooking Uttarkashi town witnessed a series of landslides on 23 September 2003 and the debris slides and rock falls continued for 2 weeks. This landslide complex was triggered due to the incessant rainfall prior to the event, and its occurrence led to the blockage of the pilgrim route to Gangotri (source of the Ganges river) and evacuation of thousands of people to safer places. Though there was no loss of lives due to timely evacuation, heavy losses to the property were reported. High-resolution stereoscopic earth observation data were acquired after the incidence to study the landslide in detail with emphasis on the cause of the landslide and mode of failure. Areas along the road and below the Varunawat foothill region are mapped for landslide risk. It was found that the foothill region of the Varunawat Parbat was highly disturbed by man-made activities and houses are dangerously located below steep slopes. The potential zones for landslides along with the existing active and old landslides are mapped. These areas are critical and their treatment with priority is required in order to minimise further landslide occurrences.     

Monitoring Large-Scale Tests for Nuclear Waste Disposal

Two large-scale “in situ” demonstration experiments and their instrumentation are described. The first test (FEBEX Experiment) involves the hydration of a compacted bentonite barrier under the combined effect of an inner source of heat and an outer water flow from the confining saturated granite rock. In the second case, the progressive de-saturation of Opalinus clay induced by maintained ventilation of an unlined tunnel is analyzed. The paper shows the performance of different sensors (capacitive cells, psychrometers, TDR’s) and a comparison of fill behaviour with modelling results. The long term performance of some instruments could also be evaluated specially in the case of FEBEX test. Capacitive sensors provide relative humidity data during long transient periods characterised by very large variations of suction within the bentonite.     

Field Measurement of Suction, Water Content, and Water Permeability

This paper presents a review of techniques for field measurement of suction, water content, and water hydraulic conductivity (permeability). Main problems in the use of field tensiometers are addressed and hints on how to improve tensiometer performance are given. Advantages and limitations of instruments for indirect measurement of suction including electrical conductivity sensors, thermal conductivity sensors, dielectric permittivity sensors, filter paper, and psychrometer are discussed. Techniques for water content measurement based on dielectric methods are then presented. These include time and amplitude domain reflectometry and capacitance. Finally, a brief overview of methods for measurement of water permeability in the field is presented.     

贵州遵义牛蹄塘组黑色岩系的硒同位素变化及其环境指示初探

西南早寒武世牛蹄塘组是分布在中国南方扬子地台的一套黑色岩系,区域上发育有典型富集多金属元素的硫化物矿化层.选取遵义松林小竹牛蹄塘组下部富硒、钼、镍等元素的黑色岩系剖面,利用Se同位素初步探讨了该剖面岩石的沉积环境和硒的可能来源.结果表明,小竹牛蹄塘组下部剖面黑色岩系的δ82/76SeSRM3149比值变化较大,下部底层含碳斑脱岩与磷块岩的变化范围在-4.35‰～ 4.11‰之间;中间镍钼层及碳质页岩、碳质碳酸盐岩的δ82/76SeSRM3149变化范围窄,平均值为0.9‰±0.23‰(n=4);上层碳质页岩为-1.24‰.结合已发表的钼同位素数据,认为中间岩石沉积于缺氧/无氧环境,但存在盆地海水与热液或充氧水团的混合;下层的岩石曾一度位于充氧与贫氧环境的边界面,局部岩石曾暴露地表经历了较强的风化和蚀变作用,海水中硒有可能来自底部富硒斑脱岩的氧化淋滤或海底热液.据此推测遵义松林小竹牛蹄塘组下部岩石的沉积环境极可能处在局限盆地靠近陆地的边缘部分,经历了充氧→贫氧→缺氧/无氧→贫氧的演化阶段.     

GEOPHYSICAL STUDIES OF WATER LEAKAGES FROM RESERVOIRS*

Considerable water leakages from reservoirs make it difficult to attain the planned storage capacity. In some cases water leakages give rise to suffusion followed by catastrophes. Until recently methods for locating water leakages were extremely imperfect. Geophysical methods offer good prospects in this direction. For solving these problems, it is effective to use streaming potential measurements, water flow rate observations and thermometry. Laboratory experiments were carried out in connection with the fact that water leakages from reservoirs are characterized by negative anomalies of natural currents; the more filtration discharge, the higher these anomalies are. As a result, the relationship governing the intensity of streaming potential and sand granulometric composition, electrolyte concentrations and other factors were revealed. To determine the velocity of water flowing to leakage sites, a special device, based on the relationship between the temperature of a heated body and its resistance, is applied. This device simultaneously makes it possible to measure the water medium temperature. Observations at reservoir sites were effected by moving along the reservoir non-polarizable potential electrodes and water velocity devices. Recordings were carried out automatically by the recording device of the logging apparatus. Under the conditions of ice cover on water surfaces, measurements were made through separate points by digging holes in the ice cover. Practical field observations were carried out at reservoir sites located in regions where fissured massive rocks as well as loose sediments predominate. In the first case field experiments were carried out in alpine reservoirs, in Armenia. The major water leakages were found to be concentrated on the right bank of the reservoir. In this connection it was not only possible to locate water leakage sites, but also to evaluate their relative intensity. These data were used for planning antifiltration measures. In the second case water leakages from a reservoir located in Uzbekistan in the submontane part of the Pamirs were studied. Streaming potential anomalies and high benthonic flow rates made it possible to discover high filtrations in the base and walls of the dam. Further perfection of these methods should not only permit the determination of water leakage sites and their relative intensity, but also filtration discharges in absolute units.     

SOME EXPERIMENTS CONCERNING THE PRIMARY SEISMIC PULSE*

Recordings were made with three types of detector of the primary compressional (P) and shear (S) wave pulses generated by explosions in boreholes. Charge weights varied from 0.08 kg to 9.5 kg and detector distances varied from about 3 m to about 80 m. Scaling by the simple factor W^1/3 where W is the charge weight, enabled observations from different sized charges to be fitted to a single expression. Experiments were carried out in the Bunter sandstone and the London clay and both fluid and solid tamping were used. This variation in tamping had no significant effect on the P-waves but it may have affected the generation of SV-waves. In both media the P-wave energy carried at 30 m from the shot by frequencies less than 100 Hz decreased rapidly with depth and was usually 1–2 % of the available chemical energy for a shot depth of 15 m. The S-wave energy was much less than this, but was highly directional. The P-wave pulse had the appearance of a damped sinusoid in very good agreement with the predictions of the ‘equivalent radiator’ hypothesis. However, the surface of this radiator should be identified not with the blown cavity but with the surface at which the tensile stresses associated with the stress wave become less than the tensile strength of the rock. The predominant frequency for a 1 kg charge at a depth of 15 m was 24 Hz in the clay and 52 Hz in the sandstone. In these and similar media, therefore, an effort should be made to keep individual charges less than 1 kg in reflection shooting and less than 10 kg in refraction shooting. The value of Q was about 50 in clay and about 25 in the sandstone. These estimates are rather uncertain because of the small distances over which the pulses were observed. The Z-transforms of the sampled pulses indicated that they were all of minimum phase, or very near to it.