Single-station ellipticity retrieval and its joint inversion with dispersion curve,for a borehole test site

To obtain the shear wave velocity profile for engineering application to near-subsurface, many geophysical techniques are used. The dispersion curve alone is unable to provide deeper shear wave velocity information for deep soil deposit; therefore, a joint inversion of dispersion curves with the horizontal over vertical (H/V) (i.e., apparently ellipticity) curve is recommended. The H/V curve obtained from the microtremor recording contains a major part of Love wave contribution to the noise wavefield horizontal component. Due to this presence of Love wave fraction, the H/V curve does not completely replicate the ellipticity of Rayleigh wave. In this study, we try to compare the Rayleigh wave ellipticity obtained from the borehole velocity model to the H/V curve obtained at the same locality from seismic ambient noise recording. Two different techniques available for the Love effect minimization are tested and compared with the borehole ellipticity. Finally, the joint inversion of H/V and dispersion curve is made, which shows great correspondence with the previous measurement at the site.     

Si‐bearing metal and niningerite in Almahata Sitta fine‐grained ureilites and insights into the diversity of metal on the ureilite parent body

A detailed mineralogical and chemical study of Almahata Sitta fine‐grained ureilites (MS‐20, MS‐165, MS‐168) was performed to shed light on the origin of these lithologies and their sulfide and metal. The Almahata Sitta fine‐grained ureilites (silicates <30 μm grain size) show textural and chemical evidence for severe impact smelting as described for other fine‐grained ureilites. Highly reduced areas in Almahata Sitta fine‐grained ureilites show large (up to ～1 mm) Si‐bearing metal grains (up to ～4.5 wt% Si) and niningerite [Mg_>0.5,(Mn,Fe)_<0.5S] with some similarities to the mineralogy of enstatite (E) chondrites. Overall, metal grains show a large compositional variability in Ni and Si concentrations. Niningerite grains probably formed as a by‐product of smelting via sulfidation. The large Si‐Ni variation in fine‐grained ureilite metal could be the result of variable degrees of reduction during impact smelting, inherited from coarse‐grained ureilite precursors, or a combination of both. Large Si‐bearing metal grains probably formed via coalescence of existing and newly formed metal during impact smelting. Bulk and in situ siderophile trace element abundances indicate three distinct populations of (1) metal crystallized from partial melts in MS‐20, (2) metal resembling bulk chondritic compositions in MS‐165, and (3) residual metal in MS‐168. Almahata Sitta fine‐grained ureilites developed their distinctive mineralogy due to severe reduction during smelting. Despite the presence of E chondrite and ureilite stones in the Almahata Sitta fall, a mixing relation of E chondrites or their constituents and ureilite material in Almahata Sitta can be ruled out based on isotopic, textural, and mineral‐chemical reasons.     

Efficient algorithms for the earth's gravitational potential and its partial derivatives for satellite prediction

In this paper, economical recursion formulae for the Earth's gravitational potential and its partial derivatives with respect to the Cartesian coordinates, and time will be established for any number and any type of the harmonic coefficients. General computational algorithms for their implementations on digital computers are also given.Now at the Department of Astronomy, King Abdul-Aziz Univ., Jeddah, Saudi Arabia.Now at the Department of Mathematics, Girls College of Education, Jeddah, Saudi Arabia.     

Sustainable Development Goals (SDGs) Associated with Groundwater Over-Exploitation Vulnerability: Geographic Information System-Based Multi-criteria Decision Analysis

Natural Resources Research - Groundwater over-exploitation is related to various environmental, economic, and social aspects, which should be addressed comprehensively to support a sustainable...     

Indoor activity size distribution of the short-lived radon progeny

Activity size distribution of the short-lived radon progeny in indoor air was measured continuously over several weeks. Two different measurement techniques were used: a direct measurement with a low-pressure Berner cascade impactor for attached fraction of ²¹⁴Pb and ²¹⁴Bi (≥100 nm) and an indirect determination based on measurement with a wire screen diffusion battery (unattached fraction 0.5–5 nm, ²¹⁸Po, ²¹⁴Pb). In parallel, the meteorological parameters like temperature, humidity were registered. Measured activity size distribution of radon progeny can be approximated by a sum of three log-normal distributions modes (nucleation, accumulation and coarse). The greatest activity fraction was adsorbed on aerosol particles in the accumulation size range (100–1000 nm) with activity median aerodynamic diameters (AMAD_a) and geometric standard deviations (GSD _a ) values of 250–500 nm, and 1.5–3.5, respectively. The influence of the weather conditions on the activity of the accumulation particles was not significant. In contrast to the results of measurements a small but significant fraction of the radon progeny (average value 5 %) was attached to coarse particles (>1000 nm). This fraction varied between 0 and 10 %. On the other hand, although the amount of unattached activities not more 10 % of the total activity, but is considered to yield about 50 % of the total radiation dose. The mean thermodynamic equivalent diameters of ²¹⁸Po and ²¹⁴Pb were determined to be 1.28 and 1.30 nm with relative mean geometric standard deviations of 1.30 and 1.24, respectively. Based on the obtained results of radon progeny size distributions (attached and unattached), the total deposition fractions of the human lung were evaluated by using a lung deposition model.     

Chemical variations of sulfides and metal in enstatite chondrites—Introduction of a new classification scheme

In this study, the metal and sulfide compositions of 45 enstatite chondrites were analyzed to determine possible mineral-chemical trends correlated with the petrologic type. Data for 35 additional samples were taken from the literature. Considering the data from this huge number of different E chondrite samples (80 in total), none of the trends previously described in the literature could be clearly confirmed. Also, among the opaque phases of enstatite chondrites, no other “new” correlations between mineral chemistry and the petrologic type were found. However, major differences in the sulfide and metal chemistry became obvious. Specifically, a certain number of chondrites in the EH and the EL groups have Cr in troilite above 2 wt%, Fe in niningerite or alabandite above 20 wt%, and lack abundant daubréelite. Differences were also found for Ni concentrations in kamacite. Thus, we propose a system for classifying E chondrites by defining four major subgroups: EH_a, EL_a, EH_b, and EL_b. All subgroups show full petrologic sequences that are similar to each other. This observation, in combination with the differences in sulfide and metal chemistry, suggests an origin of the samples from different parent bodies. Considering the anomalous E chondrite samples that neither fit in the previous classification scheme nor in the new one described here, the samples investigated in this study require at least eight different parent bodies.     

Vertical sediment fluxes and wave-induced sediment resuspension in a shallow-water coastal lagoon

The present study describes variations in the vertical fluxes measured concurrently with sediment traps at both a shallow water (4 m) and a deeper water (7.5 m) position in a coastal lagoon in April 1995. A tripod equipped with five sediment traps (trap openings at 0.35 m, 0.75 m, 1.05 m, 1.40 m, and 1.80 m above the seabed) was placed at the shallow water position. This tripod was deployed three times during the study period and deployment periods varied between 2 d and 5 d. The second sediment trap, placed at the deep water position in the central part of the lagoon, measured vertical flux for intervals of 12 h at 1.4 m above the seabed. The horizontal distance between the sediment traps was 8 km. The average maximum vertical flux at the shallow water position reached 27.9 g m⁻² d⁻¹ during a period of high, westerly wind speeds, and a maximum vertical flux of 16.9 g m⁻² d⁻¹ was reached at the deep water position during a period of high, easterly wind speeds. Both strong resuspension events were closely related to increased wave shear stress derived from surface waves. Maximum wave-induced resuspension rate was 10 times higher at the shallow water position and 3.8 times higher at the deep water position compared with the net sedimentation rate in the lagoon. Small resuspension events occurred at the shallow water position during periods of increased current shear stress, Estimations of conditions for transport of sediment between shallow water and deep water showed that particles must be resuspended to a height between 3 m and 4 m and that current speeds must be higher than about 0.1 m s⁻¹. An average sedimentation rate of 3.8 g m⁻² d⁻¹ was obtained at the shallow water position during a period without wave shear stress and low current shear stress. This rate measured by sediment traps is similar to a net sedimentation rate in the lagoon of 4.4 g m⁻² d⁻¹, which was determined by radiocarbon dating of a sediment core (Kristensen et al. 1995).     

Phytoplankton and bacterial community structures and their interaction during red-tide phenomena

Phytoplankton and bacteria diversity were studied before, during and after red tide phenomena during spring season 2015 in the Eastern Harbour (E.H.) of Alexandria, Egypt. Fifty five species of phytoplankton were identified and represented different distinct classes “Bacillariophyceae; Dinophyceae, Chlorophyceae, Cyanophyceae and Eugelenophyceae”. Also, Diatom formed the most dominant group. The average number of the phytoplankton density varied from 4.8 × 10⁴ to 1.1 × 10⁶ cell l^-1 during the study period and Skeletonema costatum was the agent causing the red tide. The existence percentages of bacteria ranged from 2.6 to 17.9% on all media tested. The bacterial isolates on the nutrient agar medium represented the highest existence with a total percentage of 43.6%, followed by MSA medium (25.7%), while the lowest percentage was for the AA medium at 7.8%. However, twelve isolates were selected as representative for bacterial community during study interval. Based on the morphological, biochemical, physiological and enzymatic characteristics, the bacterial strains were described. Depending on the 16S rDNA gene sequence, three common antagonists were aligned as: Vibrio toranzoniae strain Vb 10.8, Ruegeria pelagia strain NBRC 102038 and Psychrobacter adeliensis strain DSM 15333. The interaction between these bacteria and S. costatum was studied. The growth of S. costatum was significantly lower whenever each bacterium was present as compared to axenic culture. More specifically, 30% (v/v) of the all tested bacteria showed the strongest algicidal activities, as all S. costatum cells were killed after two days. 10% of R. pelagia and P. adeliensis also showed significant algicidal activities within six days.