Development of design storm hyetographs in hyper-arid and arid regions: case study of Sultanate of Oman

The temporal distribution of the design storm is an important input in hydrological models. This research aims to develop design storm profiles representative of arid and hyper-arid areas based on actual storm recordings. Two hundred thirty-six rainfall storms were collected from seventeen rainfall gauges that cover the coastal zone of Oman for the period from 1993 to 2007. Storms were classified into four categories according to their total durations. Design storm hyetographs were derived from raw rainfall records for all four categories using the Alternating Block Method (ABM) and were also computed by ABM applied on the Intensity-Duration-Frequency (IDF) curves. Both design storm profiles were compared and it was found that the ABM_IDF storm profiles were equivalent to the four ABM_Storms profiles from a practical point of view as they produce similar peak discharges. The storm profiles developed in the current research were also compared to the commonly used Soil Conservation Service (SCS) dimensionless distributions and the UK50 storm profiles. The results showed that the most conservative commonly used SCS type II and the UK50 summer profiles are not safe to be used in design purposes in arid and hyper arid regions, despite their wide utilization in many codes of practice in these regions. The study recommends using the newly developed dimensionless storm profiles derived from the actual records.     

Vertical vibration capacity of a single pile in dry sand

In this study, the dynamic response of pile foundation in dry sandy soil excited by two opposite rotary machines was considered experimentally. A small scale physical model was manufactured to accomplish the experimental work in the laboratory. The physical model consists of two small motors supplied with eccentric mass (0.012?kg) and eccentric distance (20?mm) representing the two opposite rotary machines, an aluminum shaft as the pile, and a steel plate a pile cap. The experimental work was achieved taking the following parameters into considerations: pile embedment depth ratio (L/d, where L is the pile length and d is its diameter) and operating frequency of the rotary machines. All tests were conducted in medium dense fine sandy soil with 60% relative density. Twelve tests were performed to measure the change in load transferred through the pile’s tip to the underlying soil. To predict precisely the dynamic load that will be induced from the rotary machines, a mini load cell with a capacity of 100?kg was mounted between the aluminum plate (the machine base) and the steel plate (pile cap). The results revealed that, before machine operation, the pile tip load was approximately equal to the static load (machine and pile cap), whereas during machines’ operation, the pile tip load decreased for all embedment depth ratios and operating frequencies. This reduction was due to the action of skin friction that was mobilized along the pile during operation, and as a result the factor of safety against pile bearing failure increases. For all operating frequencies and pile lengths, the factor of safety against bearing failure increased during machines’ operation, where the pile tip load became less than its value before starting operation. During operation, the skin friction resistance mobilized along pile length led to decrease the bearing load.     

Finite strain analysis for deformed Neoproterozoic rock associations of the Al Amar fault zone,Eastern Arabian Shield,Saudi Arabia

Arabian Journal of Geosciences - In this work, quantitative analysis of coastal zone landform morphology is carried out through the integration of landscape index, remote sensing (RS) and...     

Stochastic Modeling of Short Term Variations of Sea Level in Eastern Canada

Hourly sea level records from three stations in eastern Canada (Québec-Lauzon, Harrington-Harbour and Halifax) are analyzed both in frequency domain from 1970 to 1979 and in time domain during 1973. At the three stations, the deterministic model explains 90 to 96% of the total variability of sea level. The semidiurnal and diurnal tides contribute largely to its variations. The residual series, less than 10% of the initial variations of sea level, contain irregular values including extreme values of seiches and storm surges. Such random variations are analyzed and modeled following the method described by Box and Jenkins (1976). The long period variations (2 to 30 days) can be attributed to meteorological forcing (atmospheric pressure and winds). The short period variations (some hours to one day) can be attributed to longitudinal seiches, semidiurnal and diurnal atmospheric tides, and inertial oscillations. The water discharge from the St. Lawrence River contributes 29% of the monthly residual sea level at Qué     

Review: Assessment and modeling of seawater intrusion in coastal aquifers of the Arabian Peninsula

Hydrogeology Journal - Significant urbanization and industrialization, combined with strong population growth, have been witnessed in the Arabian Peninsula (Oman, United Arab Emirates, Saudi...     

Potential link between exposure to fungicides chlorothalonil and mancozeb and haemic neoplasia development in the soft-shell clam Mya arenaria: A laboratory experiment

The aetiology of haemic neoplasia (HN) is unknown, so far but many causative factors are suggested such as viral, pollution and genetics. The aim of this study was to determine if, under chronic exposure, two major pesticides (chlorothalonil and mancozeb) which are used in potato production could induce HN in soft-shell clams (Mya arenaria). Short-term experiments with acute exposure were also performed. Clams were collected from an epizootic site (North River, PEI) and from a site free of the disease (Magdalen Islands, Quebec). The tetraploid level of haemocytes was assessed by flow cytometry for each clam to determine the HN status. The bioaccumulation of pesticides in tissues was quantified by gas chromatography/mass spectrometry (GC/MS) for chlorothalonil while mancozeb and manganese were quantified by inductively coupled plasma-mass spectrometer (ICP/MS). Long term exposure to fungicide Bravo 500^® did not induce high tetraploid levels on negative calm from North River and the analysis of the digestive gland and the mantle did not reveal any detectable level of chlorothalonil. In the Manzate 200 DF^®, some clams revealed high level of tetraploid cells but no difference were observed between the treatments and the control. The analysis of the digestive gland and the mantle for manganese did not highlight any significant difference in tissue concentration (p = 0.05). For the acute exposure, chlorothalonil analysis showed that the active ingredient is distributed between four chlorinated compounds: 99.5% for chlorothalonil isomers, 0.4% for pentachlorothalonil and 0.1% for trichlorothalonil isomers. For a 72 h experiment, the accumulation was within 4 h; the higher tissue concentration of chlorothalonil was 59.2 μg g⁻¹ in the mantle after 48 h, following by a decrease to an undetectable level at the end. For the manganese, the accumulation was detected after 4 h; the higher tissue concentration was 48.8 μg g⁻¹ in the mantle after 24 h and, over the following 48 h, the accumulation decreased until the end of the trial. Based on the data, the accumulation of these fungicides seems to be transitory. Chlorothalonil and mancozeb are both oxidative-stress promoters and could have induced cell dysfunction while in the tissue. Study on the effect of these fungicides on the p53 protein system is an example of strategy that would provide information on cellular events promoting neoplasia.     

3D geomodeling of the Lower Cretaceous oil reservoir, Masila oil field, Yemen

Oil was first discovered in the Masila area of Yemen in the late 1990s, with about 90% of the reserves found in the Lower Qishn Clastic Member of the Qishn Formation. The porosity determinations of the Lower Qishn Clastic are relatively high and the permeability ranges from 103 to 374?md. This paper tries to evaluate the hydrocarbons in the porous zones encountered in the Lower Cretaceous formations, which were penetrated by the eight wells in the study area. The water saturation shows low values, while the hydrocarbon saturation is in a reverse relation, i.e., the hydrocarbon increases where the water saturation decreases. Different cross-plots such as Rho-PHIN, Rho-DTN, and M-N were used in lithological identification for the two studied formations (Saar and Qishn) in the studied wells. Formation evaluation and presentation forms of the obtained petrophysical parameters have frequently proven that the formations have high hydrocarbon saturation in this area and contain many pay zones. On of the main targets of this paper is to build a detailed 3D geological modeling of the Lower Cretaceous Sequence conducted through an integrated study.     

影响三大洲的北非强沙尘暴动力机制WRF-chem模拟与分析北大核心

基于WRF-chem模式对北非2018年3月下旬的典型强沙尘暴过程进行模拟,分析了此次强沙尘发生季节、持续时间、局地特征以及传输路径的关键动力系统与动力机制。鉴于起沙是沙尘暴发生的关键点之一,并且起沙主要取决于风力和下垫面沙源性质,本文测试了三种起沙参数化方案的影响,并将模拟结果与卫星MODIS监测及其再分析资料MERRA-2进行了对比,又经系列统计方法检验。结果显示,宏观思路的起沙方案GOCART比AFWA和UoC两种起沙方案更适合此次大尺度强沙尘暴数值模拟(锋面跨度接近60个经度)。综合沙尘暴关键系统的动力机制分析和数值模拟结果显示,强沙尘暴关键系统为深厚的西风槽、沙尘冷锋锋面和锋后的地面高压反气旋。北非中部深厚的西风槽为后倾槽,该系统稳定,造成沙尘暴持续时间长。沙尘暴锋后反气旋中的下沉气流抑制了扬沙向高层扩散,造成低层能见度恶劣。沙尘锋区结合了动力、热动力以及湿热动力不稳定,因此锋区风力大,地面沙尘驱动力强。而西风槽和强大反气旋依托环流形势,提供了沙尘传输到三大洲的长途输送力。