Application of a new river classification scheme to Australia's tropical rivers

A revised typology of Australian tropical rivers was applied to the complete channel network (named and major rivers) shown on 1:250 000 topographic maps for three large drainage basins in northern Australia (Daly River, NT; Fitzroy River, WA; Flinders River, Qld). Reach mapping and classification were conducted using the revised typology. The 12 major river types proposed were: (1) bedrock rivers; (2) bedrock‐confined and ‐constrained rivers; (3) low sinuosity (straight) rivers; (4) meandering rivers; (5) wandering rivers; (6) anabranching rivers; (7) chains of ponds; (8) gullies; (9) floodouts; (10) lakes, swamps, billabongs and wetlands; (11) non‐channelized valley floors; and (12) estuarine rivers. The 12 major river types were developed based on river reach mapping for more than 264 000 km² of tropical Australian catchments. At scales larger than 1:250 000, subdivision of each major river type is recommended. In the Daly and Fitzroy catchments, confined and constrained rivers dominate, whereas in the Flinders and Fitzroy catchments, anabranching rivers dominate. The dominant river types need benchmarking with adequate numbers of control reaches so that channel changes induced by human and natural impacts can be measured by reference to the stability of these controls. Wandering rivers, floodouts and non‐channelized valley floors were rare for the 1:250 000 channel network in northern Australia but need inclusion in national parks.     

A model for assessing iceberg hazard

Natural Hazards - With the polar regions opening up to more marine activities but iceberg numbers more likely to increase than decline as a result of global warming, the risk from icebergs to...     

Quantification of the gas mass emitted during single explosions on Stromboli with the SO2 imaging camera

We performed measurements using an SO₂ imaging camera of the SO₂ gas mass emitted during five discrete explosive events on Stromboli volcano on 3 October 2006. The SO₂ gas mass released during discrete explosions was 15–40 kg per explosion, producing 3–8% of the total daily SO₂ gas emission, demonstrating that in terms of gas flux Strombolian explosions are a second-order phenomenon compared with quiescent degassing. Using the typical gas composition measured with OP-FTIR allows us to determine the total gas mass released during an explosion as 360–960 kg with a volume of 1500–4100 m³ at 1 bar. At the probable source pressure of gas slug formation of 75 MPa this gas amount would occupy a volume equivalent to a sphere with a radius of 0.8–1 m, comparable with estimates of Stromboli's conduit geometry.     

Natural aggregates in the performance and durability of concrete: physical characteristics

The production of rock aggregates for construction is the largest of the extractive industries in Britain. Natural aggregates form the main component, by volume, in the manufacture of concrete but the part played by aggregates in the durability and performance aspects of concrete is still only moderately understood. This feature summarizes the main characteristics of common aggregate in concrete, especially those leading to cracking and deterioration. Physical and mechanical causes of concrete cracking are of immense importance but are omitted from the following. The feature expands on the earlier one: ‘Concrete: a man‐made rock?’ (Geology Today, 2010, v.26, n.2). To follow is another that will continue the story by looking at chemical reactivity in concretes.     

Constraining the degree of the dominant mode in QQ Vir

We present early results of the application of a method which uses multicolor photometry and spectroscopy for ? discrimination. This method has been successfully applied to the pulsating hot subdwarf Balloon?090100001. Here we apply the method to QQ?Vir (PG1325+101). This star was observed spectroscopically and photometrically in 2008. Details on spectroscopy can be found in Telting et al. (Astrophys. Space Sci. 2010, this volume), while photometry and preliminary results on ? discrimination are provided here. The main aim of this work was to compare the value of the ? parameter derived for the main mode in QQ?Vir to previously published values derived by using different methods.     

Effects of variations in hydrogeological parameters on water-table mounding in sandy loam and loamy sand soils beneath stormwater infiltration basins

The two-dimensional variably-saturated numerical model HYDRUS-2D, previously calibrated to recharge events from an infiltration basin, was used to predict water-table mounding under hypothetical basin design scenarios, and the primary factors that affect water-table mounding were evaluated. Infiltration basins are often utilized in urban environments to recharge stormwater to the aquifer. As a result of localized recharge beneath these basins, mound formation may reduce the thickness of the unsaturated zone available to filter pollutants and may reduce the infiltration rate of the basin. Understanding the effects of various physical factors on water-table mound formation is important for infiltration basin siting. For sandy loam and loamy sand subsurface materials, mound heights increased as the thickness of both the unsaturated and saturated zones decreased. Mound heights increased as the initial soil moisture, basin size and ponding depth increased. A thin sedimentation layer on the basin floor delayed mound formation, but only slightly decreased the maximum mound height. This analysis could be used in future selection of infiltration basin locations; however, the analysis is limited to conditions that represent only a select range of basin design conditions and parameters typical of a glacial till environment in Wisconsin, USA.     

G-WADI—the first decade

The G-WADI network by UNESCO promotes the global capacity for management of water resources in arid and semi-arid areas. The primary aim has been to build a comprehensive global network to promote regional and international cooperation so as to increase knowledge and improve management practices through the sharing of information. The G-WADI objectives and achievements of the past 10 years are reviewed. A number of key initiatives have been implemented––the formation of five regional networks, the creation of a central G-WADI web site, promotion of near-real-time rainfall distribution software enhanced by the inclusion of satellite based precipitation estimations, as well as workshop and web-based activities on chemical and isotopic tracers and on rain water harvesting. Two workshops on surface and on groundwater modeling, supported by publications have been held in India and China. The Asian G-WADI network remains very active, but activities in the other three regions are developing (Africa, Arab Region, Latin America and the Caribbean).