Heat budget of the surface mixed layer south of Africa

ARGO hydrographic profiles, two hydrographic transects and satellite measurements of air–sea exchange parameters were used to characterize the properties and seasonal heat budget variations of the Surface Mixed Layer (SML) south of Africa. The analysis distinguishes the Subtropical domain (STZ) and the Subantarctic Zone (SAZ), Polar Frontal Zone (PFZ) and Antarctic Zone (AZ) of the Antarctic Circumpolar Current. While no Subantarctic Mode Water forms in that region, occurrences of deep SML (up to ∼450 m) are observed in the SAZ in anticyclones detached from the Agulhas Current retroflection or Agulhas Return Current. These are present latitudinally throughout the SAZ, but preferentially at longitudes 10–20° E where, according to previous results, the Subtropical Front is interrupted. Likely owing to this exchange window and to transfers at the Subantarctic Front also enhanced by the anticyclones, the SAZ shows a wide range of properties largely encroaching upon those of the neighbouring domains. Heat budget computations in each zone reveal significant meridional changes of regime. While air–sea heat fluxes dictate the heat budget seasonal variability everywhere, heat is mostly brought through lateral geostrophic advection by the Agulhas Current in the STZ, through lateral diffusion in the SAZ and through air–sea fluxes in the PFZ and AZ. The cooling contributions are by Ekman advection everywhere, lateral diffusion in the STZ (also favoured by the ∼10° breach in the Subtropical Front) and geostrophic advection in the SAZ. The latter likely reflects an eastward draining of water warmed through mixing of the subtropical eddies.     

Fluxes of uranium and thorium series isotopes in the Santa Barbara Basin

Samples from the MANOP Santa Barbara Basin sediment trap intercomparison were analyzed for the isotopes of uranium, thorium, radium, lead, and polonium. All of the traps showed approximately the same compositions and isotopic ratios, indicating that they trapped similar materials. The²³⁴Th flux via falling particles was very close to the flux predicted from the production and scavenging rates of²³⁴Th from the water column. The²¹⁰Pb content of the trapped particles and the surface sediments were the same, however, the measured flux of²¹⁰Pb was seven times greater than the predicted flux. Predicted and measured fluxes of²²⁸Th and²¹⁰Po were similarly out of balance. To explain this apparent inconsistency, we suggest (as others have done) that the Santa Barbara Basin is an area where scavenging from the water column is intensified and where sediments deposited initially on the margins may be physically remobilized on a short time scale. These two effects increase the apparent area from which the basin derives the longer-lived isotopes but does not increase significantly the supply of the short-lived²³⁴Th.     

A field study of the coupled effects of aquifer stratification,fluid density,and groundwater fluctuations on dispersivity assessments

A number of experimental studies have tackled the issue of solute transport parameter assessments either in the laboratory or in the field. But yet, the behavior of a plume in the field under density driven forces, is not well known due to possible development of instabilities. Some field tracer tests on the fate of plumes denser than native groundwater such as those encountered under waste disposal facilities, have pointed out the processes of sinking and splitting at the early stage of migration. The process of dispersion was widely investigated, but the range of dispersivity values obtained from either experimental tests, or numerical and theoretical calculations is still very large, even for the same type of aquifers. These discrepancies were considered to be essentially caused by soil heterogeneities and scale effects. In the meantime, studies on the influence of sinking and fingering have remained more scarce. The objective of the work is to analyze how transport parameters such as dispersivities can be affected by unstable conditions, which lead to plume sinking and fingering. A series of tracer tests were carried out to study under natural conditions, the transport of a dense chloride solution injected in a shallow two-layered aquifer. Two types of experiments were performed: in the first type, source injection was such that the plume could travel downward from one layer to the other of higher pore velocity, and in the second one, the migration took place only in the faster layer. The results suggest some new insights in the processes occurring at the early stages of a dense plume migration moving in a stratified aquifer under groundwater fluctuations, which can be summarized through the following points: (i) Above a stability criterion threshold, a fingering process and a multi modal plume transport take place, but local dispersivities can be cautiously derived, using breakthrough curves matching. (ii) When water table is subject to some cycling or rising, the plume can be significantly distorted in the transverse direction, leading to unusual values of the ratio between longitudinal and transverse dispersivities. (iii) Under stable conditions, for example in the case of straightforward injection in the faster aquifer layer, longitudinal dispersivity is greater than the transverse component as usually encountered, and the obtained transport parameters are closed to macro dispersivity values, which reach their asymptotic limit at very short distances. (iv) The classical scale effect about the varying dispersivity at short distances could be a process mainly due to the distance required for a plume stabilization.     

Temperature variability in the Bay of Biscay during the past 40 years,from an in situ analysis and a 3D global simulation

A global in situ analysis and a global ocean simulation are used jointly to study interannual to decadal variability of temperature in the Bay of Biscay, from 1965 to 2003. A strong cooling is obtained at all depths until the mid-1970's, followed by a sustained warming over ～30 years. Strong interannual fluctuations are superimposed on this slow evolution. The fluctuations are intensified at the surface and are weakest at ～500 m. A good agreement is found between the observed and simulated temperatures, in terms of mean values, interannual variability and time correlations. Only the decadal trend is significantly underestimated in the simulation. A comparison to satellite sea surface temperature (SST) data over the last 20 years is also presented. The first mode of interannual variability exhibits a quasi-uniform structure and is related to the inverse winter North Atlantic Oscillation (NAO) index. Regarding the vertical structure, most cool and warm anomalies are generated at the surface, with the strongest ones penetrating down to 700 m and lasting up to 5 years. The complete heat budget from 1965 to 2004 is presented, including the contributions of vertical transport, freshwater flux and surface elevation. Interannual anomalies are mainly generated by the surface heat flux, while oceanic transports may become more important at longer time scales.     

Reducing global GHG emissions by replicating successful sector examples: the ‘good practice policies’ scenario

This article shows the potential impact on global GHG emissions in 2030, if all countries were to implement sectoral climate policies similar to successful examples already implemented elsewhere. This assessment was represented in the IMAGE and GLOBIOM/G4M models by replicating the impact of successful national policies at the sector level in all world regions. The first step was to select successful policies in nine policy areas. In the second step, the impact on the energy and land-use systems or GHG emissions was identified and translated into model parameters, assuming that it would be possible to translate the impacts of the policies to other countries. As a result, projected annual GHG emission levels would be about 50 GtCO₂e by 2030 (2% above 2010 levels), compared to the 60 GtCO₂e in the ‘current policies’ scenario. Most reductions are achieved in the electricity sector through expanding renewable energy, followed by the reduction of fluorinated gases, reducing venting and flaring in oil and gas production, and improving industry efficiency. Materializing the calculated mitigation potential might not be as straightforward given different country priorities, policy preferences and circumstances.

Key policy insights

• Considerable emissions reductions globally would be possible, if a selection of successful policies were replicated and implemented in all countries worldwide.

• This would significantly reduce, but not close, the emissions gap with a 2°C pathway.

• From the selection of successful policies evaluated in this study, those implemented in the sector ‘electricity supply’ have the highest impact on global emissions compared to the ‘current policies’ scenario.

• Replicating the impact of these policies worldwide could lead to emission and energy trends in the renewable electricity, passenger transport, industry (including fluorinated gases) and buildings sector, that are close to those in a 2°C scenario.

• Using successful policies and translating these to policy impact per sector is a more reality-based alternative to most mitigation pathways, which need to make theoretical assumptions on policy cost-effectiveness.

     

Bay of Biscay and Pyrenees

The different hypotheses proposed for the creation of the Bay of Biscay are reviewed. New geological and geophysical data collected in the last two years in the Bay and in the Pyrenean domain give new insight into the tectogenesis of the Pyrenees. Geological data of the Pyrenean area provide tight constraints on the hypothesis of formation of the Bay. The most probable hypothesis is an opening by rotation of the Iberian Peninsula around a pole of rotation situated near Paris, which resulted in strike-slip motion along the North Pyrenean fault during the Upper Mesozoic. A progressive westward migration of the pole initiated in the late Cretaceous blocked the motion along the fault and led to the main Eocene tectogenetic Pyrenean phase.     

New insights on the interior of solar-like pulsators thanks to CoRoT: the case of HD 49385

The high performance photometric data obtained with space mission CoRoT offer the opportunity to efficiently constrain our models for the stellar interior of solar-like pulsating stars. On the occasion of the analysis of the oscillations of solar-like pulsator HD 49385, a G0-type star in an advanced stage of evolution, we revisit the phenomenon of the avoided crossings. Christensen-Dalgaard proposed a simple analogy to describe an avoided crossing between two modes. We here present an extension of this analogy to the case of n modes, and show that it should lead, in certain cases, to a characteristic behavior of the eigenfrequencies, significantly different from the n=2 case. This type of behavior seems to be observed in HD 49385, from which we infer that the star should be in a Post Main Sequence phase.     

Formation of the mid-fifteenth century Kuwae caldera (Vanuatu) by an initial hydroclastic and subsequent ignimbritic eruption

In the mid-fifteenth century, one of the largest eruptions of the last 10 000 years occurred in the Central New Hebrides arc, forming the Kuwae caldera (12x6 km). This eruption followed a late maar phase in the pre-caldera edifice, responsible for a series of alternating hydromagmatic deposits and airfall lapilli layers. Tuffs related to caldera formation ( 120 m of deposits on a composite section from the caldera wall) were emitted during two main ignimbritic phases associated with two additional hydromagmatic episodes. The lower hydromagmatic tuffs from the precaldera maar phase are mainly basaltic andesite in composition, but clasts show compositions ranging from 48 to 60% SiO₂. The unwelded and welded ashflow deposits from the ignimbritic phases and the associated intermediate and upper hydromagmatic deposits also show a wide compositional range (60–73% SiO₂), but are dominantly dacitic. This broad compositional range is thought to be due to crystal fractionation. The striking evolution from one eruptive style (hydromagmatic) to the other (magmatic with emission of a large volume of ignimbrites) which occurred either over the tuff series as a whole, or at the beginning of each ignimbritic phase, is the most impressive characteristic of the caldera-forming event. This strongly suggests triggering of the main eruptive phases by magma-water interaction. A three-step model of caldera formation is presented: (1) moderate hydromagmatic (sequences HD 1–4) and magmatic (fallout deposits) activity from a central vent, probably over a period of months or years, affected an area slightly wider than the present caldera. At the end of this stage, intense seismic activity and extrusion of differentiated magma outside the caldera area occurred; (2) unhomogenized dacite was released during a hydromagmatic episode (HD 5). This was immediately followed by two major pyroclastic flows (PFD 1 and 2). The vents spread and intense magma-water interaction at the beginning of this stage decreased rapidly as magma discharge increased. Subsequent collapse of the caldera probably commenced in the southeastern sector of the caldera; (3) dacitic welded tuffs were emplaced during a second main phase (WFD 1–5). At the beginning of this phase, magma-water interaction continued, producing typical hydromagmatic deposits (HD 6). Caldera collapse extended to the northern part of the caldera. Previous C¹⁴ dates and records of explosive volcanism in ice from the south Pole show that the climactic phase of this event occurred in 1452 A.D.     

华南石炭纪岩关-大塘界线期牙形石地层分带

系统采集不同沉积相区和连续沉积的剖面,即浅海台地相广西柳江龙殿山剖面、台缘缓坡相云南施甸鱼硐剖面和台内盆地相广西柳州碰冲剖面,运用数理统计方法,研究了华南岩关—大塘界线过渡期牙形石的产出丰度和相分布,在恢复生物演化序列的基础上,对各剖面首先详细分带,再进一步综合成系统的5个牙形石带,即Gnathodustypicus-G.cuneiformis带、Gnathodustypicus-Protognathoduscordiformis带、Scaliognathusanchoralis-Gnathoduspseu-dosemiglaber带、Gnathoduspraebilineatus带和Paragnathodushomopunctatus带。以生物系统发生为标准,严格限定各带的界线,并与北美、西欧同期地层进行精确对比,为建立杜内阶—维宪阶界线的全球层型(GSSP)提供可靠依据。