Experimental study on the deterioration and natural remediation of the Ariake Sea tidal mud caused by the sea laver treatment acid practice and the upward seepage of pore water liquid

This study presents a laboratory study of the following two aspects: (1) the influence of sea laver treatment acid on the geoenvironmental properties of Ariake Sea tidal mud, and (2) the natural remediation effect on the sea laver treatment acid contaminated Ariake Sea tidal mud caused by the upward seepage of pore water liquid in the mud. Firstly, the mechanisms of the transport of sea laver treatment acid in the Ariake Sea tidal mud and the generation mechanisms of the upward seepage flow in the Ariake Sea tidal mud are discussed. Secondly, a series of one-dimensional laboratory infiltration tests were carried out to investigate the deterioration of the Ariake Sea tidal mud caused by the sea laver acid treatment practice. Test results reveal that the acid treatment practice caused considerable change in the geochemical properties of the mud in terms of increase in sulfide content and decrease in pH value. After the treatment by the sea laver treatment acid, the sulfide content of the mud even exceeded the safe limit value for the benthos, which represents undesirable living condition for benthos. Thirdly, series of laboratory fresh seawater infiltration tests for the deteriorated Iida site mud were conducted to illustrate this natural remediation efficiency. It is found that with the infiltration of the fresh seawater, the sulfide content of the Iida site mud was considerably reduced and pH value increased to an acceptable range for benthos living in the tidal flat mud. With the increase in the infiltration time and the hydraulic gradient, the remediation efficiency could be increased.     

A new method of estimating the ratio between in situ rock stresses and tectonics based on empirical and probabilistic analyses

This paper describes a new procedure for assessing the ratio between in situ stresses in rock masses by means of K (K = σ_H / σ_v, being σ_H and σ_v principal stress) and tectonics for purposes of engineering geology and rock mechanics. The method combines the use of the logic decision tree and the empirical relationship between the Tectonic Stress Index, TSI, and a series of K in situ values obtained from an extensive database. The decision tree considers geological and geophysical factors affecting stress magnitudes both on the regional and local scale. The TSI index is defined by geological and geomechanical parameters. The method proposed provides an assessment of the magnitude of horizontal stresses of tectonic origin. Results for several regions of Europe are presented and the possible applications of the procedure are discussed.     

General characteristics of the geochemical evolution of silicic melts during the development of massive sulfide magmatic ore systems: Evidence from the investigation of melt inclusions

The investigation of melt inclusions in the minerals of volcanic rocks from the massive sulfide deposits of Siberia and the Urals revealed some specific features in the development of their magmatic ore systems. It was shown that the petrochemical and rare earth element compositions of melt inclusions reflect the geodynamic conditions of their formation: island arc conditions for the massive sulfide deposits of Rudny Altai, eastern Tuva, and the Salair Range and a back arc basin environment for the Yaman-Kasy deposit. The silicic melts of inclusions from the volcanic rocks of massive sulfide deposits show some specific features with respect to the contents of volatile components. In all of the ore deposits studied, fluorine content was always low (0.03–0.08 wt %), whereas chlorine content (0.13–0.28 wt %) was higher than the average value for silicic melts (0.17 wt %). There is a strong differentiation of water content in melt inclusions, both between deposits and between various volcanics from a single deposit. Ore-bearing melts show the highest water contents of 3.34–4.07 wt %. High Cu contents in the silicic melts of the Yubileinoe and Kyzyl-Tashtyg deposits (up to 7118 and 3228 ppm, respectively) may indicate the affinity of some ore components to particular silicic magmas. This is supported by the elevated contents of Cu in the porphyry Cu deposits of Romania (Valea Morii), Mongolia (Bayan Ula), and Bolivia. On the other hand, the silicic melts of inclusions from the molybdenum-uranium deposit of the Strel’tsovka ore field show high contents of another group of ore components (U and F).     

Conditions of Quaternary magmatism at Spitsbergen Island

Petrological and geochemical data obtained on the Quaternary lavas of volcanoes at Spitsbergen Island indicate that the rocks were produced via the deep-seated crystallization of parental alkaline magmas at 8–10 kbar. The character of clinopyroxene enrichment in incompatible elements indicates that the mineral crystallized from more enriched melts than those inferred from the composition of the host lavas. These melts were close to the parental melts previously found as veinlets in mantle hyperbasite xenoliths in the lavas. According to the character of their enrichment in Pb and Sr radiogenic isotopes and depletion in Nd, the basalts from Spitsbergen Island define a single trend with the weakly enriched tholeiites of the Knipovich Ridge, a fact suggesting the closeness of the enriched sources beneath the continental margin of Spitsbergen and beneath the spreading zone. Magmatic activity at Spitsbergen was related to the evolution of the Norwegian-Greenland basin, which evolved in pulses according to the shift of the spreading axes. The most significant of the latter events took place in the Neogene, when the Knipovich Ridge obtained its modern position near the western boundary of Spitsbergen. Early in the course of the evolution, the emplacement of alkaline melts generated at Spitsbergen into the oceanic mantle could form the enriched mantle, which was later involved in the melting process beneath the spreading zone.     

Stable isotope study of the Archaean rocks of the Vredefort impact structure,central Kaapvaal Craton,South Africa

The Vredefort dome in the Kaapvaal Craton was formed as a result of the impact of a large meteorite at 2.02 Ga. The central core of Archaean granitic basement rocks is surrounded by a collar of uplifted and overturned strata of the Witwatersrand Supergroup, exposing a substantial depth section of the Archaean crust. Orthogneisses of the core show little variation in whole-rock δ ¹⁸O value, with the majority being between 8 and 10‰, with a mean of 9.2‰ (n = 35). Quartz and feldspar have per mil differences that are consistent with O-isotope equilibrium at high temperatures, suggesting minimal interaction with fluids during subsequent cooling. These data refute previous suggestions that the Outer Granite Gneiss (OGG) and Inlandsee Leucogranofels (ILG) of the core represent middle and lower crust, respectively. Granulite-facies greenstone remnants from the ILG have δ ¹⁸O values that are on average 1.5‰ higher than the ILG host rocks and are unlikely, therefore, to represent the residuum from the partial melting event that formed the host rock. Witwatersrand Supergroup sedimentary rocks of the collar, which were metamorphosed at greenschist-to amphibolite-facies conditions, generally have lower δ ¹⁸O values than the core rocks with a mean value for metapelites of 7.7‰ (n = 45). Overall, through an ∼20 km thick section of crust, there is a general increase in whole-rock δ ¹⁸O value with increasing depth. This is the reverse of what is normal in the crust, largely because the collar rocks have δ ¹⁸O values that are unusually low in comparison with metamorphosed sedimentary rocks worldwide. The collar rocks have δD values ranging from −35 to −115‰ (average −62‰, n = 29), which are consistent with interaction with water of meteoric origin, having a δD of about −25 to −45‰. We suggest that fluid movement through the collar rocks was enhanced by impact-induced secondary permeability in the dome structure. Electronic supplementary material The online version of this article (doi:) contains supplementary material, which is available to authorized users.     

Li-Sr-Nd isotope signatures of the plume and cratonic lithospheric mantle beneath the margin of the rifted Tanzanian craton (Labait)

Lithium concentrations and isotopic compositions of olivine and ⁸⁷Sr/⁸⁶Sr and ¹⁴³Nd/¹⁴⁴Nd of coexisting clinopyroxene from peridotite xenoliths from the Quaternary Labait volcano, Tanzania, document the influence of rift-related metasomatism on the ancient cratonic mantle. Olivines show negative correlations between Fo content and both δ⁷Li and Li concentrations. Olivines in iron-rich peridotites (Fo_85–87) have high Li concentrations (3.2–4.8 ppm) and heavy δ⁷Li (+5.2 to +6.6). In contrast, olivines in ancient, refractory peridotites have lower Li concentrations (∼2 ppm) and relatively light δ⁷Li (+2.6 to +3.5). This reflects mixing between ancient, refractory cratonic lithosphere and asthenosphere-derived rift magmas. A uniquely fertile, deformed, high-temperature garnet lherzolite, interpreted to be from the base of the lithosphere, has a ⁸⁷Sr/⁸⁶Sr of 0.7029 and ¹⁴³Nd/¹⁴⁴Nd of 0.51286, similar to HIMU oceanic basalts. It provides the best estimate of the Sr–Nd isotope composition of the upwelling mantle (i.e., plume, sensu lato) underlying this portion of the East African Rift, and is slightly less radiogenic compared to previous estimates of the plume that were based on rift basalts. Although elevated δ⁷Li are not exclusive to HIMU source regions, the data collectively indicate that the plume beneath Labait has HIMU characteristics in Sr, Nd and Li isotope composition. Electronic supplementary material The online version of this article (doi:) contains supplementary material, which is available to authorized users.     

Timing of UHP metamorphism in the Hong’an area,western Dabie Mountains,China: evidence from zircon U–Pb age,trace element and Hf isotope composition

The Hong’an area (western Dabie Mountains) is the westernmost terrane in the Qinling-Dabie-Sulu orogen that preserves UHP eclogites. The ages of the UHP metamorphism have not been well constrained, and thus hinder our understanding of the tectonic evolution of this area. LA-ICPMS U–Pb age, trace element and Hf isotope compositions of zircons of a granitic gneiss and an eclogite from the Xinxian UHP unit in the Hong’an area were analyzed to constrain the age of the UHP metamorphism. Most zircons are unzoned or show sector zoning. They have low trace element concentrations, without significant negative Eu anomalies. These metamorphic zircons can be further subdivided into two groups according to their U–Pb ages, and trace element and Lu–Hf isotope compositions. One group with an average age of 239 ± 2 Ma show relatively high and variable HREE contents (527 ≥ Lu_N ≥ 14) and ¹⁷⁶Lu/¹⁷⁷Hf ratios (0.00008–0.000931), indicating their growth prior to a great deal of garnet growth in the late stage of continental subduction. The other group yields an average age of 227 ± 2 Ma, and shows consistent low HREE contents and ¹⁷⁶Lu/¹⁷⁷Hf ratios, suggesting their growth with concurrent garnet crystallization and/or recrystallization. These two groups of age are taken as recording the time of prograde HP to UHP and retrograde UHP–HP stages, respectively. A few cores have high Th/U ratios, high trace element contents, and a clear negative Eu anomaly. These features support a magmatic origin of these zircon cores. The upper intercept ages of 771 ± 86 and 752 ± 70 Ma for the granitic gneiss and eclogite, respectively, indicate that their protoliths probably formed as a bimodal suite in rifting zones in the northern margin of the Yangtze Block. Young Hf model ages (T _DM1) of magmatic cores indicate juvenile (mantle-derived) materials were involved in their protolith formation. Electronic supplementary material The online version of this article (doi:) contains supplementary material, which is available to authorized users.     

Influence of temperature,composition, silica activity and oxygen fugacity on the H<Subscript>2</Subscript>O storage capacity of olivine at 8 GPa

Olivine crystals were grown in the presence of a hydrous silicate fluid during multi-anvil experiments at 8 GPa and 1,000–1,600°C. Experiments were conducted both in a simple system (FeO–MgO–SiO₂–H₂O) and in a more complex system containing additional elements (CaO–Na₂O–Al₂O₃–Cr₂O₃–TiO₂–FeO–MgO–SiO₂–H₂O). Silica activity was buffered by the presence of either pyroxene (high a _SiO2) or ferropericlase (low a _SiO2), and was buffered by the presence of Ni + NiO or Fe + FeO, or constrained by the presence of Fe₂O₃. Raman spectroscopy was used to identify pyroxene polymorphs in the run products. Clinoenstatite was present in the 1,000°C experiment, and enstatite in experiments at 1,400–1,520°C. The H₂O content of olivine was measured using secondary ion mass spectroscopy, and infrared spectroscopy was used to investigate the nature of hydrous defects. The H₂O storage capacity of olivine decreases with increasing temperature at 8 GPa. In contrast to previous experimental results at ≤2 GPa, no significant effect of varying oxygen fugacity is evident, but H₂O storage capacity is enhanced under conditions of low silica activity. No significant growth of low wavenumber (<3,400 cm⁻¹) peaks, generally associated with high at low pressure, was observed in the FTIR spectra of olivine from the high experiments. Our experiments show that previous high pressure H₂O storage capacity measurements for olivine synthesized under more oxidizing conditions than the Earth’s mantle are not likely to be compromised by the of the experiments. However, the considerable effect of temperature on H₂O storage capacity in olivine must be taken into account to avoid overestimation of the bulk upper mantle H₂O storage capacity.