Seismic improvement of slender masonry tower by using hysteretic devices and partial prestressing technique

An innovative system for seismic improvement of slender masonry towers by using hysteretic devices and partial prestressing technique was developed and applied to a case study. The proposed technique consists in a low level of prestressing of the upper part of the tower in order to localize in the un-prestressed lower part of the tower, i.e. a limited zone near the basement, the vertical displacements due to the cracking of masonry under seismic action. The positioning of dissipative devices, such as the Buckling-Restrained Axial Dampers, across the localization zone allows a significant contribution in terms of damping for hysteretic dissipation. The main effect of such an intervention is the reduction of the seismic demand to the tower and consequently the reduction of the top displacement as well as of the level of damage of the masonry. Both numerical analyses and experimental tests on a scale model of a Venetian bell tower were carried out showing the efficiency and reliability of the proposed technique.     

Using GB-SAR technique to monitor slow moving landslide

A Ground-Based SAR (GB-SAR) interferometer was employed to measure the surface displacements of a landslide occurring in the Carnian Alps, north-eastern Italy, which has affected a national road and seriously damaged a road tunnel still under construction. Moreover, since the landslide is located on the left bank of the Tagliamento River Valley, it is feared that this mass movement might dam the river, creating a basin that would increase natural hazard for the valley inhabitants. The data collected from December 2002 to July 2005 by a conventional monitoring system, consisting of a GPS network and boreholes equipped with inclinometric tubes, showed that the landslide was moving at a quasi-constant rate of about 3 cm per year. Due to the slow deformation rate of the landslide, a recently developed GB-SAR technique based on the analysis of a restricted ensemble of coherent points was used. Two surveys, each lasting two days, were planned in December 2004 and July 2005, in order to map and measure the surface displacements that occurred over time. The results from the radar were compared with the ones derived from the GPS monitoring network. An agreement was achieved among the data collected, showing the capability of the GB-SAR technique to measure displacements even within a time span of several months between the surveys.     

Correction to: A novel methodological approach for land subsidence prediction through data assimilation techniques

Computational Geosciences - A Correction to this paper has been published: https://doi.org/10.1007/s10596-021-10079-6     

Grazing Management Plans improve pasture selection by cattle and forage quality in sub-alpine and alpine grasslands

Over the last decades, the reduction of manpower for herd management has led to an increase of continuous grazing systems(CGS) in the Italian Alps, which allow cattle to roam freely. Under CGS, due to high selectivity, livestock exploit grasslands unevenly, over-and under-using specific areas at the same time with negative effects on their conservation. To counteract these effects, a specific policy and management tool(i.e. Grazing Management Plan) has been implemented by Piedmont Region since 2010. The Grazing Management Plans are based on the implementation of rotational grazing systems(RGS), with animal stocking rate adjusted to balance it with grassland carrying capacity. A case study was conducted on alpine summer pastures to test the 5-year effects produced by the implementation of a Grazing Management Plan in grasslands formerly managed under several years of CGS on 1) the selection for different vegetation communities by cattle, 2) the abundance of oligo-, meso-, and eutrophic plant species(defined according to Landolt N indicator value), and 3) forage yield, quality, and palatability. A total of 193 vegetation surveys were carried out in 2011 and repeated in 2016. Cows were tracked yearly with Global Positioning System collars to assess their grazing selectivity, and forage Pastoral Value(PV) was computed to evaluate forage yield, quality, and palatability. Five years after RGS implementation, cow selectivity significantly decreased and the preference for the different vegetation communities was more balanced than under CGS. The abundance of meso-and eutrophic species increased, whereas oligotrophic ones decreased. Moreover, the abundance of moderately to highly palatable plant species increased, whereas non-palatable plant species decreased, with a consequent significant enhancement of the PV. Our findings indicate that the implementation of Grazing Management Plans can be considered a sustainable and effective management tool for improving pasture selection by cattle and forage quality in mountain pastures.     

No significant Alpine tectonic overprint on the Cimmerian Strandja Massif (SE Bulgaria and NW Turkey)

We provide the first comprehensive picture of the thermochronometric evolution of the Cimmerian Strandja metamorphic massif of SE Bulgaria and NW Turkey, concluding that the bulk of the massif has escaped significant Alpine-age deformation. Following Late Jurassic heating, the central part of the massif underwent a Kimmeridgian-Berriasian phase of relatively rapid cooling followed by very slow cooling in Cretaceous-to-Early Eocene times. These results are consistent with a Late Jurassic–Early Cretaceous Neocimmerian (palaeo-Alpine) phase of north-verging thrust imbrication and regional metamorphism, followed by slow cooling/exhumation driven by erosion. From a thermochronometric viewpoint, the bulk of the Cimmerian Strandja orogen was largely unaffected by the compressional stress related to the closure of the Vardar–?zmir–Ankara oceanic domain(s) to the south, contrary to the adjacent Rhodopes. Evidence of Alpine-age deformation is recorded only in the northern sector of the Strandja massif, where both basement and sedimentary rocks underwent cooling/exhumation associated with an important phase of shortening of the East Balkan fold-and-thrust belt starting in the Middle–Late Eocene. Such shortening focused in the former Srednogorie rift zone because this area had been rheologically weakened by Late Cretaceous extension.     

Development and Application of 2D and 3D GRASS Modules for Simulation of Thermally Driven Slope Winds

The ability to manage and process fully three‐dimensional information has only recently been made available for a few Geographical Information Systems (GIS). An example of integrated and complementary use of 2D and 3D GRASS modules for the evaluation and representation of thermally induced slope winds over complex terrain is presented. The analytic solution provided by Prandtl (1942) to evaluate wind velocity and (potential) temperature anomaly induced by either diurnal heating or nocturnal cooling on a constant angle slope is adopted to evaluate wind and temperature profiles at any point over both idealised and real complex terrain. As these quantities depend on the slope angle of the ground and on the distance from the slope surface suitable procedures are introduced to determine the coordinate n of a point in the 3D volume measured along the direction locally normal to the terrain surface. A new GRASS module has been developed to evaluate this quantity and to generate a 3D raster file where each cell is assigned the value of the cell on the surface belonging to the normal vector. The application of the algorithm implemented in GRASS to an ideal valley and to a real valley close to the city of Trento in the Alps provides results in accordance with data reported in the literature. An extension of Prandtl's (1942) model to take into account humidity and evaporation processes on the soil is also proposed and implemented.     

Land uplift due to subsurface fluid injection

The subsurface injection of fluid (water, gas, vapour) occurs worldwide for a variety of purposes, e.g. to enhance oil production (EOR), store gas in depleted gas/oil fields, recharge overdrafted aquifer systems (ASR), and mitigate anthropogenic land subsidence. Irrespective of the injection target, some areas have experienced an observed land uplift ranging from a few millimetres to tens of centimetres over a time period of a few months to several years depending on the quantity and spatial distribution of the fluid used, pore pressure increase, geological setting (depth, thickness, and area extent), and hydro-geomechanical properties of the injected formation. The present paper reviews the fundamental geomechanical processes that govern land upheaval due to fluid injection in the subsurface and presents a survey of some interesting examples of anthropogenic uplift measured in the past by the traditional levelling technique and in recent times with the aid of satellite technology. The examples addressed include Long Beach, Santa Clara Valley, and Santa Ana basin, California; Las Vegas Valley, Nevada; Cold Lake and other similar sites, Canada; Tokyo and Osaka, Japan; Taipei, Taiwan; Krechba, Algeria; Upper Palatinate, Germany; Chioggia and Ravenna, Italy.     

Preconditioners in computational geomechanics: A survey

The finite element (FE) solution of geomechanical problems in realistic settings raises a few numerical issues depending on the actual process addressed by the analysis. There are two basic problems where the linear solver efficiency may play a crucial role: 1. fully coupled consolidation and 2. faulted uncoupled consolidation. A class of general solvers becoming increasingly popular relies on the Krylov subspace (or Conjugate Gradient‐like) methods, provided that an efficient preconditioner is available. For both problems mentioned above, the possible preconditioners include the diagonal scaling (DS), the Incomplete LU decomposition (ILU), the mixed constraint preconditioning (MCP) and the multilevel incomplete factorization (MIF). The development and the performance of these algorithms have been the topic of several recent works. The present paper aims at providing a survey of the preconditioners available to date in computational geomechanics. In particular, a review and a critical discussion of DS, ILU, MCP and MIF are given along with some comparative numerical results. Copyright © 2010 John Wiley & Sons, Ltd.     

Improved Leap—Frog Symplectic Integrators for Orbits of Small Eccentricity in the Perturbed Kepler Problem

I have improved the precision of the leap–frog symplectic integrators for perturbed Kepler problems at small eccentricities, without significant loss of CPU time. The integration scheme proposed is competitive, in some situations, with the so-called mixed variable integrators.     

Analysis of the Chaotic Behaviour of Orbits Diffusing along the Arnold Web

In a previous work [Guzzo et al. DCDS B 5, 687–698 (2005)] we have provided numerical evidence of global diffusion occurring in slightly perturbed integrable Hamiltonian systems and symplectic maps. We have shown that even if a system is sufficiently close to be integrable, global diffusion occurs on a set with peculiar topology, the so-called Arnold web, and is qualitatively different from Chirikov diffusion, occurring in more perturbed systems. In the present work we study in more detail the chaotic behaviour of a set of 90 orbits which diffuse on the Arnold web. We find that the largest Lyapunov exponent does not seem to converge for the individual orbits while the mean Lyapunov exponent on the set of 90 orbits does converge. In other words, a kind of average mixing characterizes the diffusion. Moreover, the Local Lyapunov Characteristic Numbers (LLCNs), on individual orbits appear to reflect the different zones of the Arnold web revealed by the Fast Lyapunov Indicator. Finally, using the LLCNs we study the ergodicity of the chaotic part of the Arnold web.