The passivation of calcite by acid mine water. Column experiments with ferric sulfate and ferric chloride solutions at pH 2

Column experiments, simulating the behavior of passive treatment systems for acid mine drainage, have been performed. Acid solutions (HCl or H₂SO₄, pH 2), with initial concentrations of Fe(III) ranging from 250 to 1500 mg L⁻¹, were injected into column reactors packed with calcite grains at a constant flow rate. The composition of the solutions was monitored during the experiments. At the end of the experiments (passivation of the columns), the composition and structure of the solids were measured. The dissolution of calcite in the columns caused an increase in pH and the release of Ca into the solution, leading to the precipitation of gypsum and Fe–oxyhydroxysulfates (Fe(III)–SO₄–H⁺ solutions) or Fe–oxyhydroxychlorides (Fe(III)–Cl–H⁺ solutions). The columns worked as an efficient barrier for some time, increasing the pH of the circulating solutions from 2 to 6–7 and removing its metal content. However, after some time (several weeks, depending on the conditions), the columns became chemically inert. The results showed that passivation time increased with decreasing anion and metal content of the solutions. Gypsum was the phase responsible for the passivation of calcite in the experiments with Fe(III)–SO₄–H⁺ solutions. Schwertmannite and goethite appeared as the Fe(III) secondary phases in those experiments. Akaganeite was the phase responsible for the passivation of the system in the experiments with Fe(III)–Cl–H⁺ solutions.     

Mineralogical sources of the buffer capacity in a granite catchment determined by strontium isotopes

The role of different minerals in base cation release and thus the increase of buffering capacity of groundwater against acid deposition is controversially discussed in the literature. The ⁸⁷Sr/⁸⁶Sr ratios and base cation concentration were investigated in whole rock leachates, mineral separates, precipitation, soil solution, groundwater and stream water samples in the Lehstenbach catchment (Germany) to identify the weathering sequence of the granite bedrock. Three different approaches were followed in parallel. It was assumed that the contribution of different minerals to base cation supply of the groundwater with increasing weathering intensity would be observed by investigating (1) unweathered rock leachates, deep groundwater and shallow groundwater, (2) groundwater samples from new groundwater wells, reflecting the initial weathering of the drilled bedrock, and groundwater from wells that were drilled in 1988, (3) stream water during baseflow, dominated by deep groundwater, and stream water during high flow, being predominantly shallow groundwater. Whereas the first approach yielded consistent patterns, there was some evidence that groundwater from the new wells initially reflected contamination by the filter gravel rather than cation release in an initial stage of weathering. Time series samples of stream water and groundwater solute concentrations and isotope ratios turned out to reflect varying fractions of soil water and precipitation water at baseflow and high flow conditions rather than varying contributions of different minerals that prevail at different stages of granite weathering.     

Flood hazard delineation combining geomorphological and hydrological methods: an example in the Northern Iberian Peninsula

Flood mapping requires the combination and integration of geomorphological and hydrological-hydraulic methods; however, despite this, there is very little scientific literature that compares and validates both methods. Two types of analysis are addressed in the present article. On the one hand, maps of flood plains have been elaborated using geomorphological evidence and historical flood data in the mountainous area of northwestern Spain, covering an area of more then 232 km² of floodplains. On the other hand, a hydrometeorological model has been developed (Clark semidistributed unit hydrograph) in the Sarria River basin (155 km², NW Spain). This basin is not gauged, hence the model was subjected to a goodness-of-fit test of its parameter (curve number) by means of Monte Carlo simulation. The peak flows obtained by means of the hydrological model were used for hydraulic modeling (one-phase, one-dimensional and steady flow) in a 4 km² urban stretch of the river bed. The delineation of surface areas affected by floods since 1918, as well as those analyzed subsequent to the geomorphological study, reveals a high degree of reliability in the delineation of the flooded areas with frequent recurrence intervals (<50 years). If we compare these flooded surface areas with the estimate obtained by the hydrological-hydraulic method we can see that the latter method overestimates the extent of the surface water by 144% for very frequent recurrence intervals (>10 years) and underestimates it as the recurrence interval increases, by up to 80% less floodplain for exceptional events (>500 years). Finally, a management map is put forth combining the most reliable results available by integrating both methods. Originally presented at the Sixth International Conference on Geomorphology.     

Stability at high-pressure,elastic behaviour and pressure-induced structural evolution of CsAlSi<Subscript>5</Subscript>O<Subscript>12</Subscript>, a potential host for nuclear waste

The elastic and structural behaviour of the synthetic zeolite CsAlSi₅O₁₂ (a = 16.753(4), b = 13.797(3) and c = 5.0235(17) Å, space group Ama2, Z = 2) were investigated up to 8.5 GPa by in situ single-crystal X-ray diffraction with a diamond anvil cell under hydrostatic conditions. No phase-transition occurs within the P-range investigated. Fitting the volume data with a third-order Birch–Murnaghan equation-of-state gives: V ₀ = 1,155(4) ų, K _T0 = 20(1) GPa and K′ = 6.5(7). The “axial moduli” were calculated with a third-order “linearized” BM-EoS, substituting the cube of the individual lattice parameter (a ³, b ³, c ³) for the volume. The refined axial-EoS parameters are: a ₀ = 16.701(44) Å, K _T0a = 14(2) GPa (β_a = 0.024(3) GPa^?1), K′ _a = 6.2(8) for the a-axis; b ₀ = 13.778(20) Å, K _T0b = 21(3) GPa (β_b = 0.016(2) GPa^?1), K′ _b = 10(2) for the b-axis; c ₀ = 5.018(7) Å, K _T0c = 33(3) GPa (β_c = 0.010(1) GPa^?1), K′ _c = 3.2(8) for the c-axis (K _T0a:K _T0b:K _T0c = 1:1.50:2.36). The HP-crystal structure evolution was studied on the basis of several structural refinements at different pressures: 0.0001 GPa (with crystal in DAC without any pressure medium), 1.58(3), 1.75(4), 1.94(6), 3.25(4), 4.69(5), 7.36(6), 8.45(5) and 0.0001 GPa (after decompression). The main deformation mechanisms at high-pressure are basically driven by tetrahedral tilting, the tetrahedra behaving as rigid-units. A change in the compressional mechanisms was observed at P ≤ 2 GPa. The P-induced structural rearrangement up to 8.5 GPa is completely reversible. The high thermo-elastic stability of CsAlSi₅O_12, the immobility of Cs at HT/HP-conditions, the preservation of crystallinity at least up to 8.5 GPa and 1,000°C in elastic regime and the extremely low leaching rate of Cs from CsAlSi₅O₁₂ allow to consider this open-framework silicate as functional material potentially usable for fixation and deposition of Cs radioisotopes.     

Mineralogy and geochemistry of El Dorado epithermal gold deposit, El Sauce district, central-northern Chile

Summary The El Dorado Au-Cu deposit is located in an extensive intra-caldera zone of hydrothermal alteration affecting Upper Cretaceous andesites of the Los Elquinos Formation at La Serena (≈ 29°47′S Lat., 70°43′W Long., Chile). Quartz-sulfide veins of economic potential are hosted by N25W and N20E fault structures associated with quartz-illite alteration (+supergene kaolinite). The main ore minerals in the deposit are pyrite, chalcopyrite ± fahlore (As/(As + Sb): 0.06−0.98), with electrum, sphalerite, galena, bournonite-seligmanite (As/(As + Sb): 0.21−0.31), marcasite, pyrrhotite being accessory phases. Electrum, with an Ag content between 32 and 37 at.%, occurs interstitial to pyrite aggregates or along pyrite fractures. Pyrite commonly exhibits chemical zonation with some zones up to 1.96 at.% As. Electron probe microanalyses of pyrite indicate that As-rich zones do not exhibit detectable Au values. Fluid inclusion microthermometry shows homogenization temperatures between 130 and 352 °C and salinities between 1.6 and 6.9 wt.% NaCl eq. Isotope data for quartz, ankerite and phyllosilicates and estimated temperatures show that δ¹⁸O and δD for the hydrothermal fluids were between 3 and 10‰ and between −95 and −75‰, respectively. These results suggest the mineralizing fluids were a mixture of meteoric and magmatic waters. An epithermal intermediate-sulfidation model is proposed for the formation of the El Dorado deposit. Author’s present address: J. Carrillo-Rosúa, Dpto. de Didáctica de las Ciencias Experimentales, Universidad de Granada, Campus de Cartuja, 18071, Granada, Spain     

Methodology of hydrogeological characterization of deep carbonate aquifers as potential reservoirs of groundwater. Case of study: the Jurassic aquifer of <Emphasis Type="Italic">El Maestrazgo</Emphasis> (Castellón,Spain)

A methodology for the characterization of deep carbonate aquifers has been developed and applied to El Maestrazgo Jurassic aquifer in Castellón, Spain. Characterization of these aquifer formations, located at more than 300 m deep, consisted of a previous phase of compilation, analysis and synthesis of the existing information about the area, followed by a coordinated combination of different speciality studies: geology, stratigraphy, structural analysis, hydrogeology, hydrochemistry, geophysics and remote sensing. Geological studies included geological mapping, definition of stratigraphical units and facies and structural analysis. The aim of the hydrogeology study was to define aquifer formations, recharge area, aquifer points inventory and groundwater flow directions for the establishment of piezometric and water quality observation nets. Special techniques were applied, like thermal infrared aerial images and the evaluation of submarine groundwater discharge by means of natural radium isotopes. Hydrochemical techniques, including majority elements characterization and stable isotopes (¹⁸O, ²H and ³H) determination, allowed classifying hydrochemical facies and establishing a renewal pattern for water within the system. Geophysics was useful in determining the aquifer geometry, the features of the basement and the petrophysical characteristics of the geological formations. Preliminary results show an important tectonic complexity and the possibilities for groundwater uses in the area of study.     

Ermittlung der QNH-werte aus dem luftdruckfeld der synoptischen bodenkarte

Резюме Дабление воздуха, переснитанное иа уровень моря по стандартной атмосфере в Q-коде обозчачается через QNH. Давление воздуха пересчитанное на уровень моря по высотной барометрической формуле обознаеается через QFF. Для целей авиационной службы погоды должны быть известны значения QNH, однако Зе барическое поле на синоптических картах выражается через QFF. С помощью рис. 1 для соответствующей температуры воздуха на станцин и ее высоты н. у. м. можно определить разность значений QFF—QNH при давленин QFF=1000мб. Далее по табл. 2 можно определить поправку для каждого значения QFF отличного от значения QFF при ином давлении, чем 1000мб путем умножения табулированного значения ва разность QFF—1000мб и его алгебраического сложения со значением, полученным по рис. 1.