Summary Litton Divisions presently produce both high accuracy GPS surveyors and low—cost GPS navigation sets. Aero Service'sMACROMETERR Interferometric Surveyors, have become the standard against which GPS surveying equipment is measured. Litton Aero Products
has developed a highly digitized, low costL1,C/A code GPS card set. The integration of these technologies had led to the development of a low-cost, high-precision, GPS survey
system which can be configured with or without a codelessL2 capability.
TheMINI-MAC surveying system is the first member of the new generation of GPS survey systems resulting from this joint development. The
system design is described in this paper, and initial survey test results using a prototypeMINI-MAC surveying system are presented. 相似文献
Eighty-nine juvenile Atlantic sturgeon,Acipenser oxyrhynchus oxyrhynchus, including 10 recaptures, were collected, tagged and released in the upper tidal Delaware River between July 1981 and December 1984. All were captured in the river channel between Roebling and Trenton, New Jersey, using bottom-set experimental gill nets during daylight hours. The species was present from July through December and collected in increased numbers in the past two years. The fork lengths ranged from 284 to 862 mm (mean±SD = 516 mm±106 mm) and the weights from 140 to 4,250 g (mean±SD = 1,369 g±815 g). Ten juvenile Atlantic sturgeon were recaptured between September 1983 and December 1984 and were at large from one to 418 d. Recapture data suggest that these sturgeon utilize this area annually from July through December, possibly as a nursery. Juvenile Atlantic sturgeon appear to utilize the upper tidal portion of the Delaware River for a much longer period of time and at lower temperatures than in other river systems. 相似文献
The pressure dependence of melt viscosities on the join diopside-albite has been studied using falling-sphere viscometry. The five melt compositions investigated are: diopside, Ab25Di75, Ab50Di50, Ab75Di25 and albite. Experiments were performed at 1500° and 1600°C and at pressures of 5, 10, 15, 20 and 25 kbar. The positive and negative pressure dependence of the viscosity of diopside and albite, respectively, were confirmed. All intermediate compositions show an initial decrease in viscosity with increasing pressure; however, melt of Ab25Di75 composition passes through a minimum viscosity at approximately 12 kbar and 1600°C. This behavior is analogous to the variation in the viscosity of water with pressure at low temperature.
It is suggested that the three-dimensional, fully polymerized, albite structure dominates flow at low pressures. With increasing pressure, disruption of this structure and decrease in the average size of the flow units leads to domination by the diopside structure. The variation in viscosity with composition along the join at one atmosphere can be adequately modelled using the
and
(1965) configurational entropy model with an additional two-lattice configurational entropy of mixing term. The pressure dependence of viscosity in the diopside-albite system, however, cannot be predicted by the model, because there is an absence of information on the pressure dependence of the model parameters.
It is probable that relatively polymerized magmas (e.g. rhyolites to SiO2-saturated basalts) show a negative pressure dependence of viscosity to depths where they originate in the lower crust or upper mantle. In contrast, the most depolymerized, naturally-occurring melts, such as strongly SiO2-undersaturated basalts and picrites, may exhibit a viscosity minimum. The viscosity of these melts may be sufficiently high at depths within the upper mantle to inhibit their segregation, rise and eventual eruption at the surface. 相似文献
The Southern Alps are the topographic expression of late Cenozoic (<8 Ma ago) uplift of the crust of the leading edge of the Pacific plate in South Island, New Zealand. New fission track data on the basement exposed in the Southern Alps quantify the age, amount, and rate of rock uplift, and in combination with geomorphic parameters permit the construction of a new model of the geomorphic evolution of the Southern Alps. The model emphasizes the development over time and space of rock uplift, mean surface elevation, exhumation of crustal section, and relief. The earliest indications of mean surface uplift are between 4 and 5 Ma ago at the Alpine Fault. Mean surface uplift, which lagged the start of rock uplift, propagated southeastward from the Alpine Fault at a rate of 30 km/Ma. By about 4 Ma ago, exhumation had exposed greywacke basement adjacent to and east of the entire 300 km long central section of the Alpine Fault. At 3 Ma ago, greenschist was exposed in the southern parts of the Southern Alps near Lake Wanaka, and since then has become exhumed along a narrow strip east of the Alpine Fault. The model infers that amphibolite grade schist has been exhumed adjacent to the Alpine Fault only in the last 0·3 Ma. The age of the start of rock uplift and the amount and rate of rock uplift, all of which vary spatially, are considered to be the dominant influences on the development of the landscape in the Southern Alps. The Southern Alps have been studied in terms of domains of different rock uplift rate. At present the rate of rock uplift varies from up to 8–10 mm/a adjacent to the Alpine Fault to 0·8–1·0 mm/a along the southeastern margin of the Southern Alps. This spectrum can be divided into two domains, one northwest of the Main Divide where the present rock uplift rates are very high (up to 8–10 mm/a) and exceed the long-term value of 0·8–1·0 mm/a, and another to the southeast of the Main Divide where the long-term rate is 0·8–1·0 mm/a. A domain of no uplift lies immediately to the east of the Southern Alps, and is separated from them by a 1·0–1·5 km step in the basement topography. We argue that this spatial sequence of uplift rate domains represents a temporal one. The existing models of the geomorphic development of the Southern Alps—the dynamic cuesta model of J. Adams and the numerical model of P. Koons—are compared with the new data and evolutionary model. Particular constraints unrealized by these two earlier models include the following: the earlier timing of the start of rock uplift of the Southern Alps (8 Ma ago); the spatial variation in the timing of the start of rock uplift (8 Ma ago to 3 Ma ago); the lower long-term rock uplift rate (0·8–1·0 mm/a) of the Southern Alps for most of the late Cenozoic; the lag between the start of rock uplift and the start of mean surface uplift; and the patterns of the amounts of late Cenozoic rock uplift and erosion across the Southern Alps. 相似文献
A detailed field investigation has been completed at a gasoline-contaminated aquifer near Rocky Point, NC, to examine possible indicators of intrinsic bioremediation and identify factors that may significantly influence the rate and extent of bioremediation. The dissolved plume of benzene, toluene, ethylbenzene, and xylene (BTEX) in ground water is naturally degrading. Toluene and o-xylene are most rapidly degraded followed by m-, p-xylene, and benzene. Ethylbenzene appears to degrade very slowly under anaerobic conditions present in the center of the plume. The rate and extent of biodegradation appears to be strongly influenced by the type and quantity of electron acceptors present in the aquifer. At the upgradient edge of the plume, nitrate, ferric iron, and oxygen are used as terminal electron acceptors during hydrocarbon biodegradation. The equivalent of 40 to 50 mg/I of hydrocarbon is degraded based on the increase in dissolved CO2 relative to background ground water. Immediately downgradient of the source area, sulfate and iron are the dominant electron acceptors. Toluene and o-xylene are rapidly removed in this region. Once the available oxygen, nitrate, and sulfate are consumed, biodegradation is limited and appears to be controlled by mixing and aerobic biodegradation at the plume fringes. 相似文献
Sampling in the upper tidal Delaware River between Trenton, New Jersey, and Philadelphia, Pennsylvania, from July 1981 through December 1984 demonstrated the existence of a significant population of shortnose sturgeon. The sturgeon aggregate in the river channel during daylight hours, especially in the area between Trenton and Florence, New Jersey (river km 211.8 to 198.8). Occurrence in the river downstream of Florence appears to be restricted by poor water quality during summer months. Sturgeon were present in the study area throughout the year, but largest numbers were collected from May though November. No spawning was observed during this study, but presence of males with milt suggests that spawning possibly occurs in the Trenton area. Preliminary population estimates (Peterson, Schnabel and Seber-Jolly) indicate an adult population of approximately 6,000–14,000 shortnose sturgeon occupying the upper tidal Delaware River. 相似文献
Hydrothermal experiments in the temperature range 750–1020°C have defined the saturation behavior of zircon in crustal anatectic melts as a function of both temperature and composition. The results provide a model of zircon solubility given by: In DZrzircon/melt= ?3.80?[0.85(M?1)]+12900/T where DZrzircon/melt is the concentration ratio of Zr in the stoichiometric zircon to that in the melt, T is the absolute temperature, and M is the cation ratio (Na + K + 2Ca)/(Al · Si). This solubility model is based principally upon experiments at 860°, 930°, and 1020°C, but has also been confirmed at temperatures up to 1500°C for M = 1.3. The lowest temperature experiments (750° and 800°C) yielded relatively imprecise, low solubilities, but the measured values (with assigned errors) are nevertheless in agreement with the predictions of the model.For M = 1.3 (a normal peraluminous granite), these results predict zircon solubilities ranging from ~ 100 ppm dissolved Zr at 750°C to 1330 ppm at 1020°C. Thus, in view of the substantial range of bulk Zr concentrations observed in crustal granitoids (~ 50–350 ppm), it is clear that anatectic magmas can show contrasting behavior toward zircon in the source rock. Those melts containing insufficient Zr for saturation in zircon during melting can have achieved that condition only by consuming all zircon in the source. On the other hand, melts with higher Zr contents (appropriate to saturation in zircon) must be regarded as incapable of dissolving additional zircon, whether it be located in the residual rocks or as crystals entrained in the departing melt fraction. This latter possibility is particularly interesting, inasmuch as the inability of a melt to consume zircon means that critical geochemical “indicators” contained in the undissolved zircon (e.g. heavy rare earths, Hf, U, Th, and radiogenic Pb) can equilibrate with the contacting melt only by solid-state diffusion, which may be slow relative to the time scale of the melting event. 相似文献
Estimation of linear combinations is accomplished by using the observed (available) data. Accordingly, to require the negative of a modeled variogram function to be positive definite for all possible data combinations is unnecessary when only the observed data are used in estimation. The requirement that the negative of a variogram model be conditionally positive semidefinite is then relaxed to apply at the observed spatial locations only. In this setting a simple, yet crude, sufficient condition is developed to ensure that a variogram model will yield nonnegative variances for the available data. It is seen that the condition is independent of the dimensionality of the data and applies to both isotropic and anisotropic models. An example of the application of the condition is also presented. The condition is harder to satisfy as the amount of data increases and must be adjusted as the variogram changes to accommodate new data. 相似文献