Controls on porphyroblast size along a regional metamorphic field gradient

Garnet-bearing schists from the Waterville Formation of south-central Maine provide an opportunity to examine the factors governing porphyroblast size over a range of metamorphic grade. Three-dimensional sizes and locations for all garnet porphyroblasts were determined for three samples along the metamorphic field gradient spanning lowest garnet through sillimanite grade, using high-resolution X-ray computed tomography. Comparison of crystal size distributions to previous data sets obtained by stereological methods for the same samples reveals significant differences in mode, mean, and shape of the distributions. Quantitative textural analysis shows that the garnets in each rock crystallized in a diffusion-controlled nucleation and growth regime. In contrast to the typical observation of a correlation between porphyroblast size and position along a metamorphic field gradient, porphyroblast size of the lowest-grade specimen is intermediate between the high- and middle-grade specimens’ sizes. Mean porphyroblast size does not correlate with peak temperatures from garnet-biotite Fe-Mg exchange thermometry, nor is post-crystallization annealing (Ostwald Ripening) required to produce the observed textures, as was previously proposed for these rocks. Robust pseudosection calculations fail to reproduce the observed garnet core compositions for two specimens, suggesting that these calc-pelites experienced metasomatism. For each of these two specimens, Monte Carlo calculations suggest potential pre-metasomatism bulk compositions that replicate garnet core compositions. Pseudosection analyses allow the estimation of the critical temperatures for garnet growth: ∼481, ∼477, and ∼485°C for the lowest-garnet-zone, middle-garnet-zone, and sillimanite-zone specimens, respectively. Porphyroblast size appears to be determined in this case by a combination of the heating rate during garnet crystallization, the critical temperature for the garnet-forming reaction and the kinetics of nucleation. Numerical simulations of thermally accelerated, diffusion-controlled nucleation, and growth for the three samples closely match measured crystal size distributions. These observations and simulations suggest that previous hypotheses linking the garnet size primarily to the temperature at the onset of porphyroblast nucleation can only partially explain the observed textures. Also important in determining porphyroblast size are the heating rate and the distribution of favorable nucleation sites.     

Large and giant hydrocarbon accumulations in the transitional continent-ocean zone

The petroleum resource potential is considered for the Atlantic, West Pacific, and East Pacific types of deepwater continental margins. The most considerable energy resources are concentrated at the Atlantic-type passive margins in the zone transitional to the ocean. The less studied continental slope of backarc seas of the generally active margins of the West Pacific type is currently not so rich in discoveries as the Atlantic-type margin, but is not devoid of certain expectations. In some of their parameters, the margins bounded by continental slopes may be regarded as analogs of classical passive margins. At the margins of the East Pacific type, the petroleum potential is solely confined to transform segments. In the shelf-continental-slope basins of the rift and pull-apart nature, petroleum fields occur largely in the upper fan complex, and to a lesser extent in the lower graben (rift) complex. In light of world experience, the shelf-continental-slope basins of the Arctic and Pacific margins of Russia are evaluated as highly promising.     

Biofacies analysis of Upper Cretaceous deposits in the Ust-Yenisei region: Implications of palynomorphs

The results of palynomorph biofacies analysis in the Upper Cretaceous deposits of the Ust-Yenisei region are presented. The established facies confinement and indicative features of separate palynomorph groups are used, along with identified dinocyst morphotypes and taxa, in paleogeographic reconstructions. Seven palynomorph associations characterizing continental, coastal-marine, shallow-and deep-water facies are distinguished based on quantitative proportions between morphological groupings and individual taxa. As boundaries between distinguishable biostratigraphic and facies subdivisions do not coincide, dinocysts were likely insignificantly dependent in distribution on facies in the West Siberian epicontinental basin at least. On the other hand, distribution trends of particular dinocyst morphotypes and other microphytofossils are correlative with transgressive-regressive cycles and can be used for reconstruction of paleoenvironments.     

An Attempt to Predict the Failure Time of Abandoned Mine Pillars

Summary  Left in place pillars of abandoned mines are subject to weathering (e.g action of water, bacteria) that degrades their mechanical strength and eventually leads to collapse. A simple weathering model is proposed, that is governed by two parameters: the rate of progression of weathered front and the rate of degradation of the compressive strength with time. Both plane strain and axisymmetric analyses are performed and closed form solutions of the variation with time of the bearing capacity of the pillar are given. Experimental data of the tests conducted on gypsum and anhydrite specimens attacked by water are presented. It is shown that in order to fit the experimental data a third parameter must be introduced. New closed form solutions are given and the data are used for estimating the time to failure of abandoned gypsum mines in Northern Italy. Authors’ address: Dr. Riccardo Castellanza, Research Assistant, Department of Structural Engineering, Milan University of Technology (Politecnico), Piazza Leonardo da Vinci 32, 20133 Milan, Italy     

In situ strength measurements on natural upper-mantle minerals

Using in situ strength measurements at pressures up to 10 GPa and at room temperature, 400, 600, and 700°C, we examined rheological properties of olivine, orthopyroxene, and chromian-spinel contained in a mantle-derived xenolith. Mineral strengths were estimated using widths of X-ray diffraction peaks as a function of pressure, temperature, and time. Differential stresses of all minerals increase with increasing pressure, but they decrease with increasing temperature because of elastic strain on compression and stress relaxation during heating. During compression at room temperature, all minerals deform plastically at differential stress of 4–6 GPa. During subsequent heating, thermally induced yielding is observed in olivine at 600°C. Neither orthopyroxene nor spinel shows complete stress relaxation, but both retain some stress even at 700°C. The strength of the minerals decreases in the order of chromian-spinel ≈ orthopyroxene > olivine for these conditions. This order of strength is consistent with the residual pressure of fluid inclusions in mantle xenoliths.     

Methodology for preliminary assessment of Natech risk in urban areas

Concern for natural hazard-triggered technological disasters (Natech disasters) in densely populated and industrialized areas is growing. Residents living in urban areas subject to high natural hazard risk are often unaware of the potential for secondary disasters such as hazardous materials releases from neighboring industrial facilities, chemical storage warehouses or other establishments housing hazardous materials. Lessons from previous disasters, such as the Natech disaster during the Kocaeli earthquake in Turkey in 1999 call for the need to manage low frequency/high consequence events, particularly in today’s densely populated areas. However, there is little guidance available on how local governments and communities can assess Natech risk. To add to the problem, local governments often do not have the human or economic resources or expertise to carry out detailed risk assessments. In this article, we propose a methodology for preliminary assessment of Natech risk in urban areas. The proposed methodology is intended for use by local government officials in consultation with the public. The methodology considers possible interactions between the various systems in the urban environment: the physical infrastructure (e.g., industrial plants, lifeline systems, critical facilities), the community (e.g., population exposed), the natural environment (e.g., delicate ecosystems, river basins), and the risk and emergency management systems (e.g., structural and nonstructural measures). Factors related to vulnerability and hazard are analyzed and qualitative measures are recommended. Data from hazardous materials releases during the Kocaeli, Turkey earthquake of August 17, 1999 are used as a case study to demonstrate the applicability of the methodology. Limitations of the proposed methodology are discussed as well as future research needs.

Methodology of hydrogeological characterization of deep carbonate aquifers as potential reservoirs of groundwater. Case of study: the Jurassic aquifer of <Emphasis Type="Italic">El Maestrazgo</Emphasis> (Castellón,Spain)

A methodology for the characterization of deep carbonate aquifers has been developed and applied to El Maestrazgo Jurassic aquifer in Castellón, Spain. Characterization of these aquifer formations, located at more than 300 m deep, consisted of a previous phase of compilation, analysis and synthesis of the existing information about the area, followed by a coordinated combination of different speciality studies: geology, stratigraphy, structural analysis, hydrogeology, hydrochemistry, geophysics and remote sensing. Geological studies included geological mapping, definition of stratigraphical units and facies and structural analysis. The aim of the hydrogeology study was to define aquifer formations, recharge area, aquifer points inventory and groundwater flow directions for the establishment of piezometric and water quality observation nets. Special techniques were applied, like thermal infrared aerial images and the evaluation of submarine groundwater discharge by means of natural radium isotopes. Hydrochemical techniques, including majority elements characterization and stable isotopes (¹⁸O, ²H and ³H) determination, allowed classifying hydrochemical facies and establishing a renewal pattern for water within the system. Geophysics was useful in determining the aquifer geometry, the features of the basement and the petrophysical characteristics of the geological formations. Preliminary results show an important tectonic complexity and the possibilities for groundwater uses in the area of study.