Efficacy of Coagulants and Ballast Compounds in Removal of Cyanobacteria (<Emphasis Type="Italic">Microcystis</Emphasis>) from Water of the Tropical Lagoon Jacarepaguá (Rio de Janeiro,Brazil)

Eutrophication is considered the most important water quality problem in freshwaters and coastal waters worldwide promoting frequent occurrence of blooms of potentially toxic cyanobacteria. Removal of cyanobacteria from the water column using a combination of coagulant and ballast is a promising technique for mitigation and an alternative to the use of algaecides. In laboratory, we tested experimentally the efficiency of two coagulants, polyaluminium chloride (PAC) and chitosan (made of shrimp shells), alone and combined with two ballasts: red soil (RS) and the own lagoon sediment, to remove natural populations of cyanobacteria, from an urban brackish coastal lagoon. PAC was a very effective coagulant when applied at low doses (≤8 mg Al L^?1) and settled the cyanobacteria, while at high doses (≥16 mg Al L^?1) large flocks aggregated in the top of test tubes. In contrast, chitosan was not able to form flocks, even in high doses (>16 mg L^?1) and did not efficiently settle down cyanobacteria when combined with ballast. The RS itself removed 33–47 % of the cyanobacteria. This removal was strongly enhanced when combined with PAC in a dose-dependent matter; 8 mg Al L^?1 was considered the best dose to be applied. The lagoon sediment alone did not promote any settling of cyanobacteria but removal was high when combined with PAC. Combined coagulant and ballast seems a very efficient, cheap, fast and safe curative measure to lessen the harmful cyanobacteria bloom nuisance in periods when particularly needed, such as around the 2016 Olympics in Jacarepaguá Lagoon.     

The Role of Sediment Dynamics for Inorganic Accretion Patterns in Southern California’s Mediterranean-Climate Salt Marshes

Salt marsh resilience to sea-level rise depends on marsh plain elevation, tidal range, subsurface processes, as well as surface accretion, of which suspended-sediment concentration (SSC) is a critical component. However, spatial and temporal patterns of inorganic sedimentation are poorly quantified within and across Salicornia pacifica (pickleweed)-dominated marshes. We compared vertical accretion rates and re-examined previously published suspended-sediment patterns during dry-weather periods at Seal Beach Wetlands, which is characterized by a mix of Spartina foliosa (cordgrass) and pickleweed, and for Mugu Lagoon, where cordgrass is rare. Mugu Lagoon occurs higher in the tidal frame and receives terrigenous sediment from an adjacent creek. Feldspar marker horizons were established in winter 2013–2014 to measure accretion. Accretion rates at Seal Beach Wetlands and Mugu Lagoon were 6 ± 0.5 mm/year (mean ± SE) and 2 ± 0.3 mm/year. Also, the estimated sediment flux (g/year) across the random feldspar plots was 3.5 times higher at Seal Beach Wetlands. At Mugu Lagoon, accretion was higher near creeks, although not statistically significant. Dry-weather SSC showed similar concentrations at transect locations across sites. During wet weather, however, SSC at Mugu Lagoon increased at all locations, with concentrations decaying farther than 8 m from tidal creek edge. Based on these results from Mugu Lagoon, we conclude accretion patterns are set by infrequent large flooding events in systems where there is a watershed sediment source. Higher accretion rates at Seal Beach Wetlands may be linked to lower-marsh elevations, and thus more frequent inundation, compared with Mugu Lagoon.     

Laboratory studies on the sputtering contribution to the sodium atmospheres of Mercury and the Moon

To ascertain the importance of sputtering by solar wind ions on the formation of a sodium exosphere around Mercury and the Moon, we have irradiated with 4 keV He ions, the Na bearing tectosilicates: albite, labradorite, and anorthoclase, as well as adsorbed Na layers deposited on albite and on olivine (a neosilicate that does not contain Na). Sodium at the surface and near surface (<40 Å) was quantified with X-ray photoelectron spectroscopy before and after each irradiation to determine the depletion cross section. We measured a cross section for sputtering of Na adsorbed on mineral surfaces, σ_s ≈ 1 × 10^?15 cm² atom^?1. In addition, mass spectrometric analyses of the sputtered flux show that a large fraction of the Na is sputtered as ions rather than as neutral atoms. These results have strong implications for modeling the sodium population within the mercurian and the lunar exospheres.     

Distribution and sources of aliphatic hydrocarbons in surface sediments of Sergipe River estuarine system

The assessment of aliphatic hydrocarbons was performed in the Sergipe River estuarine system, northeastern Brazil. Aliphatic hydrocarbons concentration ranged from 9.9 ug g?1 up to 30.8 ug g?1 of dry sediment. The carbon preference index (CPI, based on nC?? to nC?? range), indicated predominance of petrogenic input in two of the sites analyzed (P4 and P5). The unresolved complex mixture (UCM) was found to be present in seven of the nine sites sampled (except for P4 and P5). Overall, the results of this work suggest that there is a mix of organic matter sources to the sediment. Although the coast of Sergipe has an intense off shore petroleum exploration and the Sergipe River crosses the entire city of Aracaju, the capital city of Sergipe, non-significant anthropogenic fingerprint was assessed.     

Tracing seafloor methane emissions with benthic foraminifera: Results from the Ana submarine landslide (Eivissa Channel,Western Mediterranean Sea)

The hypothesis that benthic foraminifera are useful proxies of local methane emissions from the seafloor has been verified on sediment core KS16 from the headwall of the Ana submarine landslide in the Eivissa Channel, Western Mediterranean Sea. The core MS312 from a nearby location with no known methane emissions is utilised as control. The core was analysed for biostratigraphy, benthic foraminiferal assemblages, Hyalinea balthica and Uvigerina peregrina carbon and oxygen stable isotope composition, and sedimentary structures. The upper part of the core records post-landslide deglacial and Holocene normal marine hemipelagic sediments with highly abundant benthic foraminifera species that are typical of outer neritic to upper bathyal environment. In this interval, the δ¹³C composition of benthic foraminifera indicates normal marine environment analogous to those found in the control core. Below the sedimentary hiatus caused by the emplacement of the slide, the foraminiferal assemblages are characterised by lower density and higher Shannon Index. Markedly negative δ¹³C shifts in benthic foraminifera are attributed to the release of methane through the seabed. The mean values of the ¹³C anomaly in U. peregrina are ? 0.951 ± 0.208 in the pre-landslide sediments, and ? 0.269 ± 0.152 in post-slide reworked sediments deposited immediately above the hiatus. The δ¹³C anomaly in Hyalinea balthica is ? 2.497 ± 0.080 and ? 2.153 ± 0.087, respectively. To discard the diagenetic effects on the δ¹³C anomaly, which could have been induced by Ca–Mg replacement and authigenic carbonate overgrowth on foraminifera tests, a benthic foraminifera subsample has been treated following an oxidative and reductive cleaning protocol. The cleaning has resulted, only in some cases, in a slight reduction of the anomaly by 0.95% for δ¹³C and < 0.80% for δ¹⁸O. Therefore, the first conclusion is that the diagenetic alteration is minor and it does not alter significantly the overall carbon isotopic anomaly in the core. Consequently, the pre-landslide sediments have been subject to pervasive methane emissions during a time interval of several thousand years. Methane emissions continued during and immediately after the occurrence of Ana Slide at about 61.5 ka. Subsequently, methane emissions decreased and definitely ceased during the last deglaciation and the Holocene.     

Crustal thickness estimation beneath the southern central Andes at 30°S and 36°S from S wave receiver function analysis

We have used the S wave receiver function (SRF) technique to investigate the crustal thickness beneath two seismic profiles from the CHARGE project in the southern central Andes. A previous study employing the P wave receiver function method has observed the Moho interface beneath much of the profiles. They found, however, that the amplitude of the P to S conversion was diminished in the western part of the profiles and have attributed it to a reduction of the impedance contrast at the Moho due to lower crustal ecologitization. With SRF, we have successfully detected S to P converted waves from the Moho as well as possible conversions from other lithospheric boundaries. The continental South American crust reaches its maximum thickness of ∼70 km (along 30°S between 70°W and 68.5°W) beneath the Principal Cordillera and the Famatina system and becomes thinner towards the Sierras Pampeanas with a thickness of ∼40 km. Negative phases, possibly related to the base of the continental and oceanic lithosphere, can be recognized in the summation traces at different depths. By comparing our results with data obtained from previous investigations, we are able to further constrain the thickness of the crust and lithosphere beneath the central Andes.     

Forest Fire Alert System: a Geo Web GIS prioritization model considering land susceptibility and hotspots – a case study in the Carajás National Forest,Brazilian Amazon

To increase the monitoring potential of forest fires, an alert classification methodology using satellite-mapped hotspots has been established to help forest managers in the prioritization of which hotspot to be verified in the field, thus potentially improving the distribution of fire-fighting resources. A computer application was developed based on web-distributed geographical information technology whose main function is to interact automatically generated satellite hotspots and risk areas indicated in fire-susceptibility maps and classify them into five alert levels. The location of the hotspots is available continuously every 4 h, and a susceptibility map is produced daily through map algebra algorithm, which uses static (topography, vegetation and land use) and dynamic (weather) variables. Every process runs through automated geoprocessing routines. The methodology was tested during the dry period of 2007 in the Carajás National Forest, in the Brazilian Amazon, within an area of 400,000 ha. It is a critical area constantly threatened by fires caused by invasions and deforestation owing to intense agribusiness advances and mining activities in its surroundings. This situation results in observations of many hotspots inside the study area for the same day and almost the same time period, in places of extreme opposites, demanding complex rapid analysis and hindering the decision of the displacement of fire-fighting teams. Further, a major mining company operates within the National Forest area, maintaining actions of protection as part of its environmental mining license. Results are presented under three aspects: (i) the credibility of the daily susceptibility map (algorithm), which showed strong correlation between areas of greatest risks and the confirmed forest fires; (ii) the reliability of hotspots (alert levels), confirming 71% of fires; (iii) accuracy in the decision of which hotspot to be checked, which revealed the same number of verifications at different alert levels, 82% confirmed alert 5 hotspots (maximum) and only 50% from alert 1 (minimum), resulting in faster fire-fighting actions, minimizing burned areas and, in some cases, allowing fire control before its spreading. Therefore, the methodology demonstrated that GIS routines are able to determine the relationship between a reality-based, interpreted susceptibility map of the area and satellite-generated hotspots, highlighting the ones of highest hazard level through the alert classification, becoming an important tool to help decisions from the fire-control center, especially for high-risk regions. The methodology may be extrapolated to other forested areas.     

Robust Regulation of Alkalinity in Highly Uncertain Continuous Anaerobic Digestion Processes

In this paper, a multiple‐input multiple‐output (MIMO) model‐based robust control scheme is proposed for the indirect control of both total alkalinity and the ratio (intermediate alkalinity)/(total alkalinity) by regulating volatile fatty acid concentrations and strong ions concentration, while guaranteeing the so‐called operational stability in anaerobic digestion (AD) processes. The proposed MIMO regulator is an adaptive controller derived from an AD model which incorporates the physicochemical equilibrium of the system as well as the use of a robust interval observer to estimate key process bounds that are used in the computation of the control efforts. Numerical simulations were carried out for a number of operating conditions under the most uncertain scenarios. Results showed that the proposed multivariable control law is able to recover the system stability around a pre‐determined set point in the face of parameter uncertainty and load disturbances.