A Note On Surface Humidity Measurements In The Cold Canadian Environment

In the cold Canadian environment, humidity measurements can be verydifficult to conduct. In this brief communication, humidity observationstaken by two different sensors at six remote Canadian Arctic locations arecompared. The observations collected by Vaisala HMP35CF sensors displaya strong tendency toward the ice saturation point whereas dew cell instrumentsexhibit significantly lower values of relative humidity with respect to ice (RH_i).Humidity data collected by HMP35CF hygrometers are therefore unreliable sincethey are subject to persistent icing that lead them to record values of RH_i near 100%, irrespective of the air temperature. The high humidity bias emerges atmeteorological stations mounted with the HMP35CF probes since these instrumentsare usually neither sheltered nor heated, and are not attended to at regular intervals. Thus, great care must be taken in utilizing humidity data recorded by HMP35CF sensors across the network of climate autostations in Canada.     

Particle size dependent response of aerosol counters

During an international workshop at the Institute for Experimental Physics of the University of Vienna, Austria, which was coordinated within the Committee on Nucleation and Atmospheric Aerosols (IAMAS-IUGG), 10 instruments for aerosol number concentration measurement were studied, covering a wide range of methods based on various different measuring principles. In order to investigate the detection limits of the instruments considered with respect to particle size, simultaneous number concentration measurements were performed for monodispersed aerosols with particle sizes ranging from 1.5 to 50 nm diameter and various compositions.The instruments considered show quite different response characteristics, apparently related to the different vapors used in the various counters to enlarge the particles to an optically detectable size. A strong dependence of the 50% cutoff diameter on the particle composition in correlation with the type of vapor used in the specific instrument was found. An enhanced detection efficiency for ultrafine hygroscopic sodium chloride aerosols was observed with water operated systems, an analogous trend was found for n-butanol operated systems with nonhygroscopic silver and tungsten oxide particles.     

Pseudodynamic tests on rubber base isolators with numerical substructuring of the superstructure and strain‐rate effect compensation

A pseudodynamic testing procedure has been applied by which the seismic response of a base‐isolated building is obtained by using as specimen the isolators, while the superstructure is numerically simulated. The procedure also takes advantage of the continuous pseudodynamic testing capabilities of the ELSA laboratory, which increase the accuracy of the results and reduce the strain‐rate effect of the rubber bearings. A simple proportional correction of the measured forces compensates the remaining strain‐rate effect due to the unrealistic speed of the test. The correction factor is obtained by means of a characterizing test on the specific rubber isolators. The developed method has been successfully applied to the prediction of the seismic response of a base‐isolated four‐storey building submitted to several specified accelerograms. The results for those earthquakes as well as the effects of some changes of the parameters of the system are discussed. Copyright © 2002 John Wiley & Sons, Ltd.     

Towards a direct collapse–load method of design for concrete frames subjected to severe ground motions

Most current methods of design for concrete structures under earthquake loads rely on highly idealized ‘equivalent’ static representations of the seismic loads and linear‐elastic methods of structural analysis. With the continuing development of non‐linear methods of dynamic analysis for the overload behaviour and collapse of complete concrete structures, a more direct and more accurate design procedure becomes possible which considers conditions at system collapse. This paper describes an evaluation procedure that uses non‐linear dynamic collapse–load analysis together with global safety coefficients. A back‐calibration procedure for evaluating the global safety coefficients is also described. The aim of this paper is to open up discussion of alternative methods of design with improved accuracy which are necessary to move towards a direct collapse–load method of design. Copyright © 2002 John Wiley & Sons, Ltd.     

Seismic Hazard for Selected Sites in Greece: A Bayesian Estimate of Seismic Peak Ground Acceleration

A procedure for estimating maximum values of seismic peak ground accelerationat the examined site and quantiles of its probabilistic distribution in a future timeinterval of a given length is considered. The input information for the method areseismic catalog and regression relation between peak seismic acceleration at a givenpoint and magnitude and distance from the site to epicenter (seismic attenuation law).The method is based on Bayesian approach, which simply accounts for influenceof uncertainties of seismic acceleration values. The main assumptions for the method are Poissonian character of seismic events flow and distribution law of Gutenberg-Richter's type. The method is applied to seismic hazard estimation in six selected sitesin Greece.     

A double-head photon-counting photometer for fast timing observations

The structure of the electronics of the two-head, high-speed photometer operating on the 152-cm G.D. Cassini telescope of Bologna University has been fully redesigned for high-time-resolution observations of fast variable sources, in particular, of the optical counterparts of X-ray binary systems. The fast photometer now permits sampling times from 0.1 ms to 100 s. The handling of the system clock and I/O configuration have been modified to provide rigorous synchronization of the sampling time with an external high-stability clock and the continuous acquisition of an uninterrupted data stream. The continuous data-acquisition process, which is driven by an external clock, is limited only by the capacity of the hard disk and is supported by a double-buffer SRAM memory designed to overcome any discontinuity in the asynchronous communication with the computer. Real-time monitoring of the data enables continuous evaluation of the weather conditions, and the directly displayed light curve can be used to determine the optimal management of the observations.     

Simultaneous use of geochemical and geophysical methods to characterise abandoned landfills

. Groundwater sampling and geophysical methods determined a serious contamination problem associated with refilled exploitation sites at the Cal Dimoni area, Llobregat delta, Barcelona, Spain. To characterise this process, hydrogeochemical analyses were performed and showed the following modifications to groundwater chemical composition: increasing pH values, changing redox conditions, significant increases in total organic carbon (TOC) and certain trace elements, and high groundwater conductivity values. Major ion content accumulations were found under the refilled area. In contrast, elements involved in the oxidation–reduction processes, such as iron, manganese and nitrates, clearly diminished. Electromagnetic prospecting methods were also performed and delineated the contamination plume extent. These methods also showed separate sources of contamination, one clearly related to the groundwater–refilled zone leachate interaction, another as a consequence of the manure–accumulation surface site. Geochemical and geophysical methods have shown similar results for locating groundwater contamination sources, and for determining leachate generation mechanisms and flow paths.     

Modelling of Tsunami Propagation in the Vicinity of the French Coast of the Mediterranean

The problem of tsunami-risk for the French coast of the Mediterraneanis discussed. Historical data of tsunami manifestation on the French coast are described and analysed.Numerical simulation of potential tsunamis in the Ligurian Sea is done and the tsunami wave heightdistribution along the French coast is calculated. For the earthquake magnitude 6.8 (typical value forMediterranean) the tsunami phenomenon has a very local character. It is shown that the tsunami tide-gaugerecords in the vicinity of Cannes–Imperia present irregularoscillations with characteristic periodof 20–30 min and total duration of 10–20h.Tsunami propagating from the Ligurian sea to the west coastof France have significantly lesser amplitudes and they are more low-frequency (period of 40–50min).The effect of far tsunamis generated in the southern Italy and Algerian coast is studied also, thedistribution of the amplitudes along the French coast for far tsunamis is more uniform.     

Isotope Evidences of the Paleozoic Stage of Epigenetic Transformation of Vendian Sediments of the Russian Platform

The Rb–Sr characteristics of whole-rock samples of Upper Vendian clayey rocks recovered by Gavrilov-Yam boreholes are studied. The Rb–Sr age versus sampling depth relationship has been revealed. Three sample assemblages are identified. The errorchron relationship of samples in the first interval (1760–2400 m) fits the age of 390 ± 40 Ma corresponding to the initial Hercynian history characterized by the transformation of platformal sediments. The other two assemblages (2410–2525 and 2528–2560 m) make up isochrons with slopes corresponding to 590 ± 50 and 690 ± 10 Ma, respectively. Their geochronological meaning is unclear.     

A Platinum Group Element and Re-Os Isotope Investigation of Siderophile Element Recycling in Subduction Zones: Comparison of Grenada, Lesser Antilles Arc, and the Izu-Bonin Arc

The picritic (MgO >13·5%) lavas of Grenada providea unique opportunity to evaluate the platinum group elements(PGE) and Os isotope compositions of primitive subduction-generatedmelts. Compared with other arc lavas they have undergone verylimited crustal contamination (