Spatial variation of the intertidal sediments and macrozoo-benthic assemblages along Eighty-mile Beach, North-western Australia

The extensive intertidal flats along Eighty-mile Beach in North-western Australia appear to be monotonous and homogeneous and seem ideally suited to study tidal zonation in macrozoo-benthic communities and their possible correlates with characteristics of the sediment. In October 1999, we sampled benthic invertebrates and sediments at a total of 895 sampling stations distributed over six different locations, each location separated by 15 km of unsampled foreshore along Eighty-mile Beach. To test for the presence or absence of patterns of tidal zonation (distinct height-related zones of specific sediment grain sizes or zoobenthic taxonomic groups) or patchiness (distinct patches of specific sediment grain sizes or zoobenthic taxonomic groups not related to tidal height) each location was divided into three along-shore sections and each section (transect) was examined at two or three tidal heights. Zonation was observed for sediment grain sizes. Sediments were coarser at the highest intertidal level and finer towards the low water line. Benthic assemblages also differed among tidal heights, but in terms of species-composition the differences were not consistent among the locations. Each location supported a unique collection of benthic invertebrates. Therefore the hypothesis of the presence of distinct zones of specific species or zoobenthic taxonomic groups was rejected; the presence of benthic patches was confirmed. The distribution of sediments and the composition of benthic assemblages were surprisingly poorly correlated compared to those reported in 12 previous quantitative studies around the world. One possible explanation might be that super-cyclone Vance, which hit the study-area only six months before this study, contributed to this poor correlation. Alternatively, the poor correlation may indicate that biotic interactions are more important than the assumed abiotic structuring.     

Problems with biogenic silica measurement in marginal seas

Surface sediment samples from the Bohai, Yellow Sea, and the Pacific were used to assess biogenic silica (BSi) content and to study uncertainties in BSi measurements. The contents of BSi in the Bohai and Yellow Sea are all less than 1%. The dissolution of BSi in sediments from the Bohai and Yellow Sea is very important to maintain high levels of silicate in the water column. The non-biogenic silica from clay minerals has an obvious effect on BSi of sediment samples in the Bohai and Yellow Sea with low BSi and high clay minerals. The solid to solution ratio was found to have a great influence on BSi measurement, which can induce uncertainties up to 75%. The effect of loss by sorption and centrifugation is negligible. Interlaboratory comparison of techniques for BSi measurement by the wet alkaline extraction technique of Mortlock and Froelich [Deep-Sea Res. 36 (1989) 1415-1426] with clay correction was suggested to give no significant differences. However, differences in sediment compositions and reagent to sample ratio may limit the application of the wet alkaline extraction method.     

Kuroshio extension variability explored through assimilation of TOPEX/POSEIDON altimeter data into a quasi-geostrophic model

Mesoscale features in the eastward extension of the Kuroshio were investigated using assimilation of TOPEX/POSEIDON (T/P) data into a three-layer quasi-geostrophic model. The T/P data exhibited an elongated state of the southern recirculation gyre in 1993–95 and 1997, between whose two periods the gyre had a contracted state in 1995–96. A few stationary eddies were located in the southern gyre during the contracted state. The baroclinic instability, which was indicated by the phase shift from the uppermost-to the lowest-layer anomalies toward the downstream side, was evident near the Kuroshio Extension (KE) path. Since the instability never appeared in the artificial model without bottom topography, the topographic barrier for the eastward flow in the lowest layer was a necessary condition for the instability. The instability synchronized with the transition in the western region of the KE axis from the elongated to the contracted states. This evolution was interpreted as if the baroclinic instability played some part in the KE states and was a trigger for the transition from the elongated to the contracted states.     

The Equatorial Atlantic Mid-Ocean Channel: An Ultra High-Resolution Image of Its Burial History Based on TOPAS Profiles

Multibeam bathymetric and ultra high-resolution seismic data reveal that the distal course of the Equatorial Atlantic Mid-Ocean Channel (EAMOC) extends further east and south than was previously known, and is controlled by the presence of morphologic highs related to the Fernando de Noronha Fracture Zone. Distal course of the EAMOC is buried by sediments, and does not have bathymetric expression on the seafloor. The channel fill consists of three seismic sequences, suggesting that the recent geological evolution of the channel is composed of successive phases of decreasing sedimentary activity that finally resulted in its complete burial. Tectonic and volcanic activity related to the Fernando de Noronha Fracture Zone and Ridge, together with the effect of strong pulses of the Antarctic bottom water current during the upper Pliocene are suggested to have contributed to the progressive burial and the final abandonment of the EAMOC.     

Further evidence for non-reemergence of winter SST anomalies in the North Pacific eastern subtropical mode water area

Following our previous study (Sugimoto and Hanawa, 2005b), we further investigate the reason why reemergence of winter sea surface temperature anomalies does not occur in the North Pacific eastern subtropical mode water (NPESTMW) area, despite its occurrence in the North Pacific subtropical mode water and North Pacific central mode water areas. We use vertical temperature and salinity profiles of the World Ocean Circulation Experiment Hydrographic Program and Argo floats with high vertical and temporal resolution, together with heat flux data through the sea surface. We point out first that one of the causes for non-occurrence of reemergence is that the thickness of NPESTMW is very thin. In addition to this basic cause, two major reasons are found: a vigorous mixing in the lower portion of NPESTMW and less heat input from the atmosphere in the warming season. Since, in the lower portion of NPESTMW and deeper, the stratification is favorable for salt-finger type convection to occur compared with the other mode water areas, vigorous mixing takes place. This is confirmed by both a large Turner Angle there and the existence of staircase structures in vertical temperature and salinity profiles. From the viewpoint of heat input, the NPESTMW area gradually gains heat in the warming season compared with other mode water areas. As a result, NPESTMW cannot be capped so quickly by the shallow summer mixed layer, and water properties of NPESTMW are to be gradually modified, even in the upper portion.     

Geomorphological evidence for upslope canyon-forming processes on the northern KwaZulu-Natal shelf,SW Indian Ocean,South Africa

A geomorphological and statistical analysis of slope canyons from the northern KwaZulu-Natal continental margin is documented and compared with submarine canyons from the Atlantic margin of the USA. The northern KwaZulu-Natal margin is characterized by increasing upslope relief, concave slope-gradient profiles and features related to upslope growth of the canyon forms. Discounting slope-gradient profile, this morphology is strikingly similar to canyon systems of the New Jersey slope. Several phases of canyon incision indicate that downslope erosion is also an important factor in the evolution of the northern KwaZulu-Natal canyon systems. Despite the strong similarities between the northern KwaZulu-Natal and New Jersey slope-canyon systems, key differences are evident: (1) the concavity of the northern KwaZulu-Natal slope, contrasting with the ∼linear New Jersey slope; (2) the relative isolation of the northern KwaZulu-Natal canyons, rather than the dense clustering of the New Jersey canyons; and (3) the absence of strongly shelf-breaching canyons along the northern KwaZulu-Natal margin. In comparison with the New Jersey margin, we surmise a more youthful stage of canyon evolution, a result of either the canyons themselves being younger or the formative processes being less active. Less complicated patterns of erosion resulting from reduced sediment availability have developed in northern KwaZulu-Natal. The reduction in slope concavity on the New Jersey margin may be the result of grading of the upper slope by intensive headward erosion, a process more subdued—or less evident—on the KwaZulu-Natal margin.     

The capacity of marine plankton, macrophytes and particulate matter to adsorb Cu in the presence of Mg

A complexometric titration technique was employed to measure the total capacity of a variety of marine organisms to adsorb Cu²⁺. Measured adsorption capacities were 0.22 meq g⁻¹ for phytoplankton, 0.3–1.0 meq g⁻¹ for macrophytes, 1.0–2.5 meq g⁻¹ for zooplankton and 0.3 meq g⁻¹ for suspended particulate matter. The capacity of these materials to adsorb Cu²⁺ was reduced significantly in the presence of Mg²⁺ at seawater concentrations. Competition between Mg^t2+ and Cu²⁺ for adsorption sites at pH 6 is described by an average conditional equilibrium constant of 10^3.7. This constant is such that very little Cu²⁺ may be adsorbed onto particulates and marine phytoplankton in the presence of Mg²⁺. Further, primary productivity data and estimates of the detrital carbon sedimentation in Long Island Sound suggest that the flux of particulate carbon is insufficient to remove significant amounts of Cu from the water column to sediments by adsorption mechanisms.     

Measurement of alkaline and earthy ions in fish otolith and sea water using a high performance ion chromatography

Fish growth and the relation between growth and environmental conditions offer a good opportunity for measuring alkaline and earthy ions in fish otoliths.The analytical method must involve high sensitivity when attempting to discriminate between fish growth and environmental conditions.The aim of this paper is to propose a chromatographic method, with low detection limits, as a new approach in determining some important micronutrients present in sea water and fish otoliths.The work samples are: coastal, off-shore and sediment waters and fish otoliths (Engraulis encrasicholus, Mullus barbatus, Umbrina cirrhosa, Sciaena umbra, Pagellus erythrinus) in the Adriatic Sea and the Canal of Sicily.The analytical method includes an IONPAC CS12A chromatographic column and a 18 mM methanesulfonic acid eluent.The detection limit readings obtained with this method, for one E. encrasicholus fish otolith, weighing 2.6 mg are equal or inferior to 0.1 μg/L for lithium (Li), 59 μg/L for sodium (Na), 46 μg/L for ammonium (NH₄), 23 μg/L for potassium (K), 13 μg/L for magnesium (Mg), 88 μg/L for manganese (Mn), 2.567 μg/L for calcium (Ca) and 13 μg/L for strontium (Sr).The HPIC method minimizes overlaps such as Na on Li, and NH₄ in seawater and Ca on Mg and Sr in fish otolith. These elements are an essential constituent present in otoliths when describing the relation between growth and environmental conditions.Good separation among analytes is achieved within 16 min.     

Inverse reconstructions of ecosystem flows in investigating regime shifts: impact of the choice of objective function

Inverse analysis is increasingly used in ecosystem modelling to objectively reconstruct a large number of unknown flows or interactions from a small number of observations. This type of analysis may be useful in relating observed regime shifts in ecosystem structure to underlying processes. Inversions of ecosystem flow networks currently use a constrained least-squares solution which at the same time minimizes the squared norm (the sum of squares) of the reconstructed flows. This minimum norm (MN) inversion is thought to be a parsimonious solution to the ecosystem flow inverse problem, but it may well not reflect how ecosystems are organised. It has been proposed instead that ecosystems evolve to maximize energy/mass flows or that they maximize the information content of the network weighted by ecosystem flows (ascendancy). We used simulated inverse experiments, where inverse analyses are applied to simulations of flow networks, to explore objective functions different than the MN generally used. We could not compute inverse solutions that maximize ascendancy because the objective function is unbounded. We could calculate inversions that maximize flows; however, these generally overestimated the simulated flows, even though the simulations were designed to maximize flows. It appears that the ecosystem flow inverse problem is too under-determined (too few data relative to the number of unknowns) to allow the use of these maximizing goal functions. We introduce a new minimization that simultaneously minimizes the squared flows and the squared differences between flows. This smoothing minimization makes the inverse flows as even as possible and it helps with some technical issues with MN inversions. The simulated inverse experiments indicated that this smoothed norm (SM) is the most robust in comparative analyses of contrasting ecosystem states, such as those that can be associated with regime shifts. Like the MN inversion, the SM inversion has no ecological basis. However, it is a conservative norm that is less likely to produce false differences between the dynamics of regimes.     

An improved Ewing heat probe frame

The standard Ewing heat probe frame has been improved through the design of a new takedown model whose parts are held together by lynch pins. When a 600 lb (272 kg) unit of this type is taken apart, the heaviest single piece of the dismantled unit weighs only 75 lb (34 kg).This makes it feasible for one person to handle, transport, and assemble the new unit. A central, main support member of a heat probe using this frame can be suspended over the side of a research vessel while the heavier temperature recorder and ballast weights are attached by means of the quickaction lynch pins. This makes it possible to use this device on relatively small vessels which are not designed for coring work, having a minimum of free deck space and without launching platforms or hydraulic A-frame booms.