Experimental studies on the slowly varying drift motion of a berthed container ship model

The effects of free-surface waves on the floating structures are of great importance in the offshore industry. Among the six degrees of motions of a surface ship the absence of restoring forces in surge, sway and yaw led to critical situations for moored ships in the recent times. The order of forces in horizontal plane and their exciting frequencies are matters of interest. The resonance with the presence of moored chains led to many accidents in the recent past. The lines in dry conditions may not give good damping and in wet condition they may trigger the system to chaotic motions and jumps. Two different loading conditions of a container ship model are tested with waves in laboratory conditions in two different drafts. The mooring lines are chosen as per scale law and the energy under the response spectrum is determined from the plots. The results give new insights into the movement of a berthed ships subjected to waves. Response of the moored ship to different loading conditions in different water depths are discussed in this paper. The paper gives the order of energy due to first-order and slowly varying movement of a berthed container model in a towing tank.     

Three‐dimensional simulation of tsunami run‐up around conical island

At the circular Babi Island in the Flores tsunami (1992) and pear shaped island in the Okushiri event (1993), unexpectedly large tsunami run‐up heights in the lee of conic islands were observed. The flume and basin physical model studies were conducted in the Coastal Hydraulic Laboratory, Engineering Research and Development Center, U.S. Army Corps of Engineers to provide a better understanding of the physical phenomena and verify numerical models used in predicting tsunami wave run‐up on beaches, islands, and vertical walls. Reasonably accurate comparison of run‐up height of solitary waves on a circular island has been obtained between laboratory experimental results and two‐dimensional computation model results. In this study we apply three‐dimensional RANS model to simulate wave run‐up on conical island. In the run‐up computation we obtain that 3D calculations are in very good comparison with laboratory and 2D numerical results. A close examination of the three‐dimensional velocity distribution around conical island to compare with depth‐integrated model is performed. It is shown that the velocity distribution along the vertical coordinate is not uniform: and velocity field is weaker in the bottom layer and higher on the sea surface. The maximum difference (about 40%) appears at the time when solitary wave reached the circular island.     

Water mass formation variability in the intermediate layer of the east sea

Long-term variability in the intermediate layer of the eastern Japan Basin has been investigated to understand the variability of water mass formation in the East Sea. The simultaneous decrease of temperature at shallower depths and oxygen increasing at deeper depths in the intermediate layer took place in the late 1960’s and the mid-1980’s. Records of winter sea surface temperatures and air temperatures showed that there were cold winters that persisted for several years during those periods. Therefore, it was assumed that a large amount of newly-formed water was supplied to the intermediate layer during those cold winters. Close analysis suggests that the formation of the Upper Portion of Proper Water occurred in the late 1960’s and the Central Water in the mid-1980’s.     

Identification of Pb sources in Yellow Sea sediments using stable Pb isotope ratios

Rapid economic developments in East Asian countries have inevitably resulted in environmental degradation in the surrounding seas, and concern for both the environment and protection from pollutants is increasing. Identification of sources of contaminants is essential to environmental pollution management. In this study, the provenance of anthropogenic lead (Pb), a major pollutant of Yellow Sea sediments, was determined for river mouth sediments, including those of the Changjiang, Huanghe, Han, and Geum Rivers, and for age-determined shelf core sediments through the measurement of Pb isotope ratios in the HCl-leached fraction using multi-collector inductively coupled plasma-mass spectrometry (MC ICP/MS). Anthropogenic Pb has accumulated in shelf core sediments since 1910, and its isotope ratios were estimated as 0.863–0.866 and 2.119–2.125 for ²⁰⁷Pb/²⁰⁶Pb and ²⁰⁸Pb/²⁰⁶Pb, respectively, from the mixing relationships of the two endmembers. River mouth sediments exhibited enough distinction in anthropogenic Pb isotope ratios to be discriminated: 0.874 (2.144) in the Huanghe, 0.856 (2.129) in the Han, 0.857 (2.122) in the Geum, and 0.854 (2.101) in the Changjiang for ²⁰⁷Pb/²⁰⁶Pb (²⁰⁸Pb/²⁰⁶Pb), respectively. Although isotope ratios of geogenic Pb in sediments dating before 1910 showed narrow ranges (0.842–0.845 and 2.088–2.100 for ²⁰⁷Pb/²⁰⁶Pb and ²⁰⁸Pb/²⁰⁶Pb, respectively), distinct isotope ratios in each core permitted source identification of sediments in the Yellow Sea based on geographic locations and the geogenic Pb of each river. By comparing the isotope ratios of the estimated anthropogenic Pb to source-related materials, the provenances of anthropogenic Pb in Chinese river sediments were presumed to be Chinese coal or ore, which is also a major source of atmospheric particulate Pb. The anthropogenic Pb in the shelf core sediments in the northern Yellow Sea originated from northern Chinese cities such as Beijing and Tianjin through atmospheric pathways. Pb isotope ratios indicated that Pb in Korean river sediments was characteristic of local Korean ores.     

Slope inclinometers for landslides

Slope inclinometers/indicators are used to determine the magnitude, rate, direction, depth, and type of landslide movement. This information is usually vitally important for understanding the cause, behavior, and remediation of a landslide. However, many inclinometer measurements fail to achieve these intended aims because of lack of appreciation of the many factors that need to be correctly implemented during installation, monitoring, and data reduction to yield useful data. This paper presents some guidelines for understanding, installing, and interpreting slope inclinometers and presents three case histories that illustrate some of the pitfalls that can develop if these guidelines are not followed.     

Tectonic relation between northeastern China and the Korean peninsula revealed by interpretation of GRACE satellite gravity data

The major continental blocks in northeastern Asia are the North China block and the South China block, which have collided starting from the Korean peninsula. Geologic and geophysical interpretations reveal a well defined suture zone in northeastern China from Qinling through Dabie to Jiaodong. The discovery of high-pressure metamorphic rocks in the Hongseong area of the Korean peninsula, prominent evidence for the collision zone, indicates extension of the collision zone in northeastern China into the Korean peninsula. Interpretation of the GRACE satellite gravity dataset shows two prominent structural boundaries in the Yellow Sea. One extends from the Jiaodong Belt in eastern China to the Imjingang Belt in the Korean peninsula. The other extends from near Nanjing, eastern China, to Hongseong. Tectonic movement in or near the suture zone may be responsible for seismic activity in the western Korean peninsula and the development of the Yellow Sea sedimentary basin.     

Yeosu dinosaur track sites of Korea: The youngest dinosaur track records in Asia

Eighty two dinosaur trackways were newly discovered in Upper Cretaceous lacustrine deposits on islands in the vicinity of Yeosu, Korea. Most dinosaur tracks occur in marginal lake deposits with polygonal desiccation cracks. The dinosaur tracks at the Yeosu site include 65 ornithopod trackways, 16 theropod trackways and one sauropod trackway. The prevalence of ornithopod tracks and the limited occurrence of sauropod tracks at the Yeosu site evidently reflect decreased sauropod diversity in the Upper Cretaceous. All ornithopod trackways represent bipeds, and most of the ornithopod tracks are similar to Caririchnium from other sites of the Korean peninsula. All fossil wood specimens collected in the study area represent conifers (three species of cupressaceous and two species of taxodiaceous conifers, and a new species) except for one, which is a discotyledon. It is thus inferred that the southwestern part of the Korean Peninsula was primarily covered with mesic forests with taxodiaceous trees during the Late Cretaceous. The K–Ar age of the Yeosu tracksite is determined as 81–65 Ma (Camapnian to Maastrichtian). It indicates that the Yeosu track site contains the last records of dinosaurs living in Asia. Consequently, semi-arid palaeoclimatic conditions, together with a large lake as a persistent water source and rich vegetation of gymnosperm trees as food, resulted in the preservation of abundant dinosaur tracks in the Upper Cretaceous on the Korean Peninsula.     

Distribution of cadmium, chromium, copper, lead and zinc in marine sediments in Hong Kong waters

Partitioning of heavy metals (Cd, Cr, Cu, Pb, Zn) in marine sediments collected from various sites in Hong Kong waters were determined using sequential extraction method. Sediments from Kellette Bank, located in Victoria Harbour, had higher metal concentrations especially Cu and Zn than most other sites. Slightly over 20% of total Cu and Cr existed as readily available forms in Peng Chau and Kellette Bank. At most sampling sites, over 15% of the Cu existed as the exchangeable form indicating that Cu could be readily released into the aqueous phase from sediments. A significantly higher percentage of Pb and Zn was associated with the three non-residual fractions. Hence, there is a greater environmental concern for remobilization of Pb and Zn compared with Cr. The high amount of residual Cd (>50%) and the relatively lower Cd content indicate that little environmental concern is warranted for the remobilization of Cd. Distribution of metals in sediments collected from different depth at Kellette Bank shows that metal concentrations decreased with profile depth. The levels of Pb and Zn associated with the two readily available fractions increased sharply in the surface sediment. These metals represented the pollutants, which were introduced into the area in the mid-eighties through early nineties as a result of rapid economic and industrial development in the territory. As significant portions of these metals were bound to the readily available phases in the surface sediments, metal remobilization could be a concern. An erratum to this article can be found at     

伴随模式同化系统在修正模式地形中的应用

任何模式都只是实际大气的一种近似模拟，存在误差。鉴于传统的四维资料伴随模式同化系统都是假设模式完全正确仅对初始场进行修正。将伴随模式同化系统应用于修正模式地形误差，通过对不同初始地形的修正试验表明，MM5伴随模式同化系统能很好地对地形误差进行修正，能够反演出与初始气象要素场分辨率相匹配、与模式更协调的地形场，为伴随模式同化系统的广泛应用提供了一种新的思路。     

基于ODBC的地震前兆数据批量卸出与转换程序的实现

介绍了CDBC技术、工作流程及数据传递方式；分析了研制数据卸出与转换程序的关键技术及实现方法；描述了程序的组织结构。通过实例说明了该程序在全国前兆台网中心卸载与转换地震前兆数字化的观测数据中的应用。