“多对多”模式GPS台站网系统设计与应用分析

本文在分析GPS RTK定位工作模式的基础上,以苏州市为研究对象,讨论了＂多对多＂模式GPS台站网系统设计,研究了相应的操作规程,并进行了该模式下的定位试验,对定位结果的精度进行了分析,最后给出了结论。     

Climate changing characteristics of Zhangye City in Heihe River basin during 1968–2005

At present, researches on climate change of the Heihe River basin mainly focus on the relationship between basin climate change and regional water resources, regional desertification and dynamic climatic seasons of sandstorm, but less on climate change of oasis region, where there are more intense and frequent human activities. Based on data of precipitation, temperature, strong wind and dust events frequencies obtained from the six meteorological stations of Zhangye region in Heihe River basin, the features of climate change during 1968–2005 were carefully studied. Results show that the regional temperature rise rate exceeded the average level of China. The annual precipitation changed a little, but the precipitation had a slowly increasing trend in spring and winter. Frequencies of strong wind and sandstorm days show obviously descending trends, which had a close correlation with the regional temperature rise and the precipitation increase in spring and winter. Meanwhile, further human economic activities and exploitations to the oasis in the inland valley of arid regions also affected the climate change of this region, which has a sensitive and fragile eco-environment. __________ Translated from Journal of Desert Research, 2007, 27(6): 1048–1054 [译自: 中国沙漠]     

电容测试法判断测井电缆系统故障

测井电缆因长途颠簸、拉伸及绞车缠绕挤压,电缆连接器、电缆、绞车滑环、滑环连线等部位极易出现故障。电容测试法是一种简易、快速的检测方法,该法可在现场准确诊断出故障电缆的位置。以四芯铠装电缆为例,每根缆芯的正常阻值约为80Ω/1 000m,两缆芯间的分布电容约为170PPF/1 000m。在实际检测中,根据电容较小时测点的位置,可以有效判断故障部位;而电缆故障位置则可利用电阻及电容的线性关系进行计算予以确定。     

煤层气储层测井评价有关问题的讨论

煤层气的形成和储层的特性决定了煤层气储层评价的一系列关键参数,这些参数可用常规测井方法直接或间接获得。目前常规测井方法包括自然电位、双侧向（或感应）、微电极、补偿密度、自然伽马、声波时差、声波全波列、中子孔隙率以及井径测井等。选用不同测井方法采用线性回归或体积模型等方法,可以获得煤层气储层评价参数。     

初至层析静校正在复杂山地三维地震勘探中的应用

随着地形高差增大、地貌单元多变、近地表模型复杂,目前被广泛应用的初至折射静校正的精度已无法满足精细勘探的要求。初至层析静校正技术,由给定的初始模型进行正演,用射线追踪方法得到初始模型的初至波,利用该初至波和实际拾取的初至波进行比较,计算地表模型的修正量,反复迭代求得准确的地表模型。山西省国阳新能股份有限公司二矿390水平九采扩区地表标高940～1100m,地貌单元复杂,在对该区资料处理时,利用初至层析折射静校正,经9次迭代计算后,真实地刻划出近地表模型。在二种静校正技术对比中,初至折射静校正不但近地表模型精度低于层析折射静校正,而且其叠加剖面精细程度也远低于层析静校正,如在初至折射静校正叠加剖面同相轴上呈现的凹凸形态,在层析静校正叠加剖面并无显示,且后者剖面的信噪比也比前者明显提高。     

Non-Linear Theory and Power-Law Models for Information Integration and Mineral Resources Quantitative Assessments

Singular physical or chemical processes may result in anomalous amounts of energy release or mass accumulation that, generally, are confined to narrow intervals in space or time. Singularity is a property of different types of non-linear natural processes including cloud formation, rainfall, hurricanes, flooding, landslides, earthquakes, wildfires, and mineralization. The end products of these non-linear processes can be modeled as fractals or multifractals. Hydrothermal processes in the Earth’s crust can result in ore deposits characterized by high concentrations of metals with fractal or multifractal properties. Here we show that the non-linear properties of the end products of singular mineralization processes can be applied for prediction of undiscovered mineral deposits and for quantitative mineral resource assessment, whether for mineral exploration or for regional, national and global planning for mineral resource utilization. In addition to the general theory and framework for the non-linear mineral resources assessment, this paper focuses on several power-law models proposed for characterizing non-linear properties of mineralization and for geoinformation extraction and integration. The theories, methods, and computer system discussed in this paper were validated using a case study dealing with hydrothermal Au mineral potential in southern Nova Scotia, Canada.     

淄博市洪山、寨里煤矿地下水串层污染形成原因及防治

淄博市洪山、寨里煤矿区隐伏的奥陶系灰岩裂隙岩溶水污染严重。水质污染突发于矿坑全面闭坑以后，污染范围与矿坑水区一致，地下水污染组份与矿坑水的高含量组份相同。水质恶化主要由矿坑水串层污染所致。在此针对串层污染形成原因及影响因素，提出了防治对策。     

GGM02 – An improved Earth gravity field model from GRACE

A new generation of Earth gravity field models called GGM02 are derived using approximately 14 months of data spanning from April 2002 to December 2003 from the Gravity Recovery And Climate Experiment (GRACE). Relative to the preceding generation, GGM01, there have been improvements to the data products, the gravity estimation methods and the background models. Based on the calibrated covariances, GGM02 (both the GRACE-only model GGM02S and the combination model GGM02C) represents an improvement greater than a factor of two over the previous GGM01 models. Error estimates indicate a cumulative error less than 1 cm geoid height to spherical harmonic degree 70, which can be said to have met the GRACE minimum mission goals. Electronic Supplementary Material Supplementary material is available in the online version of this article at     

Near-Wall Flow Development After A Step Change In Surface Roughness

An experimental study of the initial flow field downstream of a step change in surface roughness is presented. The roughness length of the downstream surface was approximately tenfold that of the upstream roughness and, unlike all previous studies, attention was concentrated on the roughness sublayer region beneath the inertial (log-law) region. The experiments were conducted at a boundary layer Reynolds number of about 6 × 10⁴ (based on layer thickness andfree-stream velocity) and around a longitudinal location where the (downstream) roughness length, z_o2, was about 1% of the boundary-layer thickness atthe roughness change point.The thickness of the roughness sublayer was found for the two roughness. It was observed that the vertical profiles of mean velocity and turbulence characteristics started to show similarity after about 160z₀₂ downstream of the roughness change. The presence of a shear stress overshoot is shown to depend strongly on the precise location (with respect to the roughness elements) at which the measurements are made and the thickness of the equilibrium layer is shown to be very sensitive to the way it is defined. It is demonstrated that the growing equilibrium layer has first to encompass the roughness sublayer before any thickness of inertial sublayer can be developed. It follows that, in somepractical cases, like flows across some urban environments, the latter(log-law) region may never exist at all.     

Parameter identification of inelastic structures under dynamic loads

The generalized model of differential hysteresis contains 13 control parameters with which it can curve‐fit practically any hysteretic trace. Three identification algorithms are developed to estimate the control parameters of hysteresis for different classes of inelastic structures. These algorithms are based upon the simplex, extended Kalman filter, and generalized reduced gradient methods. Novel techniques such as global search and internal constraints are incorporated to facilitate convergence and stability. Effectiveness of the devised algorithms is demonstrated through simulations of two inelastic systems with both pinching and degradation characteristics in their hysteretic traces. Owing to very modest computing requirements, these identification algorithms may become acceptable as a design tool for mapping the hysteretic traces of inelastic structures. Copyright © 2002 John Wiley & Sons, Ltd.