Impact Compressive Creep Characteristics of Simulative Soil for Deep-Sea Sediment

The impact load (equivalent impact height) applied to deep-sea sediment by a walking mining machine was first deduced by the energy conservation principle, and the simulative soil was prepared based on the deep-sea sediment collected from the Pacific C-C mining area. The self-designed impact compressive creep tests of the simulative soil were conducted under different ground stresses and impact heights, in order to determine impact compressive creep parameters using a K-H rheological model. Test results show that the impact compressive creep curves have three similar creep stages (transient creep, unstable creep, and stable creep) to static compressive creep curves, where the transient creep deformation and total deformation at the unstable creep stage decrease with the impact load. Among the three impact compressive creep parameters (K₁, K₂, β) of the simulative soil, K₁ is first increased with impact height and finally fluctuated to a certain stable value, while K₂ and β are approximately linearly increased with impact height. The maximum subsidence of the mining machine under a specific designed ground stress and walking velocity predicted by the impact compressive creep constitutive equation can be used for safety assessment of the mining machine.     

Aerodynamic Parameters of a UK City Derived from Morphological Data

Detailed three-dimensional building data and a morphometric model are used to estimate the aerodynamic roughness length z ₀ and displacement height d over a major UK city (Leeds). Firstly, using an adaptive grid, the city is divided into neighbourhood regions that are each of a relatively consistent geometry throughout. Secondly, for each neighbourhood, a number of geometric parameters are calculated. Finally, these are used as input into a morphometric model that considers the influence of height variability to predict aerodynamic roughness length and displacement height. Predictions are compared with estimations made using standard tables of aerodynamic parameters. The comparison suggests that the accuracy of plan-area-density based tables is likely to be limited, and that height-based tables of aerodynamic parameters may be more accurate for UK cities. The displacement heights in the standard tables are shown to be lower than the current predictions. The importance of geometric details in determining z ₀ and d is then explored. Height variability is observed to greatly increase the predicted values. However, building footprint shape only has a significant influence upon the predictions when height variability is not considered. Finally, we develop simple relations to quantify the influence of height variation upon predicted z ₀ and d via the standard deviation of building heights. The difference in these predictions compared to the more complex approach highlights the importance of considering the specific shape of the building-height distributions. Collectively, these results suggest that to accurately predict aerodynamic parameters of real urban areas, height variability must be considered in detail, but it may be acceptable to make simple assumptions about building layout and footprint shape.     

中国对虾(Penaeus chinensis)幼体血液循环的活体观察

溞对中国对虾早期幼体的循环系统及血液流向进行了活体观察 ,描述了中国对虾早期幼体发育阶段中幼体循环系统血管的走向与分布、血液的流向及循环路径等 ,比较各期幼体循环系统的形态 ,并探讨对虾早期幼体循环系统的发育过程。     

Calculation and analysis of negative skin of monopile applied for offshore wind turbine

Monopiles are considered to be as a kind of viable foundation types for offshore wind turbines. The effect of negative skin friction on pile foundation is always an important problem. There are very important theoretical and practical significance to study the distribution law of negative skin friction and the calculation method. Based on the special stratum, the stress and strain of the monopile and soil are simplified, and the improved Kezdi’s double-broken-line model is adopted. The analytical solution of negative skin friction of monopile is deduced according to the degree of skin friction. An engineering case was analyzed by the method, and the calculated results agree well with the measured data. The calculation method proposed can accurately describe the range of the monopile skin frictional distribution and the position of the neutral point, and it is simple and convenient to calculate, that is also a feasible method for calculating the negative skin friction of monopile of offshore wind turbines in practical engineering.     

On dynamic coupling effects between a spar and its mooring lines

The responses of a spar constrained by slack mooring lines to steep ocean waves and tensions in the mooring lines are simulated using two different numerical schemes: a quasi-static approach (SMACOS) and a coupled dynamic approach (COUPLE). The two approaches are the same in computing wave loads on the structure. Their difference is in modeling dynamic forces of mooring lines; that is the dynamic forces are included in the computation of COUPLE but neglected in SMACOS. The numerical simulation is examined against the laboratory measurements of the JIP Spar in a water depth of 318 m. The dynamic coupling effects between the JIP Spar and its mooring lines in different water depths (318, 618 and 1018 m) are investigated by the comparison of numerical simulations obtained using the quasi-static and coupled dynamic approaches. It is found that the damping of mooring lines reduces the slow-drift surge and pitch of the Spar, especially in deep water. The reduction in the amplitude of slow-drift surge can reach about 10% in a water depth of 1018 m. The tension in mooring lines may greatly increase in the wave frequency range when dynamic forces in mooring lines are considered. The mooring-line tension in the wave frequency range predicted by the coupled dynamic approach can be eight times as great as the corresponding prediction by the quasi-static approach in a water depth of 1018 m. This finding may have important implications for the estimation of the fatigue strength and life span of the mooring lines deployed in deep water oceans.     

济州岛南部海区的双跃层现象

本文分析了济州岛南部区域温度双跃层现象的类型及其成因。特别阐明了双跃层的波状现象,指出:强流锋区的侧向效应,黑潮次—中层混合水的爬升,黄海冷水团边缘密度环流引起的侧向流动,以及上、下层流速、流向不一致引起的剪切作用,是导致双跃层波状现象的主要原因。发现上、下跃层之间存在着“跃层间环流”,这是一个有趣的海洋学现象,它将导致双扩散的发生和有利于双跃层的维持。     

利用GPS拖体在万山区域测量平均海面技术研究

Wanshan area has been chosen to be the specified field to calibrate and validate(Cal/Val) the HY-2 altimeter and its follow-on satellites. In March 2018, an experiment has been conducted to determine the sea surface height(SSH) under the HY-2 A ground track(Pass No. 203). A GPS towing-body(GPS-TB) was designed to measure the SSH covering an area of about 6 km×28 km wide centered on the HY-2 A altimeter satellite ground track. Three GPS reference stations, one tide gauge and a GPS buoy were placed in the research area, in order to process and resolve the kinematic solution and check the precision of the GPS-TB respectively. All the GPS data were calculated by the GAMIT/GLOBK software and TRACK module. The sea surface was determined by the GPS-TB solution and the tide gauge placed on Zhiwan Island. Then the sea surface of this area was interpolated by Arc GIS10.2 with ordinary Kriging method. The results showed that the precision of the GPS-TB is about 1.10 cm compared with the tide gauge placed nearby, which has an equivalent precision with the GPS buoy. The interpolated sea surface has a bias of –1.5–4.0 cm with standard deviation of 0.2–2.4 cm compared with the checking line. The gradient of the measured sea surface is about 1.62 cm/km along the HY-2 orbit which shows a good agreement compared with the CLS11 mean sea surface(MSS). In the Cal/Val of satellites, the sea surface between the tide gauge/GPS buoy and the footprint of altimeter can be improved by this work.     

Sea surface height anomaly and geostrophic circulation variations in the South China Sea from TOPEX/POSEIDON altimetry

The sea surface height anomaly (SSHA) and geostrophic circulation in the South ChinaSea (SCS) are studied using TOPEX/POSE1DON (T/P) altimetry data. The SSHA, which is obtained after tidal correction based on the tidal results from T/P data, is predominated by seasonal alternating monsoons. The results reveal that the SSHA in the central part of the SCS is positive in spring and summer, but negative in autumn and winter. It is also found that the SSHA in the SCS can be approached with the sum of tidal constituents SA and SSA. The geostrophic circulations in the SCS are calculated according to sea surface dynamic topography, which is the sum of SSHA and mean sea surface height. It is suggested that the circulation in the upper layer of the SCS is generally cyclonic and notably western intensified during autumn and winter, while the western intensification is weak during spring and summer. It is also indicated that the Kuroshio intrudes into the northeastern SCS throuth the Luzon Strait in winter. But ther     

环渤海湾海洋资源环境承载力定量研究

环渤海湾地区经济发展迅速但开发利用过度,生态问题突出。本文以社会环境学理论、系统论、可持续发展理论等为基础,建立了环渤海湾海洋资源环境承载力评价指标体系,利用单项评价法,以地级市为基本单位对环渤海湾地区的海洋资源环境承载力进行评价。结果表明滨州市的海洋资源环境承载力较好,其次为唐山市和天津市,沧州市的海洋资源环境承载力较弱。