The study of intermittent hydrophysical fields in the vicinity of the frontal zone

CTD data provided by the MGI-4204 and MARK-III probes are used to study the quasistationary subpolar front structure in the north-western Sea of Japan. In order to provide further insights into the intermittent scalar hydrophysical fields, the method of inhomogeneity identification using temperature pulsations calculated by the moving interval is suggested. The experimentally-derived inhomogeneity distribution is satisfactorily approximated by the exponential law.Translated by V. Puchkin.     

Vertical distribution and water solubility of phosphorus and heavy metals in sediments of the St. Lucie Estuary, South Florida, USA

Accumulation and distribution of heavy metals and phosphorus in sediments impact water quality. There has been an increasing concern regarding fish health in the St. Lucie Estuary, which is related to increased inputs of nutrients and metals in recent decades. To investigate vertical changes of contaminants (P, Cd, Cr, Co, Cu, Ni, Pb, Zn, and Mn) in sediments of the St. Lucie Estuary in South Florida, 117 layer samples from six of the 210 to 420 cm depth cores were analyzed for their total and water-soluble P and heavy metals, clay, total Fe, Al, K, Ca, Mg, Na, and pH. Principal component analysis (PCA) was used in two sets of analytical data (total and water-soluble contaminant concentrations) to document changes of contaminants in each core of sediments. The PCA of total contaminants and minerals resulted in two factors (principal components). The first and second factors accounted for 61.7 and 17.2 % of the total variation in all variables, and contrast indicators associated with contaminants of P, Cd, Co, Cr, Ni, Pb, Zn, and Mn and accumulation of Fe and Al oxides, respectively. The first factor could be used for overall assessment of P and heavy metal contamination, and was higher in the upper 45–90 cm than the lower depths of each core. The concentrations of P and heavy metals in the surface layers of sediments significantly increased, as compared with those in the sediments deeper than 45–90 cm. The PCA of water-soluble contaminants developed two factors. The second factor (Cu–P) was higher in the upper than the lower depths of the sediment, whereas the highest score of the first factor (Cd–Co–Cr–Ni–Pb–Zn–Mn) occurred below 100 cm. The water-soluble Cu and P concentrations were mainly dependent on their total concentrations in the sediments, whereas the water-soluble Cd, Co, Cr, Ni, Pb, Zn, and Mn concentrations were mainly controlled by pH.     

Magma-hydrothermal system interaction inferred from volcanic gas measurements obtained during 2003–2008 at Meakandake volcano,Hokkaido, Japan

Phreatic eruptions occurred at the Meakandake volcano in 1988, 1996, 1998, 2006, and 2008. We conducted geochemical surveillance that included measurements of temperature, SO₂ emission rates, and volcanic gas composition from 2003 to 2008 at the Nakamachineshiri (NM), Northwest (NW), and Akanuma (AK) fumarolic areas, and the 96–1 vent, where historical eruptions had occurred. The elemental compositions of the gases discharged from the different areas are similar compared with the large variations observed in volcanic gases discharged from subduction zones. All the gases showed high apparent equilibrium temperatures, suggesting that all these gases originated from a common magmatic gas. The gases discharged from each area also exhibited different characteristics, which are probably the results of differences in the conditions of meteoric water mixing, quenching of chemical reactions, and vapor-liquid separation. The highest apparent equilibrium temperatures (about 500°C) were observed in the case of NW fumarolic gases, despite the low outlet temperature of about 100°C at these fumaroles. Since the NW fumaroles were formed as a result of the 2006 phreatic eruption, the high-temperature gas supply to the NW fumarole suggests that the phreatic eruption was caused by the ascent of high-temperature magmatic gases. The temperatures, compositions, and emission rates of the NM and 96–1 gases did not show any appreciable change after the 2006 eruption, indicating that each fumarolic system had a separate magmatic-hydrothermal system. The temperatures, compositions, and emission rates of the NM fumarolic gases were apparently constant, and these fumaroles are inferred to be formed by the evaporation of a hydrothermal system with a constant temperature of about 300°C. The 96–1 gas compositions showed large changes during continuous temperature decrease from 390° to 190°C occurred from 2003 to 2008, but the sulfur gas emission rates were almost constant at about four tons/day. At the 96–1 vent, the SO₂/H₂S ratio decreased, while the H₂/H₂O ratio remained almost constant; this was probably caused by the rock-buffer controlled chemical reaction during the temperature decrease.     

Late Cambrian microbial build-ups,Llano Area,Central Texas: A three-phase morphological evolution

Although Late Cambrian microbial build-ups were recognized in the Point Peak Member of the Wilberns Formation in Central Texas (USA) nearly 70 years ago, only a few studies focused specifically on the build-ups themselves. This study focuses on the interpretation of the regional (15 measured sections described in literature representing an area of 8000 km²) and local (field and drone photogrammetry studies in a 25 km² area from within south Mason County) microbial build-up occurrence, describes their growth phases and details their interactions with the surrounding inter-build-up sediments. The study establishes the occurrence of microbial build-ups in the lower and upper Point Peak members (the Point Peak Member is informally broken up into the lower Point Peak and the upper Point Peak members separated by Plectotrophia zone). The lower Point Peak Member consists of three <1 m thick microbial bioherms and biostrome units, in addition to heterolithic and skeletal/ooid grainstone and packstone beds. One, up to 14 m thick, microbial unit associated with inter-build-up skeletal and ooid grainstone and packstone beds, intercalated with mixed siliciclastic–carbonate silt beds, characterizes the upper Point Peak member. The microbial unit in the upper Point Peak member displays a three-phase growth evolution, from an initial colonization phase on flat based, rip-up clast lenses, to a second aggradation and lateral expansion phase, into a third well-defined capping phase. The ultimate demise of the microbial build-ups is interpreted to have been triggered by an increase of water turbidity caused by a sudden influx of fine siliciclastics. The lower Point Peak member represents inner ramp shallow subtidal and intertidal facies and the upper Point Peak member corresponds to mid-outer ramp subtidal facies. Understanding the morphological architecture and depositional context of these features is of importance for identifying signatures of early life on Earth.     

Premelting and calcium mobility in gehlenite (Ca2Al2SiO7) and pseudowollastonite (CaSiO3)

 Premelting effects in gehlenite (Ca₂Al₂SiO₇) have been studied by Raman spectroscopy and calorimetry, and in gehlenite and pseudowollastonite (CaSiO₃) by electrical conductivity. The enthalpy of premelting of gehlenite is 17.3 kJ mol⁻¹ and represents 9% of the reported enthalpy of fusion, which is in the range of the reported fraction of other minerals. The Raman and electrical conductivity experiments at high temperatures, for gehlenite and pseudowollastonite, show that the premelting effects of both compositions are associated with enhanced dynamics of calcium atoms near the melting point. This conclusion agrees with the results obtained for other minerals like diopside, but contrasts with those found for sodium metasilicate in which the weaker bonding of sodium allows the silicate framework to distort near the melting temperature and deform in such a way to prefigure the silicate entities present in the melt. Received: 30 April 2002 / Accepted: 7 August 2002 Acknowledgements We thank Y. Linard for help with DSC measurements and two anonymous reviewers for their constructive comments. This work has been partly supported by the EU Marie-Curie fellowship contract no. HPMF-CT-1999-00329, the CNRS-Carnegie Institution of Washington program PICS no.192, and the NSF grants EAR-9614432 and EAR-9901886 to B.O.M.     

Late Devensian environments in the Vale of Mowbray, North Yorkshire, UK: evidence from palynology

Two radiocarbon-dated Lateglacial pollen diagrams from the Vale of Mowbray (northern Vale of York) are presented from sites in the lowlands between the washlands courses of the rivers Swale and Ure in North Yorkshire, an area with little previous palynological research despite its proximity to the Devensian glacial advance limits in eastern England. The profiles, from Snape Mires and Nosterfield, include the Loch Lomond Stadial (Younger Dryas) and the Holocene transition, while that from Snape Mires also includes the period from the early part of the Lateglacial Interstadial. This profile differs from most published Interstadial diagrams from the Yorkshire region in having a long-delayed expansion of tree and shrub taxa. Juniperus (juniper) remains important after vegetation development takes place and the pollen record includes evidence of two cold climate oscillations before the maximum development of Betula (birch) woodland near the end of the Lateglacial Interstadial. At both profiles Artemisia (mugwort) frequencies are lower during the Loch Lomond Stadial than at many regional sites, probably due to edaphic factors in these lowland locations. The two sites provide valuable environmental data that enable comparison between the more wooded Lateglacial vegetation to the south in the Vale of York and Humberside and the more open contemporaneous vegetation to the north in the Durham and Northumberland lowlands.     

Report of the International Astronomical Union Division I Working Group on Precession and the Ecliptic

The IAU Working Group on Precession and the Equinox looked at several solutions for replacing the precession part of the IAU 2000A precession–nutation model, which is not consistent with dynamical theory. These comparisons show that the (Capitaine et al., Astron. Astrophys., 412, 2003a) precession theory, P03, is both consistent with dynamical theory and the solution most compatible with the IAU 2000A nutation model. Thus, the working group recommends the adoption of the P03 precession theory for use with the IAU 2000A nutation. The two greatest sources of uncertainty in the precession theory are the rate of change of the Earth’s dynamical flattening, ΔJ₂, and the precession rates (i.e. the constants of integration used in deriving the precession). The combined uncertainties limit the accuracy in the precession theory to approximately 2 mas cent⁻². Given that there are difficulties with the traditional angles used to parameterize the precession, z_A, ζ_A, and θ_A, the working group has decided that the choice of parameters should be left to the user. We provide a consistent set of parameters that may be used with either the traditional rotation matrix, or those rotation matrices described in (Capitaine et al., Astron. Astrophys., 412, 2003a) and (Fukushima Astron. J., 126, 2003). We recommend that the ecliptic pole be explicitly defined by the mean orbital angular momentum vector of the Earth–Moon barycenter in the Barycentric Celestial Reference System (BCRS), and explicitly state that this definition is being used to avoid confusion with previous definitions of the ecliptic. Finally, we recommend that the terms precession of the equator and precession of the ecliptic replace the terms lunisolar precession and planetary precession, respectively.     

Dynamical studies of cluster pairs in the Magellanic Clouds

We performed N -body simulations of star cluster encounters with Hernquist's TREECODE in a CRAY YMP-2E computer under different initial conditions (relative positions and velocities, cluster sizes, masses and concentration degrees). The total number of particles per simulation ranged from 1024 to 20480. These models are compared with a series of isodensity maps of cluster pairs in the Magellanic Clouds. Evidence is found that during the interactions, transient morphological effects such as an expanded halo, isophotal deformation and isophotal twisting can occur as a result of tidal effects and dynamical friction. The simulations also show that different outcomes are possible depending on the initial parameters: (i) long-standing changes of concentration degree can occur after the collision; (ii) one member can disaggregate; or (iii) the pair can coalesce into a single cluster with a distinct structure compared with the original ones. These simulations can reproduce a wide range of morphological structures in observed cluster pairs.