Enhanced orbit determination for BeiDou satellites with FengYun-3C onboard GNSS data

GPS Solutions - A key limitation for precise orbit determination of BeiDou satellites, particularly for satellites in geostationary orbit (GEO), is the relative weak geometry of ground stations....     

Lookback time as a test for f(R) gravity in the Palatini approach

We use the recently released data of lookback time (LT)-redshift relation, the cosmic microwave background shift parameter and the baryon acoustic oscillation measurements to constrain cosmological parameters of f (R) gravity in the Palatini formalism by considering the f (R) form of type (a) f (R) = R β/Rn and (b) f (R) = R + α ln R β. Under the assumption of a Friedmann-Robertson-Walker universe, we achieved the best fitting results of the free parameters (Ωm0, n) for (a) and (Ωm0, α) for (b). We find tha...     

An enhanced approach for surface flow routing over drainage‐constrained triangulated irregular networks

The accuracy and efficiency of the simulations in distributed hydrological models must depend on the proper estimation of flow directions and paths. Numerous studies have been carried out to delineate the drainage patterns based on gridded digital elevation models (DEMs). The triangulated irregular network (TIN) has been increasingly applied in hydrological applications due to the advantages of high storage efficiency and multi‐scale adaptive performance. Much of the previous literature focuses mainly on filling the depressions on gridded DEMs rather than treating the special cases in TIN structures, which has hampered its applications to hydrological models. This study proposes a triangulation‐based solution for the removal of flat areas and pits to enhance the simulation of flow routing on triangulated facet networks. Based on the drainage‐constrained TIN generated from only a gridded DEM by the compound point extraction (CPE) method, the inconsistent situations including flat triangles, V‐shape flat edges and sink nodes are respectively identified and rectified. The optimization algorithm is an iterative process of TIN reconstruction, in which the flat areas are generalized into their center points and the pits are rectified by embedding break lines. To verify the proposed algorithm and investigate the potential for flow routing, flow paths of steepest descent are derived by the vector‐based tracking algorithm based on the optimized TIN. A case study of TIN optimization and flow path tracking was performed on a real‐world DEM. The outcomes indicate that the proposed approach can effectively solve the problem of inconsistencies without a significant loss in accuracy of the terrain model.     

Mapping hourly dynamics of urban population using trajectories reconstructed from mobile phone records

Understanding the spatiotemporal dynamics of urban population is crucial for addressing a wide range of urban planning and management issues. Aggregated geospatial big data have been widely used to quantitatively estimate population distribution at fine spatial scales over a given time period. However, it is still a challenge to estimate population density at a fine temporal resolution over a large geographical space, mainly due to the temporal asynchrony of population movement and the challenges to acquiring a complete individual movement record. In this article, we propose a method to estimate hourly population density by examining the time‐series individual trajectories, which were reconstructed from call detail records using BP neural networks. We first used BP neural networks to predict the positions of mobile phone users at an hourly interval and then estimated the hourly population density using log‐linear regression at the cell tower level. The estimated population density is linearly correlated with population census data at the sub‐district level. Trajectory clustering results show five distinct diurnal dynamic patterns of population movement in the study area, revealing spatially explicit characteristics of the diurnal commuting flows, though the driving forces of the flows need further investigation.     

Sea-Level Change Over the China Sea and Its Vicinity Derived from 25-Year T/P Series Altimeter Data

The characteristics of sea-level change in the China Sea and its vicinity are studied by combining TOPEX/Poseidon (T/P), Jason-1, Jason-2, and Jason-3 altimeter data. First, the sea-surface height is computed by using monthly data via collinear adjustment, regional selection, and crossover adjustment. The sea-level anomaly (SLA) from October 1992 to July 2017 is calculated based on the difference that is obtained by the value derived from the inverse distance weighting method to interpolate the CNES_CLS15 model value at a normal point. By analyzing the satellite data at the same time in orbit, three mean bias groups over the China Sea and its vicinity are obtained: the difference between T/P and Jason-1 is ??11.76 cm, the difference between Jason-1 and Jason-2 is 9.6 cm, and the difference between Jason-2 and Jason-3 is 2.42 cm. To establish an SLA series for 25 years in the study area, the SLAs are corrected. Mean rate of sea-level rise of the Bohai Sea, Yellow Sea, East China Sea, and South China Sea of 4.87 mm/a, 2.68 mm/a, 2.88 mm/a, and 4.67 mm/a, respectively, is found by analyzing the series of SLAs.     

Weak GPS signal tracking using FFT discriminator in open loop receiver

An open loop tracking architecture, which tracks GPS signals under weak and challenging conditions, is analyzed. The in-phase and quadrature-phase integration pair is regarded as a single tone complex signal. An FFT-based method is used as a frequency discriminator to estimate the Doppler frequency residual of the single tone signal. Another FFT-based method applies complex squaring to eliminate the effect of the navigation data bits polarities. The performance of the FFT-based discriminators is assessed in three criteria. Those criteria are the signal strength and dynamic range that can be tracked and the accuracy of the estimated Doppler frequency. In addition, the performance of the discriminators is analyzed to provide the theoretical and simulated peak detection probability. The results indicate that the FFT discriminator can track signals about 5 dB weaker than the signals that can be tracked by the complex squared FFT discriminator. In a quasi-static environment, the Doppler frequency residual can be assumed to be around zero, which can enable the FFT-based discriminators to track signals with approximately 2 dB less power. Moreover, the performance of the FFT-based discriminators is compared with the performance of two other frequency discriminators, namely the fast–slow and power-based. The comparison results indicate that these two frequency discriminators give higher frequency estimation accuracy, but they have a narrower dynamic range.     

An Immune Genetic Algorithm to Buildings Displacement in Cartographic Generalization

Spatial conflicts may occur when map data are displayed at a scale smaller than that of the source map. This study applies the displacement operator in cartographic generalization to resolve such spatial conflicts and to improve the clarity and legibility of map. The immune genetic algorithm (IGA) is used in this study for buildings displacement to solve conflicts. IGA is based on the genetic algorithm (GA) and employs the self‐adjusting mechanism of antibody concentration to enhance population diversity. Meanwhile, the elitism retention strategy is adopted in IGA to guarantee that the best individual (antibody) is not lost and destroyed in the next generation to strengthen convergence efficiency. The compared experiment between IGA and GA shows that the displacement result produced by IGA performs better than GA. Finally, in order to make the displaced map more attractive to cartographers, two constraints – the building alignment constraint and building tangent relation constraint – are applied in IGA to restrict the buildings’ displacement. The same experimental data are adopted to prove that the improved IGA is useful for maintaining the two constraints.     

Fourier-based multi-scale representation and progressive transmission of cartographic curves on the internet

ABSTRACT

Automatic generation of multi-scale representations from the same spatial data source has been the research focus in map generalization for a long time. Based on the Fourier technique, this paper proposes a continuous, multi-scale representation model for progressive transformation of cartographic curves on the Internet. In our method, all the curves, whether closed or open, are depicted as periodical functions which are further expressed as Fourier series. The convergence degrees of the Fourier series are explored for different kinds of curves, and truncating frequencies are derived based on the similarity between the original and reconstructed curves. Using information theory and the Radical Law in cartography, the relationship between map scales and Fourier frequencies is established. Based on the proposed multi-scale model, we also introduce the principles and implementation of a progressive transmission method. Our method is evaluated using the contours from a topographic map. The results show that our model is a valid approach to multi-scale representation of cartographic curves.     

Enhanced fault detection and exclusion based on Kalman filter with colored measurement noise and application to RTK

GPS Solutions - The tropospheric delay is an important error source in the Global Positioning System (GPS) positioning and navigation applications. Although most of the tropospheric delays can be...