The experimental studies on electrical con-ductivities and P-wave velocities of anortho-site at high pressure and high temperature

Introduction The measurements of the compressional wave velocity and electrical conductivity of minerals and rocks are of fundamental importance to look into the earths interior, including composition, geotherm, generation and distribution of fluids and melts. Hydrous minerals formed by metamatu-siom are abundant within the earth. Previous studies have been carried out on the dehydration effect on the electrical conductivity and wave velocity of rocks such as serpentine, amphibole, most of whi…     

Seismic structural control using semi-active tuned mass dampers

This paper focuses on how to determine the instantaneous damping of the semi-active tuned mass damper (SATMD) with continuously variable damping. An off-and-towards-equilibrium (OTE) algorithm is employed to examine the control performance of the structure/SATMD system by considering the damping as an assumptive control action. The damping modification of the SATMD is carried out according to the proposed OTE algorithm, which is formulated based on analysis of the structural movement under external excitations, and the measured responses of the structure at every time instant. As examples two numerical simulations of a five-storey and a ten-storey shear structures with a SATMD on the roof are conducted. The effectiveness on vibration reduction of MDOF systems subjected to seismic excitations is discussed. Analysis results show that the behavior of the structure with a SATMD is significantly improved and the feasibility of applying the OTE algorithm to the structural control design of SATMD is also verified.     

A general model for estimating actual evaporation from non-saturated surfaces

Based on energy balance equation and mass transfer equation, a general model to estimate actual evaporation from non-saturated surfaces was derived. Making use of two concepts, “relative evaporation” and “relative drying power”, a relationship was established to account for the departure from saturated conditions. Using this model, the actual evaporation (evapotranspiration) can be calculated without the need of potential evaporation estimation. Furthermore, the model requires only a few meteorological parameters that are readily and routinely obtainable at standard weather stations. Based on nearly 30 years data of 432 meteorological stations and 512 hydrological stations in China, in combined with GIS, nine typical river basins were selected. Using the data of the selected river basins, the model was tested. The results show that the actual evaporation rate can be estimated with an error of less than 10% in most areas of China, except few years in the Yellow River Basin.     

Velocity profile of a sand cloud blowing over a gravel surface

Particle dynamic analyzer (PDA) measurement technology was used to study the turbulent characteristics and the variation with height of the mean horizontal (in the downwind direction) and vertical (in the upward direction) particle velocity of a sand cloud blowing over a gravel surface. The results show that the mean horizontal particle velocity of the cloud increases with height, while the mean vertical velocity decreases with height. The variation of the mean horizontal velocity with height is, to some extent, similar to the wind profile that increases logarithmically with height in the turbulent boundary layer. The variation of the mean vertical velocity with height is much more complex than that of the mean horizontal velocity. The increase of the resultant mean velocity with height can be expressed by a modified power function. Particle turbulence in the downwind direction decreases with height, while that in the vertical direction is complex. For fine sands (0.2–0.3 mm and 0.3–0.4 mm), there is a tendency for the particle turbulence to increase with height. In the very near-surface layer (<4 mm), the movement of blown sand particles is very complex due to the rebound of particles on the bed and the interparticle collisions in the air. Wind starts to accelerate particle movement about 4 mm from the surface. The initial rebound on the bed and the interparticle collisions in the air have a profound effect on particle movement below that height, where particle concentration is very high and wind velocity is very low.     

成都市农业区划与城市生态环境保护构想

扼要介绍了成都市区域土壤多目标地球化学调查的新近展，从地球化学和农业生态的角度论述了成都市农业区划发展构想，并探讨人工生态系统与城市生态环保建设的模式与构想建议。     

TDP-0844地震前兆数据综合采集器的研制

介绍了TDP—0844型地震前兆数据综合采集器采用的设计方案及工作原理，及各个功能模块的设计准则，并列出了采集器实现的功能。文章还给出了采集器的部分应用图例，证明该采集器能够满足地震前兆观测需要。     

Study of crustal structure with S—wave data from Maqen—Jingbian profile

2-D crustal velocity structure and vp/vs are obtained by processing and interpretation of S-wave data from Maqen-Jingbian deep seismic sounding(DSS)profile.The result shows that there exist obvious differences in 2-D S-wave velocity structure and vp/vs ratio structure along the profile.The S-wave velocities are low and vp/vs ration is high for the westem section of the profile and Haiyuan region,while they are normal for the middle and eastern sections.The changes in lithologic characters of two major anomalous zones are discussed according to lateral variation of S-wave velocity structure and vp/vs ratio structure.It is concluded that the development and occurrence of the Haiyuan strong earthquake is not only related to tectonic activities,but also to lithologic characters of the region.     

Principle and mathematical method for inverting stress State of a medium from the remote sensing data

It has been proved through experiments that the electromagnetic radiation energy of a substance will vary when stress acts on the substance. This moment, the electromagnetic radiation energy (observation value) received by the remote sensor is triggered not only by the substance temperature and also by the stress. Separating quantitatively these two kinds of electromagnetic radiation energy and then inversing the actual temperature state and stress state of a medium is a matter with practical significance in earthquake prediction and stability monitoring for the large-scale geotechnical engineering. In this paper the principle and the mathematical method for inversing stress by using multiband remote sensing data are discussed in detail. A calculation example is listed.     

Optimum multiple tuned mass dampers for structures under the ground acceleration based on the uniform distribution of system parameters

The five MTMD models, with natural frequencies being uniformly distributed around their mean frequency, have been recently presented by the first author. They are shown to have the near‐zero optimum average damping ratio (more precisely, for a given mass ratio there is an upper limit on the total number, beyond which the near‐zero optimum average damping ratio occurs). In this paper, the eight new MTMD models (i.e. the UM‐MTMD1～UM‐MTMD3, US‐MTMD1～US‐MTMD3, UD‐MTMD1 and UD‐MTMD2), with the system parameters (mass, stiffness and damping coefficient) being, respectively, uniformly distributed around their average values, have been, for the first time here, proposed to seek for the MTMD models without the near‐zero optimum average damping ratio. The structure is represented by the mode‐generalized system corresponding to the specific vibration mode that needs to be controlled. Through minimization of the minimum values of the maximum dynamic magnification factors (DMF) of the structure with the eight MTMD models (i.e. through the implementation of Min.Min.Max.DMF), the optimum parameters and values of Min.Min.Max.DMF for these eight MTMD models are investigated to evaluate and compare their control performance. The optimum parameters include the optimum mass spacing, stiffness spacing, damping coefficient spacing, frequency spacing, average damping ratio and tuning frequency ratio. The six MTMD models without the near‐zero optimum average damping ratio (i.e. the UM‐MTMD1～UM‐MTMD3, US‐MTMD1, US‐MTMD2 and UD‐MTMD2) are found through extensive numerical analyses. Likewise, the optimum UM‐MTMD3 offers the higher effectiveness and robustness and requires the smaller damping with respect to the rest of the MTMD models in reducing the responses of structures subjected to earthquakes. Additionally, it is interesting to note, by comparing the optimum UM‐MTMD3 with the optimum MTMD‐1 recently investigated by the first author, that the effectiveness and robustness for the optimum UM‐MTMD3 is almost identical to that for the optimum MTMD‐1 (without inclusion of the optimum MTMD‐1 with the near‐zero optimum average damping ratio). Recognizing these performance benefits, it is preferable to employ the optimum UM‐MTMD3 or the optimum MTMD‐1 without the near‐zero optimum average damping ratio, when installing the MTMD for the suppression of undesirable oscillations of structures under earthquakes. Copyright © 2003 John Wiley & Sons, Ltd.