Groundwater flow systems in turbidites of the Northern Apennines (Italy): natural discharge and high speed railway tunnel drainage

Turbidites crop out extensively in the Northern Apennine mountains (Italy). The huge amounts of groundwater drained by tunnels, built for the high speed railway connection between Bologna and Florence, demonstrate the aquifer-like behaviour of these units, up to now considered as aquitards. A conceptual model of groundwater flow systems (GFS) in fractured aquifers of turbidites is proposed, taking into account both system natural state and the perturbation induced by tunnel drainage. Analysis of hydrological data (springs, streams and tunnel discharge), collected over 10 years, was integrated with analysis of hydrochemical and isotopic data and a stream-tunnel tracer test. Hydrologic recession analysis of undisturbed conditions is a key tool in studying turbiditic aquifer hydrogeology, permitting the discrimination of GFS, the estimation of recharge relative to the upstream reach portion and the identification of springs most vulnerable to tunnel drainage impacts. The groundwater budgeting analysis provides evidence that the natural aquifer discharge was stream-focused through GFS, developed downslope or connected to main extensional tectonic lineaments intersecting stream beds; now tunnels drain mainly active recharge groundwater and so cause a relevant stream baseflow deplenishment (approximately two-thirds of the natural value), possibly resulting in adverse effects on local ecosystems.     

The July 1974 solar events: A possible lower limit for microwave activity

The active region McMath 10433 was the source of several flares and radio outbursts during the early part of July 1974. This region was tracked continuously, for several periods during the month at 22.2 GHz using a telescope with a 4 beam. Comparison with the results obtained simultaneously with a normal 7 GHz solar patrol instrument indicate that there is important burst activity occurring at levels below the detection limit of normal solar patrol instruments. The time-development morphology of these bursts is similar to those normally observed and has enabled the simple events to be re-interpreted. A completely new type of event - the fast absorption - has also been recognized. The correlation of the microwave events with SPA events observed on VLF propagation is also discussed.Spending a sabbatical year at CRAAM, São Paulo, Brazil.     

Deformability characteristics of brazilian laterites

This paper summarizes the resilient and permanent deformation characteristics of laterite gravels, determined by cyclic loading in triaxial tests of compacted specimens. A study of laterite pavements was carried out on eight paved road sections in the state of Mato Grosso. Also reported is the influence of fine sand admixture, specimen size and soaking in two laterite samples from Roraima and Rondônia in the North of Brazil. The experimental relationships of resilient moduli against applied stresses are interpreted empirically for models what may be incorporated in a structural analysis of full depth of laterite pavement.     

Multiparametric Traveltime Inversion

In conventional seismic processing, the classical algorithm of Hubral and Krey is routinely applied to extract an initial macrovelocity model that consists of a stack of homogeneous layers bounded by curved interfaces. Input for the algorithm are identified primary reflections together with normal moveout (NMO) velocities, as derived from a previous velocity analysis conducted on common midpoint (CMP) data. This work presents a modified version of the Hubral and Krey algorithm that is designed to extend the original version in two ways, namely (a) it makes an advantageous use of previously obtained common-reflection-surface (CRS) attributes as its input and (b) it also allows for gradient layer velocities in depth. A new strategy to recover interfaces as optimized cubic splines is also proposed. Some synthetic examples are provided to illustrate and explain the implementation of the method.     

Bio-dependent bed parameters as a proxy tool for sediment stability in mixed habitat intertidal areas

The stability of cohesive and non-cohesive sediments in a mixed intertidal habitat within the Ria Formosa tidal lagoon, Portugal, was examined during two field campaigns as part of the EU F-ECTS project. The cohesive strength meter Mk III was used to determine critical erosion shear stress (τ_c) within a variety of different intertidal habitats and substrata, including Spartina maritima fields and Zostera noltii beds. The best predictor(s) for τ_c were derived from a range of properties measured for the surface sediments (chlorophyll a, colloidal carbohydrate, water, organic content, % fraction <63 μm, and seabed elevation). Pigment biomarkers were used to identify the dominant algal groups within the surface phytobenthic assemblage.Strong, seasonally dependent relationships were found between τ_c and habitat type, chl a, colloidal carbohydrate and bed elevation. Typically, critical erosion thresholds decreased seawards, reflecting a change from biostabilisation by cyanobacteria in the upper intertidal areas, to biostabilisation by diatoms on the bare substrata of the channel edges. In the late summer/early autumn, cyanobacteria were the main sediment stabilisers, and colloidal carbohydrate was the best bio-dependent predictor of τ_c across the entire field area. In the late winter/early spring, cyanobacterial activity was lower, and sediment stabilisation by Enteromorpha clathrata was important; the best predictor of τ_c was bed elevation. The implications and use of proxies for sediment stability are discussed in terms of feedback and sedimentation processes operating across the intertidal area.     

Tracing the flow of organic matter from primary producers to filter feeders in Ria Formosa lagoon, Southern Portugal

The flow of organic matter along the main navigation channel of Ria Formosa, Portugal, was assessed using determinations of suspended particulate matter (SPM), particulate organic matter (POM), and chlorophyll a (chla) concentrations in conjunction with stable isotope values of primary producers, particulate matter, and two filter feeders. SPM in the lagoon is dominated by inorganic particles comprising 80% of total weight with organic matter averaging about 20%. The algal component of the POM averaged about 5% with the remainder comprised of detritus. The δ¹³C values of primary producers ranged from ?9.1‰ in the intertidal seagrassZostera noltii to ?30.7‰ in the red seaweedBostrychia scorpioides revealing underlying differences in the mechanisms of carbon uptake. The δ¹³C value ofB. scorpioides, which develops entangled on the salt marsh speciesSpartina maritima, suggests that its main source of inorganic carbon is atmospheric CO₂. The δ¹³C values of the high marsh macrophyteSarcocornia perennis significantly increased with distance from the ocean while δ¹³C values ofZ. noltii decreased, probably because higher decomposition of organic matter at inner stations lowers the δ¹³CO₂ value in the water. The δ¹⁵N values of Ulvales, seagrasses, and marsh plants significantly increased from outer stations to inner stations. This increase may be due either to recycling of nitrogen (N) within the marsh (with loss of light N₂ or NH₄) or to inputs of isotopically heavy N from sewage. The δ¹⁵N values of particulate matter showed an opposite trend, which indicates higher microbial degradation of organic matter at the inner lagoon. The data demonstrate that the seston in the lagoon is a mixture of detritus from lagoon primary producers with a minor contribution of microalgae. The filter feeders are most likely assimilating a mixture of phytoplankton and microphytobenthos. Digestion of lagoon seston is selective. The δ¹⁵N values of both muscle and digestive gland of filter feeders showed the opposite gradient of particulate matter indicating that the depleted δ¹⁵N of SPM at inner stations was not assimilated or even ingested. Stable isotopes values did not differ between the filter-feeders—the musselMytilus galloprovincialis collected on buoys and the clamTapes decussatus collected in the sediment—suggesting a considerable mixture of benthic-pelagic organic matter throughout the water column. Assessment of the changes in isotopic decomposition of detritus as it decays is required to refine our understanding of organic matter transfers in detrital food webs.     

Greenhouse Gas Emissions from Hydroelectric Reservoirs in Tropical Regions

This paper discusses emissions by power-dams in the tropics. Greenhouse gas emissions from tropical power-dams are produced underwater through biomass decomposition by bacteria. The gases produced in these dams are mainly nitrogen, carbon dioxide and methane. A methodology was established for measuring greenhouse gases emitted by various power-dams in Brazil. Experimental measurements of gas emissions by dams were made to determine accurately their emissions of methane (CH₄) and carbon dioxide (CO₂) gases through bubbles formed on the lake bottom by decomposing organic matter, as well as rising up the lake gradient by molecular diffusion.The main source of gas in power-dams reservoirs is the bacterial decomposition (aerobic and anaerobic) of autochthonous and allochthonous organic matter that basically produces CO₂ and CH₄. The types and modes of gas production and release in the tropics are reviewed.     

The organisation of fish assemblages in the regulated Lima basin, Northern Portugal

In order to understand the structure of fish assemblages in the modified Lima basin (Northern Portugal), two distinct datasets concerning the presence and abundance of fish species were subjected to multivariate analysis. On the River Lima two types of flow modification are present within kilometres of one another: (a) a reduced and constant flow due to hypolimnetic release; and (b) an intense and irregular flow. A comparison of their influence on fish assemblages revealed a gradient of assemblage types from tributaries to main river sites. The latter were characterised by a strong dominance of cyprinids, particularly Iberian barbel (Barbus bocagei). The former harboured two kinds of fish assemblages: those closer to the river mouth were dominated by the cyprinids Iberian chub (Squalius carolitertii) and Iberian nase (Chondrostoma polylepis), which were also frequently present in the main river; while in those further upstream the predominant species was the brown trout (Salmo trutta). Although explanatory variables such as distance from source, altitude, substrate coarseness and width were the primary correlates of fish assemblage composition, dam construction and flow regulation also had a significant effect upon assemblage structure, particularly by: i) reducing the importance of migratory species; ii) constraining the presence of trout in the regulated segments; and iii) simplifying the community, especially in the case of the constant and reduced flow regime.     

Detection and 2d modelling of cavities using pole–dipole array

The resistivity method is often used in cave prospecting. In this paper the pole–dipole array ability to detect cavities at different depths and with different water contents is investigated. The research was performed using analogical and numerical modelling. According to the results, empty caves at a depth less than four times its diameter can be easily detected. The ability of the pole–dipole array to detect water-filled caves reaches a minimum at filling percentages of 30–50%. Overburden effects research shows that low resistivity overburden reduces the resolution capability of the array. This study shows that equivalent results can be obtained by modelling the empty caves as infinite resistivity bodies or, alternatively, as very high resistivity ones. The analysis of field data acquired in the Maciço Calcário Estremenho (Portugal) shows the practical importance of the pole–dipole array in cavities prospecting.     

An adaptive finite element model for wellbore breakout simulation

A finite element formulation is proposed and implemented for analysing the stability of excavated wells using the DiMaggio-Sandler constitutive elastoplastic model with a typical carbonate reservoir configuration. The quality of the finite element approximation is ensured by applying smooth curved elements adapted to the wellbore geometry, and h − p adaptive finite element meshes in the plastic zone. General purpose procedures are defined to transfer the elastoplastic deformation history to newly created integration points. A breakout damage criterion is proposed based on the second invariant of the deviatoric plastic deformation tensor. This damage criterion is used to apply a mesh movement algorithm to represent material collapse. The automatic successive application of the breakout damage criterion results in elliptical realistically looking geometries obtained in experiments reported in the literature.