Using inverse modeling and hierarchical cluster analysis for hydrochemical characterization of springs and Talkhab River in Tang-Bijar oilfield,Iran

Hierarchical cluster analysis (HCA) and inverse modeling (PH REdox EQuilibrium (in C language) (PHREEQC)) were simultaneously useful approaches in interpreting surface water hydrochemistry within Talkhab River in the Tang-Bijar oilfield, Iran, where large uncertainties exist in the understanding of the water quality system. Q-mode HCA applied to the data revealed three major surface water associations distinguished on the basis of the major causes of variation in the hydrochemistry. The three water groups were classified as upstream waters (group 1: Ca–SO₄), intermediate waters (group 2: Ca–SO₄–Cl), and downstream waters (group 3: Na–Cl). Geochemical reaction models were constructed using PHREEQC to establish the reactions associated with the different mineral phases through inverse modeling. The hydrochemical compositions of the water groups and the mass balance calculations indicate that the dominant processes and reactions responsible for the hydrochemical evolution in the system are (1) dissolution of evaporites, (2) precipitation of carbonate minerals, (3) silicate weathering reactions, (4) limited mixing with saline water, and (5) ion exchange.     

Hydrogeological assessment of the Tabarteh fault zone by physicochemical analysis and multivariate statistical methods

Hydrogeologically, faults may impede, conduit, exert no influence, or may play a combination of these roles on groundwater flow. The object of this paper is to study the hydrogeological role of the Tabarteh fault, which is located on the border of Zagros and Central Iran tectonic zones in an alluvial aquifer. The recorded data of water table levels, chemical parameters, and discharge rate of wells, in addition to geological maps and geophysical results, were collected and evaluated. The outcrop of travertine in limited areas and the emergence of a few small springs within the alluvium show a barrier role of the fault in the groundwater flow. The spatial analysis of chemical components, head time series, and groundwater flow direction assessment demonstrated that the fault acts as both a barrier and a non-barrier in different sections. The multivariate statistical methods of cluster and discriminant analyses also confirm the dual role of the fault.     

Three-dimensional supervirtual seismic refraction interferometry

Improved supervirtual interferometry (SVI) method that enhance the signal-to-noise ratio (SNR) of noisy seismic refraction data is presented. This 3D supervirtual algorithm is helpful in removal of side lobes caused by convolution in the conventional 3D SVI method. In this study, we extend the supervirtual seismic refraction interferometry method to 3D geometries commonly used in active seismic exploration. To achieve this objective, synthetic 3D seismic refraction data were created using single patch orthogonal geometry. Simple two-layers velocity model was used. A zero phase wavelet was convolved with the refraction travel time to create the seismic wiggle trace. The refraction arrival is computed using the equation for horizontal refractor case and is not adapted for dipping refractor. Noise of Gaussian distribution with zero mean and 0.25 standard deviation was added to simulate a case of moderate ambient noise. The supervirtual algorithm, consisting of crosscorrelation, alignment, summation, and first arrival calculation is performed. By aligning and summation of all the correlogram, the stationary position of source-receiver pairs as required in the 2D supervirtual method are eliminated in this case. Synthetic data presented in this study shows accurate first arrivals after the application of the 3D SVI and traces with much better SNR than the actual traces.