An Instantaneous-Frequency Filtering Technique for High-Frequency Radar Oceanography

High-frequency (HF) radar systems are remote sensing tools that can be used to measure oceanographic parameters. Problems can occur when using the conventional periodogram (PG) method for computing power spectral estimates from backscattered radar signals. Temporal and spatial inhomogeneities within the radar measurement region can cause distortion in the spectra. This paper describes an instantaneous-frequency (IF) filtering technique that has been developed to measure the first-order modulation contained within the radar signal. Successful removal of this modulation is shown to yield an increased quality and quantity of ocean measurements     

Nutrient (P, N) dynamics in the southwestern Kattegat, Scandinavia: sedimentation and resuspension effects

 The yearly nutrient supply from land and atmosphere to the study area in SW Kattegat is 10 900 tons of N and 365 tons of P. This is only few percent of the supply from adjacent marine areas, as the yearly transport through the study area is 218 000 tons of N and 18 250 tons of P. Yearly net deposition makes up 1340 tons of N (on average 2.5 g m^–2 yr^–1) and 477 ton of P (on average 0.9 g m^–2 yr^–1). Shallow-water parts of the study area have no net deposition because of frequent (>35% of the year) resuspension. Resuspension frequency in deep water is <1% of the year. Resuspension rates, as averages for the study area, are 10–17 times higher than net deposition rates. Because of resuspension, shallow-water sediments are coarse lag deposits with small amounts of organic matter (1.1%) and nutrients (0.04% N and 0.02% P). Deep-water sediments, in contrast, are fine grained with high levels of organic matter (11.7%) and nutrients (0.43% N and 0.15% P). Laboratory studies showed that resuspension changes the diffusive sediment water fluxes of nutrients, oxygen consumption, and penetration into the sediment. Fluxes of dissolved reactive phosphate from sediment to water after resuspension were negative in organic-rich sediments (13.2% organic matter) with low porosity (56) and close to zero in coarse sediments with a low organic matter content (2.3%) and high porosity (73). Fluxes of inorganic N after resuspension were reduced to 70% and 0–20% in relation to the rates before resuspension, respectively. Received: 10 July 1995 · Accepted: 19 January 1996     

A simulation tool for high data-rate acoustic communication in ashallow-water, time-varying channel

The paper discusses the development of a simulation tool to model high data-rate acoustic communication in shallow water. The simulation tool is able to generate synthetic time series of signals received at a transducer array after transmission across a shallow-water communication channel. The simulation tool is suitable for testing advanced signal processing techniques for message recovery. A channel model has been developed based on the physical aspects of the acoustic channel. Special emphasis has been given to fluctuations of the signal transmission caused by time-varying multipath effects. At shorter ranges, the temporal variations are dominated by acoustic scattering from the moving sea surface. Therefore, the channel model produces a coherence function which may be interpreted as a time-varying reflection coefficient for the surface scattered acoustical path. A static, range-independent ray model identifies the significant multipaths, and the surface path is modulated with the time-varying reflection coefficient. The advantages and limitations of the channel model are discussed and assumptions necessary to overcome the limitations are emphasised. Based on the assumptions, an algorithm has been developed and implemented to model how a binary message will be modulated when transmitted by a transducer, is distorted in the channel and finally is received by a transducer array     

OSCR wave measurements-some preliminary results

OSCR is an HF radar system that has been developed for high spatial resolution coastal surface current measurement. This paper describes preliminary results that demonstrate that wave measurement can be successfully obtained from suitably processed OSCR data. Comparisons with data from a WAVEC directional buoy are presented and show encouraging agreement. Some of the limitations to the measurement process are discussed and indicate a maximum range of about 20 km. Surface current variability on short time scales presents the most serious obstacle to wave measurement. This appears to be more of a problem when the mean currents are large, in that in these circumstances the data fail initial quality control criteria. However, in lower mean currents, the effect is often still present and leads to errors in long wave measurement     

Infiltration at the Tai rain forest (Ivory Coast): Measurements and modelling

Infiltration experiments have been performed at three sites along a well-known catena under virgin tropical rain forest using a portable sprinkling infiltrometer. Experimentally determined infiltration curves are presented. Infiltration curves are also simulated on the basis of the Mein-Larson equation. The parameters for this model have been obtained from the infiltration curves (saturated conductivity) and simple soil moisture determinations (fillable porosity). The agreement between experimentally determined and modelled infiltration is reasonable, provided (a) saturated conductivity as derived from the experimental data is corrected, (b) a storage parameter, also derived from the experimental data, is added to the Mein-Larson model, and (c) the decline in soil porosity with depth is either small or occurs abruptly at shallow depth. Comparison of observed infiltration rates with rainfall intensity shows that Horton Overland Flow has to occur naturally at least on the middle and lower section of the catena. Despite the fact that most parameters can be estimated in principle from basic soil data, it remains advisable to obtain sprinkling infiltrometer field measurements, because of soil variability due to dynamic surface conditions, macroporosity, air entrapment, and irregularity of the wetting front.     

Composition of brines in halite‐hosted fluid inclusions in the Upper Ordovician,Canning Basin,Western Australia: new data on seawater chemistry

Analyses of primary and early diagenetic fluid inclusions in the halite from the Late Ordovician Mallowa Salt, Canning Basin, Western Australia indicate a Ca‐rich composition and high concentration of parent brines in the basin which were close to sylvite and carnallite precipitation. The salt‐bearing series in the sampled interval was overheated up to 62 °C. The recorded differences in gas compositions result from the input of several gas sources including dispersed organic matter in the salt series and hydrocarbon deposits in the underlying rocks. The high concentration of the brines in fluid inclusions does not allow quantitative reconstruction of the chemical composition of Late Ordovician parent seawater. Using the information from Early Cambrian and Late Silurian basins as a proxy, however, the new data indicate that Late Ordovician seawater was undoubtedly Ca‐rich and, in comparison with modern seawater, had a similar K content, considerably lower Mg content (c. 30%), approximately three times the Ca content and one‐third the SO₄ content.     

Radon variations in a Hungarian village

 A steady radon exhalation is assumed in most publications. In a village of North-East Hungary, however, high radon concentrations have been measured, differing strongly in neighbouring houses and varying in time, due to the interplay of geochemical phenomena. Received: 20 November 1995 · Accepted: 18 June 1996