Past environmental change and seawater intrusion into coastal Lake Lilaste,Latvia

Diatoms, organic matter and magnetic susceptibility in a 10-m-long sediment sequence from coastal Lake Lilaste, Latvia, were analysed to evaluate Holocene environmental changes related to past sea-water intrusions. Lake Lilaste is located ~1 km from the present sea coast in an area with a low uplift rate and a threshold altitude of 0.5 m a.s.l. It was thus considered to be an appropriate site to study the influence of past sea level fluctuations on the lake and its sediments. Variations in diatom community composition, along with sediment lithostratigraphy, show that a shallow, nutrient-rich freshwater lake existed there during the early Holocene. The first brackish-water diatoms appeared concurrent with a sea level rise ca. 8700 ± 50 cal a BP, but long-term, intermittent inputs of brackish water were observed between 6700 ± 40 and 4200 ± 80 cal a BP. During those time spans, diatoms indicate increased nutrient concentrations and high conductivity, a consequence of occasional mixing of brackish and freshwater that promoted biological productivity. Lilaste was isolated from the sea at 4200 ± 80 cal a BP, after which a stable freshwater environment, dominated by planktonic diatoms such as Aulacoseira ambigua, A. granulata, A. islandica and A. subarctica, was established. At 400 ± 50 cal a BP, planktonic diatoms were gradually replaced by Fragilaria spp., indicating the beginning of anthropogenic impact. The reconstructed relative water-level curve from the lake coincides with the eustatic sea level curve from 6800 ± 40 cal a BP onwards. There was a distinct increase in abundance of brackish-water diatoms when the sea level reached the threshold of Lilaste, which at that time was probably about 3 m lower than the present sea level. According to radiocarbon-dated shifts in the diatom community composition, the Litorina Sea transgression was a long-lasting event (ca. 2200 years) in the southern part of the Gulf of Riga, where the land uplift rate was near zero. It culminated more than 1000 years later than at other sites with higher uplift, in the northern part of the Baltic Sea.     

Convective and conductive heat transfer in sedimentary basins

In the Earth's crust the temperature is largely controlled by heat conduction. However, under some circumstances, the thermal state is disturbed by advection of heat associated with groundwater flow. The corresponding thermal disturbance depends on the water flow velocity (modulus and direction) and therefore thermal data may be used to constrain the pattern of natural fluid flow. In this paper, some models of thermal disturbance induced by convective heat transfer are presented. They are based on the assumption that the water flow is concentrated in thin permeable structures such as aquifer or fault zones. The steady-state and transient thermal effects associated with such scenarios are computed using a somewhat idealized model which depends on a small number of parameters: flow rate, time, aquifer geometry and thermal parameters of surrounding rocks. In order to extract the conductive and convective components of heat transfer from temperature data and to estimate the corresponding fluid flow rate, it is first necessary to estimate the thermal conductivity field. The problem of the estimation of thermal conductivity in clay-rich rocks, based on laboratory and in-situ measurements, is emphasized. Then a method is proposed for the inversion of temperature data in terms of fluid flow. Vertical and lateral variations of thermal conductivity are taken into account and the fluid flow is assumed to be concentrated on a specified surface (2-D quasi-horizontal pattern). Thermal effects of the flow are simulated by a distribution of surface heat production which can be calculated and then inverted in terms of horizontal fluid flow pattern.     

Anomalies of some tidal waves of UT1

Summary. The M _f and M _m waves of UT1 have been analysed from the BIH data during the period 1967.0 to 1984.0 in order to derive the Love number k .
These analyses performed during successive intervals of this period show some anomalies in the values of the Love number k derived from the M _f wave. Large variations with time of the amplitude and the phase appear for this wave while the values derived from the M _m wave present a good stability during the whole period.
The spectrum of the UT1-residuals (as obtained by removing the theoretical zonal tidal UT1 terms) shows the existence of a perturbation wave near the M _f period. This wave lies in the range 13.5–13.9 day according to the analysed interval; it could be related with the perturbation wave noticed by some authors near the M _f gravimetric wave.     

CHARACTERIZATION OF THE EFFECT OF PEAK SHIFTS ON THE PERFORMANCE OF THE KALMAN FILTER IN MULTICOMPONENT ANALYSES

The effect of peak shifts on the performance of a Kalman filter multicomponent analysis algorithm hasbeen investigated.A series of Gaussian test systems were employed to characterize the concentrationestimation errors and the morphology of the on-line residuals(the innovations sequence).Both forwardand reverse filters were used in the generation of the innovations sequences.It was found that thedifference between the forward and reverse innovations sequences gave an accurate indication of thedirection and magnitude of the peak shift.A series of overlapped two-component systems were alsoinvestigated.Again,a correlation between the difference innovations and the degree of the responseshift was observed.The behavior of the Katman filter in fitting the shifted fluorescence emissionspectrum of benzo[a]pyrene was also examined.The response for henzo[a]pyrene in cyclohexanesolution was compared to that obtained on the surface of a reversed phase thin layer chromatographyplate.A red shift of 4 nm was detected for the surface spectrum by observing the difference innovationssequence.This approach holds promise for correction of response shifts in multicomponent systems.     

Multidimensional-unified topological relations computation: a hierarchical geometric algebra-based approach

This article presents a geometric algebra-based model for topological relation computation. This computational model is composed of three major components: the Grassmann structure preserving hierarchical multivector-tree representation (MVTree), multidimensional unified operators for intersection relation computation, and the judgement rules for assembling the intersections into topological relations. With this model, the intersection relations between the different dimensional objects (nodes at different levels) are computed using the Tree Meet operator. The meet operation between two arbitrary objects is accomplished by transforming the computation into the meet product between each pair of MVTree nodes, which produces a series of intersection relations in the form of MVTree. This intersection tree is then processed through a set of judgement rules to determine the topological relations between two objects in the hierarchy. Case studies of topological relations between two triangles in 3D space are employed to illustrate the model. The results show that with the new model, the topological relations can be computed in a simple way without referring to dimension. This dimensionless way of computing topological relations from geographic data is significant given the increased dimensionality of geographic information in the digital era.