A spatio-temporal three-dimensional conceptualization and simulation of Dera Ismail Khan alluvial aquifer in visual MODFLOW: a case study from Pakistan

Dera Ismail Khan (DIK) is situated in the Lower Indus Basin of Pakistan. The land use has been changed in the canal command area due to irrigation activities near the Indus River. To check the current status and predict the groundwater levels in the area, the unconfined aquifer has been simulated in Visual MODFLOW for a period of 35 years, i.e., from 1985 to 2020. The 2900-km² area has been modeled with a grid of 500 by 500 m and the depth set to 100 m. The aquifer in the study area has been divided vertically and laterally into three and ten zones, respectively, for the characterization. Water wells and streams were used as the sinks and hydrologic boundaries, respectively. The model was successfully calibrated in steady and the non-steady state. The simulation revealed that the whole simulation can be divided into two phases, i.e., before and after the construction of the Chashma Right Bank Canal (CRBC), whereas the results were summarized in the form of water table depth maps and groundwater budget calculations. To determine the groundwater sustainability, a conjunctive use scenario has been employed to simulate the aquifer dynamics till 2020. The simulation revealed incremental drawdowns till the end.     

Is Ziarat a Potential Site for Conventional or Unconventional Energy Resources?

A structural interpretation of the Ziarat block in the Balochistan region (a part of the Suleiman Fold and Thrust Belt) has been carried out using seismic and seismological data. Seismic data consists of nine 2.5D pre‐stack migrated seismic lines, whereas the seismological data covers the Fault Plane Solution and source parameters. Structural interpretation describes two broad fault sets of fore and back thrusts in the study area that have resulted in the development of pop‐up structures, accountable for the structural traps and seismicity pattern in terms of seismic hazard. Seismic interpretation includes time and depth contour maps of the Dungan Formation and Ranikot group, while seismological interpretation includes Fault Plane Solution, that is correlated with a geological and structural map of the area for the interpretation of the nature of the subsurface faults. Principal stresses are also estimated for the Ranikot group and Dungan Formation. In order to calculate anisotropic elastic properties, the parameters of the rock strength of the formations are first determined from seismic data, along with the dominant stresses (vertical, minimum horizontal, and maximum horizontal). The differential ratio of the maximum and minimum horizontal stresses is obtained to indicate optimal zones for hydraulic fracturing, and to assess the potential for geothermal energy reservoir prospect generation. The stress maps indicate high values towards the deeper part of the horizon, and low towards the shallower part, attributed to the lithological and structural variation in the area. Outcomes of structural interpretation indicate a good correlation of structure and tectonics from both seismological and seismic methods.     

Seismic stratigraphy of the Mianwali and Bannu depressions,north-western Indus foreland basin

International Journal of Earth Sciences - Regional seismic reflection profiles, deep exploratory wells, and outcrop data have been used to study the structure and stratigraphic architecture of the...     

Health risk of heavy metals from vegetables irrigated with sewage water in peri-urban of Dera Ismail Khan,Pakistan

Health risks of heavy metals in vegetables irrigated with sewage water were investigated in the present study. The findings indicated a massive accumulation of heavy metals in soil and vegetables collected from Dera Ismail khan, Pakistan. The concentration levels of heavy metal in vegetables grown on soil irrigated with untreated sewage water were significantly higher at (P ≤ 0.001) than in vegetables grown on fresh-water-irrigated soil and proceeded the recommended limits of World health organization. Moreover, the findings also indicated that the adults and children consuming such vegetables ingested a large proportion of the selected toxic metals. Health risk index was greater than one for Pb and Cd in all the selected vegetables and was greater than one for Ni in three vegetables like Spinacia oleracea, Benincasa fistulosa and Lactuca sativa. Health risk assessment would be a useful tool for information regarding any threats of heavy metals contamination in vegetables.     

High-performing antifouling bacterial consortium for submerged membrane bioreactor treating synthetic wastewater

Biofouling, associated with membranes, is considered as a major operational challenge in membrane bioreactor (MBR) technology. Interrupting the process for the formation of biofilm by the action of interspecies quorum quenching (QQ) has received a significant attention since recent years. An antifouling bacterial consortium was identified to improve biofouling inhibition performance during MBR operation. For this purpose, various QQ bacteria were isolated from laboratory-scale MBR using enrichment culture method and identified via 16S rRNA. Potential quenching strains including Enterobacter cloaca, Delftia sp., and Pseudomonas sp. were utilized to control biofouling in the MBR operated in the continuous mode for 38 days. Three laboratory-scale MBRs, including two MBRs with different anti fouling consortium and a control, were operated in parallel under similar operating conditions. Biofouling control by QQ bacteria was compared based on the membrane permeability and EPS secretion from biofilm on the membrane. Both MBRs with antifouling consortium (AC-MBRs) experienced around three times less biofouling as compared to conventional MBR leading to significant decrease in acyl homoserine lactones (AHLs) concentration in the biocake. More than 90, 45, and 49% of COD, NH₄–N, and PO₄ ^3?–P removal efficiencies elucidate that QQ bacterial consortium could effectively reduce membrane biofouling without compromising the MBR efficiency. Comparatively lower concentration of bound EPS in AC-MBRs restricted the bacterial adhesion to membrane resulting in enhanced membrane permeability depicting that a broader range of signal molecules could be hydrolyzed using antifouling consortium than single or no QQ strain in the submerged MBR.     

Isolation of <Emphasis Type="Italic">Bacillus cereus</Emphasis> from botanical soil and subsequent biodegradation of waste engine oil

Waste engine oil causes a vital environmental pollution when it spill during change and transportation and products of waste engine oil causes lethal effects to the living systems. Thus, abiotic and biotic approaches are being extensively used for removal of waste engine oil pollution. Therefore in present study, waste engine oil degradation was accomplished by a new bacterial culture, isolated from the soil by an enrichment technique. Morphological, biochemical and gene sequence analysis revealed that isolate was Bacillus cereus. Subsequently, biodegradation potential of B. cereus for waste engine oil was studied. Experimental variables, such as pH, substrate concentration, inoculum size, temperature and time on the biodegradation, were checked in mineral salt medium. The biodegradation efficiency of B. cereus was determined by gravimetry, UV–visible spectrophotometry and gas chromatography. In addition, waste engine oil was also characterized by GC–MS and FTIR for its major constituents, which showed total 38 components in waste engine oil, including hopanes, benzopyrene, long-chain aliphatic hydrocarbons, dibenzothiophenes, biphenyl and their derivatives. Results of successive biodegradation indicated that B. cereus was capable to degrade 1% of waste engine oil with 98.6% degradation potential at pH 7 within 20 days. Hence, B. cereus presents an innovative tool for removing the engine oil from the contaminated area.     

Geospatial assessment of soil erosion intensity and sediment yield: a case study of Potohar Region,Pakistan

Estimation of spatial extent of soil erosion, one of the most serious forms of land degradation, is critical because soil erosion has serious implications on soil fertility, water ecosystem, crop productivity and landscape beauty. The primary objective of the current study was to assess and map the soil erosion intensity and sedimentation yield of Potohar region of Pakistan. Potohar is the rainfed region with truncated and complex topography lying at the top of the Indus Basin, the world’s largest irrigation networks of canals and barrages. Spatially explicit Revised Universal Soil Loss Equation (RUSLE) Model integrated with Remote Sensing-GIS techniques was used for detecting/mapping of erosion prone areas and quantification of soil losses. The results show that the Potohar region is highly susceptible to soil erosion with an average annual soil loss of 19 tons ha^?1 year^?1 of which the maximum erosion (70–208 tons ha^?1 year^?1) was near the river channels and hilly areas. The sediment yield due to the erosion is as high as 148 tons ha^?1 year^?1 with an average of 4.3 tons ha^?1 year^?1. It was found that 2.06% of the total area falls under severe soil erosion, 13.34% under high erosion, 15.35% under moderate soil erosion while 69.25% of the area lies in the low (tolerable) soil erosion. Chakwal and Jhelum districts of the region are seriously affected by erosion owing to their topography and soil properties. The information generated in this study is a step forward towards proper planning and implementation of strategies to control the erosion and for protection of natural resources. It is, hence, necessary that suitable water harvesting structures be made to control water to prevent soil erosion and provision of water in the lean season in this region. Tree plantation and other erosion control practices such as strip cropping can also minimize soil erosion in this region.     

Diagenetic evolution vis-a-vis reservoir characteristics of Dhosa sandstones,Ler dome,Kachchh, western India

The detrital mineralogy as well as diagenetic characters of the Dhosa Sandstone Member of Chari Formation exposed at the Lerdome, south of Bhuj was studied. In order to assess the potential of the Dhosa Sandstone as a reservoir, it is substantial to understand the diagenetic processes that are controlled largely by post-depositional cementation and compaction in addition to framework composition and original depositional textures. The petrologic analysis of 33 thin sections was carried out to discern primary composition and diagenetic features including primary and secondary porosity patterns. Monocrystalline quartz dominates the detrital mineralogy followed by polycrystalline quartz. Among the polycrystalline variety recrystallized metamorphic quartz surpasses stretched metamorphic quartz in terms of abundance. Feldspars comprise microcline and plagioclase where the former is dominant over the latter. Orthoclase too comprises a very small percentage. Mica, chert, rock fragments, and heavies form the remaining detrital constituent in descending order of their constituent percentage. The diagenetic precipitates are mainly carbonate (8.30%) and iron (7.80%) followed by clay (0.66%) and silica (0.88%) that are minor constituent of the total cementing material. The main paragenetic events identified are early cementation, mechanical compaction, late cementation, dissolution, and authigenesis of clays. The overall reservoir quality seems to be controlled by compaction and authigenic carbonate cementation. The minus cement porosity average 29.4%. The porosity loss due to compaction is 21.92% and by cementation is 29.71%. The loss of original porosity was due to early cementation followed by moderate mechanical compaction during shallow burial. Preservation of available miniscule primary porosity was ascribed to dissolution of carbonates and quartz overgrowth which resisted chemical compaction during deep burial. The studied sandstones may have low reservoir quality owing to existing porosity of less than 9%. More carbonate dissolution and its transformation in dolomite in sub-surface condition and macro-fracture porosity may result in enhanced secondary porosity and good diagenetic traps.