A new formulation of garnet–clinopyroxene geothermometer based on accumulation and statistical analysis of a large experimental data set

Published experimental data including garnet and clinopyroxene as run products were used to develop a new formulation of the garnet–clinopyroxene geothermometer based on 333 garnet–clinopyroxene pairs. Only experiments with graphite capsules were selected because of difficulty in estimating the Fe³⁺ content of clinopyroxene. For the calibration, a published subregular‐solution model was adopted to express the non‐ideality of garnet. The magnitude of the Fe–Mg excess interaction parameter for clinopyroxene (W_FeMg^Cpx), and differences in enthalpy and entropy of the Fe–Mg exchange reaction were regressed from the accumulated experimental data set. As a result, a markedly negative value was obtained for the Fe–Mg excess interaction parameter of clinopyroxene (W_FeMg^Cpx = ? 3843 J mol^?1). The pressure correction is simply treated as linear, and the difference in volume of the Fe–Mg exchange reaction was calculated from a published thermodynamic data set and fixed to be ?120.72 (J kbar^?1 mol^?1). The regressed and obtained thermometer formulation is as follows: where T = temperature, P = pressure (kbar), A = 0.5 X_grs (X_prp ? X_alm ? X_sps), B = 0.5 X_grs (X_prp ? X_alm + X_sps), C = 0.5 (X_grs + X_sps) (X_prp ? X_alm), X_prp = Mg/(Fe²⁺ + Mn + Mg + Ca)^Grt, X_alm = Fe/(Fe²⁺ + Mn + Mg + Ca)^Grt, X_sps = Mn/(Fe²⁺ + Mn + Mg + Ca)^Grt, X_grs = Ca/(Fe²⁺ + Mn + Mg + Ca)^Grt, X_Mg^Cpx = Mg/(Al + Fe^total + Mg)^Cpx, X_Fe^Cpx = Fe²⁺/(Al + Fe^total + Mg)^Cpx, K_D = (Fe²⁺/Mg)^Grt/(Fe²⁺/Mg)^Cpx, Grt = garnet, Cpx = clinopyroxene. A test of this new formulation to the accumulated data gave results that are concordant with the experimental temperatures over the whole range of the experimental temperatures (800–1820 °C), with a standard deviation (1 sigma) of 74 °C. Previous formulations of the thermometer are inconsistent with the accumulated data set; they underestimate temperatures by about 100 °C at >1300 °C and overestimate by 100–200 °C at <1300 °C. In addition, they tend to overestimate temperatures for high‐Ca garnet (X_grs ≈ 0.30–0.50). This new formulation has been tested against previous formulations of the thermometer by application to natural eclogites. This gave temperatures some 20–100 °C lower than previous formulations.     

Fifteen years progress of the TRITON array in the Western Pacific and Eastern Indian Oceans

The Triangle Trans‐Ocean Buoy Network (TRITON) project by the Japan Agency for Marine-Earth Science and Technology began with deployment in the western tropical Pacific Ocean in 1998 and has shifted to steady, long-term observations since 1999. After on-site inter-comparison with the Autonomous Temperature Line Acquisition System mooring system of the Tropical Atmosphere and Ocean (TAO) array by the National Oceanic and Atmospheric Administration, the TRITON array became the international TAO/TRITON array in 2000 as a key component of the Global Ocean and Climate Observing Systems. The TAO/TRITON array took over from the TAO array, which was developed during the Tropical Ocean and Global Atmosphere program (1985–1994), and replaced the western part of TAO with new additional real-time measurements of salinity and ocean currents. In 2001, two TRITON moorings were deployed in the eastern Indian Ocean for capturing the eastern pole of the Indian Ocean Dipole. From this initiative, the Indian Ocean Observing System (IndOOS) was designed, and the Indian Ocean mooring array (Research Moored Array for Africa–Asian–Australian Monsoon Analysis and Prediction) was developed as a key component of IndOOS. In this paper, 15 years of progress in the TRITON project in the western Pacific and eastern Indian Oceans is reviewed with regards to scientific outcomes, technological development, and collaborations with international and domestic partners. Future directions for sustainable observation in the Pacific and Indian Oceans are also discussed.     

Eocene extensional tectonics in the Amakusa region,northern Ryukyu arc

Paleogene surface tectonics in Japan is not well understood because of the paucity of onshore Paleogene stratigraphic records except for those from accretionary complexes. Paralic Paleogene formations remaining in SW Japan are usually so thin that it is difficult to decipher the tectonics from them. However, the Eocene paralic sedimentary package with a thickness of kilometers indicates syn-depositional tectonic subsidence by a few kilometers in the Amakusa archipelago, west of Kyushu Island. Thus, we made a detailed geological map of the Eocene formations in an area of ~50 square kilometers in the northwestern part of the archipelago. We identified NE-SW and NW-SE trending normal faults, most of which were recognized by previous researchers, and also discovered low-angle faults. NW-SE trending ones are known to be of the Miocene. NE-SW trending and low-angle normal faults are the oldest map-scale structures in the Eocene ones. It is not obvious within the above-mentioned area whether those normal faults are accompanied by growth strata. However, the significant southeastward thickening of the Eocene formations across the Amakusa archipelago suggests that they filled a large half graben with the basin margin fault along the eastern side of the archipelago. This basin model is consistent with the N-S to NW-SE transport directions of the low-angle and NE-SW trending normal faults. Since many NE-SW to EW trending Eocene grabens were formed in the offshore regions west of Kyushu Island and in the East China Sea, the Amakusa region was probably a northeastern branch of the rift system. The geologic structures and depositional ages of the Eocene formations indicate that the Eocene extensional tectonics removed the overlying strata to some extent for the high-P/T Takahama Metamorphic Rocks which crops out to the south of our study area.     

Primary productivity in the fast ice area near syowa station,Antarctica, during spring and summer 1983/84

In situ measurements of the primary productivity of ice algae and phytoplankton were carried out in the fast ice area near Syowa Station (69°00S, 39°35E) during the austral spring and summer of 1983/84. Standing stock of ice algae reached a maximum of 45.1 mg chla m^–2 in late October. Phytoplankton standing stock attained a value of 3.57 mg chla m^–2 in mid-January. Primary production of ice algae in late October (7.64 mgC m^–2 hr^–1) was 14 times greater than that in mid-January (0.54 mgC m^–2 hr^–1). Production in the water column in mid-January (3.46 mgC m^–2 hr^–1) was 50 times greater than that in late October (0.07 mgC m^–2 hr^–1). These results indicate a substantial production by ice algae in the spring and by phytoplankton in the summer period.     

Two Modes of Salinity and Temperature Variation in the Surface Layer of the Pacific Warm Pool

The characteristics of temperature and salinity variation in the Pacific warm pool were investigated using Empirical Orthogonal Function (EOF) analysis on one year's temperature and salinity data in the surface layer (0–50 m) obtained from the Triangle Trans-Ocean Buoy Network (TRITON) buoy array. Two dominant modes of surface temperature and salinity variation were found. One is a positive correlation mode where temperature and salinity were scattered almost parallel to isopycnal lines in a T-S diagram, which has little effect on the density field. The other is a negative correlation mode where temperature and salinity were distributed across isopycnal lines, which has a substantial impact on the density field. In particular, we found that the negative correlation mode at 5°N, 156°E was predominant on a seasonal time scale and contributed to the surface dynamic height variation, and therefore to surface geostrophic current. This revised version was published online in July 2006 with corrections to the Cover Date.     

Pre-Japan-ARGO: Experimental Observation of Upper and Middle Layers South of the Kuroshio Extension Region Using Profiling Floats

We deployed two profiling floats in the region south of the Kuroshio Extension in March 2000. Temperature and salinity profiles from a depth of 1500 × 10⁴ Pa to the surface are reported every two and four weeks, respectively. The floats performed very well for first four months after deployment. Later they failed in surfacing for a few months when the sea surface temperature in the region was high. The salinity sensors seemed to suffer from some damage during their failure-in-surfacing period. Despite this trouble, the results clearly demonstrate that the profiling float is a very useful and cost-effective tool for physical oceanographic observation in the open sea. This revised version was published online in July 2006 with corrections to the Cover Date.     

Landslide Hazard and Risk Assessment on the Northern Slope of Mt. Changbai, China

Landslide hazard and risk assessment on the northern slope of Mt. Changbai, a well-known tourist attraction near the North Korean-Chinese border, are assessed. This study is divided into two parts, namely, landslide hazard zonation and risk assessment. The 1992 Anbalagan and Singh method of landslide hazard zonation （LHZ） was modified and used in this area. In this way, an Associative Analysis Method was used in representative areas to get a measure for controlling factors （slope gradient, relative relief, vegetation, geology, discontinuity development, weak layer thickness and ground water）. For the membership degree of factor to slope failure, the middle range of limited values was used to calculate LHZ. Based on an estimation of the potential damage from slope failure, a reasonable risk assessment map was obtained using the relationship of potential damage and probable hazard to aid future planning and prediction and to avert loss of life.     

Evidence from the Rb‐Sr system for 4.4 Ga alteration of chondrules in the Allende (CV3) parent body

Abstract— The timing and processes of alteration in the CV parent body are investigated by the analysis of Sr isotopes, major and trace elements, and petrographic type and distribution of the secondary minerals (nepheline and sodalite) in 22 chondrules from the Allende (CV3) chondrite. The Sr isotopic compositions of the chondrules are scattered around the 4.0 Ga reference line on the ⁸⁷Sr/⁸⁶Sr evolution diagram, indicating that the chondrules have been affected by late thermal alteration event(s) in the parent body. The degree of alteration, determined for individual chondrules based on the distribution of nepheline and sodalite, is unrelated to the disturbance of the Rb‐Sr system, suggesting that the alteration process that produced nepheline and sodalite is different from the thermal process that disturbed the Rb‐Sr system of the chondrules. Considering the geochemical behavior of Rb and Sr, the main host phase of Sr in chondrules is likely to be mesostasis, which could be most susceptible to late thermal alteration. As there is a poor connection between the alteration degree determined from abundances of nepheline and sodalite and the disturbance of Rb‐Sr isotopic system, we consider the mesostasis to provide a constraint on the late parent body alteration process. From this point of view, 23 mesostasis‐rich chondrules, including those from literature data, were selected. The selected chondrules are closely correlated on the ⁸⁷Sr/⁸⁶Sr evolution diagram, with an inferred age of 4.36 ± 0.08 Ga. This correlation would represent an age of the final major Sr isotopic redistribution of the chondrules in the parent body.     

Yamato 86029: Aqueously altered and thermally metamorphosed CI‐like chondrite with unusual textures

Abstract— We describe the petrologic and trace element characteristics of the Yamato 86029 (Y‐86029) meteorite. Y‐86029 is a breccia consisting of a variety of clasts, and abundant secondary minerals including coarse‐ and fine‐grained phyllosilicates, Fe‐Ni sulfides, carbonates, and magnetite. There are no chondrules, but a few anhydrous olivine‐rich grains are present within a very fine‐grained phyllosilicate‐rich matrix. Analyses of 14 thermally mobile trace elements suggest that Y‐86029 experienced moderate, open‐system thermal metamorphism. Comparison with data for other heated carbonaceous chondrites suggests metamorphic temperatures of 500–600°C for Y‐86029. This is apparent petrographically, in partial dehydration of phyllosilicates to incompletely re‐crystallized olivine. This transformation appears to proceed through ‘intermediate’ highly‐disordered ‘poorly crystalline’ phases consisting of newly formed olivine and residual desiccated phyllosilicate and their mixtures. Periclase is also present as a possible heating product of Mg‐rich carbonate precursors. Y‐86029 shows unusual textures rarely encountered in carbonaceous chondrites. The periclase occurs as unusually large Fe‐rich clasts (300–500 μm). Fine‐grained carbonates with uniform texture are also present as small (10–15 μm in diameter), rounded to sub‐rounded ‘shells’ of ankerite/siderite enclosing magnetite. These carbonates appear to have formed by low temperature aqueous alteration at specific thermal decomposition temperatures consistent with thermodynamic models of carbonate formation. The fine and uniform texture suggests crystallization from a fluid circulating in interconnected spaces throughout entire growth. One isolated aggregate in Y‐86029 also consists of a mosaic of polycrystalline olivine aggregates and sulfide blebs typical of shock‐induced melt re‐crystallization. Except for these unusual textures, the isotopic, petrologic and chemical characteristics of Y‐86029 are quite similar to those of Y‐82162, the only other heated CI‐like chondrite known. They were probably derived from similar asteroids rather than one asteroid, and hence may not necessarily be paired.