Arsenic anomalies in shallow Venetian Plain (Northeast Italy) groundwater

A pilot area within the Venetian Plain was selected to assess the arsenic (As) contamination of groundwater. The area represents a typical residential, industrial and agricultural organization representative of most western countries, and is also devoid of lithologies with high or anomalous As content. Hydrogeological and chemical data have been collected, the latter spatialized by a geostatistical approach. The unconfined aquifer reservoir varies from a predominantly gravel composition in the north to a sandy and silt–clay composition further south, including peat layers. The hydrochemical features of the waters are rather homogeneous, featuring low mineral content and a Ca-bicarbonate signature. In contrast, the redox state is highly variable; oxidizing conditions are predominant in the northern and coarse parts of the aquifer, whereas reducing potentials prevail in the southern and silt–clay parts. Several well waters contain arsenic in excess of drinkable limits (=10 ppb), and most of these wells are located in the southern area. A large portion of the studied area has a high probability of containing non-potable water (up to 150 ppb As). Remarkably, As “hot spots” (As > 300 ppb, up to 431 ppb) were identified at the transition from gravel to silt–clay sediments. No industrial or agricultural source of As has been found.     

Alteration processes in the CV chondrite parent body based on analysis of NWA 2086 meteorite

Analysis of the NWA 2086 CV3 chondrite showed a matrix/chondrule ratio of 52%, similar to Bali, Mokoia, and Grosanaja. Nearly twice as many chondrule fragments as intact ones demonstrate that an early fragmentation phase occurred prior to final accretion. After this event, no substantial mechanical change or redeposition is evident. Rims with double‐layered structures were identified around some chondrules, which, in at least one case, is attributed to an accretionary origin. The rim's outer parts with a diffuse appearance were formed by in situ chemical alteration. During this later process, Mg content decreased, Fe content increased, and olivine composition was homogenized, producing a rim composition close to that of the matrix. This alteration occasionally happened along fractures and at confined locations, and was probably produced by fluid interactions. Iron oxides are the best candidate for a small grain‐sized alteration product; however, technical limitations in the available equipment did not allow exact phase identification. These results suggest that NWA 2086 came from a location (possible more deeply buried) in the CV parent body than Mokoia or Bali, and suffered less impact effects—although there is no evidence of sustained thermal alteration. This meteorite may represent a sample of the CV parent asteroid interior and provide a useful basis for comparison with other CV meteorites in the future.     

Space-time interaction amongst clusters of mining induced seismicity

Elementary cluster analysis of induced seismicity in a South African gold mine has shown that there is a clear interaction amongst the clusters; and that the level of the interaction is a function of the distance. The clusering algorithm used is an adaptation of the single-link cluster analysis which considers both three-dimensional space and time. A high level of interaction between the clusters is demonstrated from the cross-correlation analysis of seismic activity rates and radiated energy. A distinct decrease in the value of correlation coefficients was detectable as distance increased. This was somewhat surprising, considering the simplicity of the technique used. Since no attempt is made to study the physical mechanisms of interaction, these results are very preliminary, but interesting from an observational point of view.     

VERTICAL SEISMIC PROFILING IN COAL*

The intellection of seismic wave propagation in coal measures demands direct observation of the wavefield progression. Two vertical seismic profiles with high spatial and temporal sampling, were recently recorded in the Sydney Basin coalfields as part of an experimental coal seismic program. Static corrections and interval velocities were obtained by an automated system to determine first kicks and pulse rise times. Upgoing and downgoing waves were separated in the f—k-plane using a novel technique of contour slice filtering. The isolated upgoing waves clearly display reflections from the major coal seams within the stratigraphic sequence. The downgoing wave spectra were subjected to attenuation analysis. The deduced specific quality factor Q for Permian coal measure rocks lies in the range 20–70. Similar estimates were obtained in the time domain from measurements of pulse broadening. Synthetic VSP seismograms, computed using an exact recursive formulation, are an indispensable aid to interpretation. They illustrate the filtering effects of coal seams and sequences, and the effects of the contribution of internal and free-surface multiple reflections in the recorded wavetrains.     

Saturn's electrostatic discharges: Could lightning be the cause?

It is proposed that Saturn's electrostatic discharges (SED) might be generated in the planet's equatorial atmosphere, perhaps as lightning from a storm system. The 10^h10^m periodicity of the signal envelope duplicates that of Saturn's equatorial jet. The rings shield the atmosphere from solar EUV photons, and thereby substantially reduce the local ionospheric cutoff frequency to allow low-frequency SED to leak out. Many of the unusual properties of SED could be explained in terms of changes in the storm system, the relative spacecraft position in the beaming pattern of the source, local refraction of the signal by the highly disturbed ionosphere, and the influence of the ring particles on the highest frequency component of SED. A comparison of SED with planetary lightning on other planets shows that the two are similar in general character and some time behavior; the power output of SED may be higher than most planetary lightnings but that is unclear because of uncertainties in the measurements and variations in the signal's spectrum. Our simple discussion suggests that lightning could be a viable source for SED and that exotic ring mechanisms are not necessarily required.     

Biosorption of Rare-Earth Elements and Yttrium by Heterotrophic Bacteria in an Aqueous Environment

This paper reports the results of the experimental determination of the coefficient of sorption of rare-earth elements and yttrium (REY) under conditions of acidic pH using several strains of heterotrophic bacteria (Microbacterium sp., Curtobacterium sp., Bacillus subtilis, Pseudomonas putida, and Bacillus pumilis) that are widespread in natural and technogenic waters of the Far East (Russia). Insignificant fractionation between heavy and light rare-earth elements, negative cerium and dysprosium anomalies, and a positive europium anomaly were revealed. The selectivity of REY biosorption by gram-positive and gram-negative bacteria, as well as inertia of the biosorption process under more acidic conditions of the medium, were shown.     

Is there a fuelwood crisis in rural Mali?

The study takes a conventional supply and demand approach to the study of fuelwood use. It compares estimated wood production in West African bush and forest formations based on an available equation using rainfall data with own collected data on local wood consumption in a village in southern Mali. To allow comparison, data from 49 other villages in the same area are analysed. This study, toget her with an earlier study in northern Mali, indicates that locally induced deforestation caused by fuelwood use does not represent an immediate problem in rural Mali. Local use of fuelwood does not seem to be exceeding forest regeneration. However, where there is external pressure on the forest represented by commercial exploitation of wood for sale in the urban centres, fuelwood depletion might occur.     

The Role of the Magnetic Field in the Ascension of the 22nd and 23rd Cycles of Activity

The first small active regions of the last two new cycles seem to be formed, in its very first, preparatory stage, close to the equator with uncertain magnetic orientation, and as secondary products at the periphery of equatorial `magnetic bubbles' of the new magnetic flux still belonging to the old cycle. At the real beginning of the new cycle, at the periphery of its higher-latitude `magnetic bubbles', the opposite applies to the secondary regions of the ending cycle. It seems that two modes of magnetic flux supply the visible layers of the photosphere during the cycle transition phase: the emergence of the magnetic flux from the depth of the convective zone, and the mutual interaction of the earlier emerging fluxes, or the action of the `local dynamo', giving rise to the new local magnetic field concentrations.     

VELOCITY DISPERSION OF SEISMIC WAVES*

In well velocity surveys made to calibrate Sonic (CV) Logs the calibration survey uses frequencies around 50 Hz whereas the Sonic Logging tool uses frequencies around 20 kHz. There thus exists the possibility of making a direct measure of velocity dispersion. In any one survey the disturbing factors, both instrumental and operational, will often mask any dispersive effect that might exist. Consequently this paper reports on a statistical analysis of the velocity differences resulting from calibration surveys and Sonic logs. Only Borehole Compensated Sonic Logs were used. Four areas were investigated: the North Sea, Abu Dhabi, Libya and Alaska. After rejecting logs and calibration records which were obviously in error there remained 424000 feet (about 130 km) of usable log distributed throughout 66 wells. The four areas were analysed separately and in no case was the estimated dispersion significantly different from zero. However, the mean values did correlate with lithology from (? 0.17 ± 0.18)% for the essentially carbonate section in Abu Dhabi to (+ 0.45 ± 0.25)% for the sand-shale section in Alaska, a positive sign meaning that the higher frequencies travelled faster. Except for Alaska the calibration surveys were made with a wall-clamp geophone, and for these areas amplitude measurements were made. After suitable corrections estimates of the absorption parameter Q were obtained. These varied from 20 to 200 with mean values of 63 for Libya, 70 for Abu Dhabi and 88 for the North Sea (excluding the Tertiary). If, as is usually assumed, the absorption mechanism is linear and is described by a Q which is independent of frequency, then these values would necessarily imply dispersion of several percent. As instanced above no such dispersion was observed. It is possible that the expected dispersion was compensated for by invasion of the mud filtrate into the borehole walls, but it is more likely that the absorption mechanism was substantially non-linear.