Magmatism and metamorphism at ca. 1.45 Ga in the northern Gawler Craton: The Australian record of rifting within Nuna (Columbia)

U-Pb monazite and zircon geochronology and calculated metamorphic phase diagrams from drill holes in the northern Gawler Craton, southern Australia, reveal the presence of ca. 1.45 Ga magmatism and metamorphism. Magmatism and granulite facies metamorphism of this age has not previously been recognised in the Gawler Craton. The magmatic rocks have steep LREE-enriched patterns and high Ga/Al values, suggesting they are A-type granites. Calculated metamorphic forward models suggest that this event was associated with high apparent thermal gradients and reached pressures of 3.2 -5.4 kbar and temperatures of 775-815℃. The high apparent thermal gradients may reflect pluton-enhanced metamorphism, consistent with the presence of A-type granites. The recognition of ca. 1.45 Ga tectonism in the northern Gawler Craton is added to a compilation of ca. 1.50 -1.40 Ga magmatism, shear zone reactivation, rift basin development and isotope resetting throughout the South and North Australian Cratons that shows that this event was widespread in eastern Proterozoic Australia. This event is stylistically similar to ca. 1.45 Ga A-type magmatism and high thermal gradient metamorphism in Laurentia in this interval and provides further support for a connection between Australia and Laurentia during the Mesoproterozoic. The tectonic setting of the 1.50-1.40 Ga event is unclear but may record rifting within the Nuna(or Columbia) supercontinent, or a period of intracontinental extension within a long-lived convergent setting.     

Circular moraine features on the Varanger Peninsula, northern Norway, and their possible relation to polythermal ice sheet coverage

This paper introduces a new hypothesis about the formation of circular moraine features (CMFs) on felsenmeer-covered plateaux of the Varanger Peninsula, northern Norway. CMFs and glacial lineations in the northwestern part of the Varanger Peninsula were mapped from aerial photographs. In two CMF-rich areas, Base œrro-Plateau and Båtsfjordfjellet, the CMFs were investigated during fieldwork. The aim was to investigate possible entrainment, transport and deposition mechanisms of the CMFs in connection to ice sheet properties.The CMFs were deposited in connection with a polythermal ice cover. During glaciations, the ice sheet was cold-based on the boulder field plateaux and warm-based in valleys, especially in ice drainage pathways towards fjords. The CMF material was probably entrained en masse, on the Varanger Peninsula, in transition zones between warm- and cold-based ice. The debris transport took place close to the ice base. During deglaciation, the debris formed dirt cones, slowing down the melting of underlying dead-ice blocks. As material slid down the margins of the cones, the typical CMF shape was formed.     

Preservation of high‐P rocks coupled to rock composition and the absence of metamorphic fluids

Eclogites, blueschists and greenschists are found in close proximity to one another along a 1‐km coastal section where the Cyclades Blueschist Unit (CBU) is exposed on SE Syros, Greece. Here, we show that the eclogites and blueschists experienced the same metamorphic history: prograde lawsonite blueschist facies metamorphism at 1.2–1.9 GPa and 410–530°C followed, at 43–38 Ma, by peak blueschist/eclogite facies metamorphism at 1.5–2.1 GPa and 520–580°C. We explain co‐existence of eclogites and blueschists by compositional variation probably reflecting original compositional layering. It is also shown that the greenschists record retrogression at 0.34 ± 0.21 GPa and T = 456 ± 68°C. This was spatially associated with a shear zone on a scales of 10–100‐m and veins on a scale of 1–10‐cm. Greenschist facies metamorphism ended at (or shortly after) 27 Ma. We thus infer a period of metamorphic quiescence after eclogite/blueschist facies metamorphism and before greenschist facies retrogression which lasted up to 11–16 million years. We suggest that this reflects an absence of metamorphic fluid flow at that time and conclude that greenschist facies retrogression only occurred when and where metamorphic fluids were present. From a tectonic perspective, our findings are consistent with studies showing that the CBU is (a) a high‐P nappe stack consisting of belts in which high‐P metamorphism and exhumation occurred at different times and (b) affected by greenschist facies metamorphism during the Oligocene, prior to the onset of regional tectonic extension.     

Intercomparison of Himawari-8 AHI-FSA with MODIS and VIIRS active fire products

ABSTRACT

The AHI-FSA (Advanced Himawari Imager - Fire Surveillance Algorithm) is a recently developed algorithm designed to support wildfire surveillance and mapping using the geostationary Himawari-8 satellite. At present, the AHI-FSA algorithm has only been tested on a number of case study fires in Western Australia. Initial results demonstrate potential as a wildfire surveillance algorithm providing high frequency (every 10 minutes), multi-resolution fire-line detections. This paper intercompares AHI-FSA across the Northern Territory of Australia (1.4 million km²) over a ten-day period with the well-established fire products from LEO (Low Earth Orbiting) satellites: MODIS (Moderate Resolution Imaging Spectroradiometer) and VIIRS (Visible Infrared Imaging Radiometer Suite). This paper also discusses the difficulties and solutions when comparing high temporal frequency fire products with existing low temporal resolution LEO satellite products. The results indicate that the multi-resolution approach developed for AHI-FSA is successful in mapping fire activity at 500?m. When compared to the MODIS, daily AHI-FSA omission error was only 7%. High temporal frequency data also results in AHI-FSA observing fires, at times, three hours before the MODIS overpass with much-enhanced detail on fire movement.     

Quick clay—A case study of chemical perspective in Southwest Sweden

Quick clay, a soil that changes from normal firm ground to a liquid mass when it is disturbed, has been involved in most of the large and serious clay slides in Sweden, Norway and Canada. The location, time of occurrence and size of quick clay slides are difficult to predict and large slides may cause great devastation. Some geochemical studies of Swedish quick clay were done in the 1960s and early 1970s, but no systematic studies of the interrelationships of pore water chemistry, mineralogy, geotechnical properties and other parameters on quick clays in Sweden have been published. Such studies are of national and general interest because of the many combinations of rock flour source areas and sedimentation conditions that occurred across central Sweden and into the Baltic Sea area during deglaciation. In this study, geotechnical properties related to the in situ chemistry at one quick clay site were extensively studied, and spot sampling was conducted at two other locations in Southwest Sweden. In this area the clay minerals mainly are non-expanding phyllosilicate minerals (illite) and primary minerals (quartz, feldspar), which is consistent with previous studies of quick clay mineralogy. Extensive leaching has occurred at all three locations. At the extensively studied site, Surte, the lowest salinity was found at the greatest depth, inferring that the leaching by fresh water was accomplished by water movement upward and laterally through the sediment from the underlying bedrock. This is consistent with the local setting where bedrock hills rise sharply to over 100 m above the marine sediment surface. An artesian pressure would also be anticipated at this location. There is a correlation (negative) between sensitivity and salinity but there is an indication that the maximum salinity or electrical conductivity consistent with the quick clay behaviour is higher than reported elsewhere. However, for high sensitivities the salinity is about the same as reported elsewhere. In the deepest part of the borehole, there is a higher content of Fe and Al in the pore water, indicating reduced state. Further work is needed to confirm the difference in salinity and to investigate the possible interplay of salinity and potential dispersing agents such as the role of anoxic conditions, in this region. Further work is especially needed in the locations where the sediment accumulation occurred under lower salinity conditions. At all three locations, high remoulded shear strength and low sensitivity have been seen near the surface together with a decrease in pore water cation concentrations.     

Using Lead Isotopes to Determine Pottery Provenance in Cyprus: Clay Source Signatures and Comparison with Late Bronze Age Cypriote Pottery

This paper presents the lead isotopic composition of potential clay sources for pottery production, collected in the four major geological zones of Cyprus (Troodos Ophiolite, Circum Troodos Sedimentary Succession, Mamonia Terrane, Kyrenia Terrane) and evaluates its usefulness in Cypriote pottery provenance studies. The clay isotopic signatures from the four zones are compared to each other and to the isotopic composition of various utilitarian pottery wares from three Late Bronze Age sites, respectively located in southern Cyprus (Alassa‐Pano Mandilaris), east Cyprus (Enkomi), and southeast Cyprus (Hala Sultan Tekke). It also explores the potential of this method to better discriminate between potential raw materials used for the production of Base‐ring ware, one of the most characteristic fine pottery of Late Bronze Age Cyprus, which was widely spread in the Eastern Mediterranean (Courtois, 1981; Vaughan, 1991, 1994). Results show that three main lead isotopic fields can be distinguished among the Cypriote clay sources and the comparison of Plain sherds with the clay sources allows discrimination between local products and imports. They also clearly indicate that all the Base‐ring sherds analyzed in this study were made of the clays from the Kathikas Formation that crops out in only limited parts of southwest Cyprus.     

Typecasting prospective Au-bearing sedimentary lithologies using sedimentary geochemistry and Nd isotopes in poorly exposed Proterozoic basins of the Tanami region, Northern Australia

The development of a regional stratigraphy in Palaeoproterozoic basins within the Tanami region, Northern Australia has been hindered by the difficulty of discriminating sedimentary units and facies across this isolated and poorly exposed basin. A regional stratigraphy is important as it provides constraints on sedimentary basin evolution and assists in gold exploration. Gold is known to be more concentrated in certain rock formations. Based on Nd isotopes and whole rock geochemistry, five main sedimentary events have been identified in the Tanami region. Some sedimentary units were derived from homogeneous local sources, whereas others contain evidence of a well-mixed fine-grained remote provenance. Within the basins, major gold-bearing lithologies are characterised by mafic source indicators: (1) high Cr/Th ratios; (2) low Th/Sc ratios; (3) low (La/Yb)_PAAS ratios relative to Post-Archaean Average Shale (Taylor and McLennan 1985); (4) Eu anomalies equal to ∼1; and (5) distinctive ranges in initial ε _Nd values. Potential future exploration target areas have been identified in the Tanami region at the Cashel and Sunline prospects using these geochemical parameters.     

Global change revealed by palaeolimnological records from remote lakes: a review

Over recent decades, palaeolimnological records from remote sites have provided convincing evidence for the onset and development of several facets of global environmental change. Remote lakes, defined here as those occurring in high latitude or high altitude regions, have the advantage of not being overprinted by local anthropogenic processes. As such, many of these sites record broad-scale environmental changes, frequently driven by regime shifts in the Earth system. Here, we review a selection of studies from North America and Europe and discuss their broader implications. The history of investigation has evolved synchronously with the scope and awareness of environmental problems. An initial focus on acid deposition switched to metal and other types of pollutants, then climate change and eventually to atmospheric deposition-fertilising effects. However, none of these topics is independent of the other, and all of them affect ecosystem function and biodiversity in profound ways. Currently, remote lake palaeolimnology is developing unique datasets for each region investigated that benchmark current trends with respect to past, purely natural variability in lake systems. Fostering conceptual and methodological bridges with other environmental disciplines will upturn contribution of remote lake palaeolimnology in solving existing and emerging questions in global change science and planetary stewardship.     

Analysis of shallow gas and fluid migration within the Plio-Pleistocene sedimentary succession of the SW Barents Sea continental margin using 3D seismic data

Three-dimensional (3D) seismic data acquired for hydrocarbon exploration reveal that gas accumulations are common within the 2–3 km thick Plio-Pleistocene stratigraphic column of the south-western Barents Sea continental margin. The 3D seismic data have relatively low-frequency content (<40 Hz) but, due to dense spatial sampling, long source-receiver offsets, 3D migration and advanced interpretation techniques, they provide surprisingly detailed images of inferred gas accumulations and the sedimentary environments in which they occur. The presence of gas is inferred from seismic reflection segments with anomalously high amplitude and reversed phase, compared with the seafloor reflection, so-called bright spots. Fluid migration is inferred from vertical zones of acoustic masking and acoustic pipes. The 3D seismic volume allows a spatial analysis of amplitude anomalies inferred to reflect the presence of gas and fluids. At several locations, seismic attribute maps reveal detailed images of flat spots, inferred to represent gas–water interfaces. The data indicate a focused fluid migration system, where sub-vertical faults and zones of highly fractured sediments are conduits for the migration of gas-bearing fluids in Plio-Pleistocene sediments. Gas is interpreted to appear in high-porosity fan-shaped sediment lobes, channel and delta deposits, glacigenic debris flows and sediment blocks, probably sealed by low-permeability, clayey till and/or (glacio)marine sediments. Gas and fluid flow are here attributed mainly to rapid Plio-Pleistocene sedimentation that loaded large amounts of sedimentary material over lower-density, fine-grained Eocene oozes. This probably caused pore-fluid dewatering of the high-fluid content oozes through a network of polygonal faults. The study area is suggested to have experienced cycles of fluid expulsion and hydrocarbon migration associated with glacial–interglacial cycles.