Threshold condition of sand particles under codirectional combined wave and current flow

Flume experiments were carried out to determine the threshold of movement of sand on rippled surface and flat beds under the codirectional combined flows due to waves and currents. The results indicate that Shields's curve can be used to determine the threshold condition under combined flows, provided that the maximum bed shear stress is used.     

Offshore permafrost and gas hydrate stability zone on the shelf of East Siberian Seas

Dynamics of the submarine permafrost regime, including distribution, thickness, and temporal evolution, was modeled for the Laptev and East Siberian Sea shelf zones. This work included simulation of the permafrost-related gas hydrate stability zone (GHSZ). Simulations were compared with field observations. Model sensitivity runs were performed using different boundary conditions, including a variety of geological conditions as well as two distinct geothermal heat flows (45 and 70 mW/m²). The heat flows used are typical for the coastal lowlands of the Laptev Sea and East Siberian Sea. Use of two different geological deposits, that is, unconsolidated Cainozoic strata and solid bedrock, resulted in the significantly different magnitudes of permafrost thickness, a result of their different physical and thermal properties. Both parameters, the thickness of the submarine permafrost on the shelf and the related development of the GHSZ, were simulated for the last four glacial-eustatic cycles (400,000 years). The results show that the most recently formed permafrost is continuous to the 60-m isobath; at the greater depths of the outer part of the shelf it changes to discontinuous and patchy permafrost. However, model results suggest that the entire Arctic shelf is underlain by relic permafrost in a state stable enough for gas hydrates. Permafrost, as well as the GHSZ, is currently storing probable significant greenhouse gas sources, especially methane that has formed by the decomposition of gas hydrates at greater depth. During climate cooling and associated marine regression, permafrost aggradation takes place due to the low temperatures and the direct exposure of the shelf to the atmosphere. Permafrost degradation takes place during climate warming and marine transgression. However, the temperature of transgressing seawater in contact with the former terrestrial permafrost landscape remains below zero, ranging from –0.5 to –1.8°C, meaning permafrost degradation does not immediately occur. The submerged permafrost degrades slowly, undergoing a transformation in form from ice bonded terrestrial permafrost to ice bearing submarine permafrost that does not possess a temperature gradient. Finally the thickness of ice bearing permafrost decreases from its lower boundary due to the geothermal heat flow. The modeling indicated several other features. There exists a time lag between extreme states in climatic forcing and associated extreme states of permafrost thickness. For example, permafrost continued to degrade for up to 10,000 years following a temperature decline had begun after a climate optimum. Another result showed that the dynamic of permafrost thickness and the variation of the GHSZ are similar but not identical. For example, it can be shown that in recent time permafrost degradation has taken place at the outer part of the shelf whereas the GHSZ is stable or even thickening.     

Variations of antioxidant efficiency and presence of endosymbiotic diatoms in the Antarctic porifera Haliclona dancoi

The role of endosymbiotic diatoms as pro-oxidant stressors in porifera has been investigated in the Antarctic sponge Haliclona dancoi in which the presence of diatoms is influenced by marked seasonal variations during the austral summer. Both chlorophaeopigments and frustules were absent in sponge tissues sampled in early November at the beginning of the summer and increased from the mid of December with slightly shifted temporal trends. The efficiency of antioxidant defenses in the sponge showed a marked response to symbionts with clearly enhanced values corresponding to the peak of diatoms.     

Meanders in the Antarctic Polar Frontal Zone and their impact on phytoplankton

The Antarctic Polar Front is a complex set of meandering jets, which appear to support enhanced primary productivity. The US Joint Global Ocean Flux Study conducted a series of survey and process studies in part to study the processes regulating primary productivity in this high nutrient, low chlorophyll region. We deployed a set of surface velocity drifters, some of which were equipped with bio-optical sensors, to study the temporal and spatial scales of biological and physical processes in the Antarctic Polar Frontal Zone. There were two primary sets of deployments: November 1997 before the spring bloom and January 1998 after the spring bloom. The November deployment revealed a strong spring bloom that lasted about 10 days. In late spring, when incoming solar radiation began to increase, the vertical motions associated with the meanders strongly affected the accumulation of phytoplankton biomass, primarily through their impact on light availability. Weaker meandering was observed in the January deployment, and chlorophyll values remained relatively constant. As the bloom began to decay, it appears that nutrient availability became more important in regulating phytoplankton photosynthesis. Some of the drifters in the November deployment were deployed in coherent clusters, thus allowing us to calculate vertical velocities associated with the meanders. Estimates of fluorescence/chlorophyll suggest that areas of upwelling and downwelling alternately decrease and increase photosynthetic stress, perhaps as a result of changes in the availability of iron or light during the formation of the bloom.     

An experimental pressure compensated wet suit

Personal thermal insulation by means of neoprene from wet suits provides adequate temporary control of body heat loss only at the shallow end of the air diving depth range, but it constitutes by far the most popular approach to diver thermal support. Howewer, compression of the trapped gas phase in neoprene foam seriously reduces its insulation performance on exposure to high ambient pressure. With conventional wet suits equipped with heating, the necessary level of power required at depths greater than about 30 m is too high, and also unsafe without the back up that increased insulation would provide. One approach to the goal of depth-insensitive insulation is to use a wet suit with a continuous internal gas space pressurized nominally to ambient pressure, so that its thickness remains substantially constant at all depths. The composite material properties required are: outer skins that are tough, flexible and free of pin holes; an open foam internal structure capable of resisting, without significant dimensional change, the relatively small pressure changes that occur over the height of a man; and a high bond strength.Samples of a composite material that meets these requirements have been developed, and a prototype suit has been successfully fabricated by conventional techniques.     

Sedimentology of a subtidal,tide-dominated sand body in the Yellow Sea,southwest Korea

Odanam Satoe, a subtidal, tide-dominated sand body in the Yellow Sea, Korea, is linear in plan and asymmetrical in cross-section. It consists of fine- to medium-grained, well-sorted subangular sand. Bedforms consist of high-amplitude (1–2 m) sandwaves on the lower flanks of the gentler-sloping bar surface, and medium-amplitude (0.5-1 m) sandwaves on the sand body trough adjoining the steeper face, the bar crest and shallower parts of the gently sloping bar surface. Bedforms are absent on the relatively steeper bar surface, which is characterized by 2° slopes. Bedform orientation on the gentler slope is oblique by 30° to the bar crest, parallel to the sand-body crest on the crest itself, and opposite to the steeper sand-body face in the trough below the steeper slope of the bar.Bottom current velocity data show that tidal currents are semi-rotary with a flood time—velocity asymmetry over the gentler slope, and ebb time—velocity asymmetry over the steeper slope during most of the tidal cycle. Tidal-current flow parallels bar elongation over the steeper slope, whereas over the gentler slope, tidal-current flow is directed at 30° to the bar crest and changes to normal to the crest one hour prior to low tide. Bedform orientation mapped with side-scan sonar shows agreement with these flow directions.Sand dispersal around the sand body is controlled by time—velocity asymmetry and partial rotary flow directions of tidal currents. This circulation causes not only a trapezoidal mode of grain dispersal, but also westerly migration of the sand body documented from comparative bathymetric surveys in 1964 and 1980.     

Breaking wave impact on vertical and sloping coastal structures

The results of laboratory experiments on the maximum and bottom impact pressures from waves breaking directly on vertical and sloping faced coastal structures are presented. Direct wave breaking on a wall is classified as early, late, and perfect breaking. Although the present study is aimed at dealing with the type of impact resulting from the perfect breaking, to some extent the occurrence of early and late breaking are unavoidable. The wave impact pressures, therefore, have a random nature of variation from impact-to-impact under the same conditions. The maximum and bottom impact pressures on walls are treated statistically. The effects of the wall angle and foreshore slope on these two quantities are examined. The results show that for practical applications, the still-water level can be taken as the acting place for the maximum impact pressure on the wall. Simultaneous impact pressure distribution below and above still-water level may be approximated as parabolic and linear, respectively. Finally, using a wall deflection criterion, a water depth region in front of the wall is defined, where the breaking wave forces may reach a critical level.