CARBON DYNAMICS OF WETLAND IN THE SANJIANG PLAIN

1INTRODUCTIONWetlandsplayanimportant roleintheprocessofcar-bonstorage.Thetotalcarbonstoredindifferentkindsofwetlandsisabout15%-35%ofthetotalcarboninthegloballandsoils(POSTetal.,1982;GORHAM,1991).Inaddition,wetlandsaresignificantnaturalsources fortheatmospheric CH4 (MOORE,1994).It isestimatedthatabout110×1012gCH4 originates fromanaerobicdecompositioninthenaturalwetlands,CH4 emission fromthenaturalwetlandsis15%-30%oftheglobalCH4 emission andtheCH4 emission from thepeat land at hi…     

马卡良335的微光变观测

介绍了马卡良 335分别发生于 1998年和 1999年的两次短时标光变。其中的一次是微光变 ,发生于 1999年 11月 2 0日 ,微光变区域的大小约 0 .80 7光时。还对微光变的可能机制进行了讨论     

Characters of the Pco2 and CO2 Flux in the East China Sea in Autumn

Pco2 of air and seawater samples from the East China Sea(ECS) were measured in situ in autumn, 1994,Ocean currents,terrestrial fluviation,biological activities,etc.,Pco2 char-acters in air and seawater were investigated,CO2 flux and its character in the East China Sea are discussed on the basis of the Pco2 profiles of air and seawater,It was clear that the nearshore was the source of CO2;and tht the oulter sea area was the sink of CO2; and that the shelf area of the EXS is a net sink for atmospheric CO2 in autumn.     

Effect of spatial variation characteristics on contouring of design storm depth

The ordinary kriging method, a geostatistical interpolation technique, was applied for developing contour maps of design storm depth in northern Taiwan using intensity–duration–frequency (IDF) data. Results of variogram modelling on design storm depths indicate that the design storms can be categorized into two distinct storm types: (i) storms of short duration and high spatial variation and (ii) storms of long duration and less spatial variation. For storms of the first category, the influence range of rainfall depth decreases when the recurrence interval increases, owing to the increasing degree of their spatial independence. However, for storms of the second category, the influence range of rainfall depth does not change significantly and has an average of approximately 72 km. For very extreme events, such as events of short duration and long recurrence interval, we do not recommend usage of the established design storm contours, because most of the interstation distances exceed the influence ranges. Our study concludes that the influence range of the design storm depth is dependent on the design duration and recurrence interval and is a key factor in developing design storm contours. Copyright © 2003 John Wiley & Sons, Ltd.     

SORPTION AND DESORPTION CHARACTERISTICS OF CADMIUM BY FOUR DIFFERENT SOILS IN NORTHEAST CHINA

1IN TR O D U C TIO NA s a persistentand toxic pollutant, cadm ium (C d) canresultin m any adverse health effects in a variety oftis-suesand organssuch asthe lung,kidney,urinary,blad-der,pancreas,breast and prostate (SA TA R U G etal.,2003).C adm ium in so…     

On the cause of total irradiance variations observed by the CCD solar surface photometer

Spatially-resolved precise photometric observations of the whole Sun at wavelengths of 545nm (FWHM 40nm) were carried out by using the CCD solar surface photometer. Bright parts of photospheric network have contrast of several tenths of percent, and their contribution to the total irradiance is approximately half that of active region faculae. The solar irradiance variations estimated from sunspots, faculae and active network (contrast>0.3%) agreed with the ACRIM data. The quiet Sun irradiance used in the present results was different from the total irradiance at the solar minimum observed by the ACRIM, which indicates unmeasured components (contrast>0.1%) cause the 11-year cycle irradiance variation.     

Elastic solutions for stresses in a transversely isotropic half‐space subjected to three‐dimensional buried parabolic rectangular loads

In many areas of engineering practice, applied loads are not uniformly distributed but often concentrated towards the centre of a foundation. Thus, loads are more realistically depicted as distributed as linearly varying or as parabola of revolution. Solutions for stresses in a transversely isotropic half‐space caused by concave and convex parabolic loads that act on a rectangle have not been derived. This work proposes analytical solutions for stresses in a transversely isotropic half‐space, induced by three‐dimensional, buried, linearly varying/uniform/parabolic rectangular loads. Load types include an upwardly and a downwardly linearly varying load, a uniform load, a concave and a convex parabolic load, all distributed over a rectangular area. These solutions are obtained by integrating the point load solutions in a Cartesian co‐ordinate system for a transversely isotropic half‐space. The buried depth, the dimensions of the loaded area, the type and degree of material anisotropy and the loading type for transversely isotropic half‐spaces influence the proposed solutions. An illustrative example is presented to elucidate the effect of the dimensions of the loaded area, the type and degree of rock anisotropy, and the type of loading on the vertical stress in the isotropic/transversely isotropic rocks subjected to a linearly varying/uniform/parabolic rectangular load. Copyright © 2002 John Wiley & Sons, Ltd.     

The influence of a non‐associated flow rule on the calculation of the factor of safety of soil slopes

This paper presents a method that incorporates a non‐associated flow rule into the limit analysis to investigate the influence of the dilatancy angle on the factor of safety for the slope stability analysis. The proposed method retain's the advantage of the upper bound method, which is simple and has no stress involvement in the calculation of the energy dissipation and the factor of safety. Copyright © 2001 John Wiley & Sons, Ltd.     

Abundance and isotopic composition of noble gases in metal and graphite of the Bohumilitz IAB iron meteorite

Abstract— Abundances and isotopic compositions of noble gases in metal and graphite of the Bohumilitz IAB iron meteorite were measured. The abundance ratios of spallogenic components in metal reveal a ³He deficiency which is due to the diffusive loss of parent isotopes, that is, tritium (Tilles, 1963; Schultz, 1967). The diffusive loss likely has been induced by thermal heating by the Sun during cosmic‐ray exposure (～160 Ma; Lavielle et al, 1999). Thermal process such as impact‐induced partial loss may have affected the isotopic composition of spallogenic Ne. The ¹²⁹Xe/¹³¹Xe ratio of cosmogenic components in the metal indicates an enhanced production of epi‐thermal neutrons. The abundance ratios of spallogenic components in the graphite reveal that it contained small amounts of metal and silicates. The isotopic composition of heavy noble gases in graphite itself was obtained from graphite treated with HF/HCl. The isotopic composition of the etched graphite shows that it contains two types of primordial Xe (i.e., Q‐Xe and El Taco Xe). The isotopic heterogeneity preserved in the Bohumilitz graphite indicates that the Bohumilitz graphite did not experience any high‐temperature event and, consequently, must have been emplaced into the metal at subsolidus temperatures. This situation is incompatible with an igneous model as well as the impact melting models for the IAB‐IIICD iron meteorites as proposed by Choi et al. (1995) and Wasson et al (1980).     

Radar observations of Itokawa in 2004 and improved shape estimation

Abstract— We present June 2004 radar images of asteroid 25143 Itokawa (1998 SF36) that improve upon the longitude‐latitude coverage of images obtained in 2001 by Ostro et al. (2004) and use the 2001–2004 data to refine that paper's constraints on Itokawa's shape. The 2004 images, the first of the asteroid's southern side, look distinctly different from the 2001 images, revealing leading edges that are much more curved and rugged than the nearly convex leading edges seen at northern latitudes in 2001. Itokawa is shaped like a slightly asymmetrical, bent, lumpy ellipsoid with dimensions along the principal axes within 10% of 594 times 320 times 288 m. To illustrate the uncertainty space associated with shape reconstruction from images with suboptimal orientational coverage, we present two alternative three‐dimensional models of the object.