Tests on low‐ductility RC frames under high‐ and low‐frequency excitations

The response of low‐ductility reinforced concrete (RC) frames, designed typically for a non‐seismic region, subjected to two frequencies of base excitations is studied. Five half‐scaled, two‐bay, two‐storey, RC frames, each approximately 5 m wide by 3.3 m high, were subjected to both horizontal and/or vertical base excitations with a frequency of 40 Hz as well as a lower frequency of about 4 Hz (close to the fundamental frequency) using a shake table. The imposed acceleration amplitude ranged from 0.2 to 1.2g. The test results showed that the response characteristics of the structures differed under high‐ and low‐frequency excitations. The frames were able to sustain high‐frequency excitations without damage but were inadequate for low‐frequency excitations, even though the frames exhibited some ductility. Linear‐elastic time‐history analysis can predict reasonably well the structural response under high‐frequency excitations. As the frames were not designed for seismic loads, the reinforcement detailing may not have been adequate, based on the crack pattern observed. The effect of vertical excitation can cause significant additional forces in the columns and moment reversals in the beams. The ‘strong‐column, weak‐beam’ approach for lateral load RC frame design is supported by experimental observations. Copyright © 2001 John Wiley & Sons, Ltd.     

From models to performance assessment: the conceptualization problem

Today, models are ubiquitous tools for ground water analyses. The intent of this paper is to explore philosophically the role of the conceptual model in analysis. Selection of the appropriate conceptual model is an a priori decision by the analyst. Calibration is an integral part of the modeling process. Unfortunately a wrong or incomplete conceptual model can often be adequately calibrated; good calibration of a model does not ensure a correct conceptual model. Petroleum engineers have another term for calibration; they refer to it as history matching. A caveat to the idea of history matching is that we can make a prediction with some confidence equal to the period of the history match. In other words, if we have matched a 10-year history, we can predict for 10 years with reasonable confidence; beyond 10 years the confidence in the prediction diminishes rapidly. The same rule of thumb applies to ground water model analyses. Nuclear waste disposal poses a difficult problem because the time horizon, 1000 years or longer, is well beyond the possibility of the history match (or period of calibration) in the traditional analysis. Nonetheless, numerical models appear to be the tool of choice for analyzing the safety of waste facilities. Models have a well-recognized inherent uncertainty. Performance assessment, the technique for assessing the safety of nuclear waste facilities, involves an ensemble of cascading models. Performance assessment with its ensemble of models multiplies the inherent uncertainty of the single model. The closer we can approach the idea of a long history with which to match the models, even models of nuclear waste facilities, the more confidence we will have in the analysis (and the models, including performance assessment). This thesis argues for prolonged periods of observation (perhaps as long as 300 to 1000 years) before a nuclear waste facility is finally closed.     

Mechanical twinning in diopside Ca(Mg,Fe)Si2O6: Structural mechanism and associated crystal defects

Diopside twins mechanically on two planes, (100) and (001), and the associated macroscopic twinning strains are identical (Raleigh and Talbot, 1967). An analysis based on crystal structural arguments predicts that both twin mechanisms involve shearing of the (100) octahedral layers (containing Ca²⁺, Mg²⁺ and Fe²⁺ ions) by a magnitude of c/2. Small adjustments or shuffles occur in the adjacent layers containing the [SiO₄]^4? tetrahedral chains. While the (100) twins are conventional with shear parallel to the composition plane, this analysis predicts that (001) twins form by a mechanism closely related to kinking. A polycrystalline diopside specimen was compressed 8% at a temperature of 400° C, a pressure of 16 kilobars, and a compressive strain rate of about 10^?4/s. Transmission electron microscopy on this specimen has revealed four basic lamellar features:

1. (100) mechanical twin lamellae;
2. (100) glide bands containing unit dislocations;
3. (001) twin lamellae;
4. (101) lamellar features, not as yet identified.

The (001) twins often contain remnant (100) lamellae of untwinned host. Twinning dislocations occur in these (100) lamellae and in the (001) twin boundaries with very high densities. Diffraction contrast experiments indicate that the twinning dislocations associated with both twin laws glide on (100) with Burgers vector b=X [001] where X is probably equal to 1/2 on the basis of the structural analysis. Parallels are drawn between mechanical twinning in clinopyroxenes and clinoamphiboles. The exclusive natural occurrence of basal twins in shock-loaded clinopyroxenes and of analogous ( \(\bar 1\) 01) twins in clinoamphiboles is given a simple explanation in terms of the relative difficulty of the “kinking” mechanism as compared to direct glide parallel to the composition plane.     

A reanalysis of the relationship between strong westerlies and precipitation in the Great Plains and Midwest regions of North America

A conceptual model relating expanded or strengthened mid-latitude summer westerlies with summer precipitation patterns has been used to explain past drought events in the Great Plains and Midwest of North America, including drought between 1200 and 1400 AD. However, this relationship was originally described using 20 years of instrumental data from the mid 20{th} century, and has not been verified with modern datasets. We reinvestigated the relationship between July westerlies and precipitation in the United States using instrumental records of the last 55 years. We also investigated whether changes in summer zonal flow patterns associated with precipitation anomalies represent a shift in the latitude of peak westerly winds or an increase in wind speed, or a combination of both.Finally, we briefly compare the pattern of precipitation anomalies to paleoclimatic records of drought between 1200 and 1400 AD. Results confirm that strong westerlies are associated with a band of decreased precipitation extending from the northern Rockies into the Midwest. Changes in summer westerlies associated with these patterns are characterized by a strengthening of mean westerly winds, with only a slight southward shift of peak winds over the Atlantic. Changes in the strength of the westerlies over both the Pacific and Atlantic appear to be important to precipitation deficits in the Midwest. Proxy-climate records from 1200 to 1400 AD indicate widespread drought in the Great Plains and Midwest, consistent with the hypothesis of stronger westerlies at this time. However, drought conditions also extended to other regions of North America, indicating a more detailed understanding of the potential causes and synoptic climatology is needed.     

Zr-in-rutile thermometry in blueschists from Sifnos, Greece

Zr-in-rutile thermometry on samples of blueschist from Sifnos, Greece, yields temperatures that reflect progressive crystallization of rutile from ca. 445 to 505°C with an analytical precision of + 18/−27 and ± 10°C using the electron microprobe and ± 1.5–3.5°C using the ion microprobe. Individual grains are generally homogeneous within analytical uncertainty. Different grains within a single sample record temperature differences as large 55°, although in most samples the range of temperatures is on the order of 25°. In several samples, Zr-in-rutile temperatures from grains within garnet are lower than temperatures from matrix grains, reflecting growth of rutile with increasing temperature of metamorphism. Although the specific rutile-producing reactions have not been identified, it is inferred that rutile grows from either continuous reaction involving the breakdown of lower grade phases (possibly ilmenite), or from pseudomorph reactions involving the breakdown of relic igneous precursors at blueschist-facies conditions. No systematic variation in rutile temperatures was observed across the blueschist belt of northern Sifnos, consistent with the belt having behaved as a coherent block during subduction.     

Rapid magmatic processes accompany arc–continent collision: the Western Bismarck arc, Papua New Guinea

New U–Th–Ra, major and trace element, and Sr–Nd–Pb isotope data are presented for young lavas from the New Britain and Western Bismarck arcs in Papua New Guinea. New Britain is an oceanic arc, whereas the latter is the site of an arc–continent collision. Building on a recent study of the Manus Basin, contrasts between the two arcs are used to evaluate the processes and timescales of magma generation accompanying arc–continent collision and possible slab detachment. All three suites share many attributes characteristic of arc lavas that can be ascribed to the addition of a regionally uniform subduction component derived from the subducting altered oceanic crust and sediment followed by dynamic melting of the modified mantle. However, the Western Bismarck arc lavas diverge from the Pb isotope mixing array formed by the New Britain and the Manus Basin lavas toward elevated ²⁰⁸Pb/²⁰⁴Pb. We interpret this to reflect a second and subsequent addition of sediment melt at crustal depth during collision. ²³⁸U and ²²⁶Ra excesses are preserved in all of the lavas and are greatest in the Western Bismarck arc. High-Mg andesites with high Sr/Y ratios in the westernmost arc are attributed to recent shallow mantle flux melting at the slab edge. Data for two historical rhyolites are also presented. Although these rhyolites formed in quite different tectonic settings and display different geochemical and isotopic compositions, both formed from mafic parents within millennia.     

The distribution of tritium and CFCs in the Weddell Sea during the mid-1980s

Transient tracer data (tritium, CFC11 and CFC12) from the southern, central and northwestern Weddell Sea collected during Polarstern cruises ANT III-3, ANT V-2/3/4 and during Andenes cruise NARE 85 are presented and discussed in the context of hydrographic observations. A kinematic, time-dependent, multi-box model is used to estimate mean residence times and formation rates of several water masses observed in the Weddell Sea.Ice Shelf Water is marked by higher tritium and lower CFC concentrations compared to surface waters. The tracer signature of Ice Shelf Water can only be explained by assuming that its source water mass, Western Shelf Water, has characteristics different from those of surface waters. Using the transient nature of tritium and the CFCs, the mean residence time of Western Shelf Water on the shelf is estimated to be approximately 5 years. Ice Shelf Water is renewed on a time scale of about 14 years from Western Shelf Water by interaction of this water mass with glacial ice underneath the Filchner-Ronne Ice shelf. The Ice Shelf Water signature can be traced across the sill of the Filchner Depression and down the continental slope of the southern Weddell Sea. On the continental slope, new Weddell Sea Bottom Water is formed by entrainment of Weddell Deep Water and Weddell Sea Deep Water into the Ice Shelf Water plume. In the northwestern Weddell Sea, new Weddell Sea Bottom Water is observed in two narrow, deep boundary currents flowing along the base of the continental slope. Classically defined Weddell Sea Bottom Water (θ ≤ −0.7°C) and Weddell Sea Deep Water (−0.7°C ≤ θ ≤ 0°C) are ventilated from the deeper of these boundary currents by lateral spreading and mixing. Model-based estimates yield a total formation rate of 3.5Sv for new Weddell Sea Bottom Water (θ = −1.0°C) and a formation rate of at least 11Sv for Antarctic Bottom Water (θ = −0.5°C).