Influence of temperature,composition, silica activity and oxygen fugacity on the H<Subscript>2</Subscript>O storage capacity of olivine at 8 GPa

Olivine crystals were grown in the presence of a hydrous silicate fluid during multi-anvil experiments at 8 GPa and 1,000–1,600°C. Experiments were conducted both in a simple system (FeO–MgO–SiO₂–H₂O) and in a more complex system containing additional elements (CaO–Na₂O–Al₂O₃–Cr₂O₃–TiO₂–FeO–MgO–SiO₂–H₂O). Silica activity was buffered by the presence of either pyroxene (high a _SiO2) or ferropericlase (low a _SiO2), and was buffered by the presence of Ni + NiO or Fe + FeO, or constrained by the presence of Fe₂O₃. Raman spectroscopy was used to identify pyroxene polymorphs in the run products. Clinoenstatite was present in the 1,000°C experiment, and enstatite in experiments at 1,400–1,520°C. The H₂O content of olivine was measured using secondary ion mass spectroscopy, and infrared spectroscopy was used to investigate the nature of hydrous defects. The H₂O storage capacity of olivine decreases with increasing temperature at 8 GPa. In contrast to previous experimental results at ≤2 GPa, no significant effect of varying oxygen fugacity is evident, but H₂O storage capacity is enhanced under conditions of low silica activity. No significant growth of low wavenumber (<3,400 cm⁻¹) peaks, generally associated with high at low pressure, was observed in the FTIR spectra of olivine from the high experiments. Our experiments show that previous high pressure H₂O storage capacity measurements for olivine synthesized under more oxidizing conditions than the Earth’s mantle are not likely to be compromised by the of the experiments. However, the considerable effect of temperature on H₂O storage capacity in olivine must be taken into account to avoid overestimation of the bulk upper mantle H₂O storage capacity.     

THERIA_G: a software program to numerically model prograde garnet growth

We present the software program THERIA_G, which allows for numerical simulation of garnet growth in a given volume of rock along any pressure–temperature–time (P–T–t) path. THERIA_G assumes thermodynamic equilibrium between the garnet rim and the rock matrix during growth and accounts for component fractionation associated with garnet formation as well as for intracrystalline diffusion within garnet. In addition, THERIA_G keeps track of changes in the equilibrium phase relations, which occur during garnet growth along the specified P–T–t trajectory. This is accomplished by the combination of two major modules: a Gibbs free energy minimization routine is used to calculate equilibrium phase relations including the volume and composition of successive garnet growth increments as P and T and the effective bulk rock composition change. With the second module intragranular multi-component diffusion is modelled for spherical garnet geometry. THERIA_G allows to simulate the formation of an entire garnet population, the nucleation and growth history of which is specified via the garnet crystal size frequency distribution. Garnet growth simulations with THERIA_G produce compositional profiles for the garnet porphyroblasts of each size class of a population and full information on equilibrium phase assemblages for any point along the specified P–T–t trajectory. The results of garnet growth simulation can be used to infer the P–T–t path of metamorphism from the chemical zoning of garnet porphyroblasts. With a hypothetical example of garnet growth in a pelitic rock we demonstrate that it is essential for the interpretation of the chemical zoning of garnet to account for the combined effects of the thermodynamic conditions of garnet growth, the nucleation history and intracrystalline diffusion. Electronic supplementary material  The online version of this article (doi:) contains supplementary material, which is available to authorized users.

An experimental study of the grain-scale processes of peridotite melting: implications for major and trace element distribution during equilibrium and disequilibrium melting

The grain-scale processes of peridotite melting were examined at 1,340°C and 1.5 GPa using reaction couples formed by juxtaposing pre-synthesized clinopyroxenite against pre-synthesized orthopyroxenite or harzburgite in graphite and platinum-lined molybdenum capsules. Reaction between the clinopyroxene and orthopyroxene-rich aggregates produces a melt-enriched, orthopyroxene-free, olivine + clinopyroxene reactive boundary layer. Major and trace element abundance in clinopyroxene vary systematically across the reactive boundary layer with compositional trends similar to the published clinopyroxene core-to-rim compositional variations in the bulk lherzolite partial melting studies conducted at similar P–T conditions. The growth of the reactive boundary layer takes place at the expense of the orthopyroxenite or harzburgite and is consistent with grain-scale processes that involve dissolution, precipitation, reprecipitation, and diffusive exchange between the interstitial melt and surrounding crystals. An important consequence of dissolution–reprecipitation during crystal-melt interaction is the dramatic decrease in diffusive reequilibration time between coexisting minerals and melt. This effect is especially important for high charged, slow diffusing cations during peridotite melting and melt-rock reaction. Apparent clinopyroxene-melt partition coefficients for REE, Sr, Y, Ti, and Zr, measured from reprecipitated clinopyroxene and coexisting melt in the reactive boundary layer, approach their equilibrium values reported in the literature. Disequilibrium melting models based on volume diffusion in solid limited mechanism are likely to significantly underestimate the rates at which major and trace elements in residual minerals reequilibrate with their surrounding melt. Electronic supplementary material  The online version of this article (doi:) contains supplementary material, which is available to authorized users.     

The effects of metamorphism on O and Fe isotope compositions in the Biwabik Iron Formation, northern Minnesota

The Biwabik Iron Formation of Minnesota (1.9 Ga) underwent contact metamorphism by intrusion of the Duluth Complex (1.1 Ga). Apparent quartz–magnetite oxygen isotope temperatures decrease from ∼700°C at the contact to ∼375°C at 2.6 km distance (normal to the contact in 3D). Metamorphic pigeonite at the contact, however, indicates that peak temperatures were greater than 825°C. The apparent O isotope temperatures, therefore, reflect cooling, and not peak metamorphic conditions. Magnetite was reset in δ¹⁸O as a function of grain size, indicating that isotopic exchange was controlled by diffusion of oxygen in magnetite for samples from above the grunerite isograd. Apparent quartz–magnetite O isotope temperatures are similar to calculated closure temperatures for oxygen diffusion in magnetite at a cooling rate of ∼5.6°C/kyr, which suggests that the Biwabik Iron Formation cooled from ∼825 to 400°C in ∼75 kyr at the contact with the Duluth Complex. Isotopic exchange during metamorphism also occurred for Fe, where magnetite–Fe silicate fractionations decrease with increasing metamorphic grade. Correlations between quartz–magnetite O isotope fractionations and magnetite–iron silicate Fe isotope fractionations suggest that both reflect cooling, where the closure temperature for Fe was higher than for O. The net effect of metamorphism on δ¹⁸O–δ⁵⁶Fe variations in magnetite is a strong increase in δ¹⁸O_Mt and a mild decrease in δ⁵⁶Fe with increasing metamorphic grade, relative to the isotopic compositions that are expected at the low temperatures of initial magnetite formation. If metamorphism of Iron Formations occurs in a closed system, bulk O and Fe isotope compositions may be preserved, although re-equilibration among the minerals may occur for both O and Fe isotopes. Electronic supplementary material The online version of this article (doi:) contains supplementary material, which is available to authorized users.     

Controls on porphyroblast size along a regional metamorphic field gradient

Garnet-bearing schists from the Waterville Formation of south-central Maine provide an opportunity to examine the factors governing porphyroblast size over a range of metamorphic grade. Three-dimensional sizes and locations for all garnet porphyroblasts were determined for three samples along the metamorphic field gradient spanning lowest garnet through sillimanite grade, using high-resolution X-ray computed tomography. Comparison of crystal size distributions to previous data sets obtained by stereological methods for the same samples reveals significant differences in mode, mean, and shape of the distributions. Quantitative textural analysis shows that the garnets in each rock crystallized in a diffusion-controlled nucleation and growth regime. In contrast to the typical observation of a correlation between porphyroblast size and position along a metamorphic field gradient, porphyroblast size of the lowest-grade specimen is intermediate between the high- and middle-grade specimens’ sizes. Mean porphyroblast size does not correlate with peak temperatures from garnet-biotite Fe-Mg exchange thermometry, nor is post-crystallization annealing (Ostwald Ripening) required to produce the observed textures, as was previously proposed for these rocks. Robust pseudosection calculations fail to reproduce the observed garnet core compositions for two specimens, suggesting that these calc-pelites experienced metasomatism. For each of these two specimens, Monte Carlo calculations suggest potential pre-metasomatism bulk compositions that replicate garnet core compositions. Pseudosection analyses allow the estimation of the critical temperatures for garnet growth: ∼481, ∼477, and ∼485°C for the lowest-garnet-zone, middle-garnet-zone, and sillimanite-zone specimens, respectively. Porphyroblast size appears to be determined in this case by a combination of the heating rate during garnet crystallization, the critical temperature for the garnet-forming reaction and the kinetics of nucleation. Numerical simulations of thermally accelerated, diffusion-controlled nucleation, and growth for the three samples closely match measured crystal size distributions. These observations and simulations suggest that previous hypotheses linking the garnet size primarily to the temperature at the onset of porphyroblast nucleation can only partially explain the observed textures. Also important in determining porphyroblast size are the heating rate and the distribution of favorable nucleation sites.     

Sulfide-driven arsenic mobilization from arsenopyrite and black shale pyrite

We examined the hypothesis that sulfide drives arsenic mobilization from pyritic black shale by a sulfide-arsenide exchange and oxidation reaction in which sulfide replaces arsenic in arsenopyrite forming pyrite, and arsenide (As−1) is concurrently oxidized to soluble arsenite (As+3). This hypothesis was tested in a series of sulfide-arsenide exchange experiments with arsenopyrite (FeAsS), homogenized black shale from the Newark Basin (Lockatong formation), and pyrite isolated from Newark Basin black shale incubated under oxic (21% O₂), hypoxic (2% O₂, 98% N₂), and anoxic (5% H₂, 95% N₂) conditions. The oxidation state of arsenic in Newark Basin black shale pyrite was determined using X-ray absorption-near edge structure spectroscopy (XANES). Incubation results show that sulfide (1 mM initial concentration) increases arsenic mobilization to the dissolved phase from all three solids under oxic and hypoxic, but not anoxic conditions. Indeed under oxic and hypoxic conditions, the presence of sulfide resulted in the mobilization in 48 h of 13-16 times more arsenic from arsenopyrite and 6-11 times more arsenic from isolated black shale pyrite than in sulfide-free controls. XANES results show that arsenic in Newark Basin black shale pyrite has the same oxidation state as that in FeAsS (−1) and thus extend the sulfide-arsenide exchange mechanism of arsenic mobilization to sedimentary rock, black shale pyrite. Biologically active incubations of whole black shale and its resident microorganisms under sulfate reducing conditions resulted in sevenfold higher mobilization of soluble arsenic than sterile controls. Taken together, our results indicate that sulfide-driven arsenic mobilization would be most important under conditions of redox disequilibrium, such as when sulfate-reducing bacteria release sulfide into oxic groundwater, and that microbial sulfide production is expected to enhance arsenic mobilization in sedimentary rock aquifers with major pyrite-bearing, black shale formations.     

Globalisation in practice: On the politics of boiling pigswill

This paper is about ‘material politics’. It argues that this may be understood as a material ordering of the world in a way that contrasts this with other and equally possible alternative modes of ordering. It also suggests that while material politics may well involve words, it is not discursive in kind. This argument is made for the mundane and material practice of boiling pigswill that the 2001 UK foot and mouth outbreak showed to have a layered importance. Boiling pigswill was a political technique in at least three different ways. First it made difference, dividing the rich from the poor by separating disease free countries from those in which foot and mouth is endemic. Second, it joined times and places by linking past agricultural practices with those of the contemporary world, and linking Britain with the world. And third, it also showed a way of limiting food scarcity on a world wide scale because it allowed food to be recycled, albeit on a small scale, in a region of plenty. ‘Politics’ is often linked to debate, discussion, or explicit contestation. Alternatively, it is sometimes seen as being embedded in and carried by artefacts. For the case of boiling pigswill neither approach is satisfactory. The first privileges the life of the mind while in the second politics is linked too strongly to a single order. The version of politics presented here foregrounds both materiality and difference. And it involves articulation: the question is not whether something is political all by itself but whether it can be called political as part of the process of analysing it.     

Mapping ambivalence: Exploring the geographies of community change and rails-to-trails development using photo-based Q method and PPGIS

As the literature on trail development suggests, recreational trail projects can generate conflicts and controversies, particularly when built on abandoned rail corridors through developed areas. These conflicts are often understood as “not in my back yard” (NIMBY) reactions, suggesting a spatial proximity to conflict which increases as one draws closer to the proposed trail. This research seeks to understand local residents’ perceptions and reactions to recreational trail development in the City of Delaware (Ohio, USA). It addresses two spatially infused questions: Does the potential for conflict related to trail development increase as people live closer to a potential trail (the NIMBY factor)? Can important qualitative factors about favorable and unfavorable land uses including potential recreational trail sites be defined using a participatory methodology and then represented in GIS? The study used a mixed-method approach to collect and analyze qualitative data from a group of local residents. Each participant was interviewed and asked to sort 19 pictures related to trail development. After each of the sorts, participants were asked to explain why they ranked the pictures the way they did. Results of the picture sorts were then analyzed using Q method and mapped with GIS. The results show that spatial proximity matters in the context of trail development and potential NIMBY reactions to trails. Significant differences were found in the picture sorts that reveal the importance of proximity and location, although in a manner contrary to the assumptions in the writings on rails-to-trails. Through combining qualitative methods, Q analysis and PPGIS analysis, the research shows that qualitative place-based studies are capable of generating insights about the complexities of situated geographic change such as recreational trail development.