Environmental hydrogeology of the southern sector of the Samborombon Bay wetland,Argentina

The Samborombon Bay wetland is located on the west margin of the Rio de la Plata estuary, in the Province of Buenos Aires, Argentina. This paper analyses the geological, geomorphologic, soil and vegetation characteristics of the southernmost sector of this wetland and their influence on surface water and groundwater. The study area presents three hydrologic units: coastal dunes, sand sheets and coastal plain. Coastal dunes and sand sheets are recharge zones of high permeability with well-drained, non-saline soils, and a few surface water flows. Changes in the water table are related to rainfall. Groundwater in coastal dunes is Ca–Mg–HCO₃ to Na–HCO₃, and of low salinity (590 mg/l). Groundwater in sand sheets is mainly Na–HCO₃ with a salinity of about 1,020 mg/l. The coastal plain exhibits medium to low permeability sediments, with submerged saline soils poorly drained. Groundwater is Na–Cl with a mean salinity of 16,502 mg/l. A surface hydrological network develops in the coastal plain. Surface water levels near the shoreline are affected by tidal fluctuations; far from the shoreline water accumulates because of poor drainage. Both sectors have Na–Cl water, but the former is more saline. Human intervention and sea level rise may affect the wetland severely.     

Interference of Multiple Strip Footings on Sand Using Small Scale Model Tests

By using small scale model tests, the interference effect on the vertical load-deformation behavior of a number of equally spaced strip footings, placed on the surface of dry sand, was investigated. At any stage, all the footings were assumed to (i) carry exactly equal magnitude of load, and (ii) settle to the same extent. No tilt of the footing was permitted. The effect of clear spacing (s) among footings on the results was explored. A new experimental setup was proposed in which only one footing needs to be employed rather than a number of footings. The bearing capacity increases continuously with decrease in spacing among the footings. The interference effect becomes further prominent with increase in soil friction angle. In contrast to an increase in the bearing capacity, with decrease in spacing of footings, an increase in the footing settlement associated with the ultimate state of shear failure was observed. The present experimental observations were similar to those predicted by the available theory, based on the method of characteristics. As compared to the theory, the present experimental data, however, indicates much greater effect of interference especially for larger spacing among footings.     

Analysis of the 2003 Varunawat Landslide,Uttarkashi, India using Earth Observation data

Mass movements such as landslides in mountainous terrains are natural degradation processes and one of the most important landscape-building factors. Varunawat Parbat overlooking Uttarkashi town witnessed a series of landslides on 23 September 2003 and the debris slides and rock falls continued for 2 weeks. This landslide complex was triggered due to the incessant rainfall prior to the event, and its occurrence led to the blockage of the pilgrim route to Gangotri (source of the Ganges river) and evacuation of thousands of people to safer places. Though there was no loss of lives due to timely evacuation, heavy losses to the property were reported. High-resolution stereoscopic earth observation data were acquired after the incidence to study the landslide in detail with emphasis on the cause of the landslide and mode of failure. Areas along the road and below the Varunawat foothill region are mapped for landslide risk. It was found that the foothill region of the Varunawat Parbat was highly disturbed by man-made activities and houses are dangerously located below steep slopes. The potential zones for landslides along with the existing active and old landslides are mapped. These areas are critical and their treatment with priority is required in order to minimise further landslide occurrences.     

Finite Element Modeling of Swelling Soil Pressures Using Joint/Interface Elements

There could be some discontinuities in a soil media such as layers, earth structures, cracks, and fissures so that estimation of stresses and deformations in these types of soil masses are somewhat different from continuous masses. The discontinuities in a soil mass could be considered as a special link between two blocks. Transmitted swelling pressures affected by the soil properties of the backfill especially at the interface between the backfill and retaining wall. In order to estimate the transmitted swelling pressure distribution behind a retaining wall, using with interface element, a new finite element model and a code (SWELPRES) have been developed. To evaluate the effect of backfill characteristics and interface element from the transmitted lateral swelling pressures, four cases of thickness of backfills with or without interface elements are investigated.     

Monitoring Large-Scale Tests for Nuclear Waste Disposal

Two large-scale “in situ” demonstration experiments and their instrumentation are described. The first test (FEBEX Experiment) involves the hydration of a compacted bentonite barrier under the combined effect of an inner source of heat and an outer water flow from the confining saturated granite rock. In the second case, the progressive de-saturation of Opalinus clay induced by maintained ventilation of an unlined tunnel is analyzed. The paper shows the performance of different sensors (capacitive cells, psychrometers, TDR’s) and a comparison of fill behaviour with modelling results. The long term performance of some instruments could also be evaluated specially in the case of FEBEX test. Capacitive sensors provide relative humidity data during long transient periods characterised by very large variations of suction within the bentonite.     

Partitioning of polycyclic aromatic hydrocarbons between water and particles compared to bioaccumulation in mussels: a harbour case

Water and particles from three sites located in Halifax Harbour, near and further away from combined municipal sewage effluents (CMSE) were analysed for parental and alkylated polycyclic aromatic hydrocarbons (par and alkPAH). Bioavailability of PAH was compared for inter-tidal mussels collected at the same sites in April and November. The PAH fingerprint determined over 9 sampling times covering a period of 19 months differed more between phases (water and particles) and seasons, than between sites. In the spring, more alkPAH associated with diesel and gasoline were detected in the soluble phase, along with more bioaccumulation of alkPAH in inter-tidal mussels. A broader number of parPAH were detected in mussels collected in the fall. The mean sum of dissolved alkPAH concentrations was higher in water at the site closer to raw CMSE than at the other two sites and particles of that site. However, lowest bioconcentration factors (BCF) were determined in mussels of this more contaminated site. Similar biota-particle accumulation factors (BPAF) were determined for parPAH in mussels from the three sites, all lower than the BCF of alkPAH. The study indicates that sewage treatment plants will reduce the amount of parPAH especially larger than fluoranthene and pyrene from being deposited in the harbour; that alk naphthalenes and fluorenes present in water will continue to be discharged; that the disturbance of sediments can make particle-bound PAH available to mussels.     

Constraining the origin and evolution of confined turbidite systems: southern Cretan margin,Eastern Mediterranean Sea (34°30–36°N)

Bathymetric, 9.5-kHz long-range sidescan sonar (OKEAN), seismic reflection and sediment-core data are used in the analysis of two tectonic troughs south of Crete, Eastern Mediterranean Sea. Here, up to 1.2 s two-way travel time (TWTT) of strata have accumulated since the Middle Miocene in association with extension in the South Aegean region. The study area comprises >100-km- long by >25-km-wide basins filled by sediments subdivided into two seismic units: (1) an upper Unit 1 deposited in sub-basins which follow the present-day configuration of the southern Cretan margin; (2) a basal Unit 2, more than 500 ms (TWTT) thick, accumulated in deeper half-graben/grabens distinct from the present-day depocentres. Both units overlap a locally stratified Unit 3 comprising the pre-Neogene core complex of Crete and Gavdos. In this work, the interpreted seismic units are correlated with the onshore stratigraphy, demonstrating that denudation processes occurring on Crete and Gavdos in response to major tectonic events have been responsible for high sedimentation rates along the proximal southern Cretan margin. Consequently, topographically confined sedimentary units have been deposited south of Crete in the last 12 Ma, including turbidites and other mass-flow deposits fed by evolving transverse and axial channel systems. Surface processes controlling facies distribution include the direct inflow of sediment from alluvial-fan systems and incising mountain rivers onto the Cretan slope, where significant sediment instability processes occur at present. In this setting, seismic profiles reveal eight different types of stratigraphic contacts on basin-margin highs, and basinal areas show evidence of halokinesis and/or fluid escape. The acquired data also show that significant changes to the margin’s configuration occurred in association with the post-Alpine tectonic and eustatic episodes affecting the Eastern Mediterranean.     

Sublethal effects of hydrogen sulfide in sediments on the Urchin Lytechinus pictus

Laboratory exposures of the urchin Lytechinus pictus to sediment dosed with varying concentrations of hydrogen sulfide (H₂S), but without elevated organic material, were conducted. Changes in mortality, behavior, growth and gonad production were measured during 49 days' flow through exposures. Hydrogen sulfide concentrations of 165·8 μ liter⁻¹ in pore water caused significant changes in all parameters measured. Concentrations as low as 32·9 μ liter⁻¹ caused significant decreases in wet weight and male gonad production. A concentration of 91·8 μ liter⁻¹ caused the mortality rate to increase 100-fold over control exposures (0·63 μ liter⁻¹). Sublethal effects on growth and gonad production could have been caused by either direct biochemical inhibition by H₂S or secondarily through behavioral modifications. Hydrogen sulfide concentrations above 165·8 μ liter⁻¹ are common near sewage outfalls and could contribute to changes in species composition and sediment toxicity that occur there.     

Mixed-function oxygenases as biological monitors around petroleum hydrocarbon development sites: Potential for induction by diesel and other drilling mud base oils containing reduced levels of polycyclic aromatic hydrocarbons

The use of oil-based drilling muds has been discouraged in hydrocarbon exploration and production in the marine environment but these muds are presently being used to a considerable degree in the United Kingdom and Norwegian sectors of the North Sea. Field studies in the North Sea have demonstrated only localized impacts around individual drilling sites,^1,2 even including those sites where ‘toxic’ diesel oils were employed as base fluids in drilling muds. Yet the question of disposal of cuttings contaminated with oil from drilling muds remains somewhat controversial. The induction of mixed-function oxygenases (MFO) has been validated on a number of occasions in the field as a sensitive index of low level hydrocarbon exposure (reviewed by Payne),³ including sites in the North Sea where diesel-based muds were used.⁴ The present study demonstrates that any potential for induction by hydrocarbon contaminated cuttings will probably be reduced by substitution of low-aromatic base oils for diesel in drilling mud formulations.     

Mechanisms controlling the temporal variation of the sea ice edge in the Southern Ocean

This paper examines the mechanism controlling the short time-scale variation of sea ice cover over the Southern Ocean. Sea ice concentration and ice velocity datasets derived from images of the Defense Meteorological Satellite Program (DMSP) Special Sensor Microwave Imager (SSM/I) are employed to reveal this mechanism. The contribution of both dynamic and thermodynamic processes to the change in ice edge location is examined by comparing the meridional velocity of ice edge displacement and sea ice drift. In the winter expansion phase, the thermodynamic process of new ice production off the ice edge plays an important role in daily advances of ice cover, whereas daily retreats are mostly due to southward ice drift. On the other hand, both advance and retreat of ice edges in the spring contraction phase are mostly caused by the dynamic process of the ice drift. Based on the above mechanism and the linear relation between the degree of ice production at the ice edge and northward wind speed, the seasonal advance of ice cover can be roughly reproduced using the meridional velocity of ice drift at the ice edge.