贵州都匀下泥盆统蟒山群Zosterophyllum australianum(澳大利亚工蕨)新材料及其古地理意义*

Zosterophyllum(工蕨属)是早期陆生植物的代表性类群之一,全球广泛分布。Z.australianum(澳大利亚工蕨)产自华南和澳大利亚,是东北冈瓦纳古植物地理区系的典型分子。文中描述了产自贵州都匀包阳剖面蟒山群中的Z.australianum新材料。该标本的孢子囊具短柄,呈椭圆形或扇形,宽2.6~4.1 mm,高可达3.9 mm,加厚带宽约0.6 mm,紧密螺旋排列形成孢子囊穗,与云南文山早泥盆世坡松冲植物群中的Z. australiaunum极为相似。依据目前对Z. australianum时代延限的认识,并结合蟒山群其他植物属种的发现(如Adoketophyton subverticillatum),推断该群下段的时代为早泥盆世布拉格期。Z. australianum在蟒山群中的发现,扩展了该植物的地理分布范围,反映出蟒山群中的植物组合与坡松冲植物群存在一定联系。     

Process and Mechanisms of Deep Fluid Effects on Hydrocarbon Generation and Pore Space in Shale: A Case Study from the Mesoproterozoic Xiamaling Formation in the Zhaojiashan Section

Heat carried by deep fluid might greatly affect hydrocarbon generation and pore space in shale. Dyke intrusion carrying high levels of heat may be a means by which to explore the influence of deep fluid on shale reservoirs. This study evaluates hydrocarbon generation and analyzed the evolution of shale storage space in the third member of the Xiamaling Formation in the Zhaojiashan section, Hebei Province, based on experimental data such as TOC, SEM, VRo, low-temperature N2 adsorption and high-pressure mercury injection. The results show that the dyke intrusion reduced the shale TOC content drastically―by up to 77%―and also induced instantaneous hydrocarbon generation over a range about 1.4 times the thickness of the intrusion. Furthermore, the dyke intrusion might transform organic pores in surrounding shales into inorganic pores. There were two shale porosity peaks: one appeared when VRo = 2.0%, caused by the increase of organic pores as thermal maturity increased, the other occurred when the VRo value was between 3% and 4%, caused by the increase of inorganic mineral pores. It can be concluded that dyke intrusion can be an effective tool with which to study how deep fluid affects instantaneous hydrocarbon generation and pore space in shale.     

Reverse fault slip through soft rock and sand strata by centrifuge modeling tests

The devastating damage after the 1999 Chi-Chi and 1999 Izmit earthquakes has greatly motivated soil–reverse fault interaction studies. However, most centrifuge modeling studies have employed a single homogeneous soil layer during testing, which does not represent in situ conditions. Indeed, while geological conditions vary spatially, engineering soils are often underlain by soft rocks. Therefore, four centrifuge models were developed to evaluate the effect of soft rock layers on the ground surface and subsurface deformation. Sand–cement mixtures of varying thicknesses with a uniaxial compressive strength of 0.975 MPa, simulating extremely soft rock, were overlain by pluviated sandy soil. The model thickness was 100 mm, corresponding to 8 m in the prototype scale when spun at 80 g. Every model was subjected to a vertical offset of 50 mm/4 m (0.5 H; H: total sedimentary deposit thickness) along a reverse fault with a 60° dip. The results indicate that the presence of a soft rock stratum results in the creation of a horst profile at the ground surface. Additionally, the thinner the soil layer on top of the soft rock stratum is, the longer and higher the horst created at the ground surface. Consequently, the fault deformation zone lengthens proportionally with the increasing thickness ratio of the soft rock. Furthermore, the presence of soft rock as an intermediary stratum between bedrock and soil causes the deformation zone boundary on the hanging wall side to move in the direction of fault movement.

     

Fabric evolution and liquefaction resistance in multiple-liquefaction process: a micromechanical study using DEM-clump

Acta Geotechnica - Recent earthquake case histories in Japan and New Zealand revealed that soil sites can experience liquefaction multiple times under a sequence of earthquake shaking. Field...     

Hybrid machine learning model with random field and limited CPT data to quantify horizontal scale of fluctuation of soil spatial variability

Acta Geotechnica - The scale of fluctuation (SOF) is the critical parameter to describe the soil spatial variability, which significantly influences the embedded geostructures. Due to the limited...     

Enhanced anisotropic bounding surface plasticity model considering modified spacing ratio of anisotropically consolidated clay

Acta Geotechnica - The critical state of anisotropically consolidated clay is not well captured by the classical anisotropic bounding surface plasticity model without considering the real...     

基于颗粒阻尼器的多鼓型古柱抗震性能研究

为保护地震作用下历史遗迹帕特农神庙多鼓石柱,提出将破损的石鼓替换为填充颗粒的空鼓,以减轻多鼓石柱动力响应。本文基于PFC3D与FLAC3D软件,实现了离散-有限耦合作用,模拟了附有颗粒阻尼器帕特农神庙多鼓型石柱,研究了颗粒阻尼器对帕特农神庙石柱的减震效果,并分析地震强度、频率、阻尼器位置等因素对减震效果的影响。研究结果表明,将颗粒阻尼器替换破损的空鼓,PFC3D与FLAC3D耦合计算结果与试验结果基本一致,减震效果显著,说明耦合分析方法研究颗粒阻尼器抗震性能具有较高的可靠性;地震强度不同时,分层颗粒阻尼器仍可较好地耗散能量;颗粒阻尼器对结构的减震性能受激励频率的影响显著,频率越高,减震效果越好;颗粒阻尼器布置在古柱中上部减震效果优于布置在古柱下部。     

Shaking table test of subgrade slope reinforced by gravity retaining wall with geogrids

Gravity retaining wall with geogrids has showed excellent seismic performance from Wenchuan great earthquake. However, seismic damage mechanism of this kind of wall is not sufficiently clear. In view of this, a large shaking table test of the gravity retaining wall with geogrids to reinforce the subgrade slope was carried out, and based on the Hilbert-Huang transform and the marginal spectrum theory, the energy identification method of the slope dynamic failure mode was studied. The results show that the geogrids can effectively reduce displacement and rotation of the retaining wall, and it can effectively absorb the energy of the ground movement when combined with the surrounding soil. In addition, it also reveals the failure development of the gravity retaining wall with geogrids to reinforce the subgrade slope. The damage started in the deep zone near the geogrids, and then gradually extended to the surface of the subgrade slope and other zones, finally formed a continuous failure surface along the geogrids. The analysis results of the failure mode identified by the Hilbert marginal spectrum are in good consistency with the experimental results, which prove that the Hilbert marginal spectrum can be applied to obtain the seismic damage mechanism of slope.

     

In situ calcite U−Pb geochronology by high-sensitivity single-collector LA-SF-ICP-MS

Science China Earth Sciences - U?Pb geochronology of calcite using laser ablation-inductively coupled plasma-mass spectrometry (LA-ICP-MS) is an emerging method, with potential applications...     

Temporal evolution of the focal mechanism consistency of the 2021 Yangbi MS 6.4 earthquake sequence in Yunnan

Using the Cut And Paste (CAP) method, we invert the focal mechanism of 38 moderate earthquakes (M_S ≥ 3.0) recorded by Yunnan seismic network and analyze the corresponding focal mechanism consistency based on the minimum spatial rotation angle. Our results indicate that the M_S 6.4 mainshock is induced by a lateral strike slip fault (with a rake angle of ～ ?165°) and a little normal-faulting component event along a nearly vertical plane (dipping angle～ 79° and strike ～138°). Combining our results with high resolution catalog, we argue that the seismogenic fault of this earthquake sequence is a secondary fault western to the major Weixi-Qiaohou-Weishan fault. The focal mechanism evolution can be divided into three periods. During the first period, the foreshock sequence, the focal mechanism consistency is the highest (KA<36°); during the second period which is shortly after the mainshock, the focal mechanism shows strong variation with KA ranging from 8° to 110°; during the third period, the seismicity becomes weak and the focal mechanism of the earthquakes becomes more consistent than the second period (18°<KA<73°). We suggest that the KA, to some extent, represents the coherence between local tectonic stress regime and the stress state of each individual earthquake. Furthermore, high focal mechanism consistency and high linearity of seismic distribution may serve as indicators for the identification of foreshock sequence.