Evidence for Early Miocene wrench faulting in the Marlborough Fault System,New Zealand: structural implications

Abstract

In New Zealand, the Marlborough strike-slip faults link the Hikurangi subduction zone to the Alpine fault collision zone. Stratigraphic and structural analysis in the Marlborough region constrain the inception of the current strike-slip tectonics.

Six major Neogene basins are investigated. Their infill is composed of marine and freshwater sediments up to 3 km thick; they are characterised by coarse facies derived from the basins bounding relief, high sedimentation rates and asymmetric geometries. Proposed factors that controlled the basins generation are the initial geometry of the strike-slip faults and the progressive strike-slip motion. Two groups of basins are presented: the early Miocene (23 My) basins were generated under wrench tectonics above releasing-jogs between basement faults. The late Miocene (11 My) basins were initiated by halfgrabens tilted along straighter faults during a transtensive stage. Development of faults during Cretaceous to Oligocene times facilitated the following propagation of wrench tectonics. The Pliocene (5 My) to current increasing convergence has shortened the basins and distorted the Miocene array of faults. This study indicates that the Marlborough Fault System is an old feature that connected part of the Hikurangi margin to the Alpine fault since the subduction and collision initiation. © Elsevier, Paris     

Authigenic carbonates related to active seepage of methane-rich hot brines at the Cheops mud volcano,Menes caldera (Nile deep-sea fan,eastern Mediterranean Sea)

On the passive margin of the Nile deep-sea fan, the active Cheops mud volcano (MV; ca. 1,500 m diameter, ~20–30 m above seafloor, 3,010–3,020 m water depth) comprises a crater lake with hot (up to ca. 42 °C) methane-rich muddy brines in places overflowing down the MV flanks. During the Medeco2 cruise in fall 2007, ROV dives enabled detailed sampling of the brine fluid, bottom lake sediments at ca. 450 m lake depth, sub-surface sediments from the MV flanks, and carbonate crusts at the MV foot. Based on mineralogical, elemental and stable isotope analyses, this study aims at exploring the origin of the brine fluid and the key biogeochemical processes controlling the formation of these deep-sea authigenic carbonates. In addition to their patchy occurrence in crusts outcropping at the seafloor, authigenic carbonates occur as small concretions disseminated within sub-seafloor sediments, as well as in the bottom sediments and muddy brine of the crater lake. Aragonite and Mg-calcite dominate in the carbonate crusts and in sub-seafloor concretions at the MV foot, whereas Mg-calcite, dolomite and ankerite dominate in the muddy brine lake and in sub-seafloor concretions near the crater rim. The carbonate crusts and sub-seafloor concretions at the MV foot precipitated in isotopic equilibrium with bottom seawater temperature; their low δ¹³C values (–42.6 to –24.5‰) indicate that anaerobic oxidation of methane was the main driver of carbonate precipitation. By contrast, carbonates from the muddy lake brine, bottom lake concretions and crater rim concretions display much higher δ¹³C (up to –5.2‰) and low δ¹⁸O values (down to –2.8‰); this is consistent with their formation in warm fluids of deep origin characterized by ¹³C-rich CO₂ and, as confirmed by independent evidence, slightly higher heavy rare earth element signatures, the main driver of carbonate precipitation being methanogenesis. Moreover, the benthic activity within the seafloor sediment enhances aerobic oxidation of methane and of sulphide that promotes carbonate dissolution and gypsum precipitation. These findings imply that the coupling of carbon and sulphur microbial reactions represents the major link for the transfer of elements and for carbon isotope fractionation between fluids and authigenic minerals. A new challenge awaiting future studies in cold seep environments is to expand this work to oxidized and reduced sulphur authigenic minerals.     

Estimating suspended sediment concentrations from turbidity measurements and the calibration problem

In situ turbidity meters are being increasingly used to generate continuous records of suspended sediment concentration in rivers. However, the usefulness of the information obtained depends heavily on the existence of a close relationship between fluctuations in suspended sediment concentration and turbidity and the calibration procedure that relates suspended sediment concentration to the turbidity meter's signal. This study assesses the relationship between suspended sediment concentration and turbidity for a small (1·19 km²) rural catchment in southern Brazil and evaluates two calibration methods by comparing the estimates of suspended sediment concentration obtained from the calibrated turbidity readings with direct measurements obtained using a USDH 48 suspended sediment sampler. With the first calibration method, the calibration relationship is derived by relating the turbidity readings to simultaneous measurements of concentration obtained from suspended sediment samples collected from the vicinity of the turbidity probe during flood events. With the second method, the calibration is based on the readings obtained from the turbidity meter when the probe immersed in samples of known concentration prepared using soils collected from the catchment. Overall, there was a close link between fluctuations in suspended sediment concentration and turbidity in the stream at the outlet of the catchment, and the estimates of sediment concentration obtained using the first calibration method corresponded closely with the conventionally measured sediment concentrations. However, use of the second calibration method introduced appreciable errors. When the estimated sediment concentrations were compared with the measured values, the mean errors were ± 122 mg l^?1 and + 601 mg l^?1 for the first and second calibration procedures respectively. Copyright © 2007 John Wiley & Sons, Ltd.     

Preliminary spectral characterization of snow in a high altitude tropical glacier and potential effects of impurities in snow on albedo of tropical glaciers

This paper presents some preliminary measurements of snow spectral reflectance on the tropical Bolivian Zongo glacier. Measurements show a correct agreement with theoretical spectral albedo of pure snow in the near infrared region, but lower values in the visible region (by 10–20%) probably due to aerosols contained in snow. Impurity contents ranged from 10 to 100 ppmw in one‐week‐old snow collected from the Zongo glacier, but measurements are scarce. Large amounts of snowfall partly compensate the proximity of dust sources in mid‐latitude glaciers, whereas on outer‐tropical glaciers precipitations are not abundant and are very seasonal, and sources of aerosols are proximate. Copyright © 2007 John Wiley & Sons, Ltd.     

Biodegradation and transport of benzene,toluene, and xylenes in a simulated aquifer: comparison of modelled and experimental results

Both laboratory experiments and numerical modelling were conducted to study the biodegradation and transport of benzene–toluene–xylenes (BTX) in a simulated semi‐confined aquifer. The factors incorporated into the numerical model include advection, hydrodynamic dispersion, adsorption, and biodegradation. The various physico‐chemical parameters required by the numerical model were measured experimentally. In the experimental portion of the study, BTX compounds were introduced into the aquifer sand. After the contaminants had been transported through the system, BTX concentrations were measured at 12 equally spaced wells. Subsequently, microorganisms obtained from the activated sludge of a sewage treatment plant and cultured in BTX mixtures were introduced into the aquifer through the 12 sampling wells. The distribution data for BTX adsorption by the aquifer sand form a nonlinear isotherm. The degree of adsorption by the sand varies, depending on the composition of the solute. The degradation time, measured from the time since the bacteria were added to the aquifer until a specific contaminant was no longer detectable, was 35–42 h for BTX. The dissolved oxygen, after degradation by BTX compounds and bacteria, was consumed by about 40–60% in the entire simulated aquifer; thus the aerobic conditions were maintained. This study provides insights for the biodegradation and transport of BTX in aquifers by numerical modelling and laboratory experiments. Experimental and numerical comparisons indicate that the results by Monod degradation kinetics are more accurate than those by the first‐order degradation kinetics. Copyright © 2002 John Wiley & Sons, Ltd.     

Effects of boundary conditions and partial drainage on cyclic simple shear test results—a numerical study

Owing to imperfect boundary conditions in laboratory soil tests and the possibility of water diffusion inside the soil specimen in undrained tests, the assumption of uniform stress/strain over the sample is not valid. This study presents a qualitative assessment of the effects of non‐uniformities in stresses and strains, as well as effects of water diffusion within the soil sample on the global results of undrained cyclic simple shear tests. The possible implications of those phenomena on the results of liquefaction strength assessment are also discussed. A state‐of‐the‐art finite element code for transient analysis of multi‐phase systems is used to compare results of the so‐called ‘element tests’ (numerical constitutive experiments assuming uniform stress/strain/pore pressure distribution throughout the sample) with results of actual simulations of undrained cyclic simple shear tests using a finite element mesh and realistic boundary conditions. The finite element simulations are performed under various conditions, covering the entire range of practical situations: (1) perfectly drained soil specimen with constant volume, (2) perfectly undrained specimen, and (3) undrained test with possibility of water diffusion within the sample. The results presented here are restricted to strain‐driven tests performed for a loose uniform fine sand with relative density D_r=40%. Effects of system compliance in undrained laboratory simple shear tests are not investigated here. Copyright © 2004 John Wiley & Sons, Ltd.     

Paleomagnetism of the North American Precambrian: a look at the data base

More than half of the approximately 650 paleopoles reported from all Precambrian cratons have been obtained from North America. The observations have spurred a proliferation of apparent polar wander paths to support different hypotheses for the tectonic evolution of the continent. Many of the reasons for this development can be traced to the inadequacy of the data base with its average of only 1.6 poles 10 Ma^?1 (as compared to 7 poles 10^?1 Ma for the last 300 Ma). Even when it is assumed that a ·primary’ pole has been derived from each rock unit sampled, the total number of ·primary’ poles (excluding the 900–1200 Ma interval) yields an average of only 0.4 pole 10 Ma^?1. An inspection of the data base shows a non-systematic sampling of a non-continuous (fragmented) paleomagnetic record with gaps as large as tens and even hundreds of Ma. More importantly, a search through the literature reveals that very few poles have an age known to better than 50 Ma and for many poles the age bracket could be as large as a few hundreds of Ma. This is partly owing to the fact that radiometric and paleomagnetic sites rarely originate from the same localities. It is shown that this limited data base with all its deficiencies and uncertainties cannot be used to support certain hypotheses, or for the drawing of a meaningful apparent polar path for the whole of the Precambrian. It appears that, because of the enormous time scale, Precambrian paleomagnetism should rather be directed towards the construction of segments of polar paths such as those in the 900–1200 Ma interval. Comparison of well dated contemporaneous segments from different parts (or structural provinces) could be used most effectively to delineate relative movements, if any, and reconstruct the mosaic of the past continent for certain time intervals. One of the recent developments of Precambrian paleomagnetism has been to show that the apparent pole did not remain constrained to the equatorial region, but made several excursions into high latitudes.