Array analyses of volcanic earthquakes and tremor recorded at Las Cañadas caldera (Tenerife Island, Spain) during the 2004 seismic activation of Teide volcano

We analyze data from three seismic antennas deployed in Las Cañadas caldera (Tenerife) during May–July 2004. The period selected for the analysis (May 12–31, 2004) constitutes one of the most active seismic episodes reported in the area, except for the precursory seismicity accompanying historical eruptions. Most seismic signals recorded by the antennas were volcano-tectonic (VT) earthquakes. They usually exhibited low magnitudes, although some of them were large enough to be felt at nearby villages. A few long-period (LP) events, generally associated with the presence of volcanic fluids in the medium, were also detected. Furthermore, we detected the appearance of a continuous tremor that started on May 18 and lasted for several weeks, at least until the end of the recording period. It is the first time that volcanic tremor has been reported at Teide volcano. This tremor was a small-amplitude, narrow-band signal with central frequency in the range 1–6 Hz. It was detected at the three antennas located in Las Cañadas caldera. We applied the zero-lag cross-correlation (ZLCC) method to estimate the propagation parameters (back-azimuth and apparent slowness) of the recorded signals. For VT earthquakes, we also determined the S–P times and source locations. Our results indicate that at the beginning of the analyzed period most earthquakes clustered in a deep volume below the northwest flank of Teide volcano. The similarity of the propagation parameters obtained for LP events and these early VT earthquakes suggests that LP events might also originate within the source volume of the VT cluster. During the last two weeks of May, VT earthquakes were generally shallower, and spread all over Las Cañadas caldera. Finally, the analysis of the tremor wavefield points to the presence of multiple, low-energy sources acting simultaneously. We propose a model to explain the pattern of seismicity observed at Teide volcano. The process started in early April with a deep magma injection under the northwest flank of Teide volcano, related to a basaltic magma chamber inferred by geological and geophysical studies. The stress changes associated with the injection produced the deep VT cluster. In turn, the occurrence of earthquakes permitted an enhanced supply of fresh magmatic gases toward the surface. This gas flow induced the generation of LP events. The gases permeated the volcanic edifice, producing lubrication of pre-existing fractures and thus favoring the occurrence of VT earthquakes. On May 18, the flow front reached the shallow aquifer located under Las Cañadas caldera. The induced instability constituted the driving mechanism of the observed tremor.     

Water Quality Monitoring to Support the European Commission's Water Framework Directive Reporting Requirements

This article aims at providing a simple way for water quality monitoring in a set of reservoirs using an earth observation‐based approach and the assessment of the use of this technique for a monitoring network in order to meet the requirements and objectives of the Water Framework Directive (WFD) by the Member States of the European Union. The study carried out was preformed in 42 reservoirs of the Ebro River Basin, in the northeast of Spain. The proposed methodology is based on the development of an algorithm for the estimation of water quality by means of LANDSAT TM band reflectance. Some band ratios were used in the model as well. Trophic State Index (TSI), calculated by means of Secchi Disc Transparency data, was estimated using a forward stepwise multiple regression analysis and the TM2 band and TM1/TM2 ratio. The final results showed a large variability in water quality across reservoirs. Moreover, substantial spatial heterogeneity was also observed in the water bodies. These results demonstrate the likelihood of developing a monitoring network based on remote sensing techniques for the implementation of the WFD.     

Effects of industrial by-product amendments on As,Cd and Tl retention/release in an element-spiked acidic soil

To asses the efficiency of two by-products (phosphogypsum (PG) and sugar foam (SF), rich in gypsum and calcium carbonate, respectively) in the immobilization of three toxic elements (As, Cd and Tl) in an acidic soil, batch-scale sorption and desorption experiments were conducted after 18 months of in situ amendment application. The Langmuir isotherms applied for sorption studies showed that the estimated maximum sorption capacity of the elements was highest in the SF-treated samples. The amount of element retained and the percentage of extraction after TCLP tests indicated that those samples amended with sugar foam (SF and PG + SF) had the potential to immobilize As, Cd and Tl in an acidic soil with low sorptive capacity. In addition to sorption and desorption experiments, scanning electron microscopy in back-scattered electron mode (SEM-BSE) showed the formation of Al-hydroxy polymers which provides the soil with additional sorption capacity. The three target elements were associated with the Al-hydroxy polymers, probably through direct coordination or the formation of ternary complexes. By means of statistical analysis it has been found that sorption processes of As, Cd and Tl in this soil mainly depend on the treatment, whereas desorption is an element-dependent process.     

Thermal and mechanical structure of the central Iberian Peninsula lithosphere

The central Iberian Peninsula (Spain) is made up of three main tectonic units: a mountain range, the Spanish Central System and two Tertiary basins (those of the rivers Duero and Tajo). These units are the result of widespread foreland deformation of the Iberian plate interior in response to Alpine convergence of European and African plates. The present study was designed to investigate thermal structure and rheological stratification in this region of central Spain. Surface heat flow has been described to range from 80 to 60 mW m⁻². Highest surface heat flow values correspond to the Central System and northern part of the Tajo Basin. The relationship between elevation and thermal state was used to construct a one-dimensional thermal model. Mantle heat flow drops from 34 mW m⁻² (Duero Basin) to 27 mW m⁻² (Tajo Basin), and increases with diminishing surface heat flow. Strength predictions made by extrapolating experimental data indicate varying rheological stratification throughout the area. In general, in compression, ductile fields predominate in the middle and lower crusts and lithospheric mantle. Brittle behaviour is restricted to the first 8 km of the upper crust and to a thin layer at the top of the middle crust. In tension, brittle layers are slightly more extended, while the lower crust and lithospheric mantle remain ductile in the case of a wet peridotite composition. Discontinuities in brittle and ductile layer thickness determine lateral rheological anisotropy. Tectonic units roughly correspond to rheological domains. Brittle layers reach their maximum thickness beneath the Duero Basin and are of least thickness under the Tajo Basin, especially its northern area. Estimated total lithospheric strength shows a range from 2.5×10¹² to 8×10¹² N m⁻¹ in compression, and from 1.3×10¹² to 1.6×10¹² N m⁻¹ in tension. Highest values were estimated for the Duero Basin.Depth versus frequency of earthquakes correlates well with strength predictions. Earthquake foci concentrate mainly in the upper crust, showing a peak close to maximum strength depth. Most earthquakes occur in the southern margin of the Central System and southeast Tajo Basin. Seismicity is related to major faults, some bounding rheological domains. The Duero Basin is a relative quiescence zone characterised by higher total lithospheric strength than the remaining units.     

Site effect evaluation at Mexico City: Dominant period and relative amplification from strong motion and microtremor records

Site effects in Mexico City are discussed in terms of simple 1D, one-layer, linear models. The analysis is focussed on two parameters: dominant period and maximum amplification relative to a firm site within the city. The data used is a compilation of strong motion data and microtremor measurements. Strong motion data consist of digital acceleration records for nine events recorded by the Accelerographic Network of Mexico City. The authors analyzed spectral ratios of horizontal components of soft soil sites relative to an average of firm site observations for this data set. Dominant period, maximum relative amplification and an estimate of material damping were computed from the empirical transfer functions thus obtained. Microtremor data were compiled from measurement of different groups during the period 1985–1992. In all, 409 measurement points were analyzed. Values of dominant period obtained from microtremor measurements are in excellent agreement with those obtained from empirical transfer functions for strong motion data. The synthesis of results allows us to draw a detailed and robust map of dominant period for Mexico City. Based on this map, the authors propose some modifications to the current microzonation of Mexico City and evaluate a proposed model to account for site effects in this city.     

Paleoseismic indications along ‘aseismic’ fault segments in the guadalentín depression (SE Spain)

The Guadalentín Depression, located in SE Spain (Murcia Region), is bounded by two of the main NE-SW master faults of the Eastern Betics Cordilleras: The Lorca-Alhama and the Palomares left-lateral strike-slip faults. Available earthquake data indicate that, in the last 600 years, some sectors of the Lorca-Alhama Fault and the entire sector of the Palomares Fault have not been associated with significant historical seismicity. However, they show a wide range of diagnostic features of earthquake surface displacements on late Pleistocene and Holocene alluvial and colluvial surfaces. Aside from the left-lateral offsets recorded along 045–050 ° master fault strands of the Lorca-Alhama Fault, major paleoseismic surface displacements show different kinematics in relation to the broad orientation of the fault strands: (1) vertical normal displacements along 010–020 ° trending faults mainly preserved as degraded fault scarps of 2.5-1.8 m high (Aljibejo site); and (2) vertical reverse displacements, with average offsets of 0.2 – 1 m, along 065–080 ° subsidiary faults. In this last group, the younger one (Carraclaca Baths site) remains as a fault scarp of 0.8 m height affecting a cascade tufa which was active until the Spanish Roman Period (2nd Century B.C. to 6th Century A.D.). In other cases, reverse offsets resulted in smaller displacements (0.26 m) of paleosols, but show a recurrent behaviour (La Escarihuela site). The strongest earthquakes recorded in the study area did not exceed more than Mb 4.5 or MSK Intensity VIII (historical) with no evidence of coseismic rupture. Therefore, the preliminary data presented here seem to indicate that the paleoseismic activity on both faults is capable of producing coseismic surface displacements, probably reaching magnitudes of at least 6.5. These data show that paleoseismic studies based on geomorphological analyses are a useful tool in the assessment of the relative degree of activity of apparently ‘aseismic’ fault traces.