Using ALSM to map sinkholes in the urbanized covered karst of Pinellas County,Florida—1, methodological considerations

Comparison of a database of interpreted sinkholes made using airborne laser swath mapping (ALSM) with databases of sinkholes made from interpretation of aerial photographs reveals substantial disagreement. The discrepancies involve the location, number, areas, and circularity of interpreted sinkholes. Methodological factors that contribute to the discrepancies include blockage of ALSM laser returns in thick vegetation, multi-path reflections, and misrepresentation of the true extent of sinkholes. Comparison of two ALSM-derived databases made (1) independently from versus (2) in combination with earlier air photo analysis in undeveloped regions had the following result: one-fourth of the sinkholes interpreted by using the composite method were missed by the independent analysis, and one-third of the sinkholes that were interpreted from the independent analysis were not interpreted as sinkholes using the composite method. Subjective interpretation leads to a high level of uncertainty such that the results of the remote sensing studies are suspect, if not invalid.     

Estimation of groundwater recharge using the soil moisture budget method and the base-flow model

A detailed characterization of the site is crucial to designing an efficient method of managing the risks associated with tailings from abandoned mines. Therefore, samples collected from various depths within tailings in Guryong mine, Korea, were analyzed for their chemical, physical and mineralogical characteristics. All samples of the Guryong tailings had acid-generating potential. However, in the oxidation zone, the net acid generation (NAG) was low (30 kg H₂SO₄ t⁻¹) although the acid neutralization potential (ANP) was less than zero. The ANP values in the unoxidation zone were higher (> −56.0 kg CaCO₃ t⁻¹) than in the other zones. As a result, the amount of alkali ions that are needed to neutralize the acid needs to be considered. In this experiment G3, G4 and G6 drill cores containing fine tailings particles near the unoxidation zone were observed to contain calcite (CaCO₃) with acid-neutralizing capacity. A low pH (2−4) in the oxidation zone of the tailings changed to a neutral pH in the unoxidation zone of the tailings. These results suggest that the acid-neutralizing capacity of the tailings was controlled by particle and mineral composition of tailings.     

Determining effective wellbore permeability from a field pressure test: a numerical analysis of detection limits

We propose a simple pressure test that can be used in the field to determine the effective permeability of existing wellbores. Such tests are motivated by the need to understand and quantify leakage risks associated with geological storage of CO₂ in mature sedimentary basins. If CO₂ is injected into a deep geological formation, and the resulting CO₂ plume encounters a wellbore, leakage may occur through various pathways in the “disturbed zone” surrounding the well casing. The effective permeability of this composite zone, on the outside of the well casing, is an important parameter for models of leakage. However, the data that exist on this key parameter do not exist in the open literature, and therefore specific field tests need to be done in order to reduce the uncertainty inherent in the leakage estimates. The test designed and analyzed herein is designed to measure effective wellbore permeability within a low-permeability caprock, bounded above and below by permeable reservoirs, by pressurizing the reservoir below and measuring the response in the reservoir above. Alternatively, a modified test can be performed within the caprock without directly contacting the reservoirs above and below. We use numerical simulation to relate pressure response to effective well permeability and then evaluate the range of detection of the effective permeability based on instrument measurement error and limits on fracture pressure. These results can guide field experiments associated with site characterization and leakage analysis.     

Spatial data for landslide susceptibility, hazard, and vulnerability assessment: An overview

The aim of this paper is to discuss a number of issues related to the use of spatial information for landslide susceptibility, hazard, and vulnerability assessment. The paper centers around the types of spatial data needed for each of these components, and the methods for obtaining them. A number of concepts are illustrated using an extensive spatial data set for the city of Tegucigalpa in Honduras. The paper intends to supplement the information given in the “Guidelines for Landslide Susceptibility, Hazard and Risk Zoning for Land Use Planning” by the Joint ISSMGE, ISRM and IAEG Technical Committee on Landslides and Engineered Slopes (JTC-1). The last few decades have shown a very fast development in the application of digital tools such as Geographic Information Systems, Digital Image Processing, Digital Photogrammetry and Global Positioning Systems. Landslide inventory databases are becoming available to more countries and several are now also available through the internet. A comprehensive landslide inventory is a must in order to be able to quantify both landslide hazard and risk. With respect to the environmental factors used in landslide hazard assessment, there is a tendency to utilize those data layers that are easily obtainable from Digital Elevation Models and satellite imagery, whereas less emphasis is on those data layers that require detailed field investigations. A review is given of the trends in collecting spatial information on environmental factors with a focus on Digital Elevation Models, geology and soils, geomorphology, land use and elements at risk.     

Late Palaeozoic hydrocarbon migration through the Clair field, West of Shetland, UK Atlantic margin

Geochemical analysis of bitumen- and hydrocarbon-bearing fluid inclusions from the Devonian-Carboniferous Clair field indicates that the reservoirs contain a mixture of oils from different marine and lacustrine sources. Reconstruction of the Clair field oil-charge history using fluid inclusion petrography show that oil-charging occurred at times of K-feldspar, quartz and calcite cementation. Temperature–composition–time data yielded from the integration of fluid inclusion microthermometry with high-resolution Ar–Ar dating, date hydrocarbon-bearing K-feldspar overgrowths at 247 ± 3.3 Ma. These data show that in order for oil to be trapped within primary fluid inclusions in K-feldspar overgrowths, hydrocarbon migration throughout the UK Atlantic margin must have been taking place during the Late Palaeozoic and as such, current industry oil-play models based solely on oil charging from Jurassic-Cretaceous marine sources are clearly incomplete and need revision. Apatite fission track analysis and vitrinite reflectance data were used to reconstruct thermal burial histories and assess potential oil generation from Middle Devonian lacustrine source rocks. Thermal history data from wells along The Rona Ridge adjacent to the Clair field show that the Palaeozoic section was heated to greater than 100 °C at some time between 270 and 230 Ma, confirming that Devonian source rocks were mature and expelling oil during the Late Palaeozoic at the time that authigenic K-feldspar overgrowths were growing in the Clair field.     

Water release patterns of heated speleothem calcite and hydrogen isotope composition of fluid inclusions

Speleothem fluid inclusions are a potential paleo-precipitation proxy to reconstruct past rainwater isotopic composition (δ¹⁸O, δD). To get a better insight in the extraction of inclusion water from heated speleothem calcite, we monitored the water released from crushed and uncrushed speleothem calcite, heated to 900 °C at a rate of 300 °C/h, with a quadrupole mass spectrometer. Crushed calcite released water in three not well individualised peaks between 25 and 360 °C, 360 and 650 °C and between 650 and 800 °C while uncrushed calcite released water in two distinct temperature intervals: between 25 and 550 °C and between 550 and 900 °C.Water from two speleothems from the Han-sur-Lesse cave was recovered using three different techniques: i) the crushing and heating to 360 °C technique, ii) the decrepitation by heating to 550 °C and iii) the decomposition by heating to 900 °C technique. Measurements of the δD of water recovered by the decomposition of Han-sur-Lesse calcite heated to 900 °C did not show a 20 to 30‰ offset as found by previous authors. However a difference of 7‰ was observed between water released before and after decomposition of the calcite. Water recovery from the Han-sur-Lesse samples suggests that a simple heating technique (up to 550 °C) without crushing could both (a) recover water with δD representative of that of the drip water and (b) double the water yield as compared to the crushing and heating method.Our study warns for possible contamination of the recovered inclusion water with hydration water of lime, responsible for the recovery of water with very negative δD values.     

Reformulated O correction of mass spectrometric stable isotope measurements in carbon dioxide and a critical appraisal of historic ‘absolute’ carbon and oxygen isotope ratios

Mass-spectrometric stable isotope measurements of CO₂ use molecular ion currents at mass-to-charge ratios m/z 44, 45 and 46 to derive the elemental isotope ratios n(¹³C)/n(¹²C) and n(¹⁸O)/n(¹⁶O), abbreviated ¹³C/¹²C and ¹⁸O/¹⁶O, relative to a reference. The ion currents have to be corrected for the contribution of ¹⁷O-bearing isotopologues, the so-called ‘¹⁷O correction’. The magnitude of this correction depends on the calibrated isotope ratios of the reference. Isotope ratio calibrations are difficult and are therefore a matter of debate. Here, I provide a comprehensive evaluation of the existing ¹³C/¹²C (¹³R), ¹⁷O/¹⁶O (¹⁷R) and ¹⁸O/¹⁶O (¹⁸R) calibrations of the reference material Vienna Standard Mean Ocean Water (VSMOW) and CO₂ generated from the reference material Vienna Pee Dee Belemnite (VPDB) by reaction with 100% H₃PO₄ at 25 °C (VPDB-CO₂). I find , ¹⁸R_VSMOW/10⁻⁶ = 2005.20 ± 0.45, ¹³R_VPDB-CO2/10^-6= 11124 ± 45, and ¹⁸R_VPDB-CO2/10^-6=2088.37±0.90. I also rephrase the calculation scheme for the ¹⁷O correction completely in terms of relative isotope ratio differences (δ values). This reveals that only ratios of isotope ratios (namely, ¹⁷R/¹³R and ¹³R¹⁷R/¹⁸R) are required for the ¹⁷O correction. These can be, and have been, measured on conventional stable isotope mass spectrometers. I then show that the remaining error for these ratios of isotope ratios can lead to significant uncertainty in the derived relative ¹³C/¹²C difference, but not for¹⁸O/¹⁶O. Even though inter-laboratory differences can be corrected for by a common ‘ratio assumption set’ and/or normalisation, the ultimate accuracy of the ¹⁷O correction is hereby limited. Errors of similar magnitude can be introduced by the assumed mass-dependent relationship between ¹⁷O/¹⁶O and ¹⁸O/¹⁶O isotope ratios. For highest accuracy in the ¹³C/¹²C ratio, independent triple oxygen isotope measurements are required. Finally, I propose an experiment that allows direct measurement of ¹³R¹⁷R/¹⁸R.     

The composition and crystallinity of the near-surface regions of weathered alkali feldspars

Our ability to identify thin non-stoichiometric and amorphous layers beneath mineral surfaces has been tested by undertaking X-ray photoelectron spectroscopy (XPS) and transmission electron microscopy (TEM) work on alkali feldspars from pH 1 dissolution experiments. The outcomes of this work were used to help interpret XPS and TEM results from alkali feldspars weathered for <10,000 years in soils overlying the Shap Granite (north-west England). The chemistry of effluent solutions indicates that silica-rich layers a few nanometers in thickness formed during the pH 1 experiments. These layers can be successfully identified by XPS and have lower Al/Si, Na/Si, K/Si and Ca/Si values than the outermost ∼9 nm of unweathered controls. Development of Al-Si non-stoichiometry is coupled with loss of crystal structure to produce amorphous layers that are identifiable by TEM where >∼2.5 nm thick, whereas the crystallinity of albite is retained despite leaching of Na to depths of tens to hundreds on nanometers. Integration of XPS data over the outermost 6-9 nm of naturally weathered Shap feldspars shows that they have stoichiometric Al/Si and K/Si ratios, which is consistent with findings of previous TEM work on the same material that they lack amorphous layers. There is some XPS evidence for loss of K from the outermost couple of nanometers of Shap orthoclase, and the possibility of leaching of Na from albite to greater depths cannot be excluded using the XPS or TEM results. This study demonstrates that the leached layer model, as formulated from laboratory experiments, is inapplicable to the weathering of alkali feldspars within acidic soils, which is an essentially stoichiometric reaction.     

Comparison of arsenic concentrations in simultaneously-collected groundwater and aquifer particles from Bangladesh,India, Vietnam,and Nepal

One of the reasons the processes resulting in As release to groundwater in southern Asia remain poorly understood is the high degree of spatial variability of physical and chemical properties in shallow aquifers. In an attempt to overcome this difficulty, a simple device that collects groundwater and sediment as a slurry from precisely the same interval was developed in Bangladesh. Recently published results from Bangladesh and India relying on the needle-sampler are augmented here with new data from 37 intervals of grey aquifer material of likely Holocene age in Vietnam and Nepal. A total of 145 samples of filtered groundwater ranging in depth from 3 to 36 m that were analyzed for As (1–1000 μg/L), Fe (0.01–40 mg/L), Mn (0.2–4 mg/L) and S (0.04–14 mg/L) are compared. The P-extractable (0.01–36 mg/kg) and HCl-extractable As (0.04–36 mg/kg) content of the particulate phase was determined in the same suite of samples, in addition to Fe(II)/Fe ratios (0.2–1.0) in the acid-leachable fraction of the particulate phase. Needle-sampler data from Bangladesh indicated a relationship between dissolved As in groundwater and P-extractable As in the particulate phase that was interpreted as an indication of adsorptive equilibrium, under sufficiently reducing conditions, across 3 orders of magnitude in concentrations according to a distribution coefficient of 4 mL/g. The more recent observations from India, Vietnam and Nepal show groundwater As concentrations that are often an order of magnitude lower at a given level of P-extractable As compared to Bangladesh, even if only the subset of particularly reducing intervals characterized by leachable Fe(II)/Fe >0.5 and dissolved Fe >0.2 mg/L are considered. Without attempting to explain why As appears to be particularly mobile in reducing aquifers of Bangladesh compared to the other regions, the consequences of increasing the distribution coefficient for As between the particulate and dissolved phase to 40 mL/g for the flushing of shallow aquifers of their initial As content are explored.