Sheet flow and suspension of sand in oscillatory boundary layers

after revisionTime-dependent measurements of flow velocities and sediment concentrations were conducted in a large oscillating water tunnel. The measurements were aimed at the flow and sediment dynamics in and above an oscillatory boundary layer in plane bed and sheet-flow conditions. Two asymmetric waves and one sinusoidal wave were imposed using quartz sand with D₅₀ = 0.21 mm. A new electro-resistance probe with a large resolving power was developed for the measurement of the large sediment concentrations in the sheet-flow layer. The measurements revealed a three layer transport system consisting of a pick-up/deposition layer, an upper sheet flow layer and a suspension layer.In the asymmetric wave cases the total net transport was directed “onshore” and was mainly concentrated in the thin sheet flow layer (< 0.5 cm) at the bed. A small net sediment flux was directed “offhore” in the upper suspension layer. The measured flow velocities, sediment concentrations and sedimenl fluxes showed a good qualitative agreement with the results of a (numerical) 1DV boundary-layer flow and transport model. Although the model did not describe all the observed processes in the sheet-flow and suspension layer, the computational results showed a reasonable agreement with measured net transport rates in a wide range of asymmetric wave conditions.     

A new method for the generation of second-order random waves

In order to prevent the generation of spurious free sub- and superharmonics of random waves in a laboratory channel, the control signal for the wave board has to be derived according to a higher-order wave theory. An expression for this control signal has been derived with the perturbation method of multiple scales. It is much less complex and requires less computation time than the expressions obtained from the full second-order theory. The new method for second-order subharmonics was verified experimentally for waves with bichromatic and continuous first-order spectra. The data were analysed with the complex-harmonic principal-component analysis to reduce the influence of noise.     

Tropical Marine Fungi*

Abstract. Marine Ascomycetes, Basidiomycetes and Deuteromycetes were collected in tropical and subtropical regions (Australia, Belize, Fiji, Hawaii, Marshall Islands, Mexico, New Zealand, Palau, Thailand), and the known range of distribution for these fungi was extended. Exclusively tropical are 27 taxa, 9 are probably restricted to the tropics also, and 11 are cosmopolitan. Distribution maps are given for 5 taxa. New species (4), varieties (3), and combinations (2) of Ascomycetes are proposed, and keys to the taxa of Halosarpheia and Lulworthia are presented. Most of the species are decomposers of mangrove parts or of detritus in sandy beaches. Nine new host plants were found. Marine Ascomycetes were discovered for the first time living in shells of foraminifera.     

Mercury speciation in surface and deep waters of the Mediterranean Sea

Mercury speciation and its distribution in surface and deep waters of the Mediterranean Sea were studied during two oceanographic cruises on board the Italian research vessel URANIA in summer 2003 and spring 2004 as part of the Med Oceaneor and MERCYMS projects. The study included deep water profiles of dissolved gaseous Hg (DGM), reactive Hg (RHg), total Hg (THg), monomethyl Hg (MeHg) and dimethyl Hg (DMeHg) in open ocean waters. Average concentrations of measured Hg species were characterized by seasonal and spatial variations. Overall average THg concentrations ranged between 0.41 and 2.65 pM (1.32 ± 0.48 pM) and were comparable to those obtained in previous studies of the Mediterranean Sea. A significant fraction of Hg was present as “reactive” Hg (average 0.33 ± 0.32 pM). Dissolved gaseous Hg (DGM), which consists mainly of Hg⁰, represents a considerable proportion of THg (average 20%, 0.23 ± 0.11 pM). The portion of DGM typically increased towards the bottom, especially in areas with strong tectonic activity (Alboran Sea, Strait of Sicily, Tyrrhenian Sea), indicating its geotectonic origin. No dimethyl Hg was found in surface waters down to the depth of 40 m. Below this depth, its average concentration was 2.67 ± 2.9 fM. Dissolved fractions of total Hg and MeHg were measured in filtered water samples and were 0.68 ± 0.43 pM and 0.29 ± 0.17 pM for THg and MeHg respectively. The fraction of Hg as MeHg was in average 43%, which is relatively high compared to other ocean environments. The concentrations reported in this study are among the lowest found in marine environments and the quality of analytical methods are of key importance. Speciation of Hg in sea water is of crucial importance as THg concentrations alone do not give adequate data for understanding Hg sources and cycling in marine environments. For example, photoinduced transformations are important for the presence of reactive and elemental mercury in the surface layers, biologically mediated reactions are important for the production/degradation of MeHg and DGM in the photic zones of the water column, and the data for DGM in deep sea indicate the natural sources of Hg in geotectonicaly active areas of the Mediterranean Sea.     

Circulation and Brackish Water Dispersal in a Coastal Lagoon of Southwest Taiwan

Modest observations and numerical experiments were conducted to investigate circulation and brackish water dispersal in a coastal lagoon southwest of Taiwan. The Chi-Ku Lagoon, partially shielded from the sea by a string of sandbar barriers with two entrances among them, receives modest and episodic runoff from Chi-Ku Stream. Flood and ebb tidal streams entering and leaving the two entrances are found to converge and diverge in a flow stagnation area inside the lagoon. Under weak wind conditions, brackish water is preferentially retained in the flow stagnation area. Besides the observations, scenario runs using a three-dimensional numerical model also indicate strong modulation by monsoon winds. Both summer southwest monsoon and winter northeast monsoon reduce brackish water retention; the latter is found to be more effective. This revised version was published online in August 2006 with corrections to the Cover Date.     

Glacial-interglacial relationship between carbonate components and sediment reflectance in the North Atlantic

A high-resolution composite sediment record from intermediate water depths in the North Atlantic, dating back to marine isotope stage (MIS) 13, was investigated in order to determine the relationship between sediment reflectance (gray level%) and carbonate content (weight%). For this purpose, a detailed analysis of the coarse (>20 µm) and fine (<20 µm) carbonate components was carried out to assess which of the two carbonate components drives glacial-interglacial changes in sediment gray level. The results indicate that the bulk carbonate component is clearly dominated by the fine carbonate fraction, regardless of glacial or interglacial climatic mode, suggesting that the sediment gray level is usually controlled by fluctuations of the fine carbonate content. However, a comparison of MIS 1 and 5.5 indicates that, besides this difference in the contents of the two carbonate size fractions, changing modes in carbonate preservation, i.e., the preservational state of planktonic Foraminifera, may also have a profound influence on total sediment reflectance.