Factors Affecting Efficient Aquifer Restoration at In Situ Uranium Mine Sites

In situ mining of uranium typically requires the injection of a reactive leaching solution (lixiviant) such as sodium carbonate/bicarbonate, ammonium carbonate/bicarbonate, or sulfuric acid, and an oxidant such as hydrogen peroxide or oxygen into an ore-bearing, confined aquifer. It also requires the environmental restoration of the source aquifer. The stratigraphy of sandstone uranium deposits typically consists of interbedded layers of poorly consolidated sands and clays and gravels deposited in fluvial or coastal environments. The parameters that influence the migration of lixiviant during mining and restoration in these environments include induced hydraulic gradients, hydrodynamic dispersion, heterogeneity, anisotropy, physicochemical reactions, leakage into and/or through confining layers, and convergence of flow lines due to partial well penetration.
The effectiveness of the various methods of aquifer restoration is sit -specific and is dependent upon the site hydrogeology and hydrogeochemistry, and the chemistry of the lixiviant. Each method of aquifer restoration has advantages and disadvantages. Selection of the most effective and economically feasible method requires detailed knowledge of the site-specific hydrogeologic conditions.     

Modeling the Potential Effect of Additives on Enhancing the Solubility of Aromatic Solutes Contained in Gasoline

The potential effect of two common gasoline additives, ethanol and methyl tertiary-butyl ether (MTBE), on enhancing the solubility of the aromatic solutes benzene, toluene, ethylbenzene, and o-, m-, and p-xylene, was examined using a computer model, ARSOL. Aqueous solute systems containing cosolvents ethanol and MTBE at 0, 0.1, 1, and 4.3 percent were modeled for both ethanol and MTBE systems. Five- and 10-percent ethanol systems were also modeled. Little solubility enhancement was predicted by modeling at cosolvent levels less than 1 percent. At cosolvent levels greater than 1 percent, predicted solute solubility increased curvilinearly with an increase in percent cosolvent; a 10 percent cosolvent system increased aromatic hydrocarbon solubility by approximately 100 percent. According to the model predictions, MTBE enhanced solute solubility more than ethanol, with enhancement by MTBE being approximately 10 percent greater than enhancement by ethanol at 4.3 percent cosolvent. Other concerns regarding gasoline additives are the observed reduction in partitioning of solutes to soils and sediments and the contamination of water supplies due to the high water solubility of the additives.     

Subsurface Transport of Inorganic and Organic Solutes from Experimental Road Spreading of Oil-Field Brine

A study designed to evaluate ground water quality changes resulting from spreading oil-field brine on roads for ice and dust control was conducted using a gravel roadbed that received weekly applications of brine eight times during the winter phase and 11 times during the summer phase of the study. A network of 11 monitoring wells and five pressure-vacuum lysimeters was installed to obtain ground water and soil water samples. Thirteen sets of water- quality samples were collected and analyzed for major ions, trace metals, and volatile organic compounds. Two sets of samples were taken prior to brine spreading, four sets during winter-phase spreading, five sets during summer- phase spreading, and two sets during the interim between the winter and summer phases. A brine plume delineated by elevated specific-conductance values and elevated chloride concentrations developed downgradient of the roadbed during both the winter and summer phases. The brine plume caused chloride concentrations in ground water samples to exceed U.S. EPA public drinking-water standards by two-fold during the winter phase and five-fold during the summer phase. No other major ions, trace metals, or volatile organic compounds exceeded the standards during the winter or summer phases. More than 99 percent dilution of the solutes in the brine occurred between the roadbed surface and the local ground water flow system. Further attenuation of calcium, sodium, potassium, and strontium resulted from adsorption, whereas further attenuation of benzene resulted from volatilization and adsorption.     

An example of slip instability resulting from displacement-varying strength

A rock cylinder, containing a clay-filled sawcut making an angle of 30° to the sample axis, was deformed at constant confining and pore pressures and constant remote shortening rate. The sawcut surfaces contained a series of regularly spaced ridges and grooves oriented perpendicular to the direction of shear. The interaction of these grooved surfaces resulted in a sliding strength which varied periodically with displacement. By varying the effective machine stiffness through the use of an electronic feedback circuit, a range of stable and unstable slip behavior was achieved. In this way, we examined fault slip behavior which was dominated by displacement-dependent strength.     

Pahoehoe and aa in Hawaii: volumetric flow rate controls the lava structure

The historical records of Kilauea and Mauna Loa volcanoes reveal that the rough-surfaced variety of basalt lava called aa forms when lava flows at a high volumetric rate (>5–10 m³/s), and the smooth-surfaced variety called pahoehoe forms at a low volumetric rate (<5–10 m³/s). This relationship is well illustrated by the 1983–1990 and 1969–1974 eruptions of Kilauea and the recent eruptions of Mauna Loa. It is also illustrated by the eruptions that produced the remarkable paired flows of Mauna Loa, in which aa formed during an initial short period of high discharge rate (associated with high fountaining) and was followed by the eruption of pahoehoe over a sustained period at a low discharge rate (with little or no fountaining). The finest examples of paired lava flows are those of 1859 and 1880–1881. We attribute aa formation to rapid and concentrated flow in open channels. There, rapid heat loss causes an increase in viscosity to a threshold value (that varies depending on the actual flow velocity) at which, when surface crust is torn by differential flow, the underlying lava is unable to move sufficiently fast to heal the tear. We attribute pahoehoe formation to the flowage of lava at a low volumetric rate, commonly in tubes that minimize heat loss. Flow units of pahoehoe are small (usually <1 m thick), move slowly, develop a chilled skin, and become virtually static before the viscosity has risen, to the threshold value. We infer that the high-discharge-rate eruptions that generate aa flows result from the rapid emptying of major or subsidiary magma chambers. Rapid near-surface vesiculation of gas-rich magma leads to eruptions with high discharge rates, high lava fountains, and fast-moving channelized flows. We also infer that long periods of sustained flow at a low discharge rate, which favor pahoehoe, result from the development of a free and unimpeded pathway from the deep plumbing system of the volcano and the separation of gases from the magma before eruption. Achievement of this condition requires one or more episodes of rapid magma excursion through the rift zone to establish a stable magma pathway.     

The characterization of axenic culture systems suitable for plant propagation and experimental studies of the submersed aquatic angiospermPotamogeton pectinatus (Sago Pondweed)

Clonal lines of the submersed aquatic angiospermPotamogeton pectinatus were grown in three culture systems. The first, which used sucrose as a carbon source in a liquid medium, supported vigorous vegetative growth and can be used to propagate large numbers of plants in axenic conditions. In this culture system, plants were responsive to increasings photosynthetically active radiation (PAR) photon flux density (PFD) and were photosynthetically competent. However, their growth was heterotrophic and root development was poor. When these plants were transferred to a second nonaxenic culture system, which used 16-1 buckets containing artificial sediments and tap water, growth was autotrophic and plants were morphologically identical to field-harvestedP. pectinatus. The last culture system which consisted of a sand substrate and inorganic nutrient bathing solution aerated with 135 ml min^?1 ambient air enhanced to 3.0% CO₂ was axenic and supported autotrophic growth by plants that were also morphologically normal.     

Insight from large-scale observational studies of land/atmosphere interactions

This paper overviews major international studies of the land/atmosphere interaction during the 1980s and previews those proposed for the 1990s. Selective results, either particular to individual studies or common to several, are interpreted to provide insight on the value and reliability of experimental data and field systems. This is used to provide guidance for future experiments. Progress in addressing the need to provide area-average, aggregate values for surface energy fluxes is assessed, and a recommendation made for enhanced attention to the use of planetary boundary development as an indirect measure of these.     

Geology and petrology of Mahukona Volcano,Hawaii

The submarine Mahukona Volcano, west of the island of Hawaii, is located on the Loa loci line between Kahoolawe and Hualalai Volcanoes. The west rift zone ridge of the volcano extends across a drowned coral reef at about-1150 m and a major slope break at about-1340 m, both of which represent former shoreines. The summit of the volcano apparently reached to about 250 m above sea level (now at-1100 m depth) did was surmounted by a roughly circular caldera. A econd rift zone probably extended toward the east or sutheast, but is completely covered by younger lavas from the adjacent subaerial volcanoes. Samples were vecovered from nine dredges and four submersible lives. Using subsidence rates and the compositions of flows which drape the dated shoreline terraces, we infer that the voluminous phase of tholeiitic shield growth ended about 470 ka, but tholeiitic eruptions continued until at least 435 ka. Basalt, transitional between tholeiitic and alkalic basalt, erupted at the end of tholeiitic volcanism, but no postshield-alkalic stage volcanism occurred. The summit of the volcano apparently subcided below sea level between 435 and 365 ka. The tholeiitic lavas recovered are compositionally diverse.     

Atrazine Used as a Tracer of Induced Recharge

The city of Lincoln draws water from a well field along the banks of the Platte River in east-central Nebraska. We have been able to follow the infusion of atrazine into this well field under induced recharge. Samples of water from the river, several monitoring wells and a production well were analyzed by GC/MS and solid phase extraction and found to change in concentration over the range 0.1 and 5.0 ppb of atrazine through the spring, summer, and fall 1989. Increases in the concentration of atrazine relating to precipitation events in the Platte River Basin were observable in the well water samples and ultimately in Lincoln municipal tap water. Atrazine from the river was seen to move via induced recharge and into well field ground water and away from the river at an observable rate. The concentration of atrazine in the river is dependent upon time of year and precipitation in the river basin.     

Tropical deforestation: Albedo and the surface-energy balance

Recent micrometeorological measurements for Amazonian rainforest are reviewed, emphasising those aspects of the radiation and heat balance which are likely to change with deforestation. The possible consequences of such deforestation are considered by examining the sensitivity of the surface energy balance to changes in those parameters which would be most drastically altered.