Seismic response of light internal equipment in base-isolated structures

The seismic response of light secondary systems in a building is dependent on the response of the primary structural system to the seismic ground motion with the result that very high accelerations can be induced in such secondary systems. This response can be reduced through the use of aseismic base isolation which is a design strategy whereby the entire building can be decoupled from the damaging horizontal components of seismic ground motion by the use of some form of isolation system. The paper presents a theoretical analysis of the response of light equipment in isolated structures and a parallel experimental programme both of which show that the use of base isolation can not only attenuate the response of the primary structural system but also reduce the response of secondary systems. Thus, the design of equipment and piping in a base-isolated building is very much simpler than that for a conventionally founded structure: inelastic response and equipment-structure interaction need not be considered and multiple support response analysis is rendered unnecessary. Although an isolation system with linear elastic bearings can reduce the acceleration of the structure, it may be accompanied by large relative displacements between the structure and the ground. A system using lead-rubber hysteretic bearings, having a force-displacement relation which is approximately a bilinear loop, can reduce these displacements. A parallel experimental programme was carried out to investigate the response of light equipment in structures isolated using lead-rubber bearings. The experimental results show that these bearings can dissipate energy and limit the displacement and acceleration of the structure but are less effective in reducing the accelerations in the internal equipment. The results of both the analysis and the tests show that base isolation is a very effective method for the seismic protection of light equipment items in buildings.     

The solubility of quartz in aqueous sodium chloride solution at 350°C and 180 to 500 bars

The solubility of quartz in 2, 3, and 4 molal NaCl was measured at 350°C and pressures ranging from 180 to 500 bars. The molal solubility in each of the salt solutions is greater than that in pure water throughout the measured pressure range, with the ratio of solubility in NaCl solution to solubility in pure water decreasing as pressure is increased. The measured solubilities are significantly higher than solubilities calculated using a simple model in which the water activity in NaCl solutions decreases either in proportion to decreasing vapor pressure of the solution as salinity is increased or in proportion to decreasing mole fraction of water in the solvent.     

Existence of transverse waves in anisotropic poroelastic media

Out of the four waves in an anisotropic poroelastic medium, two are termed as quasi-transverse waves. The prefix 'quasi' refers to their polarizations being nearly, but not exactly, perpendicular to direction of propagation. In this composite medium, unlike perfectly elastic medium, the propagation of a longitudinal wave along a phase direction may not be accompanied by transverse waves. The existence of a transverse wave in anisotropic poroelastic media is ensured by the two equations restricting the choice of elastic coefficients of porous aggregate as well as fluid–solid coupling. Necessary and sufficient conditions for the existence of transverse waves along the coordinate axes and in the coordinate planes for general anisotropy are discussed. The discussion is extended to the case of orthotropic materials and existence for few specific phase directions is also explored. The conditions for the transverse waves decided on the basis of their apparent polarizations, that is, particle motion being perpendicular to ray direction, are also discussed. For a particular numerical model, the existence of these apparent transverse waves is solved numerically for phase directions in coordinate planes. For general directions of phase propagation, the existence of these transverse waves is checked graphically for the chosen numerical model.     

First Byurakan Spectral Sky Survey. Stars of Late Spectral Types. XI. Zone -7° ≤ δ ≤ -3°

The eleventh list of faint late M and carbon type stars detected on the plates of the First Byurakan Spectral Survey in zone -7° -3° and covering about 1000 square degrees is presented. From 126 detected stars, 88 are newly discovered objects: they are 6 carbon stars, 8 carbon star candidates, and 74 M-type stars; among the latter 38 (26 PSC + 12 FSC) are unclassified IRAS sources, and one object is an unclassified ROSAT source. Distances to the 6 newly discovered early-type carbon stars are estimated. Equatorial coordinates, red magnitudes, and spectral classes determined from the Palomar E-charts are provided. The lack of optical counterparts on Palomar O and E maps for two detected late M-type stars indicates a large variability in brightnesses of these objects (amplitude not smaller than 7.0 magnitude).     

Impacts of primary deforestation upon limestone slopes in northern Vancouver Island, British Columbia

Effects of deforestation upon slopes in limestones and in volcanic rocks in the Benson River valley, northern Vancouver Island, have been investigated quantitatively. Postlogging soil erosion and vegetal regeneration success were assessed by measuring soil depth, percent bare rock and moss cover, and the numbers and diversity of trees, shrubs, and plants on 25 sampling sites, each containing ten measuring quadrats selected at random. Sixteen sites were on the Quatsino Formation, a well-karstified limestone, and nine on the Karmutsen Formation of basaltic lavas. Eight sites were of virgin forest, 16 were logged between 1970 and 1983, and one (on limestone) was logged in 1911. Both bedrock types were significantly affected by the cutting. There was greater loss of soil and an increase in bare rock on the limestones. Erosion was increased significantly by burning on the limestones but not on the volcanics. Within-group comparisons on the limestones determined that steeper slopes and harder burned areas suffered the most and are slowest to regenerate. Volume of timber on the 1911 site was 19 percent of that in similar uncut forest sites. It appears that complete recovery on the barren limestone slopes will require at least some centuries.     

Distinct metamorphic evolution of alternating silica-saturated and silica-deficient microdomains within garnet in ultrahigh-temperature granulites: An example from Sri Lanka

Here we report the occurrence of garnet porphyroblasts that have overgrown alternating silica-saturated and silica deficient microdomains via different mineral reactions. The samples were collected from ultrahigh-temperature (UHT) metapelites in the Highland Complex, Sri Lanka. In some of the metapelites, garnet crystals have cores formed via a dehydration reaction, which had taken place at silica-saturated microdomains and mantle to rim areas formed via a dehydration reaction at silica-deficient microdomains. In contrast, some other garnets in the same rock cores had formed via a dehydration reaction which occurred at silica-deficient microdomains while mantle to rim areas formed via a dehydration reaction at silica-saturated microdomains. Based on the textural observations, we conclude that the studied garnets have grown across different effective bulk compositional microdomains during the prograde evolution. These microdomains could represent heterogeneous compositional layers (paleobedding/laminations) in the precursor sediments or differentiated crenulation cleavages that existed during prograde metamorphism. UHT metamorphism associated with strong ductile deformation, metamorphic differentiation and crystallization of locally produced melt may have obliterated the evidence for such microdomains in the matrix. The lack of significant compositional zoning in garnet probably due to self-diffusion during UHT metamorphism had left mineral inclusions as the sole evidence for earlier microdomains with contrasting chemistry.     

Lunar Gravity-Assist Maneuver As a Way of Reducing the Orbit Amplitude in the Spectrum–Röntgen–Gamma Project

Spectrum–Röntgen–Gamma (SRG) is a space observatory designed to observe astrophysical objects in the X-ray range of the electromagnetic spectrum. SRG is planned to be launched in 2019 by a Proton-M launch vehicle with a DM3 upper stage. The spacecraft will be delivered to an orbit around the Sun–Earth collinear libration point L2 located at a distance of ~1.5 million km from the Earth. Although the SRG launch scheme has already been determined at present, in this paper we consider an alternative spacecraft transfer scenario using a lunar gravity-assist maneuver. The proposed scenario allows a oneimpulse transfer from a low Earth orbit to a small-amplitude orbit around the libration point to be performed while fulfilling the technical constraints and the scientific requirements of the mission.     

Zircon and whole-rock Nd-Pb isotopic provenance of Middle and Upper Ordovician siliciclastic rocks, Argentine Precordillera

Graptolite‐bearing Middle and Upper Ordovician siliciclastic facies of the Argentine Precordillera fold‐thrust belt record the disintegration of a long‐lived Cambro‐Mid Ordovician carbonate platform into a series of tectonically partitioned basins. A combination of stratigraphic, petrographic, U‐Pb detrital zircon, and Nd‐Pb whole‐rock isotopic data provide evidence for a variety of clastic sediment sources. Four Upper Ordovician quartzo‐lithic sandstones collected in the eastern and central Precordillera yield complex U‐Pb zircon age spectra dominated by 1·05–1·10 Ga zircons, secondary populations of 1·22, 1·30, and 1·46 Ga, rare 2·2 and 1·8 Ga zircons, and a minor population (<2%) of concordant zircons in the 600–700 Ma range. Archaean‐age grains comprise <1% of all zircons analysed from these rocks. In contrast, a feldspathic arenite from the Middle Ordovician Estancia San Isidro Formation of the central Precordillera has two well‐defined peaks at 1·41 and 1·43 Ga, with no grains in the 600–1200 Ma range and none older than 1·70 Ga. The zircon age spectrum in this unit is similar to that of a Middle Cambrian quartz arenite from the La Laja Formation, suggesting that local basement rocks were a regional source of ca 1·4 Ga detrital zircons in the Precordillera Terrane from the Cambrian onwards. The lack of grains younger than 600 Ma in Upper Ordovician units reinforces petrographic data indicating that Ordovician volcanic arc sources did not supply significant material directly to these sedimentary basins. Nd isotopic data (n = 32) for Middle and Upper Ordovician graptolitic shales from six localities define a poorly mixed signal [ɛ_Nd(450 Ma) = −9·6 to −4·5] that becomes more regionally homogenized in Upper Ordovician rocks (−6·2 ± 1·0; T_DM = 1·51 ± 0·15 Ga; n = 17), a trend reinforced by the U‐Pb detrital zircon data. It is concluded that proximal, recycled orogenic sources dominated the siliciclastic sediment supply for these basins, consistent with rapid unroofing of the Precordillera Terrane platform succession and basement starting in Mid Ordovician time. Common Pb data for Middle and Upper Ordovician shales from the western and eastern Precordillera (n = 15) provide evidence for a minor (<30%) component that was likely derived from a high‐μ (U/Pb) terrane.     

Coronal disturbances

Time lapse movies acquired with the Sacramento Peak Observatory 6-in filter coronagraph very infrequently show dramatic transient events. Many of these events (at 1.04 < r/r < 1.20) are correlated with H activity at the limb, especially with large surges and eruptive prominences. Metric or centrimetric radio bursts are found associated with certain types of 5303 coronal events. The heights to which such disturbances will propagate can often be estimated from the green line movie data. We report the results of a study of all the examples of such transients observed during the last 16 years.