System dynamic modeling to assess the effect of subsurface drain spacing and depth on minimizing the environmental impacts

The excessive loss of soil nitrogen through drainage losses causes different environmental problems. The depth and spacing drain of drains play an important role in the quality and quantity of discharged drainage into the environment. In this paper, a simple but comprehensive model using system dynamic approach for water cycle and nitrogen dynamics was used to simulate the effect of drain depth and spacing on nitrate and ammonium losses in a sugarcane agro-industrial company. Twenty-four scenarios were modeled including the combination of four different drain depths and six drain spacing to compare the effect of drain depth and spacing on the nitrogen uptake by plant, denitrification, net mineralization, the amount of ammonium losses through runoff, nitrate and ammonium losses through drainage water, the sum of excessive water, the stress day index and the relative yield. The results indicated that optimal drainage system density is obtained in the depth of 1.1 m and spacing of 80 m, in a way that the total drainage losses would be reduced up to an acceptable level. The optimum designing of the drainage systems according to environmental criteria can control nitrogen pollution load at farm level and can therefore have appropriate results both in terms of economic and environmental considerations.     

Rainfall uncertainty in the Mediterranean: definitions of the daily rainfall threshold (DRT) and the rainy season length (RSL)

One of the major dilemmas in rainfall-regime research is regarding the representativity of rainfall amounts. The annual total (TOTAL) represents the summation of the contributions of all rainfall events. However, this parameter is obtained mainly by contributions of some major events, whereas, many others may contribute minute quantities of a negligible impact. A selected daily rainfall threshold (DRT) is used to filter these small events and to retain only the effective ones (for a wide range of activities), and enable focusing on them in order to better detect any important temporal changes in the rainfall regime. Two different procedures are applied to the data in order to filter out slight and/or sporadic rains: (a) definition of a DRT for each station which filters out the slight rains all year around regardless of their timing, and (b) definitions of the rainy season beginning date (RSBD) and the rainy season ending date (RSED), which filter out sporadic rain events at the beginning or the end of the rainy season, regardless of their amount. The current study presents the appropriate DRT and effective rainy season length (RSL) in 41 Mediterranean stations, and analyzes their influence on some other parameters. The main conclusions are: (1) the filtering process reduced considerably the number of rain-spells (NRS) and therefore the average intensities increased; (2) the filtering process reduced the average time that elapsed between the beginning of two consecutive rain-spells, and (3) the RSL within the study area has a clear spatial distribution, longer in the northern parts and shorter in the southern parts.     

Non-linear channel–shoal dynamics in long tidal embayments

The dynamics of finite-amplitude bed forms in a tidal channel is studied with the use of an idealized morphodynamic model. The latter is based on depth-averaged equations for the tidal flow over a sandy bottom. The model considers phenomena on spatial scales of the order of the tidal excursion length. Transport of sediment mainly takes place as suspended load. The reference state of this model is characterized by a spatially uniform M₂ tidal current over a fixed horizontal bed. The temporal evolution of deviations from this reference state is governed by amplitude equations: these are a set of non-linear equations that describe the temporal evolution of bed forms. These equations are used to obtain new morphodynamic equilibria which may be either static or time-periodic. Several of these bottom profiles show strong similarity with the tidal bars that are observed in natural estuaries. The dependence of the equilibrium solutions on the value of bottom friction and channel width is investigated systematically. For narrow channels (width small compared to the tidal excursion length) stable static equilibria exist if bottom friction is slightly larger than r_cr. For channel widths more comparable to the tidal excursion length, multiple stable steady states may exist for bottom friction parameter values below r_cr. Regardless of channel width, stable time-periodic equilibria seem to emerge as the bottom friction is increased.Responsible Editor: Jens Kappenberg     

Microbial release of potassium from K-bearing minerals by thermophilic fungus Aspergillus fumigatus

A strain of thermophilic fungus Aspergillus fumigatus was cultured with K-bearing minerals to determine if microbe-mineral interactions enhance the release of mineralic potassium. Experiments were carried out in two settings, one with the mineral grains and the fungal cells in direct contact, and the other employing a membrane (pore size 0.22 μm) to separate the two. Measurements over a period of 30 days showed that, irrespective of the experimental setup, the concentration of free K in the culture was drastically higher than those in any of the control experiments where no living organism was present. Moreover, the occurrence of mineral-cell physical contact enhanced potassium release by an additional factor of 3 to 4 in comparison to the separation experiments. For contact experiments, Electron Probe Microanalysis revealed the formation of mycelium-mineral aggregates, and Atomic Force Microscopy imaging further indicated the possible ingestion of mineral particles by the fungus cells. Contrasting to what was observed and expected in control experiments, the potassium solubilization rate showed a positive dependence upon pH when fungi and minerals were mixed directly, and exhibited no correlations with solution acidity if cell-rock contact was restrained. These results appear to suggest that A. fumigatus promoted potassium release by means of at least three likely routes, one through the complexation of soluble organic ligands, another appealing to the immobile biopolymers such as the insoluble components of secretion, and the third related to the mechanical forces in association with the direct physical contact between cells and mineral particles.     

不同温压条件下蛇纹岩和角闪岩中波速与衰减的各向异性

在实验室中研究了蛇纹岩和角闪岩样品在不同温压条件下的纵、横波速度和Q值．这两种岩样对应的主要组成矿物叶蛇纹石和普通角闪石都具有很强的晶格优选方位（LPO）．随着围压的增加,波速和Q值均增大,但是在相互正交的三个方向上（垂直或平行于层理面及线理方向）增大的速度并不相同,这与微裂隙的逐渐闭合密切相关．在600MPa的围压下升高温度直到600℃以上,由于微裂隙的热扩张受到约束,波速和Q值下降幅度很小．观测到的波速和Q值的各向异性具有不同的机理,波速各向异性主要与定向分布的微裂隙和主要矿物的LPO等构造因素有关;高围压下纵波Q值各向异性与速度各向异性正好相反,可能是由于形成层理面的定向排列的平板状矿物晶体沿不同方向边界之间接触程度不同造成的．     

Stable boundary layers: observations,models and variability part II: Data analysis and averaging effects

As argued in Part I (Derbyshire, 1995), variability is a key issue in stable boundary layers, and differences in variability between observations and idealized models may imply sytematic biases. Here we discuss how data analysis can be geared to allow for variability and thus consistency with models. Instrumental errors, smoothing methods and vertical discretization are considered. We then show how statistical averaging broadly improves the agreement of heterogeneous results in Part I with the Brost-Wyngaard closure. Recommendations are made for the information needed to analyze apparent differences between homogeneous and heterogeneous stable boundary layers.Part of UK Meteorological Office Atmospheric Processes Research Division     

Low-resolution spectra of the Io plasma torus 2 days after the Ulysses encounter

Low-resolution spectra of the Io plasma torus have been obtained on 10 and 11 February 1992 (2 days after the Ulysses encounter) using the 2 m telescope of the Bulgarian National Observatory. The spectra show the forbidden line emissions of S⁺ (λλ 6716, 6731 Å) and S²⁺ (λ 6312 Å). Measured intensities are compared with a Voyager-type model. The intensity distribution of [SII] is found to deviate from the model predictions which indicates a change in the torus at the Ulysses encounter when compared with the Voyager epoch. A corotating structure was observed, both in [SII] and [SIII], at λ_III = 170°, showing that the torus was not azimuthally symmetric. The λ 6716/λ 6731 and λ 6731/ λ 6312 line ratios indicate a higher electron density at the time of the Ulysses observations. Additionally, the shift of the torus caused by the dawn-dusk electric field could be observed. Peak intensities in [SII] were found at 5.66 ± 0.02 R_J on the West ansa and 5.91 ± 0.04 R_J on the East.     

Integrated petrographic,mineralogical, and geochemical study of the upper Kaimur Group of rocks,Son Valley,India: Implications for provenance,source area weathering and tectonic setting

The upper Kaimur Group (UKG) of the Vindhyan Supergroup in central India, primarily consists of three rock types-Dhandraul sandstone, Scarp sandstone and Bijaigarh shale. The present study aims to reconstruct the parent rock assemblages, their tectonic provenance, mineralogy, weathering intensity, hydraulic sorting and depositional tectonic setting. Samples from the UKG rocks representing the Dhandraul sandstone, Scarp sandstone and Bijaigarh shale were studied using a combination of petrographic, mineralogical, and geochemical techniques. Texturally, medium to coarse grained UKG sandstones are mature and moderate to well sorted. Deficiency of feldspars in these sandstones indicates that the rocks are extensively recycled from distant sources. Their average modal composition for Scarp (avg. Qt₉₉ F₀.₂L_0.8) and Dhandraul (avg. Qt₉₉ F_0.1L_0.8) sandstones, classifies them as quartz arenite to sub-litharenite types, which is consistent with geochemical study. Major element concentrations revealed that sandstones have high SiO₂, K₂O < Na₂O, and low Fe₂O₃, which are supported by the modal data. On the other hand, sandstone samples are enriched in most trace elements such as Ce, Sr, V, Sc and Zr and depleted in U and Th. The CIA values (43.17–76.48) of the UKG rocks indicate low to moderate weathering, either of the original source or during transport before deposition, which may have related to low-relief and humid climatic conditions in the source area. Further, petrographic and geochemical interpretations indicate that they are derived from craton interior to quartzose recycled sedimentary rocks and deposited in a passive continental margin. Therefore, granitic and low grade metamorphic rocks of Mahakoshal Group and Chotanagpur granite-gneiss, situated on the southern and south-eastern side of the Vindhyan basin are suggested as possible provenance for the UKG rocks.     

Comment and reply regarding Changyou Zhang (1995) A general formula and its inverse formula for gravimetric transformation by use of convolution and deconvolution techniques.

The incorrectness in the derivations of error formula (52) in Zhang's paper is pointed out and the correction is given. Table 3 [list of error formulae of Eqs (5)–(8)] in Zhang's paper is also corrected. Received: 25 February 1998 / Accepted: 30 June 1998     

An analytical solution for rainfall infiltration into an unsaturated infinite slope and its application to slope stability analysis

Surficial slope failures in residual soils are common in tropical and subtropical regions as a result of rainfall infiltration. This study develops an analytical solution for simulating rainfall infiltration into an infinite unsaturated soil slope. The analytical solution is based on the general partial differential equation for water flow through unsaturated soils. It can accept soil–water characteristic curve and unsaturated permeability function of the exponential form into account. Numerical simulations are conducted to verify the assumptions of the analytical solution and demonstrate that the proposed analytical solution is acceptable for the coarse soils with low air entry values. The pore‐water pressure (pwp) distributions obtained from the analytical solution can be incorporated into a limit equilibrium method to do infinite slope stability analysis for a rain‐induced shallow slip. The analysis method takes into account the influence of the water content change on unit weight and hence on factor of safety. A series of analytical parametric analyses have been performed using the developed model. The analyses indicate that when the residual soil slope, consisting of a completely decomposed granite layer underlain by a less permeable layer, is subjected to a continuous heavy rainfall, the loss of negative pwp and the reduction in factor of safety were found to be most significant for the shallow soil layer and during the first 12 h. The antecedent and subsequent rainfall intensity, depth of a less permeable layer and slope angle all have a significant influence on the pwp response and hence the slope stability. Copyright © 2012 John Wiley & Sons, Ltd.