琼东南盆地深水区构造热演化特征及其影响因素分析

To reveal the tectonic thermal evolution and influence factors on the present heat flow distribution, based on 154 heat flow data, the present heat flow distribution features of the main tectonic units are first analyzed in detail, then the tectonic thermal evolution histories of 20 profiles are reestablished crossing the main deep-water sags with a structural, thermal and sedimentary coupled numerical model. On the basis of the present geothermal features, the Qiongdongnan Basin could be divided into three regions: the northern shelf and upper slope region with a heat flow of 50–70 m W/m2, most of the central depression zone of 70–85 m W/m2, and a NE trending high heat flow zone of 85–105 m W/m2 lying in the eastern basin. Numerical modeling shows that during the syn-rift phase, the heat flow increases generally with time, and is higher in basement high area than in its adjacent sags. At the end of the syn-rift phase, the heat flow in the deepwater sags was in a range of 60–85 m W/m2, while in the basement high area, it was in a range of 75–100 m W/m2. During the post-rift phase, the heat flow decreased gradually, and tended to be more uniform in the basement highs and sags. However, an extensive magmatism, which equivalently happened at around 5 Ma, has greatly increased the heat flow values, and the relict heat still contributes about 10–25 m W/m2 to the present surface heat flow in the central depression zone and the southern uplift zone. Further analyses suggested that the present high heat flow in the deep-water Qiongdongnan Basin is a combined result of the thermal anomaly in the upper mantle, highly thinning of the lithosphere, and the recent extensive magmatism. Other secondary factors might have affected the heat flow distribution features in some local regions. These factors include basement and seafloor topography, sediment heat generation, thermal blanketing, local magmatic injecting and hydrothermal activities related to faulting and overpressure.     

Consolidation and creep behaviors of two typical marine clays in China

This paper presents an experimental investigation into the deformation characteristics of two typical marine clays obtained from Dalian and Shanghai, respectively, in China. Three kinds of laboratory tests, i.e. conventional oedometer tests, one-dimensional and triaxial creep tests were carried out. The results obtained from consolidation tests demonstrate linear v e ？ log？ relationships for Shanghai clay at normally consolidated state, while partly or even global non-linearrelationships for Dalian clay. The compression index c C for both clays follows the correlation of Cc=0.009（WL-10）where WL is the liquid limit of soil. The relationship between v log Kv （ Kv is the hydraulic conductivity of soil） and voidratio e is generally linear and the hydraulic conductivity change index kv C can be described by their initial void ratio forboth clays. The secondary compressibility of Dalian clay lies in medium to high range and is higher than that of Shanghaiclay which lies in the range of low to medium. Furthermore, based on drained triaxial creep tests, the stress-strain-timerelationships following Mesri＇s creep equation have been developed for Dalian and Shanghai clays which can predict thelong-term deformation of both clays reasonably well.     

鲜浒苔稀硫酸水解产糖工艺研究

分别用质量分数为0.6%、1.0%、1.4%、1.8%、2.2%的稀硫酸在121℃高温高压的条件下水解鲜浒苔30、60、90 min,浒苔水解残留物再用纤维素酶酶解,用DNS法测定上述各步骤中的还原糖产量。结果表明,浒苔总糖含量为67.2%。稀硫酸水解工艺中,硫酸质量分数为1.8%、水解90 min,浒苔还原糖转化率最高,达59.9%,每克干质量浒苔可产生447.0 mg还原糖。稀硫酸水解残留物纤维素酶酶解工艺中,浒苔还原糖转化率较低,在硫酸质量分数为0.6%、水解时间为60 min时还原糖转化率出现最大值,仅为6.5%。结果显示浒苔稀硫酸水解产还原糖效果显著,但并不能促进纤维素酶酶解。浒苔糖化可单独采用稀硫酸水解工艺,本实验条件下的最佳工艺条件为1.8%硫酸水解90 min。本研究探索了浒苔糖化工艺条件,对后续的浒苔燃料乙醇发酵研究具有一定的参考意义。     

基于PIV技术不同形式防波堤周围涡旋场特性研究(英文)

深水防波堤周围流场存在复杂的紊动变化,防波堤较容易发生失效破坏。本文利用PIV技术,基于模型实验,对规则波作用下防波堤周围的速度流场及其涡流特性进行了实验研究,获得了规则波流场的瞬时速度分布。通过对不同型式防波堤在不同的水力条件下的波浪流场实验数据的分析,定量地研究了防波堤堤身水域的涡旋流场的水力特性。     

天津沿海风暴潮灾害近20年统计及其成因分析(英文)

根据塘沽海洋环境监测站从1991~2010年,20年的潮汐资料进行统计分析,分析得到天津平均每年发生近10年的100 cm以上的增水过程,天津沿海夏秋两季的最高潮位和平均潮位最高,且最大增水值多出现在夏秋两季,超过100 cm的增水天数多集中在春季和秋冬季,并从天文潮因素、气象因素、海平面上升、地面沉降,以及地理因素等,总结了天津沿海风暴潮灾害的成因,最后提出了相应的风暴潮灾害防范措施。     

基于特征区域统计的多光谱遥感影像海岛瞬时岸线提取(英文)

本研究采用IKONOS遥感图像,选取波谱特征区,通过区域像元统计并计算各波段权重系数,将影像进行波谱归一化处理,使归一化的影像岛陆与海水特征更明显。在此基础上,采用最大类间方差法确定最佳分割阈值,对归一化的影像进行二值化,从而提取海岛岸线。该方法采用特征曲线法进行水陆分离,得到的二值图像保持了原图的有效边缘,采用二值形态学提取的海岸线连续可靠、信噪比高。结果表明,该方法简单、快速,能有效提取海岸线,具有实用价值。     

基于GA参数辨识的直流伺服电机PID调节器的设计

针对数控火焰切割机自动调高系统的特点和要求,采用遗传算法对其位置调节器PID参数进行全局优化辨识,有效地解决了直流伺服电机的控制精度和快速性的问题.仿真结果表明,与传统的参数辨识法相比,遗传算法参数寻优使自动调高系统的动态性能大幅提高,具有很强的鲁棒性.     

面向对象规则和支持向量机的天宫一号高光谱影像分类

传统的高光谱分类方法通常基于单一像元的光谱或纹理特征,很少考虑地物空间结构信息与空间相关特征.本文将面向对象规则与基于像元的分类进行融合,利用对象的空间结构特征和光谱特征进行混合分类,旨在克服像元层次分类的不足.本文尝试性的提出了两种混合分类方法:(1)基于分形网络演化的多尺度分割支持向量机分类(2)基于多层分水岭分割的SVM分类,并将这两种方法应用到天宫一号高光谱数据上.结果表明:基于面向对象规则的混合分类方法有效地提高了分类精度,不仅能够改善同谱异物现象,而且解决分类结果中地物破碎的问题.     

导航卫星受地球外辐射带影响仿真分析

目前国际上不同国家已经进行了多个导航系统的开发,而构成这些系统的关键空间段实体导航卫星通常分布在中高轨道上,通过地球辐射带对该空间区域内卫星的辐射影响进行仿真分析,对于中轨道空间辐射,当卫星屏蔽厚度大于9mm,再增加屏蔽厚度的方法对辐射隔离不再敏感;对于高轨道空间辐射,当卫星屏蔽厚度大于7mm,再增加屏蔽厚度方法对隔离辐射已经不再敏感。可见,仅从辐射加固角度来说,在卫星设计时,以10年寿命为例,对于中轨道卫星屏蔽厚度区间取[8,9]mm为宜,对于高轨道卫星屏蔽厚度区间取[6,7]mm为宜。     

Impact of vegetation feedback on the mid-Pliocene warm climate

Studying the vegetation feedback during warm periods of the past can lead to better understanding of those in the future.In this study,we conducted several simulations to analyze vegetation feedback during the mid-Pliocene warm period.The results indicate that the main features of vegetation change in the mid-Pliocene were a northward shift of needleleaf tree,an expansion of broadleaf tree and shrub,and a northward expansion of grass,as compared to the pre-industrial period.The global annual mean warming ratio caused by vegetation feedback was 12.1％,and this warming ratio was much larger in northern middle and high latitudes.The warming caused by vegetation change was directly related to the surface albedo change and was further amplified by snow/sea ice-albedo feedback.