SURFACE ROUGHNESS EVOLUTION OF SOILS CONTAINING ROCK FRAGMENTS

Soil surface roughness is a dynamic property which determines, to a large extent, erosion and infiltration rates. Although soils containing rock fragments are widespread in the Mediterranean region, the effect of the latter on surface roughness evolution is yet poorly understood. Therefore, laboratory experiments were conducted in order to investigate the effect of rock fragment content, rock fragment size and initial moisture content of the fine earth on the evolution of interrill surface roughness during simulated rainfall. Surface elevations of simulated plough layers along transects of 50 cm length were measured before and after simulated rainfall (totalling 192.5 mm, I = 70 mm h⁻¹) with a laser microreliefmeter. The results were used to investigate whether systematic variations in interrill surface roughness along stony hillslopes in southeastern Spain could be attributed to rock fragment cover and rock fragment size. Soil surface elevations were measured along the contour lines (50 cm long transects) with a contact microreliefmeter. Roughness was expressed by two parameters related to the height and frequency of roughness elements, respectively: standard deviation of de-trended surface elevations (random roughness: RR), and correlation length (L) derived from exponential fits of the autocorrelation functions. The frequently used assumption that surface roughness (RR) of cultivated topsoils decreases exponentially with cumulative rain is not valid for soil surfaces covered by rock fragments. The RR of soils containing small rock fragments (1.7–2.7 cm) increased with cumulative rainfall after an initial decrease during the first 17.5 mm of rainfall. For soils containing large rock fragments (7.7 cm), RR increased with rainfall above a threshold rock fragment content by mass of 52 per cent. For a given rainfall application, RR increased non-linearly with rock fragment content. The correlation length for soils containing small rock fragments decreases with rock fragment content and is significantly lower than for soils with large rock fragments. Soils covered with small rock fragments (large RR and small L) are thus well protected against raindrop impact by a water film in the depressions between the rock fragments. On abandoned agricultural fields along hillslopes in southeastern Spain, rock fragments cover increases non-linearly with slope owing to selective erosion of finer particles on steep slopes. The increase of surface cover by large rock fragments (>25 mm) is even more pronounced. The simultaneous increase of rock fragment cover and rock fragment size with slope explains the non-linear increase of RR with slope. These relationships differ for soils covered by platy misaschists and those covered with cubic andesites. The variations in correlation length along the hillslopes are not clear, probably owing to a simultaneous increase in rock fragment cover and rock fragment size. These findings may provide a better prediction of soil surface roughness of interrill areas covered by rock fragments using slope angle and lithology.     

The formation of a geometrical ridge network by the surge-type glacier Kongsvegen,Svalbard

Traditionally, geometrical ridge networks are interpreted as the product of the flow of subglacial sediment into open basal crevasses at the cessation of a glacier surge (‘crevasse-fill’ ridges). They are widely regarded as a characteristic landform of glacier surges. Understanding the range of processes by which these ridge networks form is therefore of importance in the recognition of palaeosurges within the landform record. The geometrical ridge network at the surge-type glacier Kongsvegen in Svalbard, does not form by crevasse filling. The networks consist of transverse and longitudinal ridges that can be seen forming at the current ice margin. The transverse ridges form as a result of the incorporation of basal debris along thrust planes within the ice. The thrusts were apparently formed during a glacier surge in 1948. Longitudinal ridges form through the meltout of elongated pods of debris, which on the glacier surface are subparallel to the ice foliation and pre-date the surge. This work adds to the range of landforms associated with glacier surges.     

Impact of lake‐level changes on the formation of thermogene travertine in continental rifts: Evidence from Lake Bogoria,Kenya Rift Valley

Travertine is present at 20% of the ca 60 hot springs that discharge on Loburu delta plain on the western margin of saline, alkaline Lake Bogoria in the Kenya Rift. Much of the travertine, which forms mounds, low terraces and pool‐rim dams, is sub‐fossil (relict) and undergoing erosion, but calcite‐encrusted artefacts show that carbonate is actively precipitating at several springs. Most of the springs discharge alkaline (pH: 8·3 to 8·9), Na‐HCO₃ waters containing little Ca (<2 mg l^?1) at temperatures of 94 to 97·5°C. These travertines are unusual because most probably precipitated at temperatures of >80°C. The travertines are composed mainly of dendritic and platy calcite, with minor Mg‐silicates, aragonite, fluorite and opaline silica. Calcite precipitation is attributed mainly to rapid CO₂ degassing, which led to high‐disequilibrium crystal morphologies. Stratigraphic evidence shows that the travertine formed during several stages separated by intervals of non‐deposition. Radiometric ages imply that the main phase of travertine formation occurred during the late Pleistocene (ca 32 to 35 ka). Periods of precipitation were influenced strongly by fluctuations in lake level, mostly under climate control, and by related changes in the depth of boiling. During relatively arid phases, meteoric recharge of ground water declines, the lake is low and becomes hypersaline, and the reduced hydrostatic pressure lowers the level of boiling in the plumbing system of the hot springs. Any carbonate precipitation then occurs below the land surface. During humid phases, the dilute meteoric recharge increases, enhancing geothermal circulation, but the rising lake waters, which become relatively dilute, flood most spring vents. Much of the aqueous Ca²⁺ then precipitates as lacustrine stromatolites on shallow firm substrates, including submerged older travertines. Optimal conditions for subaerial travertine precipitation at Loburu occur when the lake is at intermediate levels, and may be favoured during transitions from humid to drier conditions.     

Sedimentology,palaeoenvironments and biostratigraphy of the Pliocene–Pleistocene carbonate platform of Grande‐Terre (Guadeloupe,Lesser Antilles forearc)

Pliocene and Pleistocene deposits from Grande‐Terre (Guadeloupe archipelago, French Lesser Antilles) provide a remarkable example of an isolated carbonate system built in an active margin setting, with sedimentation controlled by both rapid sea‐level changes and tectonic movements. Based on new field, sedimentological and palaeontological analyses, these deposits have been organized into four sedimentary sequences (S1 to S4) separated by three subaerial erosion surfaces (SB0, SB1 and SB2). Sequences S1 and S2 (‘Calcaires inférieurs à rhodolithes’) deposited during the Late Zanclean to Early Gelasian (planktonic foraminiferal Zones PL2 to PL5) in low subsidence conditions, on a distally steepened ramp dipping eastward. Red algal‐rich deposits, which dominate the western part of Grande‐Terre, change to planktonic foraminifer‐rich deposits eastward. Vertical movements of tens of metres were responsible for the formation of SB0 and SB1. Sequence S3 (‘Formation volcano‐sédimentaire’, ‘Calcaires supérieurs à rhodolithes’ and ‘Calcaires à Agaricia’) was deposited during the Late Piacenzian to Early Calabrian (Zones PL5 to PT1a) on a distally steepened, red algal‐dominated ramp that changes upward into a homoclinal, coral‐dominated ramp. Deposition of Sequence S3 occurred during a eustatic cycle in quiet tectonic conditions. Its uppermost boundary, the major erosion surface SB2, is related to the Cala1 eustatic sea‐level fall. Finally, Sequence S4 (‘Calcaires à Acropora’) probably formed during the Calabrian, developing as a coral‐dominated platform during a eustatic cycle in quiet tectonic conditions. The final emergence of the island could then have occurred in Late Calabrian times.     

Validation of Jason and Envisat Altimeter Dual Frequency Rain Flags

New rain flags based on the dual frequency capabilities of the new Jason Poseidon-2 and Envisat RA2 altimeters have been tested, developed and adopted for the operational processing of the altimeter data. Their validation conducted during the calibration/validation phases of the satellites is presented here. The Jason flag is validated by comparison with the TOPEX one, using the Tandem mission. The results show a very good agreement between the two sensors and the two rain flags The Envisat flag is validated by comparison with both Jason and TOPEX using global and collocated data sets. The results show similar performances for the three sensors. The f relations estimated during the calibration-validation period and presented here have been given to the altimeter ground processing facilities for operational use.