试谈超大型铀矿床分类及找矿问题

随着核电事业在我国的发展，对铀资源保证的要求将越来越迫切。这里所指的铀资源保证应包含数量和效益两层意思，而超大型铀矿床则能同时满足对这两方面的要求。因此，在我国寻找超大型铀矿床是一项刻不容缓的任务。为了确立找矿目标，作者尝试提出了一种将矿床产出地质特征和经济效益相结合的超大型铀矿床分类方案，共划分出３大类１３个亚类。结合我国情况，作者认为在７个有远景的类型中，有３个（即Ⅰ－２、Ⅱ－１和Ⅲ－５）在我国最有突破的希望，特别是Ⅲ－５。最后，作者参考国外超大型铀矿床的找矿经验，对于加强我国对超大型铀矿床的探索提出了四点具体意见。     

鄂西娄山关组顶部古岩溶不整合面的发现及层序地层学意义

鄂西娄山关组顶部存在古岩溶不整合面，有众多陆上暴露和溶蚀标志，表明其产生受寒武纪末海平面下降事件的控制。它不仅形成了碳酸盐台地上典型的Ⅱ型层序界面，而且恰与寒武—奥陶纪年代地层界线相重合，体现了层序界面、年代界线和事件界线三位一体的有机结合     

Upper Mississippi embayment shallow seismic velocities measured in situ

Vertical seismic compressional- and shear-wave (P-and S-wave) profiles were collected from three shallow boreholes in sediment of the upper Mississippi embayment. The site of the 60-m hole at Shelby Forest, Tennessee, is on bluffs forming the eastern edge of the Mississippi alluvial plain. The bluffs are composed of Pleistocene loess, Pliocene-Pleistocene alluvial clay and sand deposits, and Tertiary deltaic-marine sediment. The 36-m hole at Marked Tree, Arkansas, and the 27-m hole at Risco, Missouri, are in Holocene Mississippi river floodplain sand, silt, and gravel deposits. At each site, impulsive P- and S-waves were generated by man-made sources at the surface while a three-component geophone was locked downhole at 0.91-m intervals.

Consistent with their very similar geology, the two floodplain locations have nearly identical S-wave velocity (V_S) profiles. The lowest V_S values are about 130 m s⁻¹, and the highest values are about 300 m s⁻¹ at these sites. The shear-wave velocity profile at Shelby Forest is very similar within the Pleistocene loess (12 m thick); in deeper, older material, V_S exceeds 400 m s⁻¹.

At Marked Tree, and at Risco, the compressional-wave velocity (V_P) values above the water table are as low as about 230 m s⁻¹, and rise to about 1.9 km s⁻¹ below the water table. At Shelby Forest, V_P values in the unsaturated loess are as low as 302 m s⁻¹. V_P values below the water table are about 1.8 km s⁻¹. For the two floodplain sites, the V_P/V_S ratio increases rapidly across the water table depth. For the Shelby Forest site, the largest increase in the V_P/V_S ratio occurs at 20-m depth, the boundary between the Pliocene-Pleistocene clay and sand deposits and the Eocene shallow-marine clay and silt deposits.

Until recently, seismic velocity data for the embayment basin came from eartquake studies, crustal-scale seismic refraction and reflection profiles, sonic logs, and from analysis of dispersed earthquake surface waves. Since 1991, seismic data for shallow sediment obtained from reflection, refraction, crosshole and downhole techniques have been obtained for sites at the northern end of the embayment basin. The present borehole data, however, are measured from sites representative of large areas in the Mississippi embayment. Therefore, they fill a gap in information needed for modeling the response of the embayment to destructive seismic shaking.     

一种基于二次灰关联分析的数列预测法

数列预测一直是评价决策中最常见而又信于把握的问题之一。本文在总结现有预测方法的基础上，结合前铛预报思想和灰色预测理论，依据数据求同原则，提出了运用二次灰关联分析，建立组合模型的预测方法，该方法易于计算机实现，并已实际应用于油气储量预测研究中。     

机载扫描激光地面测绘系统分析

本文根据机载扫描激光地面测绘系统的功能和要求，分析了它的工作原理，概括出该系统中扫描激光测距的特点，介绍了一种最新的机载扫描激光地面测绘系统，最后提出了几个需要继续研究的问题     

甘肃桦树沟(铁)铜矿床的成因机制

矿床地质地球化学特征研究结果表明，随着古陆边缘弧－槽－盆体系的发生与发展，元古代基底火山（沉积）岩系经深循环水（海水）－热系统的作用，成矿物质被浸出和搬运，并经海底喷溢作用沉淀于海盆洼地中形成桦树沟矿床含铜建造，后期变质作用使成矿物质活化、转移和富集。桦树沟矿床为喷气（流）沉积－变质改造型（铁）铜矿床。     

安徽省江淮地区清水钻进的管井取水效果探讨

本文根据施工实践的结果，综合分析对比了清水钻进与泥浆钻进的管井取水效果，指出清水钻进成井工艺是在现有机具设备条件下提高管井单井取水量的一个重要技术措施。特别是在安徽江淮相对贫水地区，采用清水钻进工艺成井的地质效果尤为明显。     

Crustal structure of Dabieshan orogenic belt

The crustal structures ofP velocity and density on the deep seismic sounding profile across the Ilabieshan orogenic belt are presented. There is a 5-km-thick crustal “root” between the Yuexi and Xiaotian where the elevation is highest on the profile. An apparent Moho offset of 4. 5 km beneath the Xiaotian-Mozitan fault marks the paleo-suture of the Triassic collision. A high-velocity anomaly zone at the depth below 3 km beneath the ultra-high pressure (UHP) zone may be correlated to the higher content of UHP metamorphic rocks. Project supported by the National Natural Science Foundation of China and the Joint Earthquake Science Foundation.     

华北地区煤的显微组分结焦性热台试验

为探讨煤的显微组分的结焦性，对不同变质程度煤的镜质组、壳质组和惰性组分别进行了显微镜热台加热试验．在加热过程中，活性组分经历了３个明显不同的变化阶段，即变形阶段、胶质体形成阶段以及固化阶段．随煤变质程度的增加，镜质组的初变温度和胶质体形成时的温度逐渐增大，而固结温度变化规律不明显；壳质组在低变质阶段因受热而挥发掉，但随煤级增高其变形程度减弱；半镜质组在受热过程中也有变形和少量胶质体形成，而惰性组只发生微弱变化．在低变质阶段，活性显微组分形成的焦炭显微结构以各向同性为主；随变质程度的增高，焦炭显微结构中各向异性成分比例增大