Symmetropy of Fault Patterns: Quantitative Measurement of Anisotropy and Entropic Heterogeneity

The purpose of the effort in this paper is to show symmetropy of fault patterns. This quantity can be considered as a measure of entropic heterogeneity and anisotropy. We describe this measure based on the discrete Walsh transform. The specific results of its applications are obtained as follows. When a rock specimen undergoes creep in a laboratory experiment, the fault propagation can be monitored by the decrease of symmetropy. Moreover, in a fault model with self-organized criticality, fault patterns of critical states and subcritical states are distinguished by the behavior of the symmetropy: subcritical fault patterns show almost constant value of symmetropy but it takes various values during critical states. These results demonstrate that symmetropy idea can be used for the quantification of fault patterns.     

Late Quaternary faulting along the western margin of the Poronaysk Lowland in central Sakhalin, Russia

Sakhalin Island straddles an active plate boundary between the Okhotsk and Eurasian plates. South of Sakhalin, this plate boundary is illuminated by a series of M_w 7–8 earthquakes along the eastern margin of the Sea of Japan. Although this plate boundary is considered to extend onshore along the length of Sakhalin, the location and convergence rate of the plate boundary had been poorly constrained. We mapped north-trending active faults along the western margin of the Poronaysk Lowland in central Sakhalin based on aerial photograph interpretation and field observations. The active faults are located east of and parallel to the Tym–Poronaysk fault, a terrane boundary between Upper Cretaceous and Neogene strata; the active faults appear to have reactivated the terrane boundary at depth in Quaternary time. The total length of the active fault zone on land is about 140 km. Tectonic geomorphic features such as east-facing monoclinal and fault scarps, back-tilted fluvial terraces, and numerous secondary faults suggest that the faults are west-dipping reverse faults. Assuming the most widely developed geomorphic surface in the study area formed during the last glacial maximum at about 20 ka based on similarities of geomorphic features with those in Hokkaido Island, we obtain a vertical component of slip rate of 0.9–1.4 mm/year. Using the fault dip of 30–60°W observed at an outcrop and trench walls, a net slip rate of 1.0–2.8 mm/year is obtained. The upper bound of the estimate is close to a convergence rate across the Tym–Poronaysk fault based on GPS measurements. A trenching study across the fault zone dated the most recent faulting event at 3500–4000 years ago. The net slip associated with this event is estimated at about 4.5 m. Since the last faulting event, a minimum of 3.5 m of strain, close to the strain released during the last event, has accumulated along the central portion of the active strand of the Tym–Poronaysk fault.     

Diurnal variations of the planetary boundary layer observed with anL-band clear-air doppler radar

Based on continuous observations of the planetary boundary layer (PBL) with anL-band (1357.5 MHz) boundary-layer radar (BLR) at a hilly location in Japan, we have discovered that on clear days, a thin enhanced echo layer corresponding to the top of the PBL (or mixed layer) appeared at about 500 m height in the morning and ascended to about 1500 m in the afternoon. Strong upward velocities were observed below the echo layer (or inside the PBL), reaching 1500 m in the afternoon.     

Sedimentary humic acid and fulvic acid as surface active substances

Surface tension of sedimentary fulvic acid (FA) and humic acid (HA) with molecular weight from < 10,000 to > 300,000 was measured at 5°C and 25°C, over a wide range of concentrations (0.114-107.4 g/l) at pH 8. HA was in the form of sodium humate. Surface tension decreases with an increase in HA and FA concentration and both HA and FA were found to be surface active materials with FA exhibiting the lowest surface tension (31 dynes/cm).Plots of surface tension vs. log concentration gave two straight lines with a break at a certain concentration similar to surfactants. From the concentration at the break point, aggregation concentration (AGC) was determined. For HA with molecular weight above 10,000, the AGC decreased with an increase in molecular weight. The more hydrophobic the HA, the greater was the tendency to form aggregates. Surface excess (surface concentration) was determined (2.3 × 10^?10?5.5 × 10^?10mol/cn²) from the slope of the plot of surface tension vs. log concentration for concentrations lower than the AGC. Adsorption of HA into the surface layer increased with increasing molecular weight of HA.     

Ambient air measurements of six bifunctional carbonyls in a suburban area

Low-molecular-weight carbonyl compounds, generated by photochemical reactions in the atmosphere and found in the exhaust of motor vehicles, have recently come to the attention of researchers because some of them are suspected carcinogens or mutagens. Six bifunctional carbonyl compounds were detected and measured in a suburban site 30 km northwest of the Tokyo metropolitan area. Samples were taken on five sunny days between 2 August and 11 August 2003 with a low-volume denuder and three-filter tandem system using O-(2,3,4,5,6-pentafluorobenzyl)hydroxylamine (PFBHA) as a sorbent. Bifunctional carbonyls were measured by gas chromatography–mass spectrometry after two derivatization processes with PFBHA and N,O-bis(trimethylsilyl)-trifluoroacetamide (BSTFA). The average total (gas plus particle) concentrations were 162.8 ng m^− 3 for pyruvic acid, 113.7 ng m^− 3 for methylglyoxal, 36.0 ng m^− 3 for glycolaldehyde and 58.6 ng m^− 3 for glyoxal.     

Monitoring Quiescent Volcanoes by Diffuse CO2 Degassing: Case Study of Mt. Fuji, Japan

Since the 8th century, more than seventeen eruptions have been recorded for the Mt. Fuji volcano, with the most recent eruption occurring in 1707 (Hoei eruption). For the past 300 years the volcano has been in a quiescent stage and, since the early 1960s, has exhibited neither fumarolic nor thermal activity. However, the number of low-frequency earthquakes with a hypocentral depth of 10–20 km increased significantly beneath the northeastern flank of Mt. Fuji in 2000–2001, suggesting a possible resumption of magmatic activity. In this study, diffuse CO₂ efflux and thermal surveys were carried out in four areas of the volcano in 2001–2002 in order to detect possible signs of the upward movement of deep magma. At all survey points, the CO₂ efflux was below the detection limit with the exception of a few points with biological CO₂ emission, and ground temperatures at a depth of 20–30 cm were below ambient, indicating no surface manifestations of gas or heat emission. Should magma rise into the subsurface, the diffuse CO₂ efflux would be expected to increase, particularly along the tectonically weakened lineation on the Mt. Fuji volcano, allowing for the early detection of pre-eruptive degassing.     

Estimation of episodic exfoliation rates of rock sheets on a granite dome in Korea from cosmogenic nuclide analysis

We have measured concentrations of cosmogenic ¹⁰Be and ²⁶Al produced in situ at bare bedrock surfaces of successive sheets developing on a granite dome in Korea and calculated the exfoliation rate of sheeting joints. The exfoliation rate was obtained using a simple model in which the sheeting joints experience intermittent denudation, i.e. peeling off along the bedrock face. We find that the average exfoliation (erosion) rate of the episodic peeling‐off process is 5·6 cm/ka^?1. The analysis is useful for understanding the evolution of granite sheeting structures on this dome in Korea. Copyright © 2006 John Wiley & Sons, Ltd.