Low-temperature coherent exsolution in alkali feldspars from high-grade metamorphic rocks of Sri Lanka

In the alkali feldspars of the amphibolite- and granulite-facies rocks of Sri Lanka, a late-stage, final exsolution event is observed which produced film lamellae and fine-scale spindles. These were investigated by optical, microprobe, single-crystal, transmission electron microscopy and atomic resolution microscopy techniques. The lamellae and spindles exsolved below the coherent solvus at temperatures as low as 300 to 350° C. Precession photographs and ARM micrographs show that the intergrowth is perfectly coherent. In sections (010) the rhombic section of the Pericline twins corresponds to analbite or high albite. The albite lamellae and spindles nucleated and grew at low temperatures in a metastable disordered structural state within a tweed-orthoclase matrix and became periodically twinned analbite or high albite, which subsequently developed only a slight increase in Al, Si order. The relationship between twin periodicity and lamellar width, predicted for coherent intergrowths by Willaime and Gandais (1972), is obeyed. In Or-rich grains, in which coherent exsolution is the only exsolution event, the film lamellae tend to be restricted to the rim, the fine-scale spindles to the centre of the grains. The films nucleated heterogeneously at grain boundaries and grew towards the grain centres. Fine-scale spindles probably nucleated homogeneously in the interior part of grains. Heterogeneous nucleation and coherent growth are not mutually exclusive.     

Hydrogeochemical zonation for groundwater management in the area with diversified geological and land-use setup

Despite its limited aerial extent, the National Capital Territory (NCT) Delhi, India, has diversified geological and topographical setup. A geochemical assessment of prevailing conditions of aquifer underlying the NCT was attempted and further classified into different hydrogeochemical zones on the basis of statistical and analyses and its correlation with land use, geological and climatic setting. Mineral phase study and isotopic analyses were used for the verification of performed clustering. Saturation indices (SI) calculated using the geochemical modelling code PHREEQC were used to distinguish the characteristics of four zones, as saturation states of the water does not change abruptly. Four different hydrogeochemical zones were statistically identified in the area: (1) intermediate (land-use-change-impacted) recharge zone, (2) discharge (agriculture-impacted) zone, (3) recharge (ridge) zone, and (4) recharge floodplain (untreated-discharge-impacted) zone. The distinctiveness of hydro-geochemical zones was further verified using stable isotopic (²H and ¹⁸O) signature of these waters. GIS-based flow regime in association with long-term geochemical evidences implied that these zones are being affected by different problems; thus, it necessitates separate environmental measures for their management and conservation. The study suggested that in a diversified urban setup where the complex interactions between anthropogenic activities and normal geochemical processes are functioning, hydrogeochmical zoning based on the integration of various techniques could be the first step towards sketching out the groundwater management plan.     

Pogo and Pangaea

Long wavelength magnetic anomalies of crustal origin derived from the POGO and MAGSAT satellite data often display a strong continuity across the now-rifted continental margins when the continents are reassembled into Pangaea. These anomalies predate the breakup of the supercontinent and represent major blocks whose crustal properties are broadly similar even though those blocks are no longer contiguous.     

Identification of the projectile at the Brent crater,and further considerations of projectile types at terrestrial craters

Impact melt samples from drill hole B1-59 at the 3.8 km diameter Brent crater (Ontario) have been analysed for siderophile trace elements indicative of meteoritic contamination. Samples from the basal melt zone at 823–857 m depth are enriched in Ir, Os, Pd, Ni, Co, Cr and Se over basement, with the abundance pattern suggesting a chondritic projectile for Brent. From a Ni-Cr correlation of 10 melt samples an L or LL chondrite is inferred. The contribution of an ultramafic country rock (alnoite) in the melt is too small to significantly influence its $\text{Ni}\text{Cr}$ ratio. Glass-rich breccias from the allochthonous breccias filling the crater also contain a meteoritic component. Interelement ratios (e.g. $\text{Ni}\text{Cr}$) are, however, fractionated relative to the melt zone samples. This, as well as the low Au content of all Brent samples, is probably a product of alteration.Additional data on impact melts from the 65 km diameter crater Manicouagan still did not reveal a meteoritic component, as also for the Mistastin crater (28 km diameter) where Cr analyses set an upper limit of 1% of an achondritic projectile component in the melt. Irghizites (tektite like glasses) from the Zhamanshin impact structure have been found to contain high Ni and Co concentrations, and our data show that Ir is also enriched. It is however not possible to define the projectile-type. Enrichment of an Ivory Coast tektite in Ir is confirmed. There are large differences in siderophile element concentrations among tektites, with otherwise similar chemical composition.There are now four known craters formed by chondrites (Clearwater East, Lapparjärvi, Wanapitei, and Brent), with Brent being the smallest of these. For smaller craters the projectiles appear to be limited to iron or stony-iron meteorites, because of atmospheric destruction of relatively small stony meteorites. It appears, however, that all major classes of meteorites are represented among the projectiles at terrestrial impact craters.     

Generation and expulsion of oils from Permian coals of the Sydney Basin,Australia

Organic geochemical and petrological assessment of coals/coaly shales and fine grained sediments, coupled with organic geochemical analyses of oil samples, all from Permo–Triassic sections of the Southern Sydney Basin (Australia), have enabled identification of the source for the widely distributed oil shows and oil seeps in this region. The Permian coals have higher hydrogen indices, higher liptinite contents, and much higher total organic matter extract yields than the fine grained sediments. A variety of source specific parameters obtained from n-alkanes, regular isoprenoids, terpanes, steranes and diasteranes indicate that the oil shows and seeps were generated and expelled predominantly from higher plant derived organic matter deposited in oxic environments. The source and maturity related biomarkers and aromatic hydrocarbon distributions of the oils are similar to those of the coals. The oil-coal relationship also is demonstrated by similarities in the carbon isotopic composition of the total oils, coal extracts, and their individual n-alkanes. Extracts from the Permo–Triassic fine grained sediments, on the other hand, have organic geochemical signatures indicative of mixed terrestrial and prokaryotic organic matter deposited in suboxic environments, which are significantly different from both the oils and coal extracts. The molecular signatures indicating the presence of prokaryotic organic matter in some of the coal extracts and oils may be due to thin sections of possibly calcareous lithologies interbedded within the coal measures. The genetic relationship between the oils and coals provides new evidence for the generation and expulsion of oils from the Permian coals and raises the possibility for commercial oil accumulations in the Permian and Early Triassic sandstones, potentially in the deeper offshore part of the Sydney Basin.     

Controls on channel deposits of highly variable rivers: Comparing hydrology and event deposits in the Burdekin River,Australia

Discharge event frequency, magnitude and duration all control river channel morphology and sedimentary architecture. Uncertainty persists as to whether alluvial deposits in the rock record are a time-averaged amalgam from all discharge events, or a biased record of larger events. This paper investigates the controls on channel deposit character and subsurface stratigraphic architecture in a river with seasonal discharge and very high inter-annual variability, the Burdekin River of north-east Australia. In such rivers, most sediment movement is restricted to a few days each year and at other times little sediment moves. However, the maximum discharge magnitude does not directly correlate with the amount of morphological change and some big events do not produce large deposits. The Burdekin channel deposits consist of five main depositional elements: (i) unit bars; (ii) vegetation-generated bars; (iii) gravel sheets and lags; (iv) antidune trains; and (v) sand sheets. The proportions of each depositional element preserved in the deposits depend on the history of successive large discharge events, their duration and the rate at which they wane. Events with similar peak magnitude but different rate of decline preserve different event deposits. The high intra-annual and inter-annual discharge variability and rapid rate of stage change make it likely that small to moderate-scale bed morphology will be in disequilibrium with flow conditions most of the time. Consequently, dune and unit bar size and cross-bed set thickness are not good indicators of event or channel size. Antidunes may be more useful as indicators of flow conditions at the time they formed. Rivers with very high coefficient of variance of maximum discharge, such as the Burdekin, form distinctive channel sediment bodies. However, the component parts are such that, if they are examined in isolation, they could lead to misleading interpretation of the nature of the depositional environment if conventional interpretations are used.     

Rheological characteristics of mixed kaolin–sand slurry,impacts of pH,temperature, solid concentration and kaolin–sand mixing ratio

Significant amount of slurry waste is produced from mineral processing plants globally constituting high levels of both kaolin and sand in aqueous suspension. Large quantities of slurry and mine tailings require efficient handling, transportation and storage system. The transportation and treatment of kaolin–sand slurry is dependent on its rheological behaviour which is a function of temperature, total solid concentration and pH. In this study, the effects of total solid concentration, pH and temperature on rheological behaviour of kaolin–sand mixture were investigated. These parameters were varied to analyse the viscosity, yield stress, flow index and shear force requirements of the mixed kaolin–sand suspension as a function of these varying parameters. Experimental rheological investigation conducted on rotational stress-controlled rheometer equipped with Peltier concentric cylinder system showed that the kaolin–sand mixture suspension is shear thickening in nature. The shear stress-rate rheograms for the kaolin–sand suspension can be modelled by the Herschel–Bulkley model with high levels of accuracy for pH range of 4–11, temperature range of 20–50 °C and solid concentration of 5–50 %. Solid concentration of the suspension was found to significantly affect the rheological behaviour of the mixture where higher kaolin–sand slurry concentration resulted in greater viscosity and the trend becoming less predictable for solid concentration greater than 50 % by weight. pH was another factor affecting the rheological behaviour of kaolin–sand slurry. pH of 3 or less resulted in the dramatic increase of viscosity of the suspension possibly due to the isoelectric point of the mixture system found between pH of 3 and 4.