Large-Eddy Simulation of Pollutant Removal from a Three-Dimensional Street Canyon

Large-eddy simulations were conducted to investigate the mechanism of pollutant removal from a three-dimensional street canyon. Five block configurations with aspect ratios (building height to length) of 1, 2, 4, 8 and $\infty $ were used to create an urban-like array. A pollutant was released from a ground-level line source at the centre of the target canyon floor. For smaller aspect ratios, the relative contribution of the turbulent mass flux to net mass flux at the roof level, which was spatially averaged along the roof-level ventilation area, was closer to unity, indicating that turbulent motions mainly affected pollutant removal from the top of the canyon. As aspect ratio increased, the relative contribution became smaller, owing to strong upwind motions. However, the relative contribution again reached near unity for the infinite aspect ratio (i.e. a two-dimensional street canyon) because of lowered lateral flow convergence. At least 75 % of total emissions from the three-dimensional street canyon were attributable to turbulent motions. Pollutant removal by turbulent motions was related to the coherent structures of low-momentum fluid above the canyons. Though the coherent structure size of the low-momentum fluid differed, the positions of low-momentum fluid largely corresponded to instantaneous high concentrations of pollutant above the target canyon, irrespective of canyon geometry.     

Effect of oxygen partial pressure on the dislocation recovery in olivine: a new constraint on creep mechanisms

The dislocation annihilation rate in experimentally deformed olivine single crystals was measured as a function of oxygen partial pressure (P_O2). It was shown that the dislocation annihilation rate decreased with increasing P_O2. This result is inconsistent with the reported P_O2 dependence of creep rate () in single olivine crystals, thus indicating that the creep in single olivine crystals is not rate-controlled by recovery, under the experimentally investigated conditions.     

Response of hybrid isolation system during a shake table experiment of a full‐scale isolated building

A full‐scale 5‐story steel moment frame building was subjected to a series of earthquake excitations using the E‐Defense shake table in August, 2011. For one of the test configurations, the building was seismically isolated by a hybrid system of lead‐rubber bearings and low friction roller bearings known as cross‐linear bearings, and was designed for a very rare 100 000‐year return period earthquake at a Central and Eastern US soil site. The building was subject to 15 trials including sinusoidal input, recorded motions and simulated earthquakes, 2D and 3D input, and a range of intensities including some beyond the design basis level. The experimental program was one of the first system‐level full‐scale validations of seismic isolation and the first known full‐scale experiment of a hybrid isolation system incorporating lead‐rubber and low friction bearings. Stable response of the hybrid isolation system was demonstrated at displacement demands up to 550 mm and shear strain in excess of 200%. Torsional amplifications were within the new factor stipulated by the code provisions. Axial force was observed to transfer from the lead‐rubber bearings to the cross‐linear bearings at large displacements, and the force transfer at large displacements exceeded that predicted by basic calculations. The force transfer occurred primarily because of the flexural rigidity of the base diaphragm and the larger vertical stiffness of the cross‐linear bearings relative to the lead‐rubber bearings.     

Nishinoshima volcano in the Ogasawara Arc: New continent from the ocean?

Nishinoshima, a submarine volcano in the Ogasawara Arc, approximately 1 000 km south of Tokyo, Japan, suddenly erupted in November 2013, after 40 years of dormancy. Olivine‐bearing phenocryst‐poor andesites found in older submarine lavas from the flanks of the volcano have been used to develop a model for the genesis of andesitic lavas from Nishinoshima. In this model, primary andesite magmas originate directly from the mantle as a result of shallow and hydrous melting of plagioclase peridotites. Thus, it only operates beneath Nishinoshima and submarine volcanoes in the Ogasawara Arc and other oceanic arcs, where the crust is thin. The primary magma compositions have changed from basalt, produced at considerable depth, to andesite, produced beneath the existing thinner crust at this location in the arc. This reflects the thermal and mechanical evolution of the mantle wedge and the overlying lithosphere. It is suggested that continental crust‐like andesitic magma builds up beneath submarine volcanoes on thin arc lithosphere today, and has built up beneath such volcanoes in the past. Andesites produced by this shallow and hydrous melting of the mantle could accumulate through collisions of plates to generate continental crust.     

Ultrasonic measurements of Vp and Qp: relaxation spectrum of complex modulus on basalt melts

Ultrasonic compressional wave velocity V_p and quality factor Q_p have been measured in alkali basalt, olivine basalt and basic andesite melts in the frequency range of 3.4–22 MHz and in the temperature range of 1100–1400°C. Velocity and attenuation of the melts depend on frequency and temperature, showing that there are relaxation mechanisms in the melts. Complex moduli are calculated from the ultrasonic data. The results fit well a complex modulus of Arrhenius temperature dependence with log-normal Gaussian distribution in relaxation times of attenuation. The analysis yields average relaxation time, its activation energy, relaxed modulus, unrelaxed modulus and width of Gaussian distribution in relaxation times. Relaxed modulus is smaller (17.5 GPa) for basic andesite melt of high silica and high alumina contents than for the other two basalt melts (18.1–18.4 GPa). The most probable relaxation times decrease from ～ 3 × 10^?10 s for basic andesite to ～ 10^?11 s for alkali basalt at 1400°C. Activation energies of attenuation, ranging from 270 to 340 kJ mol^?1 in the three melts, are highest in basic andesite. Longitudinal viscosity values and their temperature dependences are also calculated from V_p and Q_p data. The volume viscosity values are estimated from the data using the shear viscosity values. Longitudinal, volume and shear viscosities and their activation energies are highest in the basic andesite melt of the most polymerized structure.     

Effects of inertial and kinematic interaction on seismic behavior of pile with embedded foundation

Effects of inertial and kinematic forces on pile stresses are studied based on large shaking table tests on pile-structure models with a foundation embedded in dry and liquefiable sand deposits. The test results show that, if the natural period of the superstructure, T_b, is less than that of the ground, T_g, the ground displacement tends to be in phase with the inertial force from the superstructure, increasing the shear force transmitted to the pile. In contrast, if T_b is greater than T_g, the ground displacement tends to be out of phase with the inertial force, restraining the pile stress from increasing. With the effects of earth pressures on the embedded foundation and pile incorporated in, pseudo-static analysis is conducted to estimate maximum moment distribution in pile. It is assumed that the maximum moment is equal to the sum of the two stresses caused by the inertial and kinematic effects if T_b<T_g or the square root of the sum of the squares of the two if T_b>T_g. The estimated pile stresses are in good agreement with the observed ones regardless of the occurrence of soil liquefaction.     

Non-destructive monitoring of trace element levels in short-tailed albatrosses (Phoebastria albatrus) and black-footed albatrosses (Phoebastria nigripes) from Torishima Island, Japan using eggs and blood

Concentrations of 18 trace elements (V, Cr, Mn, Co, Cu, Zn, Se, Rb, Sr, Mo, Ag, Cd, Sb, Cs, Ba, Hg, Tl and Pb) were determined in abandoned eggs of short-tailed albatrosses and abandoned eggs and blood of black-footed albatrosses from Torishima Island, Japan in 2002. Mercury concentration was highest among the toxic elements in egg content of both the two species. In some egg contents of black-footed albatrosses, Hg concentrations were higher than the threshold level that may cause decreased hatchability and aberrant nesting behavior in some avian species. Concentrations of Cd in egg content and Ba in egg content and shell increased with an increase in egg breadth/length ratio, whereas Hg in egg content showed an opposite trend in black-footed albatrosses. Since egg breadth/length ratio is known to increase with the age of mother bird, this result may imply that concentrations of these elements in eggs vary with age of mother bird. In blood of black-footed albatross chicks, concentration of Hg was highest among the toxic elements and the Hg concentration showed an increase in the later growth stages. In contrast, concentration of Sr in blood decreased with growth stage. Since the behaviour of Sr is similar to that of Ca in animals, it is conceivable that Sr was used along with Ca for the formation of bone.     

Cohesive Crack Analysis of Toughness Increase Due to Confining Pressure

Apparent fracture toughness in Mode I of microcracking materials such as rocks under confining pressure is analyzed based on a cohesive crack model. In rocks, the apparent fracture toughness for crack propagation varies with the confining pressure. This study provides analytical solutions for the apparent fracture toughness using a cohesive crack model, which is a model for the fracture process zone. The problem analyzed in this study is a fluid-driven fracture of a two-dimensional crack with a cohesive zone under confining pressure. The size of the cohesive zone is assumed to be negligibly small in comparison to the crack length. The analyses are performed for two types of cohesive stress distribution, namely the constant cohesive stress (Dugdale model) and the linearly decreasing cohesive stress. Furthermore, the problem for a more general cohesive stress distribution is analyzed based on the fracture energy concept. The analytical solutions are confirmed by comparing them with the results of numerical computations performed using the body force method. The analytical solution suggests a substantial increase in the apparent fracture toughness due to increased confining pressures, even if the size of the fracture process zone is small.     

Anomalous hydrogen emissions from the San Andreas fault observed at the Cienega Winery,central California

We began continuous monitoring of H₂ concentration in soil along the San Andreas and Calaveras faults in central California in December 1980, using small H₂/O₂ fuel-cell sensors. Ten monitoring stations deployed to date have shown that anomalous H₂ emissions take place occasionally in addition to diurnal changes. Among the ten sites, the Cienega Winery site has produced data that are characterized by very small diurnal changes, a stable baseline, and remarkably distinct spike-like H₂ anomalies since its installation in July 1982. A major peak appeared on 1–10 November 1982, and another on 3 April 1983, and a medium peak on 1 November 1983. The occurrences of these peaks coincided with periods of very low seismicity within a radius of 50 km from the site. In order to methodically assess how these peaks are related to earthquakes, three H₂ degassing models were examined. A plausible correlational pattern was obtained by using a model that (1) adopts a hemicircular spreading pattern of H₂ along an incipient fracture plane from the hypocenter of an earthquake, (2) relies on the FeO–H₂O reaction for H₂ generation, and (3) relates the accumulated amount of H₂ to the mass of serpentinization of underlying ophiolitic rocks; the mass was tentatively assumed to be proportional to the seismic energy of the earthquake.     

Geological age of the Yokawa Formation of the Kobe Group (Japan) on the basis of terrestrial mammalian fossils

Abstract   The age of the Yokawa Formation of the Cenozoic Kobe Group distributed in Hyogo Prefecture of western Japan based on mammalian fossils is discussed. Two fossil dental specimens of terrestrial mammals discovered from the lowest part of the Yokawa Formation in the Sanda area are described. These two fossils described here are: (i) a right mandibular fragment with p2–m3 of Bothriodon sandaensis sp. nov. (selenodont anthracotheriid artiodactyl), which appears to be the most primitive among the species of the genus; and (ii) right m1–m3 of cf. Hyrachyus sp. (primitive rhinocerotoid perissodactyl). In the lower part of the Yokawa Formation, Zaisanamynodon (amynodontid perissodactyl) was previously reported. The morphology ('evolutionary stage') of B. sandaensis is indicative of the latest Middle to Late Eocene, that of cf. Hyrachyus sp. is indicative of the Early to Middle Eocene, and Zaisanamynodon is indicative of the Late Middle to Late Eocene. Therefore, the fossil mammals of the Yokawa Formation indicate an latest Middle Eocene ( ca . 38 Ma) correlation for the lower part of the formation, as a working hypothesis. Although the resolution of the geological age based on these mammalian fossils is relatively low compared to that based on marine index fossils, this result is concordant with the recent radiometric correlation of the lower part of the Yokawa Formation in the Sanda area.