Estimating the impact parameters of cosmic dust particles using a piezoelectric lead zirconate titanate detector

A cosmic dust detector for installation on a satellite is currently being developed using piezoelectric lead zirconate titanate (PZT), which can possess both functions of the collector and the transducer. The characteristics of the PZT detector have been studied by bombarding it with hypervelocity particles supplied by a Van de Graaff accelerator. The front surface of the detector used in this study was covered with a white paint to reduce any increase in the temperature due to the solar radiation. There was a linear relationship between the rise time of the signal produced by the detector and the particle's velocities, which were above 10 km/s on impact. This implies that individual particle velocities on impact can be inferred through the empirical formula derived from the data obtained from the PZT detector.     

Adsorption of tributyltin by tributyltin resistant marine Pseudoalteromonas sp. cells

The isolate, Pesudoalteromonas sp. TBT1, could grow to overcome the toxicity of tributyltin chloride (TBTCl) up to 30 microM in the absence of Cl(-) in the medium until the cells reached an exponential phase of growth. The viability, however, was reduced after the cells reached a stationary phase. The degradation products, such as dibutyltin (DBT) and monobutyltin (MBT), were not detected in the growth medium, indicating that the isolate has no ability to degrade TBT into less toxic DBT and MBT. Up to about 10(7.5) TBT molecules were adsorbed by a single cell. The observation of morphological changes with an electron microscope showed that the cell surface became wrinkled after exposure to the lethal concentration of 10 mM TBTCl. These results indicate that the resistance of the isolate toward the toxicity of TBTCl is not related to the unique cell surface, which seems to play an important role in preventing the diffusion of TBTCl into the cytoplasm.     

Adsorption of tributyltin by tributyltin resistant marine Pseudoalteromonas sp. cells

The isolate, Pesudoalteromonas sp. TBT1, could grow to overcome the toxicity of tributyltin chloride (TBTCl) up to 30 μM in the absence of Cl⁻ in the medium until the cells reached an exponential phase of growth. The viability, however, was reduced after the cells reached a stationary phase. The degradation products, such as dibutyltin (DBT) and monobutyltin (MBT), were not detected in the growth medium, indicating that the isolate has no ability to degrade TBT into less toxic DBT and MBT. Up to about 10^7.5 TBT molecules were adsorbed by a single cell. The observation of morphological changes with an electron microscope showed that the cell surface became wrinkled after exposure to the lethal concentration of 10 mM TBTCl. These results indicate that the resistance of the isolate toward the toxicity of TBTCl is not related to the unique cell surface, which seems to play an important role in preventing the diffusion of TBTCl into the cytoplasm.     

Effects of alkali and alkaline-earth cations on the high-pressure sound velocities of aluminosilicate glasses

Physics and Chemistry of Minerals - A black tourmaline sample from Seagull batholith (Yukon Territory, Canada) was established to be a schorl with concentrations of Fe2+ among the highest currently...     

Compressional behaviour of CaNiSi2O6 clinopyroxene: bulk modulus systematic and cation type in clinopyroxenes

A single-crystal of composition CaNiSi₂O₆ (space group C2/c) was investigated at high pressure up to about 7.8 GPa by X-ray diffraction. The unit-cell parameters were measured at 18 different pressures. The P-V data were fitted by a third-order Birch-Murnaghan equation of state V₀=435.21(1) ų, K ₀=117.6(3) GPa and K^=6.4(1). The linear axial compressibilities _a, _b, _c and a sin are 2.14(1), 3.00(1), 2.43(1) and 1.63(1) × 10–3 GPa^–1. Comparing the compressibility data with other CaM1Si₂O₆ pyroxenes we suggest that the empirical K × V = constant relationships are followed in C2/c pyroxenes only if the same valence electron character is shared.     

Development of a Multi-Layer Urban Canopy Model for the Analysis of Energy Consumption in a Big City: Structure of the Urban Canopy Model and its Basic Performance

A multilayer one-dimensional canopy model was developed to analyze the relationship between urban warming and the increase in energy consumption in a big city. The canopy model, which consists of one-dimensional diffusion equations with a drag force, has three major parameters: building width, distance between buildings, and vertical floor density distribution, which is the distribution of a ratio of the number of the buildings that are taller than some level to all the buildings in the area under consideration. In addition, a simplified radiative process in the canopy is introduced. Both the drag force of the buildings and the radiative process depend on the floor density distribution. The thermal characteristics of an urban canopy including the effects of anthropogenic heat are very complicated. Therefore, the focus of this research is mainly on the basic performance of an urban canopy without anthropogenic heat. First, the basic thermal characteristics of the urban canopy alone were investigated. The canopy model was then connected with a three-dimensional mesoscale meteorological model, and on-line calculations were performed for 10 and 11 August, 2002 in Tokyo, Japan. The temperature near the ground surface at the bottom of the canopy was considerably improved by the calculation with the canopy model. However, a small difference remained between the calculation and the observation for minimum temperature. Deceleration of the wind was well reproduced for the velocity at the top of the building by the calculation with the canopy model, in which the floor density distribution was considered.     

Necessary condition for the existence of algebraic first integrals

Existence of algebraic first integrals for a class of dynamical systems is discussed in connection with the nature of the singularities of solutions. It is shown that under some conditions, the existence of algebraic first integrals controls a quantity characterising a singularity (Kowalevski's exponent) which can be calculated in a finite procedure. Two simple examples are given, which illustrate how main theorems work.     

Kuroshio warm filament and the source of the warm water of the Tsushima Current

Characteristics and evolution of the Kuroshio frontal eddies and warm filaments are analyzed according to two series of satellite images (March 5 to 7, 1986 and April 14 to 16, 1988). The results show that the frontal eddies in the East China Sea are generated at the shelf break and move along the continental slope at a speed of 15 cm/s with the Kuroshio. The frontal eddies occur about every 10 d and evolve to be warm filaments a few hundred km in length and 30-40 km in width in the area west of the Yaku-shima. Meanwhile, the existence of the warm filament was also found in the area by analysing the hydrographic data in the area west of Kyushu during May 24-June 5, 1988.The Kuroshio warm filaments move westward opposite to the Kuroshio and then turn northward at the shelf break and become the main source of the warm water of the Tsushima Warm Current. A simple dynamic explanation for the process is presented in this paper.     

Moho depth variation beneath southwestern Japan revealed from the velocity structure based on receiver function inversion

The Philippine Sea plate is subducting under the Eurasian plate beneath the Chugoku-Shikoku region, southwestern Japan. We have constructed depth contours for the continental and oceanic Mohos derived from the velocity structure based on receiver function inversion. Receiver functions were calculated using teleseismic waveforms recorded by the high-density seismograph network in southwestern Japan. In order to determine crustal velocity structure, we first improved the linearized time-domain receiver function inversion method. The continental Moho is relatively shallow ( 30 km) at the coastline of the Sea of Japan and at the Seto Inland Sea, and becomes deeper–greater than 40 km–around 35°N and 133.8°E. Near the Seto Inland Sea, a low-velocity layer of thickness 10 km lies under the continental Moho. This low-velocity layer corresponds to the subducting oceanic crust of the Philippine Sea plate. The oceanic Moho continues to descend from south to northwest and exhibits complicated ridge and valley features. The oceanic Moho runs around 25 km beneath the Pacific coast and 45 km beneath the Seto Inland Sea, and it extends to at least to 34.5°N. The depth variation of the Moho discontinuities is in good qualitative agreement with the concept of isostasy. From the configurations of both the continental and oceanic Mohos, we demonstrate that the continental lower crust and the subducting oceanic crust overlap beneath the southern and central part of Shikoku and that a mantle wedge may exist beneath the western and eastern part of Shikoku. The southern edge of the overlapping region coincides with the downdip limit of the slip area of a megathrust earthquake.