Intraplate deformation and 3D rheological structure of the Rhine Rift System and adjacent areas of the northern Alpine foreland

The lithosphere of the Northern Alpine foreland has undergone a polyphase evolution during which interacting stress-induced intraplate deformation and upper mantle thermal perturbations controlled folding of the thermally weakened lithosphere. In this paper we address relationships among deeper lithospheric processes, neotectonics and surface processes in the Northern Alpine foreland with special emphasis on tectonically induced topography. We focus on lithosphere memory and neotectonics, paying special attention to the thermo-mechanical structure of the Rhine Graben System and adjacent areas of the northern Alpine foreland lithosphere. We discuss implications for mechanisms of large-scale intraplate deformation and links with surface processes and topography evolution.     

The OSO-1 solar neutron experiment

BF₃ counters on OSO-1 were used to look for solar neutrons by trying to observe a diurnal variation in count rate. No effect was observed and an upper limit was placed on the solar neutron flux at the earth of J _n < 2 × 10^–3 neut/cm²/sec of 10 keV < E _n < 10 meV for the period March to May 1962. No proton-producing flares occurred during this time, so the most obvious source of solar neutrons could not be studied. The emulsion experiment of Apparao et al., flown during this period, which seemed to indicate solar neutrons has probably been misinterpreted.     

Thorium and uranium isotopes in a manganese nodule from the Peru basin determined by alpha spectrometry and thermal ionization mass spectrometry (TIMS): Are manganese supply and growth related to climate?

Thorium- and uranium isotopes were measured in a diagenetic manganese nodule from the Peru basin applying alpha- and thermal ionization mass spectrometry (TIMS). Alpha-counting of 62 samples was carried out with a depth resolution of 0.4 mm to gain a high-resolution²³⁰Th_excess profile. In addition, 17 samples were measured with TIMS to obtain precise isotope concentrations and isotope ratios. We got values of 0.06–0.59 ppb (²³⁰Th), 0.43–1.40 ppm (²³²Th), 0.09–0.49 ppb (²³⁴U) and 1.66–8.24 ppm (²³⁸U). The uranium activity ratio in the uppermost samples (1–6 mm) and in two further sections in the nodule at 12.5±1.0 mm and 27.3–33.5 mm comes close to the present ocean water value of 1.144±0.004. In two other sections of the nodule, this ratio is significantly higher, probably reflecting incorporation of diagenetic uranium. The upper 25 mm section of the Mn nodule shows a relatively smooth exponential decrease in the²³⁰Th_excess concentration (TIMS). The slope of the best fit yields a growth rate of 110 mm/Ma up to 24.5 mm depth. The section from 25 to 30.3 mm depth shows constant²³⁰Th_excess concentrations probably due to growth rates even faster than those in the top section of the nodule. From 33 to 50 mm depth, the growth rate is approximately 60 mm/Ma. Two layers in the nodule with distinct laminations (11–15 and 28–33 mm depth) probably formed during the transition from isotopic stage 8 to 7 and in stage 5e, respectively. The Mn/Fe ratio shows higher values during interglacials 5 and 7, and lower ones during glacials 4 and 6. A comparison of our data with data from adjacent sediment cores suggests (a) a variable supply of hydrothermal Mn to sediments and Mn nodules of the Peru basin or (b) suboxic conditions at the water sediment interface during periods with lower Mn/Fe ratios.     

Geodynamic setting,structure, and composition of continuous trachybasalt-trachyandesite-rhyolite series in the north of Altai-Sayan area: the role of crust-mantle interaction in continental magma formation

The geologic positions and geochemical and isotope parameters of the Ordovician-early Silurian and Early-Middle Devonian continuous volcanic series of the Minusa basin and its mountainous framing are compared. Both series are composed mostly of moderately alkaline rocks with variations in SiO₂ contents from 45 to 77 wt.%. The Ordovician-early Silurian series differs from the Early-Middle Devonian one in lower contents of TiO₂ (< 1.7 wt.%) and Fe₂O_3tot and higher contents of Al₂O₃ in all rock varieties and in the more fractionated REE patterns of trachybasalts. The compositions of both series reflect two simultaneous mechanisms of magma evolution. The main process was fractional crystallization leading to the formation of rocks from trachybasalts to trachyrhyodacites. The accessory mechanism was the contamination of fractionated melts by crustal material, anatectic melting of crust, and mixing of deep-seated magmas with crustal melts. These processes had specifics at each stage and were controlled by the composition of the sources of parental melts. Their geochemical and isotopic parameters (high alkalinity, high contents of lithophile elements, negative anomalies of Nb, Ta, and Ti, and enrichment in radiogenic Sr) point to the interaction of mantle plumes with the lithospheric mantle that was metasomatically transformed during the preceding Vendian-early Cambrian subduction processes.     

Stress Field Estimations for Colima Volcano, Mexico, Based on Seismic Data

 For first time, during 1991, seismic activity was recorded during an eruption at Colima volcano. We analyze these data to obtain a stress pattern using a composite focal mechanism technique. From the analysis of regional seismicity, the Tamazula Fault and the Armeria River appear as active features and the dip of the slab east of the Jalisco Block is approximately 12°. Southwest of Colima volcano a vertical alignment of seismic events was observed. We estimate five different composite focal mechanism solutions from our data set, which indicate a change of the stress field at the volcano after the 1991 eruption. These solutions suggest that the stress field in the volcanic edifice was controlled by stresses related to the emplacement of magma superimposed on the regional stress field. No evidence of active local faults in the volcanic edifice was found. We propose a model for the eruptive process that involves tilting of the volcanic edifice. Received: 15 October 1995 / Accepted: 26 October 1998     

Biofacies analysis of Upper Cretaceous deposits in the Ust-Yenisei region: Implications of palynomorphs

The results of palynomorph biofacies analysis in the Upper Cretaceous deposits of the Ust-Yenisei region are presented. The established facies confinement and indicative features of separate palynomorph groups are used, along with identified dinocyst morphotypes and taxa, in paleogeographic reconstructions. Seven palynomorph associations characterizing continental, coastal-marine, shallow-and deep-water facies are distinguished based on quantitative proportions between morphological groupings and individual taxa. As boundaries between distinguishable biostratigraphic and facies subdivisions do not coincide, dinocysts were likely insignificantly dependent in distribution on facies in the West Siberian epicontinental basin at least. On the other hand, distribution trends of particular dinocyst morphotypes and other microphytofossils are correlative with transgressive-regressive cycles and can be used for reconstruction of paleoenvironments.     

Frictional heat generation and seismic radiation in a foam rubber model of earthquakes

Results from a study of stick-slip particle motion at the interface between two stressed foam rubber blocks indicate that normal vibrations and interface separation are an important part of the stick-slip process in foam rubber. The dimension of the dynamic slip pulse is small compared to the dimension of the model (approximately 10 cm vs. 200 cm) consistent with the abrupt-locking slip pulse model ofBrune (1970, 1976), andHeaton (1990). A comparison of frictional heat generation between stable-sliding and stick-slip foam rubber models indicates a linear relation between the temperature increase on the fault surface (for a given distance of slip) and the driving shear force for the stable-sliding model, while for the stick-slip model there is essentially no variation in frictional heat generation with an increase in shear stress. We performed experiments to investigate the ratio of normal motion to shear motion at different levels of normal stress in the stick-slip foam rubber model. Preliminary result indicate that the normal component of the particle motion increases more rapidly with increasing normal stress than the shear component. The phenomenon of interface separation and normal vibrations may thus explain some of the most frustrating problems in earthquake mechanics, e.g., the heat flow paradox, the long-term weakness of major active faults, and anomalousP-wave radiation.     

Solving the problem of shock wave attenuation in an obstacle during a contact explosion of a high-energy material charge

A problem of estimation of shock wave attenuation in an obstacle under an explosion of a high-energy material (explosive) charge on its surface is considered. An algorithm for its solution is proposed using the analytical and semiempirical dependences generally recognized in explosion physics.     

Nonstationary pearl pulsations as a signature of magnetospheric disturbances

We analyse long-lasting (several hours) Pc1 pearl pulsations with decreasing, increasing or constant central frequencies. We show that nonstationary pearl events (those with either decreasing or increasing central frequency) are observed simultaneously with increasing auroral magnetic activity at the nightside magnetosphere while the stationary events (constant central frequency) correspond to quiet magnetic conditions. Events with decreasing central frequency are observed mostly in the late morning and daytime whereas events with increasing central frequency appear either early in the morning or in the afternoon. We explain the diurnal distribution of the nonstationary pearl pulsations in terms of proton drifts depending on magnetic activity, and evaluate the magnetospheric electric field based on the variation of the central frequency of pearl pulsations.