The influence of recultivation technique and seed mixture on erosion stability after restoration in mountain environment

Control of erosion, and all of its after effects, from increased surface drainage and erosion to the formation of karst, is one of the essential problems when undertaking recultivation following necessary interventions in the sub-alpine and alpine vegetation stage (high zones). Average slope inclinations of 30–45% in the vicinity of ski runs, and far above in areas of natural erosion and avalanche zones, make restoration processes with sufficient erosion protection the prerequisite for success. Only a sufficient vegetation development of more than 70% ground cover stabilises the topsoil in the long term and reduces soil erosion to an acceptable degree. From 1999 to 2002, an international EU project with the participation of research groups and private firms from Austria, Italy and Germany was carried out under the direction of the Agricultural Research and Education Centre Raumberg-Gumpenstein (AREC) on five different Alpine sites at altitudes from 1,245 to 2,350 m above sea level. The aim of the work was the formulation of practice-relevant requirements for recultivation following intervention in high zones, especially following constructional measures in the vicinity of ski runs and lifts, torrent- and avalanche barriers. In a statistical comparison, the relationship between restoration techniques, seed mixtures of differing ecological value and vegetation cover was observed. The influence of application technique on erosion processes after restoration was obvious for the first two vegetation periods. Only with the additional use of mulch covers could increase surface drainage and noticeable soil loss be avoided. At high altitudes, the choice of seed mixture, irrespective of whether rapid or slow growing and independent of the extent of accompanying fertilisation, had no significance in the first two vegetation periods following sowing. In the following growing seasons, however, higher cover values were obtained with site-specific seed mixtures at three of the five experimental sites. While few species of the commercial seed mixture showed satisfactory persistency, most of the grasses and in particular the alpine leguminosae of site-specific seed mixtures increased their share during the observation period. In the long-term, sufficient protection against erosion is only guaranteed by the use of stable, enduring and ecologically adapted species.     

A groundwater salinity hotspot and its connection to an intermittent stream identified by environmental tracers (Mt Lofty Ranges,South Australia)

High and variable levels of salinity were investigated in an intermittent stream in a high-rainfall area (～800 mm/year) of the Mt. Lofty Ranges of South Australia. The groundwater system was found to have a local, upslope saline lens, referred to here as a groundwater salinity ‘hotspot’. Environmental tracer analyses (δ¹⁸O, δ²H, ^87/86Sr, and major elements) of water from the intermittent stream, a nearby permanent stream, shallow and deep groundwater, and soil-water/runoff demonstrate seasonal groundwater input of very saline composition into the intermittent stream. This input results in large salinity increases of the stream water because the winter wet-season stream flow decreases during spring in this Mediterranean climate. Furthermore, strontium and water isotope analyses demonstrate: (1) the upslope-saline-groundwater zone (hotspot) mixes with the dominant groundwater system, (2) the intermittent-stream water is a mixture of soil-water/runoff and the upslope saline groundwater, and (3) the upslope-saline-groundwater zone results from the flushing of unsaturated-zone salts from the thick clayey regolith and soil which overlie the metamorphosed shale bedrock. The preferred theory on the origin of the upslope-saline-groundwater hotspot is land clearing of native deep-rooted woodland, followed by flushing of accumulated salts from the unsaturated zone due to increased recharge. This cause of elevated groundwater and surface-water salinity, if correct, could be widespread in Mt. Lofty Ranges areas, as well as other climatically and geologically similar areas with comparable hydrogeologic conditions.     

Identifying saline wetlands in an arid desert climate using Landsat remote sensing imagery. Application on Ouargla Basin,southeastern Algeria

Supervised and unsupervised satellite image classifications have progressed greatly in recent years. However, discrimination difficulties still remain among classes that directly affecting data extraction and surface mapping accuracy. The Ouargla region in southeastern Algeria is intersected by wadis, where direct communication between the shallow groundwater table and these dry, overlying ephemeral stream beds exists. Underflowing groundwater exfiltrates into low-lying aeolian blowouts or endorheic basins forming oases, chotts, and sebkhas, commonly known as saline wetlands. These wetlands are becoming increasingly vulnerable to anthropogenic stress, resulting in significant water degradation. Wetland microclimates are very important to arid regions, as they promote oasis ecosystem sustainability and preservation. High water salinity in these ecosystems, however, directly affects flourishing habitat and undermines successful desert oasis development. The objective of this work is to choose the best classification method to identify saline wetlands by comparison between the different results of land use mapping within the Ouargla basin. Landsat ETM+ (2000) satellite imagery, using visual analysis with colored compositions, has identified various forms of saline wetlands in the Ouargla region desert environment in southeast Algeria. The results show that supervised classification is validated in the identification of Saharan saline wetlands, and that support vector machine (SVM) algorithm presents the best overall accuracy.     

Effects of an Omnivorous Katydid,Salinity, and Nutrients on a Planthopper-<Emphasis Type="Italic">Spartina</Emphasis> Food Web

Top–down and bottom–up effects interact to structure communities, especially in salt marshes, which contain strong gradients in bottom–up drivers such as salinity and nutrients. How omnivorous consumers respond to variation in prey availability and plant quality is poorly understood. We used a mesocosm experiment to examine how salinity, nutrients, an omnivore (the katydid Orchelimum fidicinium) and an herbivore (the planthopper Prokelisia spp.) interacted to structure a simplified salt marsh food web based on the marsh grass Spartina alterniflora. Bottom–up effects were strong, with both salinity and nutrients decreasing leaf C/N and increasing Prokelisia abundance. Top–down effects on plants were also strong, with both the herbivore and the omnivore affecting S. alterniflora traits and growth, especially when nutrients or salt were added. In contrast, top–down control by Orchelimum of Prokelisia was independent of bottom–up conditions. Orchelimum grew best on a diet containing both Spartina and Prokelisia, and in contrast to a sympatric omnivorous crab, did not shift to an animal-based diet when prey were present, suggesting that it is constrained to consume a mixed diet. These results suggest that the trophic effects of omnivores depend on omnivore behavior, dietary constraints, and ability to suppress lower trophic levels, and that omnivorous katydids may play a previously unrecognized role in salt marsh food webs.     

Application of multivariate statistical methods to indicate the origin and geochemical behavior of potentially hazardous elements in sediment around the Sarcheshmeh copper mine,SE Iran

Multivariate statistical techniques, i.e., correlation coefficient analysis, principal components analysis (PCA), and hierarchical cluster analysis (CA), were applied to the total and water-soluble concentrations of potentially hazardous metals in sediments associated with the Sarcheshmeh mine, one of the largest Oligo-Miocene porphyry copper deposits in the world. The samples were analyzed for hazardous metal concentration levels by inductively coupled plasma mass spectrometry method. Results indicate that the contaminant metals As, Cd, Cu, Mo, S, Sb, Sn, Se, Pb, and Zn were positively correlated with the total concentrations. These hazardous metals also have strong association in the PCA and CA results. Different anthropic versus natural sources of contaminant metals were distinguished by using CA method. Water-soluble fraction of hazardous metals showed that the hydro-geochemical behavior of these metals in sediments is different considerably. Elements such as Cd, Co, Cr, Cu, Fe, Mn, Ni, S, and Zn are readily water soluble from contaminated samples, especially from evaporative mineral phases, while the release of As, Mo, Sb, and Pb into the water is limited by adsorption processes. Results obtained from the application of multivariate techniques on the water-soluble fraction data set show that the hazardous metals are categorized into three groups including (1) Ni, S, Co, Cu, Cr, and Fe; (2) Se, Mn, Cd, and Zn; and (3) Sb, As, Mo, and Sn. This classification describes the hydro-geochemical behavior of hazardous metals in water–sediment environments of the Sarcheshmeh porphyry copper mine and can be used as a basis in remedial and treatment strategies.     

Environmental hydrogeology of the southern sector of the Samborombon Bay wetland,Argentina

The Samborombon Bay wetland is located on the west margin of the Rio de la Plata estuary, in the Province of Buenos Aires, Argentina. This paper analyses the geological, geomorphologic, soil and vegetation characteristics of the southernmost sector of this wetland and their influence on surface water and groundwater. The study area presents three hydrologic units: coastal dunes, sand sheets and coastal plain. Coastal dunes and sand sheets are recharge zones of high permeability with well-drained, non-saline soils, and a few surface water flows. Changes in the water table are related to rainfall. Groundwater in coastal dunes is Ca–Mg–HCO₃ to Na–HCO₃, and of low salinity (590 mg/l). Groundwater in sand sheets is mainly Na–HCO₃ with a salinity of about 1,020 mg/l. The coastal plain exhibits medium to low permeability sediments, with submerged saline soils poorly drained. Groundwater is Na–Cl with a mean salinity of 16,502 mg/l. A surface hydrological network develops in the coastal plain. Surface water levels near the shoreline are affected by tidal fluctuations; far from the shoreline water accumulates because of poor drainage. Both sectors have Na–Cl water, but the former is more saline. Human intervention and sea level rise may affect the wetland severely.     

Late Carboniferous porphyry copper mineralization at La Voluntad,Neuquén,Argentina: Constraints from Re–Os molybdenite dating

The La Voluntad porphyry Cu–Mo deposit in Neuquén, Argentina, is one of several poorly known porphyry-type deposits of Paleozoic to Early Jurassic age in the central and southern Andes. Mineralization at La Voluntad is related to a tonalite porphyry from the Chachil Plutonic Complex that intruded metasedimentary units of the Piedra Santa Complex. Five new Re–Os molybdenite ages from four samples representing three different vein types (i.e., quartz–molybdenite, quartz–sericite–molybdenite and quartz–sericite–molybdenite ± chalcopyrite–pyrite) are identical within error and were formed between ~312 to ~316 Ma. Rhenium and Os concentrations range between 34 to 183 ppm and 112 to 599 ppb, respectively. The new Re–Os ages indicate that the main mineralization event at La Voluntad, associated to sericitic alteration, was emplaced during a time span of 1.7 ± 3.2 Ma and that the deposit is Carboniferous in age, not Permian as previously thought. La Voluntad is the oldest porphyry copper deposit so far recognized in the Andes and indicates the presence of an active magmatic arc, with associated porphyry style mineralization, at the proto-Pacific margin of Gondwana during the Early Pennsylvanian.     

On CO<Subscript>2</Subscript> fluid flow and heat transfer behavior in the subsurface,following leakage from a geologic storage reservoir

Geologic storage of CO₂ is expected to produce plumes of large areal extent, and some leakage may occur along fractures, fault zones, or improperly plugged pre-existing wellbores. A review of physical and chemical processes accompanying leakage suggests a potential for self-enhancement. The numerical simulations presented here confirm this expectation, but reveal self-limiting features as well. It seems unlikely that CO₂ leakage could trigger a high-energy run-away discharge, a so-called “pneumatic eruption,” but present understanding is insufficient to rule out this possibility. The most promising avenue for increasing understanding of CO₂ leakage behavior is the study of natural analogues.     

THERIA_G: a software program to numerically model prograde garnet growth

We present the software program THERIA_G, which allows for numerical simulation of garnet growth in a given volume of rock along any pressure–temperature–time (P–T–t) path. THERIA_G assumes thermodynamic equilibrium between the garnet rim and the rock matrix during growth and accounts for component fractionation associated with garnet formation as well as for intracrystalline diffusion within garnet. In addition, THERIA_G keeps track of changes in the equilibrium phase relations, which occur during garnet growth along the specified P–T–t trajectory. This is accomplished by the combination of two major modules: a Gibbs free energy minimization routine is used to calculate equilibrium phase relations including the volume and composition of successive garnet growth increments as P and T and the effective bulk rock composition change. With the second module intragranular multi-component diffusion is modelled for spherical garnet geometry. THERIA_G allows to simulate the formation of an entire garnet population, the nucleation and growth history of which is specified via the garnet crystal size frequency distribution. Garnet growth simulations with THERIA_G produce compositional profiles for the garnet porphyroblasts of each size class of a population and full information on equilibrium phase assemblages for any point along the specified P–T–t trajectory. The results of garnet growth simulation can be used to infer the P–T–t path of metamorphism from the chemical zoning of garnet porphyroblasts. With a hypothetical example of garnet growth in a pelitic rock we demonstrate that it is essential for the interpretation of the chemical zoning of garnet to account for the combined effects of the thermodynamic conditions of garnet growth, the nucleation history and intracrystalline diffusion. Electronic supplementary material  The online version of this article (doi:) contains supplementary material, which is available to authorized users.

On estimating time offsets in the ambient noise correlation function caused by instrument response errors

Broadband seismic networks are becoming more intensive, generating a large amount of data in the long-term collection process. When processing the data, the researchers rely almost on instrument response files to understand the information related to the instrument. Aiming at the process of instrument response recording and instrument response correction, we identify several sources of the instrument response phase error, including pole–zero change, the causality difference in instrument correction method, and the problem of filter coefficient recording. The data time offset range from the instrument response phase error is calculated from one sample point to several seconds using the ambient noise data recorded by multiple seismic stations. With different data delays, the time offset of the noise correlation function is estimated to be 74% to 99% of the data delay time. In addition, the influence of instrument response phase error on the measurement of seismic velocity change is analyzed by using ambient noise data with pole–zero change, and the results show that the abnormal wave velocity with exceeding the standard value is exactly in the time period of the instrument response error, which indicates that the instrument response error affects the study of seismology.